Preparation and characterisation of refractory whiskers and selected alumina composites

A whisker is a common name of single crystalline inorganic fibre of small dimensions, typically 0.5-1 μm in diameter and 20-50 μm in length. Whiskers are mainly used as reinforcement of ceramics. This work describes the synthesis and characterisation of new whisker types. Ti0.33Ta0.33Nb0.33CxN1-x, TiB2, B4C, and LaxCe1-xB6 have been prepared by carbothermal vapour–liquid–solid (CTR-VLS) growth mechanisms in the temperature range 900-1800°C, in argon or nitrogen. Generally, carbon and different suitable oxides were used as whisker precursors. The oxides reacted via a carbothermal reduction process. A halogenide salt was added to form gaseous metal halogenides or oxohalogenides and small amount of a transition metal was added to catalyse the whisker growth. In this mechanism, the whisker constituents are dissolved into the catalyst, in liquid phase, which becomes supersaturated. Then a whisker could nucleate and grow out under continuous feed of constituents. The syntheses of TiC, TiB2, and B4C were followed at ordinary synthesis conditions by means of mass spectrometry (MS), thermogravimetry (TG), differential thermal analysis (DTA) and quenching. The main reaction starting temperatures and reaction time for the different mixtures was revealed, and it was found that the temperature inside the crucible during the reactions was up to 100°C below the furnace set-point, due to endothermic nature of the reactions. Quench experiments showed that whiskers were formed already when reaching the temperature plateau, but the yield increased fast with the holding time and reached a maximum after about 20-30 minutes. Growth models for whisker formation have been proposed. Alumina based composites reinforced by (2-5 vol.%) TiCnano and TiNnano and 25 vol.% of carbide, and boride phases (whiskers and particulates of TiC, TiN, TaC, NbC, (Ti,Ta)C, (Ti,Ta,Nb)C, SiC, TiB2 and B4C) have been prepared by a developed aqueous colloidal processing route followed by hot pressing for 90 min at 1700°C, 28 MPa or SPS sintering for 5 minutes at 1200-1600°C and 75 MPa. Vickers indentation measurements showed that the lowest possible sintering temperature is to prefer from mechanical properties point of view. In the TiNnano composites the fracture mode was typically intergranular, while it was transgranular in the SiCnano composites. The whisker and particulate composites have been compared in terms of e.g. microstructure and mechanical properties. Generally, additions of whiskers yielded higher fracture toughness compared to particulates. Composites of commercially available SiC whiskers showed best mechanical properties with a low spread but all the other whisker phases, especially TiB2, exhibited a great potential as reinforcement materials.

Autophagic programmed cell death in the suspensor and endosperm of Vicia faba : An ultrastructural study

Programmed cell death (PCD) is a widely spread phenomenon among multi-cellular organisms. Without the deletion of cells no longer needed, the organism will not be able to develop in a predicted way. It is now belived that all cells have the capacity to self-destruct and that the survival of the cells is depending on the repression of this suicidal programme. PCD has turned out to show similarities in many different species and there are strong indications that the mechanisms running the programme might, at least in some parts, be evolutionarily conserced. PCD is a generic term for different programmes of cell destruction, such as apoptosis and autophagic PCD. An important tool to determine if a cell is undergoing PCD is the transmitting electron microscope. The aims of my study were to find out if, and in what way, the suspensor and endosperm in Vicia faba (Broad bean), which are short-lived structures, undergoes PCD. The endosperm degradation preceed the suspensor cell death and they differ to some extent ultrastructurally. The cell death occurs in both tissues about 13-14 days after pollination when the embryo proper is mature enough to support itself. It was found that both tissues are committed to autophagic PCD, a cell death characteristic of conspicuous formations of autophagic vacuoles. It was shown by histochemical staining that acid phosphatases are accumulated in these vacuoles but are also present in the cytoplasm. These vacuoles are similar to autophagic vacuoles formed in rat liver cells, indicating that autophagy is a widely spread phenomenon. DNA fragmentation is the first visible sign of PCD in both tissues and it is demonstrated by a labelling technique (TUNEL). In the endosperm nuclei the heterochromatin subsequently appears in the form of a network, while in the suspensor it is more conspicuous, with heterochromatin that forms large electron dense aggregates located close to the nuclear envelope. In the suspensor, the plastids develop into chromoplasts with lycopene crystals at the same time or shortly after DNA fragmentation. This is probably due to the fact that the suspensor plastids function as hormone producing organelles and support the embryo proper with indispensable growth factors. Later the embryo will be able to produce its own growth factors and the synthesis of these, in particular gibberelines, might be suppressed in the suspensor. The precursors can then be used for synthesis of lycopene instead. Both the suspensor and endosperm are going through autophagic PCD, but the process differs in some respects. This is probably due the the different function of the two tissues, and that the signals that trigger the process presumably are different. The embryo proper is probably the source of the death signal affecting the suspensor. The endosperm, which has a different origin and function, might be controlling the death signal within its own cell. The death might in this case be related to the age of the cell.

On the Economics and Politics of Mobility

Exit, Voice and Political Change: Evidence from Swedish Mass Migration to the United States. During the Age of Mass Migration, 30 million Europeans immigrated to the United States. We study the long-term political effects of this large-scale migration episode on origin communities using detailed historical data from Sweden. To instrument for emigration, we exploit severe local frost shocks that sparked an initial wave of emigration, interacted with within-country travel costs. Because Swedish emigration was highly path dependent, the initial shocks strongly predict total emigration over 50 years. Our estimates show that emigration substantially increased membership in local labor organizations, the strongest political opposition groups at the time. Furthermore, emigration caused greater strike participation, and mobilized voter turnout and support for left-wing parties in national elections. Emigration also had formal political effects, as measured by welfare expenditures and adoption of inclusive political institutions. Together, our findings indicate that large-scale emigration can achieve long-lasting effects on the political equilibrium in origin communities. Mass Migration and Technological Innovation at the Origin. This essay studies the effects of migration on technological innovations in origin communities. Using historical data from Sweden, we find that large-scale emigration caused a long-run increase in patent innovations in origin municipalities. Our IV estimate shows that a ten percent increase in emigration entails a 7 percent increase in a muncipality’s number of patents. Weighting patents by a measure of their economic value, the positive effects are further increased. Discussing possible mechanisms, we suggest that low skilled labor scarcity may be an explanation for these results.  Richer (and Holier) Than Thou? The Impact of Relative Income Improvements on Demand for Redistribution. We use a tailor-made survey on a Swedish sample to investigate how individuals' relative income affects their demand for redistribution. We first document that a majority misperceive their position in the income distribution and believe that they are poorer, relative to others, than they actually are. We then inform a subsample about their true relative income, and find that individuals who are richer than they initially thought demand less redistribution. This result is driven by individuals with prior right-of-center political preferences who view taxes as distortive and believe that effort, rather than luck, drives individual economic success. Wealth, home ownership and mobility. Rent controls on housing have long been thought to reduce labor mobility and allocative efficiency. We study a policy that allowed renters to purchase their rent-controlled apartments at below market prices, and examine the effects of home ownership and wealth on mobility. Treated individuals have a substantially higher likelihood of moving to a new home in a given year. The effect corresponds to a 30 percent increase from the control group mean. The size of the wealth shock predicts lower mobility, while the positive average effect can be explained by tenants switching from the previous rent-controlled system to market-priced condominiums. By contrast, we do not find that the increase in residential mobility leads to a greater probability of moving to a new place of work.