131 resultados para pulsed flame photometric detector
em Repositório Institucional UNESP - Universidade Estadual Paulista "Julio de Mesquita Filho"
Resumo:
Organotin compounds, largely used as biocides in antifouling paints, are among the most toxic materials introduced into the aquatic environment. Sensitive analytical methods are thus required to characterize their occurrence in environmental and biological matrices. The comparison between two different photometric detectors in terms of analytical performance was carried out for the analysis of organotin compounds. A flame photometric detector (FPD) and a pulsed flame photometric detector (PFPD) were optimized. Their respective sensitivity, linearity range and selectivity were evaluated. Limits of detection obtained for a tributyltin compound (TBT) were 5.0 and 0.9 pg (as Sn) for the FPD and PFPD, respectively, using a 390 nm filter. The PFPD showed higher selectivity, besides reduced gas consumption in the flame, and is very attractive for organotin compound speciation in complex environmental matrices.
Resumo:
Occurrence and the effects of butyltin compounds (BTs) have been studied for some years, mainly in countries of the Northern Hemisphere. Due to widespread use of tributyltin compounds (TBTs) and considering their deleterious effects, it is necessary to conduct studies on its occurrence, especially in the marine environment because of its excessive use in coatings of ship hulls to prevent fouling. Moreover, it was important to extend the evaluation to areas where there is no current information about their occurrence. The present work reports the occurrence of BTs in marine sediments of São Paulo state, Brazil. Commercial and leisure harbor sampling sites were selected because these areas are potentially exposed to BTs from antifouling paints used on ship hulls. Analytical conditions for organotin analysis in marine sediments were optimized for GC with pulsed flame photometric detection. Detection limits ranged from 8.4 to 66.3 ng g(-1) using a 610-nm filter, and the linearity range was 20-500 ng g(-1). Concentration levels of BTs were highest in Santos harbor (360 ng g(-1) TBT in average) and Guaruja marina (670 ng g(-1) TBT in average), which seems to be related to intensive boat traffic. Lower levels of BTs were observed in Cananeia, where only fishing boats are present (50 ng g(-1) TBT in average). (C) 2002 Elsevier B.V. B.V. All rights reserved.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Tributyltin exposure is the primary cause of imposex development in gastropods, making them excellent bioindicators. The present research represents the first examination of butyltin (BT) contamination in surface sediments associated with imposex in Leucozonia nassa and L. ocellata in a harbour complex area in Espirito Santo, southeastern Brazil. The objectives of this study were to evaluate the organotin pollution in the area and to assess the sensitivity of both species to BT pollution through imposex development. Specimens were collected between 2007 and 2010 and the sediments were sampled in 2007. Imposex intensity was evaluated based on the percentage of imposexed females, the relative penis length index (RPLI) and the average value of the vas deferens sequence index (VDSI). BTs were analysed using gas chromatography equipped with a pulsed flame photometric detector (PFPD). The results demonstrated the occurrence of elevated concentrations of BTs in the sediment ranging from 383.7 to 7172.9 ng Sn g(-1), indicating a severe contamination of the area, which was confirmed by the biological monitoring results. Our findings also indicated that L. ocellata is a less sensitive species than L. nassa and that this differential sensitivity plays a key role in the distributions of the populations of both species in the studied area.
Resumo:
O aumento da produção hortícola em cultivo protegido necessita de estudos mais detalhados acerca da ocorrência de resíduos de agrotóxicos, devido às condições ambientais peculiares nesse sistema, no qual pragas de pouca importância no campo assumem relevância. Avaliou-se os resíduos dos inseticidas acefato e de seu metabólito metamidofós em tomate sob cultivo protegido e em campo. Os tratamentos aplicados foram: (a) testemunha; (b) uma aplicação de 75 g i.a. acefato.100 L-1 de água; (c) uma aplicação com 150 g i.a.100 L-1 de água; (d) quatro aplicações na dosagem de 75 g i.a.100 L-1 de água. As amostras foram tomadas a (-1), zero, 1, 3, 7, 14 e 21 dias após a última ou única aplicação. A determinação quantitativa foi feita por técnica de cromatografia em fase gasosa, usando-se detector fotométrico de chama. Os resíduos de acefato e de metamidofós nos frutos de cultivo protegido e de campo, sempre estiveram abaixo dos respectivos limites máximos de resíduos (LMRs) em todo o período de colheita das amostras. Ainda, o metabolismo de acefato a metamidofós foi muito baixo nos frutos, particularmente importante nas folhas, mas não foi bem caracterizado no solo. Os resíduos de acefato foram maiores no cultivo protegido do que no campo, especialmente em folhas e no solo, sendo também estáveis e persistentes, em geral até a amostragem de 7 dias após a aplicação.
Resumo:
Estudou-se o comportamento dos resíduos de fenitrotion em frutos e folhas de tomateiro estaqueado, através de cromatografia gasosa. O experimento de campo foi instalado quando as plantas tinham 90 dias após o transplante das mudas, e constou de quatro tratamentos: (1) uma aplicação de fenitrotion em dosagem simples, de 100 g i.a./100 litros de água, (2) uma aplicação em dosagem dobrada, de 200 g i.a./100 litros de água, (3) quatro aplicações espaçadas de sete dias, na dosagem simples e (4) testemunha. As amostras de fruto e folha foram colhidas um dia antes da aplicação (-1) e aos zero , 1, 2, 3, 5, 7 e 14 dias após. Basicamente, a metododogia para análises dos resíduos dos frutos e das folhas constou da extração com acetona e partição em clorofórmio; limpeza dos extratos em coluna de florisil (no caso de folhas) e eluição procedida com benzeno. As determinações quantitativas foram feitas por cromatografia gasosa, usando-se detector fotométrico de chama com filtro específico para fósforo. Os resíduos nas folhas foram sempre maiores do que os dos frutos (cerca de 80 vezes, em média) durante todo o período de colheita das amostras. Os valores de meia-vida de degradação de fenitrotion em frutos e folhas foram: 1,6 a 1,9 e 0,7 a 0,8 dia, respectivamente, mostrando uma diminuição mais rápida dos resíduos em folhas. As meias-vidas de persistência foram semelhantes para os dois substratos: 4,2 a 7,3 e 5,6 a 6,2 dias, respectivamente. Os resíduos encontrados nos frutos logo após a aplicação, foram menores que a tolerância oficial (0,5 ppm) para os tratamentos que utilizaram 100 g i.a./100 litros em uma ou quatro pulverizações espaçadas de sete dias. Uma única aplicação de 200 g i.a./100 litros resultou em resíduos menores que 0,5 ppm, desde um dia após a aplicação.
Resumo:
Butyltin (BTs) quantification in environmental matrices can be affected by interfering species found primarily in complex matrices,such as sediment and biota tissues. This study investigated matrix effects in analytical procedures for butyltin (TBT,DBT and MBT) quantification and speciation in sediments and in two fish tissues (gill and liver) by gas chromatography with pulsed flame photometric detection (GC-PFPD) analysis. Unlike sediment samples,tissues exhibited a significant matrix effect,thus,the quantification should be made by curve over matrix to avoid quantification errors and loss of analytical accuracy. © 2013 Sociedade Brasileira de Química.
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Clove basil (Ocimum gratissimum) extracts were obtained with supercritical CO2. Clove basil was cultivated using 0, 4, 8 and 12 kg/m(2) of organic fertilizer and was harvested in four seasons: winter, spring, summer and autumn, in the Southern Hemisphere. The extracts' global yields were determined at 40C and 150 bar for samples from all cultivation conditions and harvesting seasons. For selected samples, the extracts' global yields at 40C were determined for pressures of 100, 150, 200, 250 and 300 bar. The extracts were analyzed by gas chromatography-flame ionization detector. Antioxidant activity (AA) was assessed using the coupled reaction of beta-caroteneand linolenic acid. The extracts' global yields varied from 0.91 to 1.79% (dry basis), and the AAs varied from 62 to 84% compared with the control beta-carotene. Eugenol and beta-selinene were the major compounds. The relative proportion of eugenol varied from 35 to 60%, while the content of beta-selinene remained approximately constant (11.5-14.1%, area). The other substances quantified in the extracts were 1,8 cineole, trans-caryophyllene and alpha-selinene.
Resumo:
The objective of the present research was to study the degradation and the persistence of phenthoate (Elsan 50 CE) residues in tomato fruits. The experiment was set in a tomato field located in Mombuca, State of São Paulo, Brazil, after 45 days from seedlings transplantation. Dosages of 600 (A), 800 (B), 1200 (C) and 1600 g a.i./ha (D) were sprayed at the beginning of the ripening period of fruits. Samples of 15 fruits each were collected 1, 4, 10, 20 and 40 days after products spraying. The utilized procedure consisted of extraction with acetone and purification by partition with dichloromethane. The purified extract was concentrated and injected into a gas chromatograph equipped with alkaly flame ionization detector (AFID). The limits of detection were of 0,01 ppm for this product. The recovery percentage from fortified samples varied from 60 to 81%. The degradation and the persistence half-lives were 1 to 2 and 3 to 6 days for phenthoate, respectively.
Resumo:
Bambusa textilis is widely used in popular medicine to treat all kinds of wound inflammation, chronic fever, pulmonary and infectious diseases. The aim of this study was to compare the chemical composition of the extracts of B. textilis leaves obtained by three different extraction methods: solid/liquid extraction, Soxhlet and Clevenger system using gas chromatography with flame ionization detector (GC-FID) and gas chromatography with mass spectrometry (GC-MS) analyses. The analytical characteristics of the extracts showed some differences and the GC-MS analysis indicated the presence of higher concentrations of nitro compounds and alkalis. © VSP 2005.
Resumo:
Pós-graduação em Agronomia (Horticultura) - FCA