Cinética da remoção dos extrativos da madeira de Eucalyptus grandis durante polpação Kraft

Kinetics of the removal of Eucalyptus grandis wood extractives during Kraft pulping. The objective of this work was to study the kinetics of the removal of Eucalyptus grandis wood extractives during Kraft pulping. The pulping was done in steel tubular reactors using wood saw under the following conditions: active alkali = 14%, sulfidity = 25%; liquor-to-wood ratio = 10 L kg(-1) of dry wood; and temperatures of 130, 150, 160 and 180 C during 30, 60, 90, 120, 150 and 180 minutes. After pulping, analyses were conducted of the yield and extractives in residue (pulp and reject). Total extractives (ethyl alcohol-toluene (1:2), ethyl alcohol and hot water, respectively) and soluble extractives in acetone were analyzed. The results showed that most extractives are degraded in the first 30 minutes of the pulping process. It was observed that the removal occurs in two different stages: the first is rapid, where the majority of the extractives are removed, and the last is slow, where few extractives are removed.

Chemical properties and decay resistance of eucalyptus grandis wood from steamed logs

The objective of this study was evaluate the effect of the log steaming on the chemical properties and decay resistance of Eucalyptus grandis wood. Logs with diameter between 20 and 22 cm were studied. Half of logs were kept in its on original condition, and the other half was steamed at 90°C for 13 hours. The holocellulosc, Klason lignin, total extractives content and the weight loss caused by the decay fungus Pycnoporus sanguineous were characterized. The results showed that the log steaming of E. grandis wood cause: (l)a significantly decreased in holocellulose content; (2) an increase of 4.8% and 4.4% in total extractives and lignin content, respectively; and (3) a decrease in its durability against the decay fungus P. sanguineus in order of 13.03%. Copyright © (2012) by WCTE 2012 Committee.

Biodegradation of eucalyptus urograndis wood by fungi

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Damage and Loss Due to Ceratocystis fimbriata in Eucalyptus Wood for Charcoal Production

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Quality of wood and pulp from a clone of Eucalyptus grandis planted at three locations

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Determination of fiber length and juvenile and mature wood zones from Hevea brasiliensis trees grown in Brazil

The aim of this study was to verify the average fiber length and the juvenile and mature wood zones from Hevea brasiliensis proveniences from a reforestation area in São Paulo, Brazil. For this purpose, five Hevea brasiliensis trees were randomly collected from a 50-year-old plantation, located in Balsamo, São Paulo, Brazil. The trees were cut and five flat sawn boards were obtained. The juvenile and mature wood zones were determined by fiber length measurement from the pith to the bark. The results showed that: (a) the juvenile wood of this species occurred approx. between 40 and 55 mm, from the pith, and from this point forward, the mature wood zone was found; (b) there was a significant difference between the average fiber length of juvenile wood (1.26 mm) and mature wood (1.51 mm).

Physical and mechanical properties of thermally modified wood from E. grandis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Application of X-ray technique in nondestructive evaluation of eucalypt wood

X-rays were initially used for the inspection of special-purpose wood pieces for quantitative evaluation properties of different species. X-ray densitometry has had its use expanded ill dendroclimatology of Picea engelmannii trees. Subsequent laboratories developed applications of X-ray densitometry for environmental, wood science and technology, and related areas. This paper describes the basic methodology of X-ray densitometry applied to the eucalypt wood analysis, as well its presenting the results of applications in three areas: (i) evaluation of wood biodegradation by white rot fungi, (ii) detection of sapwood and heartwood, and (iii) determination of the effect of management oil wood properties. The wood decayed by white rot fungi was detected by X-ray densitometry with it decreasing wood density due to the biodegradation of cell wall components. The sapwood and heartwood of eucalypts were separated in response to the attenuation of X-rays, reflected by the wood anatomical structure and chemical composition. Also, Ill eucalypt trees after the application of irrigation and i characteristic wood density profiles were detected. Ill addition, the significant potential of X-ray densitometry for eucalypt wood research and analysis is discussed.

Decay resistance of thermally-modified Eucalyptus grandis wood at 140 degrees C, 160 degrees C, 180 degrees C, 200 degrees C and 220 degrees C

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Análise química da madeira e casca de diferentes tipos de eucalipto antes e durante o cultivo de shiitake em toras

Avaliaram-se a composição química da madeira e da casca de sete espécies (E. saligna E. grandis, E. urophylla, E. camaldulensis, E. citriodora, E. paniculata e E. pellita) e três clones de eucalipto (híbridos de E. grandis x E. urophylla), antes e durante o cultivo das linhagens LE-95/01 e LE-96/18 de shiitake (Lentinula edodes), em toras. Cada linhagem de shiitake foi inoculada em nove toras de cada tipo de eucalipto com 1 m de comprimento e 9 a 14 cm de diâmetro. Assim, o delineamento experimental foi inteiramente casualizado, com 20 tratamentos e nove repetições, sendo cada repetição correspondente a uma tora. As toras foram mantidas em estufa climatizada, com temperatura de 25 ºC ± 5 e umidade relativa do ar entre 60-80%, durante 12 meses. Para a determinação da composição química da madeira, analisaram-se cunhas de discos e cascas de eucalipto recém-cortadas (sem inoculação das linhagens de L. edodes) e cunhas de discos e cascas retirados de toras já inoculadas com as linhagens de L. edodes após oito meses de incubação. Os resultados mostraram diferenças nos teores de holocelulose, lignina e extrativos totais na madeira e casca após o corte e depois de oito meses de incubação nas espécies e clones de eucalipto; o maior índice de decomposição da holocelulose na madeira, ao longo do tempo, ocorreu no E. saligna (5,5%), indicando, assim, ser o mais favorável para o desenvolvimento micelial do L. edodes. Já na casca aconteceu no clone 24 (22,2%). O E. camaldulensis apresentou o maior índice de decomposição da lignina na madeira (6,8%), ao longo do tempo. Já na casca, entre os eucaliptos testados, o E. grandis sofreu a maior decomposição de lignina (21,9%); o L. edodes degradou muito mais a holocelulose e lignina da casca que da madeira, tornando evidente a importância da casca; a casca da maioria dos tipos de eucaliptos apresentou menor teor de holocelulose, maior teor de extrativos totais e teores de lignina semelhantes ou superiores quando comparados com a madeira. O fator tipo de eucalipto (espécies e clones) teve maior efeito que o fator linhagem de L. edodes na degradação da holocelulose e lignina.

Seasonal variation in wood formation of Cedrela fissilis (Meliaceae)

Cambial activity and periodicity of secondary xylem formation in Cedrela fissilis, a semi-ring-porous species, were studied. Wood samples were collected periodically from 1996 to 2000. The phenology was related to climate data of the region. The cambium has one active and one dormant period per year. The active period coincides with the wet season when trees leaf-out. The dormant period coincides with the dry season when trees lose their leaves. Growth rings are marked by parenchyma bands that begin to be formed, together with the small latewood vessels, just before the cambium becomes dormant at the beginning of the dry season. These bands are added to when the cambium reactivates in the wet season. At this time, the large earlywood vessels of the growth rings are also formed. As these bands consist of both terminal and initial parenchyma, we suggest the general term marginal bands be used to describe them. The growth layers vary in width among and within the trees.

A comparison of the wood anatomy of 11 species from two cerrado habitats (cerrado s.s. and adjacent gallery forest)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

THE EFFECT of CARBONIZATION on WOOD STRUCTURE of DALBERGIA VIOLACEA, STRYPHNODENDRON POLYPHYLLUM, TAPIRIRA GUIANENSIS, VOCHYSIA TUCANORUM, and POUTERIA TORTA FROM THE BRAZILIAN CERRADO

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influence of belt speed, grit sizes and pressure on the sanding of Eucalyptus grandis wood

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

CHEMICAL MODIFICATION EFFECT on THE MECHANICAL PROPERTIES of HIPS/COCONUT FIBER COMPOSITES

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)