Volatile compounds from organic and conventional passion fruit (Passiflora edulis F. Flavicarpa) pulp

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

On the optimum parameters of a device for harvesting energy from running and walking

This paper investigates the feasibility of using an energy harvesting device tuned such that its natural frequency coincides with higher harmonics of the input to capture energy from walking or running human motion more efficiently. The paper starts by reviewing the concept of a linear resonant generator for a tonal frequency input and then derives an expression for the power harvested for an input with several harmonics. The amount of power harvested is estimated numerically using measured data from human subjects. Assuming that the input is periodic, the signal is reconstructed using a Fourier series before being used in the simulation. It is found that although the power output depends on the input frequency, the choice of tuning the natural frequency of the device to coincide with a particular higher harmonic is restricted by the amount of damping that is needed to maximize the amount of power harvested, as well as to comply with the size limit of the device. It is also found that it is not feasible to tune the device to match the first few harmonics when the size of the device is small, because a large amount of damping is required to limit the motion of the mass.

An alternative methodology for the extraction of humic substances from organic soils

The present study reports on an alternative methodology for the extraction of Humic Substances (HS) from the soil. The extractions were carried out with 0.5 M KOH for 3 h, at a ratio of 1:20 (m/v) under a nitrogen atmosphere. The HS were separated by centrifugation based on their solubility in alcaline solution. This methodology was compared with the usual procedure in three different soil samples and in one sample from vermicompost. The yield, E4/E6 ratio, ash content, and the elemental composition (C, H, O, N) of the extracted HS have been determined. The functional groups were identified by Fourier-transform infrared spectroscopy. This novel procedure adds a new perspective to the extraction of humic substances due to the short time and high performance of the extraction in relation to the usual procedure.

Putative pyrophosphate phosphofructose 1-kinase genes identified in sugarcane may be getting energy from pyrophosphate

Pyrophosphate-dependent phosphofructokinase (PPi-PFK) has been detected in several types of plant cells, but the gene has not been reported in sugar cane. Using Citrux paradixi PPi-PFK gene (AF095520 and AF095521) sequences to search the sugar cane EST database, we have identified both the α and β subunits of this enzyme. The deduced amino acid sequences showed 76 and 80% similarity with the corresponding α and β subunits of C. paradisi. A high degree of similarity was also observed among the PFK β subunits when the alignment of the sugar cane sequences was compared to those of Ricinus communis and Solanum tuberosum, it appears that α and β are two distinct subunits; they were found at different concentrations in several sugar cane tissues. It remains to be determined if the different gene expression levels have some physiological importance and how they affect sucrose synthesis, export, and storage in vacuoles. A comparison between the amino acid sequences of β PFKs from a variety of organisms allowed us to identify the two critical Asp residues typical of this enzyme's activity site and the other binding sites; these residues are tightly conserved in all members of this protein family. Apparently, there are catalytic residues on the β subunit of the pyrophosphate-dependent enzyme.

Economic evaluation of nile tilapia juvenile production, feed with commercial ration and with primary production come from organic and inorganic fertilization

Study objective was to evaluate economically a Nile tilapia juvenile production, employing different feeding techniques. Tilapia fingerlings of 8g were stocked at 5 fish m-2 stocking in 50 and 150 m2 ponds, during 75 days. Treatments were: inorganic fertilization (P205 and N); organic fertilization (poultry manure) and commercial ration (32% CP). Water quality results were considered adequate for fish rearing. In juvenile production there were significant differences among treatments for individual final weight, medians were: for inorganic fertilization 12.92g (13.35g in 50 m2 and 12.49g in 150 m2); for organic fertilization 30.55g (33.69g in 50 m2 and 27.40g in 150 m2) and for commercial ration 51.23g (52.90g in 50 m2 and 50.15g in 150 m2). Survival rate ranged from 63 to 71%, with no statistic difference. Commercial ration was effective to bigger juvenile production, with a better market value. Costs considered in economic analyses were tilapia fingerlings, fertilizer, ration, labor and installation depreciation. Obtained information showed that juvenile production in 50 m2 ponds is not viable economically and, in 150 m2, production is viable only when commercial ration is used.

Production and application of amylases of Rhizopus oryzae and Rhizopus microsporus var. oligosporus from industrial waste in acquisition of glucose

Amylases from Rhizopus oryzae and Rhizopus microsporus var. oligosporus were obtained using agro-industrial wastes as substrates in submerged batch cultures. The enzymatic complex was partially characterised for use in the production of glucose syrup. Type II wheat flour proved better than cassava bagasse as sole carbon source for amylase production. The optimum fermentation condition for both microorganisms was 96 hours at 30°C and the amylase thus produced was used for starch hydrolysis. The product of the enzymatic hydrolysis indicated that the enzyme obtained was glucoamylase, only glucose as final product was attained for both microorganisms. R. oligosporus was of greater interest than R. oryzae for amylase production, taking into account enzyme activity, cultivation time, thermal stability and pH range. Glucose syrup was produced using concentrated enzyme and 100 g L-1 starch in a 4 hours reaction at 50°C. The bioprocess studied can contribute to fungus glucoamylase production and application. © 2013 Institute of Chemistry, Slovak Academy of Sciences.

Growth and reproduction of earthworm in organic waste mixtures and effects on chemical and microbial properties of vermicompost

There is a large demand for organic fertilizers in organic agriculture, but few options for different wastes have been studied. The aim of the present work was to evaluate the biological responses of earthworms Eisenia andrei Bouche in wastes composed of cattle manure, peanut husk and spent coffee grounds, as well as to analyze the effect of earthworms on the microbial density and chemical properties of the vermicompost. Four treatments were employed, H1: cattle manure (100%), H2: cattle manure (75%) + peanut husk (25%), H3: cattle manure (75%) + spent coffee grounds (25%), H4: cattle manure (50%) + spent coffee ground (25%) + peanut husk (25%), with six replicates in a completely randomized design. The addition of spent coffee grounds to the manure increased the total biomass and indicated a rising trend in the production of cocoons, while the peanut husk apparently did not affect these variables. The CFU of bacteria and fungi were affected by the treatments at the beginning and end of the experiment and by the earthworms during the waste transformation. The evaluated organic waste mixtures differently affected the growth and reproduction of earthworms and chemical and biological properties of humus.

Relative bioavailability of iron from organic sources for weanling piglets

Some authors consider minerals from organic sources more bioavailable for pig nutrition in comparison with inorganic sources. To evaluate the relative iron bioavailability from the organic source iron carbo-amino-phospho-chelate (ICAPC) to weanling piglets, it was conducted an experiment with 126 commercial piglets, using iron sulfate monohydrate (S) as standard. The experiment had a randomized block design with seven treatments (diet without adding specific source of iron, diet with 50, 100 and 150 ppm iron from S and diet with 50, 100 and 150 ppm iron from ICAPC), six replications and three animals per experimental unit. Performance parameters (average daily gain - ADG, feed: gain ratio - F:G) and blood variables (hemoglobin - Hb, hematocrit - Ht, transferrin - TR, latent iron-binding capacity - LIBC, total iron-binding capacity - TIBC, serum iron - Fe and transferrin saturation index - TSI) were evaluated. At the end of the experiment a piglet from each experimental unit was slaughtered and its liver and spleen removed for assessment of iron concentration by flame atomic absorption spectrometry (FAAS). The evaluated sources of iron yielded similar results for the variables of interest, but the increase in iron intake was followed by a linear increase in ADG, Hb, Ht, Fe and TSI as well as a linear decrease in the values of F:G, TR, LIBC and TIBC. Iron bioavailabilities from both ICAPC and S sources are similar for weanling piglets.

Geração de energia por microturbina alimentada à biogás em uma propriedade rural: estudo de caso

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Study of the feasibility of mix of species from sawmill waste and limiting for particleboard

This study aims to determine physical properties of particleboard made of sawmill waste, as a mix of several wood species, and two adhesives: urea-formaldehyde, usually employed in industry (even with drawbacks or formaldehyde emission during pressing) and FASTBOND®, water based resin, still poorly referenced in literature. Sixteen panels have been produced, in four experimental conditions, defined by using two adhesives and a 12 mm thick limiter (or not). Variance analysis was adopted to evaluate influence of experimental conditions on physical properties of produced panels, manufactured in nominal dimensions 350x350mm; 10% resin related to particles mass (at 5% moisture); 3.5 MPa compaction pressure, temperature 130°C, in a 10 min cycle. Tests to determine density, moisture content, swelling and water absorption were carried out based on normative parameters of ABNT NBR 14810:2006. Results have been satisfactory to panels produced with urea-formaldehyde but those manufactured with polychloroprene based resin (FASTBOND®) not meet regulatory requirements. Best results have been obtained without limiter.

Estudo da biodegradação de corantes azóicos por inóculo proveniente de biodigestor anaeróbio de alimentos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Analysis of hybrid waste-to-energy for medium-sized cities

Urban centers have a huge demand for electricity and the growing problem of the solid waste management generated by their population, a relevant social and administrative problem. The correct disposal of the municipal solid waste (MSW) generated in cities is one of the most complex engineering problems that involves logistics, safety, environmental and energetic aspects for its adequate management. Due to a national policy of solid wastes recently promulgated, Brazilian cities are evaluating the technical and economic feasibility of incinerating the non-recyclable waste. São José dos Campos, a São Paulo State industrialized city, is considering the composting of organic waste for biogas production and mass incineration of non-recyclable waste. This paper presents a waste-to-energy system based on the integration of gas turbines to a MSW incinerator for producing thermal and electric energy as an alternative solution for the solid waste disposal in São José dos Campos, SP. A technical and economic feasibility study for the hybrid combined cycle plant is presented and revealed to be attractive when carbon credit and waste tax are included in the project income. © 2013 Elsevier Ltd.

Bioenergy from stillage anaerobic digestion to enhance the energy balance ratio of ethanol production

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Organic coffee under perspective of energy efficiency

The energy analysis development in this study contributes to the understanding of the dynamics of the organic coffee productive system, in particular to assess the independence of this system with respect to the use of industrialized input products. Thus, it provides information about the sustainability of that production system. Technical itineraries used in this study consist of energy expenditure made with coffee cultivation, according to the type, source and form of energy inputs, agricultural machines, equipment and labor force used in that production system. The energy expenditure, converted into energy units, quantified the input energy. And the organic coffee production, measured in kilograms of processed coffee beans, was the output energy. Primary data used in this study were obtained from organic coffee producers in the Southern region of Minas Gerais State, Brazil, in 2011. Energy balance identified was positive, since the estimated output energy was 626.465 MJ/ha and the energy expenditure was 112.998 MJ/ha, during the useful life of the crop.

Alternatives Panels from Waste Plastics Reinforced With Fibers of Pupunha Palm for Use in Civil Construction and Furniture Industry

In order to cooperate in minimizing the problems of the current and growing volume of waste, this work aims at the production of panels made from industrial waste -thermoplastic (Polypropylene - PP; Polyethylene - PE and Acrylonitrile Butadiene Styrene - ABS) reinforced with agro-industrial waste - pupunha palm waste (shells and sheaths). The properties of the panels were evaluated: density, thickness swelling, water absorption and moisture content. It was used the ASTM D1037; EN 317; and ANSI A208.1 standards regarding particle boards. The best results in physical tests were treatments 1 (100% waste plastic), 6 (60% plastic waste and 40% waste of pupunha) and 7 (70% waste plastic and 30% waste of pupunha). The best results in the mechanical tests were treatments 3 (30% de residuos plasticos e 70% de residuos da pupunha), 4 (40% de residuos plasticos c 60% de residuos da pupunha) and 5 (50% de residuos plasticos e 50% de residuos da pupunha). For mechanical tests it was concluded that the results of modulus of rupture and of modulus of elasticity the best treatments were those with more fibers. In the tensile tests perpendicular to the surface, it is clear that using more waste plastics leads to the best results. It was concluded that the waste can be used as raw material for the production of alternative materials mainly in civil construction and furniture industries, and it can be employed in urban or rural environment, given the concept of eco-efficient products.