17 resultados para grease

em Repositório Institucional UNESP - Universidade Estadual Paulista "Julio de Mesquita Filho"


Relevância:

20.00% 20.00%

Publicador:

Resumo:

This investigation was carried out within the Parana sedimentary basin, Brazil, involved the sampling of effluents and groundwater from monitoring stations situated at different sites at São Paulo State, and was realized with the purpose of evaluating the presence of fats, oil and grease (FOG) in different matrices. Several tests were realized with very distinct materials (cooking oil, butter, margarine, pig fat, vacuum pump oil) in order to properly calibrate the spectrophotometric system. Each matrix was dissolved with 1,1,1-trichloroethane and from the stock solutions it was prepared working standards from different dilutions. The data obtained were plotted on absorbance vs. concentration graph that yielded a successful calibration curve when a mineral oil for vacuum pump was utilized in the experiments at a wavelength corresponding to 410 mn. The results obtained for the analyzed samples were compared with the limiting value established by the São Paulo State legislation on the prevention and pollution control of the environment that was established in 8(th) September 1976 by Rule No. 8468.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Realizaram-se testes físico-mecânicos e físico-químicos em couro de tilápia vermelha (Oreochromis spp.) a fim de testar a sua resistência. As amostras foram distribuídas em delineamento inteiramente ao acaso com dois tratamentos: no T1, procedeu-se à retirada do corpo-de-prova no sentido longitudinal e, no T2, à retirada do corpo-de-prova no sentido transversal. Para os testes de determinação da resistência à tração, alongamento e rasgamento progressivo, foi utilizado o dinamômetro EMIC, com velocidade de afastamento entre as cargas de 100 ± 20mm/min, em ambiente climatizado (± 23ºC e UR do ar de 50%), por 24 horas. A espessura do couro variou de 0,61 a 0,75mm, mas não houve diferença entre os sentidos analisados. O couro apresentou maior resistência à tração no sentido transversal, 25,89N/mm², (P<0,01), comparado ao sentido longitudinal, 14,20 N/mm². O alongamento foi significativamente (P<0,05) maior no sentido longitudinal, 80,8%, em relação ao transversal, 62,6%. Não houve diferença para o rasgamento progressivo entre os tratamentos. O couro apresentou teor de óxido de cromo de 3,8%, graxa de 15,1% e pH e cifra diferencial de 3,5 e 0,5, respectivamente. Os valores nos testes de resistência e físico-químicos apresentados pelo couro indicam que ele pode ser utilizado para a confecção de vestuário e artefatos de couro em geral.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Composting has been a viable and efficient alternative treatment to agroindustrial waste. This experiment was installed with the objective of analyzing the process of composting for slaughterhouse waste. Twelve piles of composting were prepared, using slaughterhouse waste, wheat straw and wood sawdust. The process was evaluated by daily temperature monitoring, observations of the occurrence of undesirable parameters (bad smell and/or ammoniacal smell, grease formation and presence of grubs and flies), as well as the capacity of recycling nutrients. The undesirable parameters were observed, on average, for the first five days after pile building; the temperatures increased, reaching 70 °C; chemical composition of compost showed relevant contents of macro and micronutrients, a high recycling potential. Utilization of impermeable floor and roof are recommended during the composting. The turning frequency used (15 days after pile building followed by turning) was adequate. The best relation of weight was 7.2 kg of waste for each kg of straw and 16.6 kg of waste for each kg of sawdust.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The use of piezocone tests with a slot filter filled with automotive grease for site characterization of tropical soils is assessed. Laboratory tests using the slot filter filled with automotive grease as well as the conventional porous piezo-element saturated with glycerin were carried out to evaluate the pore pressure (u 2) transducer response. CPTu tests using piezo-elements saturated with glycerin and the slot filter filled with grease were pushed side by side in different research sites in Brazil. Estimates of mechanical and hydraulic soil parameters were made based on pore pressure dissipation curves from using both techniques. Laboratory test results indicate that the pore pressure response using the slot filter with grease was delayed when compared to the piezo-element saturated with glycerin, since grease has a higher viscosity. For tropical soils, the records of u2 in piezocone tests using slot filter with grease presented larger peaks than with porous element saturated with glycerin. Records of u2 using the slot filter above the groundwater table suggest the increase of the degree of saturation in unsaturated zone, where porous filter can be desaturated by suction. The slot filter can be used to help the interpretation of the soil profile with deep groundwater level as well as to help detecting its position for some studied soils. The results shown high repeatability for all study sites. This technique is much easier to handle, especially for tropical soils, where the groundwater table is usually deep and pre-drilling is expensive and time consuming. © 2009 IOS Press.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Ciência Animal - FMVA

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The oil and biodiesel are oily substances which, if spilled or thrown out in the environment, can cause serious damages. In this context, bioremediation techniques can be used to the recovering of sites degradated by mineral or vegetable oil, besides them, the biodegradation. However, it is necessary that there are microorganism strains used to degradate the contaminant, previously selected for the fast, efficient and minimum impact remediation. The main objective of this study was to isolate microorganism strains coming from different ecological recesses and verify their potentiality on biodegradating oil and biodiesel. Strains of bacteria, fungi and yeasts were isolated from soils contaminated by hydrocarbons (diesel, gasoline, grease) before, by doing striations on culture plates. On the biodegradation tests, it was used the redox indicator, 2,6-dichlorophenol indophenol (DCPIP), then, after the indicador’s discoloration, the absorbance of the suspension obtained was measured. 46 different microorganism strains were isolated, and the oil, when it was used as a carbon resource, it was degradate easier than the biodiesel. The experiments showed that, in a period, the site impacted by oil spills recovers itself by the biodegradation, in aerobic conditions, by the redox activity.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

This study evaluated environmental impacts at Meio Creek watershed, Leme, Sao Paulo, Brazil. A simplified environmental analysis index was applied correlating land use and occupation (vegetation elimination or modification, wildlife, color, smell, grease, oils, foams, larvae and red worms) with water quality parameters (conductivity, dissolved oxygen, pH and temperature). The simplified environmental analysis index showed that 27.8% visited places had a high or worrying environmental impact and 5.6% had a really high impact. As to the results of physical and chemical parameters, pH and conductivity values showed the conditions and standards that water Class 2 and 3 should have. These parameters were not the same for dissolved oxygen levels at most of the analyzed points. Despite the current environmental legislation at federal, state and municipal levels, Leme city does not have an effective environmental plan to control and protect springs and Meio Creek watershed and its tributaries.