Effects of corn particle size and physical form of the diet on the gastrointestinal structures of broiler chickens

The objective of this experiment was to investigate the effects of different particle sizes, expressed as Geometric Mean Diameter (GMD) of corn (0.336mm, 0.585mm, 0.856mm and 1.12mm) of mash and pelleted broiler chicken diets on the weight of the gizzard, duodenum and jejunum+ileum; on the pH of the gizzard and small intestine and on the characteristics of the duodenal mucous layer (number and height of villi and crypt depth) in 42-day-old broilers. The physical form and the particle size of the diet had no significant effect on gizzard and intestine pH (p > 0.05). A greater gizzard weight was seen in the birds receiving pelleted diet and particle size of 0.336mm (p < 0.008). However, for the particle sizes of 0.856 and 1.12 mm, a greater weight was found in birds that received mash diet (p < 0.039 and p < 0.006, respectively). Also, gizzard weight was greater with increasing corn GMD independent of the physical form of the diet. In the mash diet, the increase in particle size promoted a quadratic response in the weight of duodenum and jejunum + ileum. The pelleted diet promoted a greater number of villi per transverse duodenum cut (p < 0.007) and greater crypt depth (p < 0.05). As the particle size increased, there was a linear increase of villus height and crypt depth in the duodenum, irrespective of the physical form of the diet.

Internal Architecture and Population Size of Acromyrmex subterraneus molestans (Hymenoptera, Formicidae) Nests: Comparison Between a Rural and an Urban Area

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Minimum size for the occurrence of vortex matter in a square mesoscopic superconductor

The study of superconducting samples in mesoscopic scale presented a remarkable improvement during the last years. Certainly, such interest is based on the fact that when the size of the samples is close to the order of the temperature dependent coherence length xi(T), and/or the size of the penetration depth lambda(T), there are some significant modifications on the physical properties of the superconducting state. This contribution tests the square cross-section size limit for the occurrence (or not) of vortices in mesoscopic samples of area L-2, where L varies discretely from 1 xi(0) to 8 xi(0).The time dependent Ginzburg-Landau (TDGL) equations approach is used upon taking the order parameter and the local magnetic field invariant along the z-direction. The vortex configurations at the equilibrium can be obtained from the TDGL equations for superconductivity as the system relaxes to the stationary state.The obtained results show that the limit of vortex penetration is for the square sample of size 3 xi(0) x 3 xi(0) in which only a single vortex are allowed into the sample. For smaller specimens, no vortex can be formed and the field entrance into the sample is continuous and the total flux penetration occurs at higher values of H/H-c2(0), where H-c2(T) is the upper critical field. Otherwise, for larger samples different vortices patterns can be observed depending on the sample size. (c) 2007 Elsevier B.V. All rights reserved.

Extended depth from focus reconstruction using NIH ImageJ plugins: Quality and resolution of elevation maps

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

MRT letter: Extended depth from focus reconstruction method for stretch zone measurement in 15-5PH steel

The stretch zone width (SZW) data for 15-5PH steel CTOD specimens fractured at -150 degrees C to + 23 degrees C temperature were measured based on focused images and 3D maps obtained by extended depth-of-field reconstruction from light microscopy (LM) image stacks. This LM-based method, with a larger lateral resolution, seems to be as effective for quantitative analysis of SZW as scanning electron microscopy (SEM) or confocal scanning laser microscopy (CSLM), permitting to clearly identify stretch zone boundaries. Despite the worst sharpness of focused images, a robust linear correlation was established to fracture toughness (KC) and SZW data for the 15-5PH steel tested specimens, measured at their center region. The method is an alternative to evaluate the boundaries of stretched zones, at a lower cost of implementation and training, since topographic data from elevation maps can be associated with reconstructed image, which summarizes the original contrast and brightness information. Finally, the extended depth-of-field method is presented here as a valuable tool for failure analysis, as a cheaper alternative to investigate rough surfaces or fracture, compared to scanning electron or confocal light microscopes. Microsc. Res. Tech. 75:11551158, 2012. (C) 2012 Wiley Periodicals, Inc.

Diel variations in decapod catch rate and size of captured individuals in a subtropical area of Brazil

Diel variations in decapod crustaceans catch rate, as well as variations in size of sampled individuals, were investigated in a sublittoral portion of Ubatuba Bay (23 degrees 20', 23 degrees 35'S and 44 degrees 50', 45 degrees 14'W) in order to detect differential patterns of occurrence. Three replicate trawls, each enclosing a 2,500 m(2) area, were performed at a median depth of 3.5 m during the waning moon period, in 3 consecutive summer and winter months. Trawls were conducted at dawn, noon, dusk and midnight. Hydrological and substratum features were monitored. Penaeoideans did not show a significant diel catch rate variation during the sampling periods, but the catch rate of brachyurans was highest at dusk and midnight during winter (p < 0.01). Fixing diel variation, catch rates of both brachyurans and penaeoideans are subjected to significant seasonal differences (p < 0.05). The largest specimens of Callinectes ornatus, Xiphopenaeus kroyeri, Rimapenaeus constrictus and Farfantepenaeus spp were found at twilight during summer. Differences on size of captured individuals mainly in samples of portunids and penaeids taken during the course of the day evidences that significant daily movements take place. This confirms that activity alterations depend on characteristics of daily schedules and on environmental demands of studied species.

Diel comparison of the catch and size of the shrimp artemesia longinaris (dendrobranchiata, penaeidae) in the ubatuba region, northern coast of the state of São Paulo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Size at maturity and egg capsules of the softnose skates Bathyraja brachyurops (Fowler, 1910) and Bathyraja macloviana (Norman, 1937) (Elasmobranchii: Rajidae) in the SW Atlantic (37 degrees 00'-39 degrees 30'S)

P>The softnose skates Bathyraja brachyurops and Bathyraja macloviana represent an important portion of the skate catches of the Uruguayan trawling fleet in the southwestern Atlantic. From March to October 2004, specimens of these species were collected at 75-200 m depth range in the area situated between latitudes 37 degrees 00'-39 degrees 30'S. For B. brachyurops, total length at which 50% of the specimens were retained by the gear was 68.0 cm for both sexes; T(L50) was estimated at 65.4 cm for males and 67.0 cm for females. For B. macloviana, total length at which 50% of the specimens were retained was 56.0-57.0 cm for both sexes; T(L50) was estimated at 53.5 cm for males and 52.0 cm for females. Egg capsule length varied from 79-91 mm in B. brachyurops and 69-75.5 mm in B. macloviana. In both species, capsules displayed striated surfaces and similar gross morphology, although egg capsules of B. macloviana had more robust anterior horns and a smaller size than those of B. brachyurops. Egg capsules of the latter also exhibited microscopical prickles. Capsule edges were laterally keeled with a groove along the keel, and a straight and transverse velum was present in the egg capsules of both species.

Group size and composition of Guiana dolphins (Sotalia guianensis) (Van Bénèden, 1864) in the Paranaguá Estuarine Complex, Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Size composition, monthly condition factor and morphometrics for fishery-dependent samples of Rioraja agassizi (Chondrichthyes: Rajidae), off Santos, Southeast Brazil

Espécimes de Rioraja agassizi foram mensalmente coletados em águas ao largo de Santos, sudeste do Brasil entre as latitudes 23º37'S e 27º40'S, desde março de 2005 até março de 2006. Um total de 278 machos e 1023 fêmeas foi capturado. A amplitude de profundidade de ocorrência foi 10-120 m, estando a espécie ausente em profundidades >120 m. A razão sexual favoreceu as fêmeas. A amplitude completa de comprimentos de R. agassizi esteve representada e oscilou nas fêmeas entre 16.0-59.4 cm comprimento e nos machos entre 13.0-47.2 cm. O tamanho médio das fêmeas foi significativamente maior do que dos machos. A distribuição de freqüência de comprimentos por amostras agrupadas foi assimétrica em ambos os sexos. As curvas da relação comprimento-largura foram sexualmente dimórficas. As fêmeas foram mais largas que os machos em todas as classes de comprimento maiores do que 25 cm. As curvas comprimento-peso total foram significativamente diferentes das curvas comprimento-peso eviscerado em ambos os sexos. As fêmeas foram mais pesadas do que os machos para uma determinada classe de comprimento. O coeficiente angular b foi <3 nos machos (alometría negativa) e nas fêmeas, mas com exceção da primavera, onde a alometría foi positiva (b>3). O fator de condição variou significativamente ao longo do ano em ambos os sexos.

Distribution of Cr, Ni, Cu, Cd and Pb in different molecular size of humic fractions extracted from water and sediment samples collected at Anhumas reservoir - Araraquara/SP

In this work was studied the distribution of Cr, Ni, Cu, Cd and Pb in humic fractions with different molecular size. The HS were extracted from waters (AHS), surface sediments (HESS), interface water sediment (HSIS) and bottom sediment (HSBS) collected in the Anhumas surface water collection reservoir, located in the district of Araraquara - São Paulo State Brazil. The humic substances were extracted by procedures recommended by International Humic Substances Society (IHSS). After purification by dialysis, the humic substances were fractionated using a multistage tangential flow ultrafiltration system. The fractionation patterns of HS characterized a mass distribution relatively uniform among the fractions with different molecular sizes, with larger values in the fractions F-2 (20.8%) and F-4 (23.8%), Except for the ions Pb(II) and Cu(II), which presented relatively higher concentrations in the fractions F-2 and F-4, respectively. In general, chromium, nickel, cadmium and lead have similar distributions in the five fractions with larger and medium molecular sizes (F-1 to F-5). With relation to the mass distributions in the different humic substances fractions extracted from sediment samples collected at three depth, they presented 42-48% of HS in the fractions with larger molecular sizes (F-1 and F-2), 29-31% in the middle fractions (F-3 and F-4) and 13-20% in the fractions with smaller molecular sizes (F-5 and F-6). In general, the metallic ions presented distributions similar among the respective fractions F-1 to F-6, Exceptions for Pb(II) and M(II) in surface sediment with concentrations relatively smaller in the fractions F-2 and F-4, respectively,

Multifractal characterization of saprolite particle-size distributions after topsoil removal

Multifractal analysis is now increasingly used to characterize soil properties as it may provide more information than a single fractal model. During the building of a large reservoir on the Parana River (Brazil), a highly weathered soil profile was excavated to a depth between 5 and 8 m. Excavation resulted in an abandoned area with saprolite materials and, in this area, an experimental field was established to assess the effectiveness of different soil rehabilitation treatments. The experimental design consisted of randomized blocks. The aim of this work was to characterize particle-size distributions of the saprolite material and use the information obtained to assess between-block variability. Particle-size distributions of the experimental plots were characterized by multifractal techniques. Ninety-six soil samples were analyzed routinely for particle-size distribution by laser diffractometry in a range of scales, varying from 0.390 to 2000 mu m. Six different textural classes (USDA) were identified with a clay content ranging from 16.9% to 58.4%. Multifractal models described reasonably well the scaling properties of particle-size distributions of the saprolite material. This material exhibits a high entropy dimension, D-1. Parameters derived from the left side (q > 0) of the f(alpha) spectra, D-1, the correlation dimension (D-2) and the range (alpha(0)-alpha(q+)), as well as the total width of the spectra (alpha(max) - alpha(min)) all showed dependence on the clay content. Sand, silt and clay contents were significantly different among treatments as a consequence of soil intrinsic variability. The D, and the Holder exponent of order zero, alpha(0), were not significantly different between treatments; in contrast, D-2 and several fractal attributes describing the width of the f(alpha) spectra were significantly different between treatments. The only parameter showing significant differences between sampling depths was (alpha(0) - alpha(q+)). Scale independent fractal attributes may be useful for characterizing intrinsic particle-size distribution variability. (c) 2006 Elsevier B.V. All rights reserved.

The influence of grain size coating and shaft angulation of different diamond tips on dental cutting

Objectives: To evaluate the influence of the grain size coating and shaft angulation of ultrasonic and high-speed diamond burs on the dental cutting effectiveness. Materials and Methods: For the grain size evaluation, cavities were prepared on 40 incisors using high-speed (1092 and 1093F KG Sorensen®) and ultrasonic tips (8.2142 and 6.2142-CVDentus®). For the shaft angulation evaluation, cavities were prepared on 40 incisors using uniangulated (T1-CVDentus®) and biangulated (T1-A CVDentus®) ultrasonic tips. The cavities were bisected and examined at 50 magnification. The width and depth of cavities were measured by Leica QWin software. Kruskal-Wallis non-parametric test was used for analysis. Results: The grain size did not affect the cutting effectiveness, but the high-speed burs promoted deeper and wider cavities than the ultrasonic tips. The shaft angulation did not affect the cutting effectiveness; both the angulated and biangulated tips had greater cutting efficiency in dentin than in enamel. Conclusions: Ultrasonic tips promoted more conservative preparations and seemed promising for cavity preparation.

Differential environmental impacts on small and medium size rivers from center of São Paulo State, Brazil, and regional management perspectives

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effects of crevice size on the establishment of macroalgae in subtropical streams

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)