Factors structuring Fucus communities at open and complex coastlines in the Baltic Sea

This thesis deals with physical factors and biological interactions affecting the distribution of two fucoid species, Fucus vesiculosus and F. serratus, in the Baltic Sea. Studies have been carried out in two quite different environments: an archipelago, and an open rocky coast. The archipelago has an extremely long coastline with a heterogeneous submerged landscape of different substrate types, slopes, water qualities, and degrees of wave exposure. The factors influencing F. vesiculosus distribution, morphology and epiphyte composition were studied in the Stockholm archipelago using field surveys and spatial modelling in Geographic information systems (GIS). A GIS-method to estimate wave exposure was developed and validated by comparing the result to an index based on vertical zonation of lichens. Wave exposure was considered an important factor for predicting the distribution of F. vesiculosus by its ability to clean hard surfaces from silt, and a predictive model was constructed based on the information of wave exposure and slope of the shore. It is suggested that the lower distribution boundary of attached F. vesiculosus is set by sediment in sheltered parts of the archipelago, and by light availability in highly wave exposed parts. The morphology of F. vesiculosus was studied over a wave exposure gradient, and several characters responded in accordance with earlier studies. However, when separating effects of wave exposure from effects of other confounding water property parameters, only thallus width was significantly different. Several water property parameters were shown to be correlated with wave exposure in the Stockholm archipelago, and the mechanism responsible for the effects on F. vesiculosus morphology is discussed. The composition of epiphytes on F. vesiculosus varied over a wave exposure gradient with a positive correlation to Elachista fucicola, and a negative to Chorda filum. At an open coast the physical environment is much less heterogeneous compared to an archipelago. The distributions of F. vesiculosus, F. serratus, turf-forming algae, and the seafloor substrate, were surveyed along the open coasts of Öland and Gotland. Turf-forming algae dominated all hard substrates in the area, and Polysiphonia fucoides was most abundant. At the Gotland coast F. vesiculosus was less abundant than at the Öland coast, and F. serratus occurred only in the southern-most part. Fucus serratus was increasingly more common towards south which was interpreted as an effect mainly of the Baltic salinity gradient, or the variation of salinity that has occurred in the past. The effects of turf-forming algae and sediment on F. serratus recruitment at 7 m depth off the Öland east coast were studied in the field, and by laboratory experiments. Almost no recruits were found in the algal turf outside the F. serratus patches. More fine sediment was found in the turf than in the F. serratus patches, suggesting that the turf accumulates sediment by decreasing resuspension. Both filamentous algae and sediment decreased the attachment ability of F. serratus zygotes and survival of recruits, and sediment had the strongest effect. It is therefore suggested that F. serratus has difficulties recruiting outside its patches, and that these difficulties are enforced by the eutrophication of the Baltic Sea, which has favoured growth of filamentous algae and increased sedimentation. An overall conclusion is that Fucus distribution is affected by large-scale-factors, such as the eutrophication and salinity changes of the Baltic Sea, as well as by small-scale variation in wave exposure, substrate and slope, and by surface competition with neighbouring species.

Dynamics of the cold surface layer of polythermal Storglaciären, Sweden

Polythermal glaciers, i.e. glaciers with a combination of ice at and below the freezing point, are widespread in arctic and subarctic environments. The polythermal structure has major implications for glacier hydrology, ice flow and glacial erosion. However, the interplay of factors governing its spatial and temporal variations such as net mass balance, ice advection and water content in the ice is poorly investigated and as yet not fully understood. This study deals with a thorough investigation of the polythermal regime on Storglaciären, northern Sweden, a small valley glacier with a cold surface layer in the ablation area. Extensive field work was performed including mapping of the cold surface layer using ground-penetrating radar, ice temperature measurements, mass balance and ice velocity measurements. Analyses of these data combined with numerical modelling were used specifically to investigate the spatial and temporal variability of the cold surface layer, the spatial distribution of the water content just below the cold surface layer transition, the effect of radar frequency on the detection of the surface layer, and the sensitivity of the cold surface layer to changes in forcing. A comparison between direct temperature measurements in boreholes and ground-penetrating surveys shows that the radar-inferred cold-temperate transition depth is within ±1 m from the melting point of ice at frequencies above ~300 MHz. At frequencies below ~155 MHz, the accuracy degrades because of reduced scattering efficiency that occurs when the scatterers become much smaller compared to the wavelength. The mapped spatial pattern of the englacial cold-temperate transition boundary is complex. This pattern reflects the observed spatial variation in net loss of ice at the surface by ablation and vertical advection of ice, which is suggested to provide the predominant forcing of the cold surface layer thickness pattern. This is further supported by thermomechanical modeling of the cold surface layer, which indicates high sensitivity of the cold surface layer thickness to changes in vertical advection rates. The water content is the least investigated quantity that is relevant for the thermal regime of glaciers, but also the most difficult to assess. Spatial variability of absolute water content in the temperate ice immediately below the cold surface layer on Storglaciären was determined by combining relative estimates of water content from ground-penetrating radar data with absolute determination from temperature measurements and the thermal boundary condition at the freezing front. These measurements indicate large-scale spatial variability in the water content, which seems to arise from variations in entrapment of water at the firn-ice transition. However, this variability cannot alone explain the spatial pattern in the thermal regime on Storglaciären. Repeated surveys of the cold surface layer show a 22% average thinning of the cold surface layer on Storglaciären between 1989 and 2001. Transient thermomechanical modeling results suggest that the cold surface layer adapts to new equilibrium conditions in only a few decades after a perturbation in the forcing is introduced. An increased winter air temperature since mid-1980s seems to be the cause of the observed thinning of the cold surface layer. Over the last decades, mass balance measurements indicate that the glacier has been close to a steady state. The quasi-steady state situation is also reflected in the vertical advection, which shows no significant changes during the last decades. Increased winter temperatures at the ice surface would result in a slow-down of the formation of cold ice at the base of the cold surface layer and lead to a larger imbalance between net loss of ice at the surface and freezing of temperate ice at the cold-temperate transition.

Solid-phase Microextraction and Detection of Organophosphate Triesters in Indoor air

In the work underlying this thesis solid-phase microextraction (SPME) was evaluated as a passive sampling technique for organophosphate triesters in indoor air. These compounds are used on a large scale as flame-retarding and plastizicing additives in a variety of materials and products, and have proven to be common pollutants in indoor air. The main objective of this work was to develop an accurate method for measuring the volatile fraction. Such a method can be used in combination with active sampling to obtain information regarding the vapour/particulate distribution in different indoor environments. SPME was investigated under both equilibrium and non-equilibrium conditions and parameters associated with these different conditions were estimated. In Paper I, time-weighted average (TWA) SPME under dynamic conditions was investigated in order to obtain a fast air sampling method for organophosphate triesters. Among the investigated SPME coatings, the absorptive PDMS polymer had the highest affinity for the organophosphate triesters and was consequently used in all further work. Since the sampling rate is dependent on the agitation conditions, the linear airflow rates had to be carefully considered. Sampling periods as short as 1 hour were shown to be sufficient for measurements in the ng-μg m-3 range when using a PDMS 100-μm fibre and a linear flow rate above 7 cm s-1 over the fibre. SPME under equilibrium conditions is rather time-consuming, even under dynamic conditions, for slowly partitioning compounds such as organophosphate triesters. Nevertheless, this method has some significant advantages. For instance, the limit of detection is much lower compared to 1 h TWA sampling. Furthermore, the sampling time can be ignored as long as equilibrium has been attained. In Paper II, SPME under equilibrium conditions was investigated and evaluated for organophosphate triester vapours. Since temperature and humidity are closely associated with the distribution constant a simple study of the effect of these parameters was performed. The obtained distribution constants were used to determine the air levels in a common indoor environment. SPME and parallel active sampling on filters yielded similar results, indicating that the detected compounds were almost entirely associated with the vapour phase To apply dynamic SPME method in the field a sampler device, which enables controlled linear airflow rates to be applied, was constructed and evaluated (Paper III). This device was developed for application of SPME and active sampling in parallel. A GC/PICI-MS/MS method was developed and used in combination with active sampling of organophosphate triesters in indoor air (Paper IV). The combination of MS/MS and the soft ionization achieved with methanol as reagent gas yielded high selectivity and detection limits comparable to those provided by GC with nitrogen-phosphorus detection (NPD). The method limit of detection, when sampling 1.5 m3 of air, was in the range 0.1-1.4 ng m-3. In Paper V, the developed MS method was used in combination with SPME for indoor air measurements. The levels detected in the investigated indoor environments range from a few ng to μg m-3. Tris(2-chloropropyl) phosphate was detected at a concentration as high as 7 μg m-3 in a newly rebuilt lecture room.