17 resultados para maximum ratio combining
em Repositório Institucional UNESP - Universidade Estadual Paulista "Julio de Mesquita Filho"
Resumo:
Exact and closed-form expressions for the level crossing rate and average fade duration are presented for equal gain combining and maximal ratio combining schemes, assuming an arbitrary number of independent branches in a Rayleigh environment. The analytical results are thoroughly validated by simulation.
Resumo:
Exact and closed-form expressions for the level crossing rate and average fade duration are presented for the M branch pure selection combining (PSC), equal gain combining (EGC), and maximal ratio combining (MRC) techniques, assuming independent branches in a Nakagami environment. The analytical results are thoroughly validated by reducing the general case to some special cases, for which the solutions are known, and by means of simulation for the more general case. The model developed here is general and can be easily applied to other fading statistics (e.g., Rice).
Resumo:
The use of rainwater for non-potable purposes generates a reduction in the consumption of treated water, however, this reduction is not observed in the generation of wastewater, as this is independent of the water source. In Brazil, the pricing on the services of collection and treatment of sewage, in general, is based on the coefficient of return of the sewage disposal system, which has a relation sewer / water proportional to the consumption of treated water measured at the consumer unit. The use of rainwater originating from utilization systems infer on the coefficient, underestimating the volume of wastewater generated. Therefore, this study presents a methodology for setting the coefficient of return. Different roof areas, reservoir volumes and rates of water consumption situations were simulated. The behavior of adjustment of the coefficient of return were also analyzed for the average area per capita roof (m² / inhabitant) of Rio Claro - SP. As a result, it can be seen that the adjustment of the coefficient of return is directly proportional to the increase of the roof areas and the volumes of reservoirs, and inversely proportional to the total water demand. The corrected coefficient of return showed the minimum value of 0.83 and a maximum value of 1.45, this variation corresponds to the maximum ratio between the demands of total water and rainwater, since the exploitation of rain water should be used only for non-potable uses, according to NBR 15527 / 07. To the municipality of Rio Claro - SP was noted an adjustment of the coefficient of return ranging from 0.99 to 6.61
Resumo:
Pós-graduação em Engenharia Mecânica - FEG
Resumo:
Aim. The purpose of this study was to provide normal values for maximum phonation time (MPT) and the s/z ratio by examining 1660 children aged 4-12 years and without vocal signs or symptoms.Methods. The technique was based on the sustained emission of the /a/ vowel and fricatives /s/ and /z/.Results. The average of the MPT in children of the different age groups was as follows: 6.09 seconds for the age group 4-6 years (males, 5.97; female, 6.21 seconds), 7.94 seconds for the age group 7-9 years (males, 8.07; females, 7.79 seconds), and 8.98 for the age group 10-12 years (males, 9.05; females, 8.92 seconds). The overall average for males was 7.78 and females 7.64 seconds. The s/z ratio was near 1.0 in most children but above 1.2 in 133 children and below 0.8 in 133 children.Conclusion. These values of MPT and s/z ratio can be used as normative in further pediatric studies.
Resumo:
Foram avaliados os efeitos da aplicação de fósforo (P) em solo argiloso, de textura média e arenoso, sobre a produção de matéria seca de Panicum maximum Jacq. cv. Tanzânia. O ensaio foi conduzido em casa de vegetação, em vasos de plástico contendo 10 dm³ de solo, em esquema fatorial e delineamento inteiramente ao acaso. Após calagem para V = 70% e aplicação de 0, 35, 70, 105 e 140 mg/dm³ de P, o solo foi umedecido, e depois de 30 dias, secado e amostrado. O ensaio foi conduzido por 76 dias, a partir da emergência das plântulas, com o primeiro corte aos 48 dias, a 10 cm do solo, e o segundo, aos 76,rente ao solo. Com a aplicação de P houve aumento de produção de matéria seca, e o maior acréscimo ocorreu com a aplicação de 35 mg/dm³. A maior produção foi obtida no solo de textura média. O teor de P nas plantas estava adequado nos solos arenoso e argiloso. No de textura média, ele diminuiu com o aumento da produção,caracterizando efeito de diluição. Com aprodução relativa e o teor de P de cada solo, foi determinado o nível crítico de 38 mg/dm³ de P extraído por resina.
Resumo:
Buscando-se avaliar morfofisiologicamente a rebrota do capim-mombaça, quatro desfolhas foram impostas ao perfilho principal, sendo estudado o comportamento da planta em termos da taxa de expansão da área foliar, crescimento do sistema radicular, nível de carboidratos totais não estruturais (CTNE) da raiz e do colmo, taxa de crescimento relativo (TCR), taxa de assimilação líquida (TAL) e razão de área foliar (RAF) às idades de 2, 5, 9 e 16 dias após as desfolhas, bem como da taxa fotossintética máxima às idades de 2, 6 e 13 dias das folhas remanescentes à desfolha. As desfolhas foram as seguintes: remoção de todas as lâminas foliares (desfolha total), a remoção da lâmina da folha adulta mais jovem (desfolha superior), a remoção das lâminas das duas folhas adultas mais velhas (desfolha inferior) e controle (sem desfolha), juntamente com o corte dos demais perfilhos, realizado a 8 cm do solo. Foram observadas cinco repetições por tratamento, segundo o delineamento inteiramente casualizado. As folhas adultas não diferiram quanto às taxas fotossintéticas máximas, que exibiram aumento nos primeiros dias após a desfolha, e queda aos 13 dias. A desfolha reduziu os teores de CTNE da base do colmo, principalmente nas plantas sob desfolha total. Comprometimento do crescimento do sistema radicular e do teor de CTNE das raízes foi observado nas plantas sob desfolha total, que também tiveram sua TCR reduzida nos primeiros dias de rebrotação. Entretanto, o aumento na RAF possibilitou a estas plantas recuperação da TCR e alta taxa de expansão da área foliar, igualando a área foliar das demais plantas aos 16 dias de rebrota.
Resumo:
This paper deals with the development and optimization of an analytical procedure using ultrafiltration and a flow-injection system, and its application in in-situ experiments to characterize the lability and availability of metal species in humic-rich hydrocolloids. The on-line system consists of a tangential flow ultrafiltration device equipped with a 3-kDa filtration membrane. The concentration of free ions in the filtrate was determined by atomic-absorption spectrometry, assuming that metals not complexed by aquatic humic substances (AHS) were separated from the complexed species (M-AHS) retained by the membrane. For optimization, exchange experiments using Cu(II) solutions and AHS solutions doped with the metal ions Ni(II), Mn(II), Fe(III), Cd (II), and Zn(II) were carried out to characterize the stability of the metal-AHS complexes. The new procedure was then applied in-situ at a tributary of the Ribeira do Iguape river (Iguape, São Paulo State, Brazil) and evaluated using the ions Fe(III) and Mn(II), which are considered to be essential constituents of aquatic systems. From the exchange between metal-natural organic matter (M-NOM) and the Cu(II) ions it was concluded that Cu(II) concentrations > 485 mu g L(-1) were necessary to obtain maximum exchange of the complexes Mn-NOM and Fe-NOM, corresponding to 100% Mn and 8% Fe. Moreover, the new analytical procedure is simple and opens up new perspectives for understanding the complexation, transport, stability, and lability of metal species in humic-rich aquatic environments.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
This study analyzed a population of the spider crab Epialtus brasiliensis, in regard to its size distribution, sex ratio and Sexual maturity. The study was conducted on a rocky shore in the Ubatuba region, state of Silo Paulo, Brazil, where a wide strip of algae covers the intertidal zone. A total of 378 specimens were obtained: 200 males (128 juvenile and 72 adult crabs) and 178 females (46 juveniles and 132 adults). Their Sizes ranged from 3.4 to 16.7 mm carapace length (CL). Taking into account that the pubertal and terminal molts are coincident in majid crabs, the maximum sizes attained by males and females are especially dependent on the factors that influence sexual maturity, mainly food resources, temperature and intraspecific competition. Males of E. brasiliensis occurred in all size classes, whereas females occurred only as far the 10th size class (12-13 min CL). file total sex ratio did not differ statistically from 1 : 1, but when the juvenile and adult specimens were analyzed separately the differences between sexes were significantly different, with higher proportions of immature males and mature females. The CL50 calculated for males and females was 10.4, and 6.9 min CL, respectively. Thus, males reach their sexual maturity at a larger size than females. This feature may be important for the reproductive strategy of this species, because larger males probably have greater reproductive Success.
Resumo:
The relationship between the dielectric properties (dielectric constant, ε′, and loss factor, ε; activation energy, E a) and the ratio of epoxy resin (OG) to hardener of the epoxy resin thermosetting polymers was investigated. The amplitude of the ε″ peak decreases with increasing OG content until about 73 wt.% and slightly increases at higher OG content. The temperature of the position of the ε″ peak increases with the increasing of OG content, reaching maximum values for compositions in the range of 67 and 73 wt.%, and then it decreases sharply at higher OG content. The activation energy obtained from dielectric relaxation increased with increasing wt.% OG up to around 70 wt.%. Further increase in concentration of OG up to 83 wt.% reduced E a. The curves of tensile modulus and fracture toughness mechanical properties as a function of OG content presented a similar behavior. ©2006 Sociedade Brasileira de Química.
Resumo:
Data from a multibreed commercial flock located at Mid-West of Brazil, supported by Programa de Melhoramento Genético de Caprinos e Ovinos de Corte (GENECOC), were used to estimate genetic parameters of traits related to ewe productivity by Average Information Restricted Maximum Likelihood method applied to an animal model. The analyzed traits were litter weight at birth (LWB) and at weaning (LWW), ewe weight at weaning (EW) and ewe production efficiency, estimated by WEE=LWW/EW 0.75. The heritabilities were 0.26±0.05, 0.32±0.06, 0.37±0.03 and 0.10±0.02 for LWB, LWW, EW and WEE, respectively. Significant effects for direct heterosis were observed for LWW and EW. Recombination losses were important for EW and WEE. Genetic correlations of LWB with LWW, EW and WEE were 0.68, 0.37 and 0.15, respectively; of LWW with EW and WEE were 0.30 and 0.34, respectively; and between EW and WEE was -0.25. Even though it is a low heritability trait, WEE can be indicated as a selection criteria for improving the ewe productivity without increasing the mature weight of animals due to its genetic correlations with LWW and other traits. © 2011 Elsevier B.V.
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)