Crystal structures and luminescence properties of La3Zr4F25 and alpha-LaZr3F15

During a study of the LaF3-ZrF4 system, both La3Zr4F25 and alpha-LaZr3F15 compounds have been evidenced. Their crystal structures have been determined from single-crystal X-ray diffraction data. La3Zr4F25 crystallises in the cubic system with a= 12.384 Angstrom and I (4) over bar 3d space group (no. 220). Its crystal structure is built up of (ZrF6)(2-) octahedra and (LaF8)(5-) dodecahedra sharing corners. The low temperature form, alpha, of LaZr3F15 is orthorhombic (space group Pmmn, no. 59) with a = 15.721 Angstrom, b = 16.299 Angstrom, c= 8.438 Angstrom. Its structure is built of corner-sharing tricaped trigonal prisms surrounding the La3+ ions and both octahedra and monocapped trigonal prisms encompassing the Zr4+ ions. This structure is characterised by dynamically disordered (ZrF6)(2-) complex anions.The Eu3+ luminescence properties of these phases have been investigated and are discussed in relationship with their crystal structures.

Caries resistance of lased human enamel with Er : YAG laser - morphological and ratio Ca/P analysis

Objective: In vitro analysis of caries resistance of dental enamel under caries simulation after irradiation with Er:YAG laser. Background Data: More susceptible to caries development spots at adjacent hard tissues from cavity preparations of dental tissues using burrs or lasers are quite common. Methods: Thirteen caries-free third permanent human molars were distributed as follows: G1: sound control and caries control; G2: Er:YAG 100, 200, 300, or 400 mJ/ 10 Hz/ 3 sec.; G3: the same parameters of G2 followed by artificial caries simulation, through dynamic model of demineralization and remineralization (DE/RE). Caries resistance analysis was evaluated through scanning electron microscopy (SEM) and Ca/P rate (X-Rays spectroscopy - EDX). Results: Photomicrographs showed that the Er:YAG laser created craters with rough aspect which became more evident as the energy per pulse was increased, but without change of regular morphology of enamel prisms. Significant statistical changes among the irradiated and control groups was observed considering the Ca/P ratio. Conclusion: Irradiated groups showed higher caries resistance than control groups. However, it is not possible to affirm that the enamel surface accidental irradiation could be a benefit to caries resistance for other situations can be considered, as biofilm deposit, which could increase the caries susceptibility.

Rovearinids (stemless crinoids) in the Albian carbonates of the offshore Santos Basin, southeastern Brazil: stratigraphic, palaeobiogeographic and palaeoceanographic significance

Microfacies analysis of marine carbonates cored by Petrobras well 1-SPS-6 in the offshore Santos Basin (southeastern Brazil) has revealed a remarkable fossil assemblage of calpionellids (colomiellids), favusellids, hedbergellids, globigerinelloidids, buliminids, radiolarians, inoceramid prisms, roveacrinids, and saccocomids(?) preserved in lower Albian calcimudstones-wackestones of the lower part of the Guaruja Formation. This assemblage represents an allochtonous accumulation in a deep neritic to shallow bathyal hypoxic environment. Besides 'saccocomid-like' sections, the only determinable sections of roveacrinids are thecal plates of Poecilocrinus dispandus elongatus Peck, 1943. This species was previously only known from the Weno Formation of Texas. The Brazilian material extends its records farther south from at least the lower Albian, which then represents the earliest occurrence of this peculiar family in the South Atlantic region. Taking into account their Albian global distribution and the location of their oldest representative (Hauterivian near Alicante, Spain), the Roveacrinidae dispersed westward throughout all of Cretaceous Tethys. The Tethyan origin of Roveacrinidae is further evidence that, during late Aptian-Albian times, the northern South Atlantic (north of the Walvis-SBo Paulo Ridge) was supplied by a Tethyan water mass. (C) 2001 Elsevier B.V. Ltd. All rights reserved.

Enamel caries resistance accidentally irradiated by the Nd : YAG laser

When the carious tissue is eliminated either by conventional methods (with burs) or with lasers, the risk of accidentally damage the surface of adjacent teeth may occur, which hypothetically could lead to a more susceptible surface for canes formation. This in vitro study aims to evaluate the caries resistance of the dental enamel surface irradiated by the Nd:YAG laser applied in conditions simulating accidental exposition. Thirteen third molars were used in this study. The experimental groups were: G1: sound control and control + carious; G2: contact Nd:YAG laser at 0.75, 1, 2, or 3 W; 10 Hz; 3 sec (27, 35, 71, and 106 J/cm(2)); G3: same parameters from G2 + caries artificial induction through the demineralization and demineralization (DES/RE) dynamic model. The caries resistance analysis was evaluated by the superficial morphological aspect through SEM images and also by Ca/P proportion through energy dispersive X-ray spectroscopy (EDX). The micrograph images showed that the Nd:YAG laser changed the normalmorphology of the enamel prisms resulting in a melted and re-solidified surface intensified with the power increase. Significant statistical differences were observed applying the Kruskal-Wallis statistical test (p <= 0.01) among the Nd:YAG laser irradiated groups and the control with caries regarding the Ca/P proportion. As an exception, this was not observed when 3 W; 10 Hz; 3 sec; 106 J/cm(2) was applied and posteriously submitted to a cariogenic challenge. The results indicate that the Nd:YAG laser accidental irradiation at low power settings did not represent risks to the enamel caries resistance.

Crystal structures and luminescence properties of La3Zr4F25 and α-LaZr3F15

During a study of the LaF3-ZrF4 system, both La3Zr4F25 and α-LaZr3F15 compounds have been evidenced. Their crystal structures have been determined from single-crystal X-ray diffraction data. La3Zr4F25 crystallises in the cubic system with a = 12.384 Å and 143d space group (no. 220). Its crystal structure is built up of (ZrF6)2- octahedra and (LaF8)5- dodecahedra sharing corners. The low temperature form, α, of LaZr3F15 is orthorhombic (space group Pmmn, no. 59) with a = 15.721 Å, b = 16.299 Å, c = 8.438 Å. Its structure is built of corner-sharing tricaped trigonal prisms surrounding the La3+ ions and both octahedra and monocapped trigonal prisms encompassing the Zr4+ ions. This structure is characterised by dynamically disordered (ZrF6)2- complex anions. The Eu3+ luminescence properties of these phases have been investigated and are discussed in relationship with their crystal structures.

Brazilian results on structural masonry concrete blocks

The purpose of this paper is to study the mechanical behavior of concrete blocks and prisms when performing axial compression tests within the Brazilian base of knowledge, intending to foment data of this kind for a world-based network. The blocks were built using five different mixtures in which the quantity of cement and the compacting ratio (density) were varied (during the fabrication process). The three-course-high prisms were assembled using 1 cm (0.39 in.) thick full-bedded joints, always trying to leave the mortar's characteristics constant. The axial compression tests were conducted according to Brazilian practice code recommendations, because most of these standards are very similar to international practice codes. The compressive strength, strains, and rupture form of each mixture studied were recorded. Attempts were made to correlate the strength, efficiency ratio (block strength/prism strength) of the prisms, strains, and rupture form; with the quantity of cement and compacting ratio. The data are presented in tables and figures, and the obtained results are discussed throughout the text. Copyright © 2007, American Concrete Institute. All rights reserved.

Estudo teórico e experimental das ligações diretas contra-fiadas entre paredes de blocos de concreto em escala real e reduzida 1:4

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo experimental de ligações entre paredes de alvenaria estrutural de blocos cerâmicos sujeitas a ações verticais

Pós-graduação em Engenharia Civil - FEIS

Análise do comportamento experimental e numérico de prismas de alvenaria estrutural utilizando o elemento finito prismático regular parabólico

Pós-graduação em Engenharia Civil - FEIS

Estudo da reação álcali-agregado na tomada d'água da UHE Jaguari por meio de ensaios laboratoriais

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise da adição de resíduos de concreto em tijolos prensados de solo-cimento

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo das ligações entre pilares de concreto e alvenaria cerâmica de vedação

Pós-graduação em Engenharia Civil - FEIS

Influência do graute e da taxa de armadura no comportamento da alvenaria de blocos de concreto

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Análise numérica do comportamento não-linear de prismas de alvenaria estrutural submetidos a ações verticais utilizando o elemento finito prismático regular linear

Pós-graduação em Engenharia Civil - FEIS

Desenvolvimento das técnicas de produção de blocos de concreto para alvenaria estrutural na escala (1:4)

Pós-graduação em Engenharia Civil - FEIS