79 resultados para Serial-distributed arithmetic

em Reposit


Relevância:

30.00% 30.00%

Publicador:

Resumo:

A parallel technique, for a distributed memory machine, based on domain decomposition for solving the Navier-Stokes equations in cartesian and cylindrical coordinates in two dimensions with free surfaces is described. It is based on the code by Tome and McKee (J. Comp. Phys. 110 (1994) 171-186) and Tome (Ph.D. Thesis, University of Strathclyde, Glasgow, 1993) which in turn is based on the SMAC method by Amsden and Harlow (Report LA-4370, Los Alamos Scientific Laboratory, 1971), which solves the Navier-Stokes equations in three steps: the momentum and Poisson equations and particle movement, These equations are discretized by explicit and 5-point finite differences. The parallelization is performed by splitting the computation domain into vertical panels and assigning each of these panels to a processor. All the computation can then be performed using nearest neighbour communication. Test runs comparing the performance of the parallel with the serial code, and a discussion of the load balancing question are presented. PVM is used for communication between processes. (C) 1999 Elsevier B.V. B.V. All rights reserved.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Networked control systems (NCS) are distributed control system in which sensors, actuators and controllers are physically separated and connected through communication networks. NCS represent the evolution of networked control architectures providing greater modularity and control decentralization, ease maintenance and diagnosis and lower cost of implementation. A recent trend in this research topic is the development of NCS using wireless networks which enable interoperability between existing wired and wireless systems. This paper presents the feasibility analysis of using a serial RS-232 to Bluetooth converter as a wireless sensor link in NCS. In order to support this investigation, relevant performance metrics for wireless control applications such as jitter, time delay and messages lost are highlighted and calculated to evaluate the converter capabilities. In addition the control performance of an implemented motor control system using the converter is analyzed. Experimental results led to the conclusion that serial RS-232 Bluetooth converters can be used to implement wireless networked control systems (WNCS) providing transmission rates and closed control loop times which are acceptable for NCS applications. © 2011 IEEE.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Networked control systems (NCS) are distributed control system where the sensors, actuators and controllers are physically separated and connected through communication networks. NCS represent the evolution of networked control architectures providing greater modularity and control decentralization, ease maintenance and diagnosis and lower cost of implementation. A recent trend in this research topic is the development of NCS using wireless networks (WNCS) enabling interoperability between existing wired and wireless systems. This paper evaluates a serial RS-232 ZigBee device as a wireless sensor link in NCS. In order to support this investigation, relevant performance metrics for wireless control applications such as jitter, time delay and messages lost are highlighted and calculated to evaluate the device capabilities. In addition the control performance of an implemented motor control system using the device is analyzed. Experimental results led to the conclusion that serial RS-232 ZigBee devices can be used to implement WNCS and the use of this device delay information in the PID controller discretization can improve the control performance of the system. © 2012 IEEE.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Cultura de fezes (Método de Exclusão Competitiva - EC) utilizada para prevenir a colonização cecal de aves por Salmonella enterica serovar Enteritidis (SE) foi submetida a cultivos seriados para evitar a presença de patógenos e, após o tratamento mais adequado, foi armazenada em temperatura de refrigeração antes do seu uso por até 63 dias. Os resultados mostraram que o cultivo repetido por 14 vezes não prejudica a ação protetora da cultura (CE), a qual continua inibindo a colonização cecal por SE. O produto submetido a 12 cultivos e armazenado durante 28 dias em temperatura de refrigeração também continua eficaz.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This paper aims to present, using a set of guidelines, how to apply the conservative distributed simulation paradigm (CMB protocol) to develop efficient applications. Using these guidelines, even a user with little experience on distributed simulation and computer architecture can have good performance on distributed simulations using conservative synchronization protocols for parallel processes.The set of guidelines is focus on a specific application domain, the performance evaluation of computer systems, considering models with coarse granularity and few logical processes and running over two platforms: parallel (high performance communication environment) and distributed (low performance communication environment).

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Energy policies and technological progress in the development of wind turbines have made wind power the fastest growing renewable power source worldwide. The inherent variability of this resource requires special attention when analyzing the impacts of high penetration on the distribution network. A time-series steady-state analysis is proposed that assesses technical issues such as energy export, losses, and short-circuit levels. A multiobjective programming approach based on the nondominated sorting genetic algorithm (NSGA) is applied in order to find configurations that maximize the integration of distributed wind power generation (DWPG) while satisfying voltage and thermal limits. The approach has been applied to a medium voltage distribution network considering hourly demand and wind profiles for part of the U.K. The Pareto optimal solutions obtained highlight the drawbacks of using a single demand and generation scenario, and indicate the importance of appropriate substation voltage settings for maximizing the connection of MPG.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

In this paper an efficient algorithm for probabilistic analysis of unbalanced three-phase weakly-meshed distribution systems is presented. This algorithm uses the technique of Two-Point Estimate Method for calculating the probabilistic behavior of the system random variables. Additionally, the deterministic analysis of the state variables is performed by means of a Compensation-Based Radial Load Flow (CBRLF). Such load flow efficiently exploits the topological characteristics of the network. To deal with distributed generation, a strategy to incorporate a simplified model of a generator in the CBRLF is proposed. Thus, depending on the type of control and generator operation conditions, the node with distributed generation can be modeled either as a PV or PQ node. To validate the efficiency of the proposed algorithm, the IEEE 37 bus test system is used. The probabilistic results are compared with those obtained using the Monte Carlo method.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Avaliaram-se os efeitos do butorfanol e da buprenorfina sobre variáveis cardiovasculares e neuroendócrinas em cães anestesiados com desfluorano, utilizando-se 30 cães adultos, machos e fêmeas, distribuídos em três grupos denominados grupo butorfanol (GBT), grupo buprenorfina (GBP) e grupo-controle (GCO). A anestesia foi induzida com propofol (8mg/kgIV) e nos animais intubados administrou-se desfluorano (1,5CAM). Após 30 minutos, nos cães do GBT, aplicou-se butorfanol (0,4mg/kgIM); nos do GBP, buprenorfina (0,02mg/kgIM); e nos do GCO, solução de NaCl a 0,9% (0,05ml/kgIM). Avaliaram-se: freqüência cardíaca; pressões arteriais sistólica, diastólica e média; débito cardíaco; pressão venosa central; cortisol; hormônio adrenocorticotrópico; noradrenalina; e glicose. As colheitas dos dados foram feitas aos 30 minutos após o início da administração do desfluorano (M0), 15 minutos após a administração do opióide ou placebo (M15), e a cada 15 minutos após M15 (M30, M45, M60 e M75). Para a avaliação neuroendócrina utilizaram-se os momentos M-30 (antes da administração dos fármacos), M0, M15 e M45. Na freqüência cardíaca houve diferença entre M0 e M15 (129 e 111bat/min) em GBT, e entre M0 e M30 (131 e 112bat/min) em GBP. Na pressão arterial média, a diferença foi entre M0 (86mmHg) e todos os momentos que se seguiram (todos os valores foram menores que 72mmHg), em GBT. A pressão arterial diastólica foi menor em todos os momentos (<53mmHg) quando comparada com a do M0 (67mmHg), em GBT. Na pressão arterial sistólica, a diferença foi entre M0 e M15 e M30 (112 versus 93 e 94mmHg, respectivamente) em GBT. A inclusão dos opióides determinou discreta redução nos parâmetros cardiovasculares, enquanto o desfluorano interferiu na função neuroendócrina elevando os níveis plasmáticos de glicose.