Energy efficiency for standard penetration tests

The need for standardization of the measured blow count number N-spt into a normalized reference energy value is now fully recognized. The present paper extends the existing theoretical approach using the wave propagation theory as framework and introduces an analysis for large displacements enabling the influence of rod length in the measured N-spt values to be quantified. The study is based on both calibration chamber and field tests. Energy measurements are monitored in two different positions: below the anvil and above the sampler. Both experimental and numerical results demonstrate that whereas the energy delivered into the rod stem is expressed as a ratio of the theoretical free-fall energy of the hammer, the effective sampler energy is a function of the hammer height of fall, sampler permanent penetration, and weight of both hammer and rods. Influence of rod length is twofold and produces opposite effects: wave energy losses increase with increasing rod length and in a long rod composition the gain in potential energy from rod weight is significant and may partially compensate measured energy losses. Based on this revised approach, an analytical solution is proposed to calculate the energy delivered to the sampler and efficiency coefficients are suggested to account for energy losses during the energy transference process.

Orientation, building height and sky view factor as energy efficiency design parameters

The energy efficiency of buildings should be a goal at the pre-design phase, though the importance of the design variables is often neglected even during the design process. Highlighting the relevance of these design variables, this research studies the relationships of building location variables with the electrical energy consumption of residential units. The following building design parameters are considered: orientation, story height and sky view factor (SVF). The consideration of the SVF as a location variable contributes to the originality of this research. Data of electrical energy consumption and users' profiles were collected and several variables were considered for the development of an Artificial Neural Network model. This model allows the determination of the relative importance of each variable. The results show that the apartments' orientation is the most important design variable for the energy consumption, although the story height and the sky view factor play a fundamental role in that consumption too. We pointed out that building heights above twenty-four meters do not optimize the energy efficiency of the apartments and also that an increasing SVF can influence the energy consumption of an apartment according to their orientation.

Education for Energy Efficiency through an Educational Game

This paper presents an assessment of an educational game for teaching the efficient use of electricity. Developed with Adobe Flash (R), it is a virtual board game where participants choose a car that starts the path and reaches the same final goal, going through a number of track steps defined in terms of a dice that each player rolls in turn. The car moves if the participant is able to correctly answer a question that is randomly generated by the software. The objective of the game is to answer questions related to energy efficiency promoting a healthy and attractive learning process for participants on concepts related to energy efficiency such as: the rational use of energy, the basic concepts of forms of energy generation, among others. The main objective of this paper is to assess the impact of the application of this virtual game in the teaching and learning process of high school students. Therefore, the game was applied in the discipline of physics in a class of junior high public school in the state of Sao Paulo. Initially, the class that had 43 students was divided into 10 groups of 4 students, and 1 group of 3 students. Each student group competed with one another. The idea was that each of them should indicate a student who was the representative of this group until only 4 group leaders were selected for the finals. At this stage, each student could interact with a group of up to ten students that acted as advisers. The adopted assessment process is based on the model proposed by Savi [7]. Then, at the end of the game, the students answered a prepared questionnaire based on the model proposed by Savi. According to Savi, although there are significant studies that show the importance of educational games for the process of cognitive development and learning concepts of students, there are few papers that present forms of assessing the potential of these resources. Thus, the assessment criteria proposed by Savi are based on the model of training evaluation by Kirkpatrick [3], taken as a reference to measure the efficiency of processes of continuing education courses for professionals. The authors assert that the metric of the evaluation proposed to assess the game is based on the first level of the model proposed by Kirkpatrick.

Modeling of hydraulic and energy efficiency indicators for water supply systems

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Volt-VAR multiobjective optimization to peak-load relief and energy efficiency in distribution networks

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Organic coffee under perspective of energy efficiency

The energy analysis development in this study contributes to the understanding of the dynamics of the organic coffee productive system, in particular to assess the independence of this system with respect to the use of industrialized input products. Thus, it provides information about the sustainability of that production system. Technical itineraries used in this study consist of energy expenditure made with coffee cultivation, according to the type, source and form of energy inputs, agricultural machines, equipment and labor force used in that production system. The energy expenditure, converted into energy units, quantified the input energy. And the organic coffee production, measured in kilograms of processed coffee beans, was the output energy. Primary data used in this study were obtained from organic coffee producers in the Southern region of Minas Gerais State, Brazil, in 2011. Energy balance identified was positive, since the estimated output energy was 626.465 MJ/ha and the energy expenditure was 112.998 MJ/ha, during the useful life of the crop.

Efficiency evaluation of ZrB2 incorporation in the MgB 2 matrix phase using high-energy milling

The present study suggests the use of high energy ball milling to mix (to dope) the phase MgB2 with the AlB2 crystalline structure compound, ZrB2, with the same C32 hexagonal structure than MgB 2, in different concentrations, enabling the maintenance of the crystalline phase structures practically unaffected and the efficient mixture with the dopant. The high energy ball milling was performed with different ball-to-powder ratios. The analysis of the transformation and formation of phases was accomplished by X-ray diffractometry (XRD), using the Rietveld method, and scanning electron microscopy. As the high energy ball milling reduced the crystallinity of the milled compounds, also reducing the size of the particles, the XRD analysis were influenced, and they could be used as comparative and control method of the milling. Aiming the recovery of crystallinity, homogenization and final phase formation, heat treatments were performed, enabling that crystalline phases, changed during milling, could be obtained again in the final product. © (2010) Trans Tech Publications.

Energy and hydraulic efficiency in conventional water supply systems

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Efficiency in Brazil's industrial sectors in terms of energy and sustainable development

This article evaluates the efficiency of Brazil's industrial sectors from 1996 to 2009, taking into account energy consumption and respective contributions to the country's economic and social aspects. This analysis used a mathematical programming method called Data Envelopment Analysis (DEA), which enabled, from the SBM model and the window analysis, to evaluate the ability of industries to reduce energy consumption and fossil-fuel CO2 emissions (inputs), as well as to increase the Gross Domestic Product (GDP) by sectors, the persons employed and personnel expenses (outputs). The results of this study indicated that the Textile sector is the most efficient industrial sector in Brazil, according to the variables used, followed by these sectors: Foods and Beverages, Chemical, Mining, Paper and Pulp, Nonmetallic and Metallurgical.

Energy balance for biodiesel production by the castor bean crop (Ricinus communis L.)

The castor bean crop (Ricinus communis L.) has acquired prestige due to industries interest in the oil quality and recently for new sources of energy demand. The experiment that served as basis for the data used in this study was conducted at the Lageado Experimental Farm, in Botucatu - SP, 2008. This study aimed to avaluate the crop viability through energy balance and energy efficiency since the implantation until biodiesel production using parameters of consumption in operational management for installation and maintenance of culture harvest and oil production. The soil management operations, sow and harvest consumed the total of 266.20 MJ ha(-1), gathering with the fertilizers, pesticides, fuels, lubricants, labor, seed and industrial processing totaled 56,808 MJ ha(-1) of energy inputs. The energy production was 72,814.00 MJ ha(-1). The industry still lacks studies thal would contribution data collection and more specific energy coefficients. The castor beans cultivation was considered efficient allowing again of 15983.44 MJ ha(-1) equivalent to about 415 liters of diesel oil.

Feedlot performance, feed efficiency and carcass traits in Nellore cattle selected for postweaning weight

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Simulation of the energy performance of maize production integrated to pig farming

Foi avaliado o desempenho energético da suinocultura integrada à produção de milho em grão em sistema de plantio direto mecanizado. Nesta concepção de integração proposta, os dejetos suínos são utilizados como fertilizantes na produção de milho. O sistema foi delimitado envolvendo as atividades associadas ao manejo dos suínos e de produção do milho (manejo do solo, cultivo e colheita). O período de análise considerado foi de um ano, o que possibilita a produção de três lotes de suínos e duas safras de milho. Para avaliar o desempenho energético, foram criados três indicadores: eficiência energética, eficiência de uso de fontes não renováveis e o custo de energia não renovável para a produção de proteína. As entradas energéticas são compostas pelos insumos e pela infraestrutura, utilizados na criação dos suínos e na produção de milho, e pela radiação solar incidente no agrossistema. Já as saídas são representadas pelos seus produtos (suínos terminados e o milho). Os resultados obtidos nas simulações apontam que a integração melhora o desempenho energético das granjas suinícolas, aumentando a eficiência energética (186%) e a eficiência não renovável (352%), além de reduzir o custo de energia não renovável para a produção de proteína (‑58%).

Energy transfer between Pr3+ ions in a fluoroindate glass

The efficiency of energy transfer (ET) between Pr3+ ions in a fluoroindate glass is determined. ET rates, WET, were determined for dilute samples and the results show a dependence of WET on the Pr3+ concentration. ET processes which contribute to resonance fluorescence and frequency upconversion emission were studied. The origin of the interaction energy among the Pr3+ ions was determined to be dipole - dipole. © 1998 Elsevier Science B.V. All rights reserved.

Windrowing and prismatic baling of sugar cane vegetal residues: Some operational parameters and energetic efficiency

It was evaluated the energetic efficiency and operational parameters of a windrowing and prismatic baling, both from CASE NEW HOLLAND® operations in sugarcane vegetal residues (green leaves, dry leaves and tops) picked mechanically in green cane. The area belongs to COSTA PINTO MILL (COSAN® Group) which was harvested mechanically by combines in the State of Sao Paulo, Brazil. The geographic location of the area is: Latitude 22°40'30S, Longitude 47°36'38W and Altitude of 605m. The variety was RB 82-5336, planted in 1.40m row spacing, with 78t.ha-1 yield. The vegetal residues analysis obtained 69.93% of leaves, 21.44% of stalks fractions, 2.27% of tops and 6.36% of total strange matter. The vegetal residues values were: gross heat of 18.43MJ.kg-1, low heat of 17.00MJ.kg'1 and useful heat of 12.94MJ.kg-1. The vegetal residues average energetic potential was 342.48GJ.ha-1. The treatments were simple, double and triple windrowing. The use of the rake and prismatic baler to pick up the residues was viable. The simple windrowing treatment presented the best results: effective capacity of 83.06t.ha-1, fuel consumption of 0.18L.t -1 and 99.95% of positive energetic efficiency. The bales obtained in the treatment of triple windrowing presented the largest specific mass average of 221.11kg.m-3. The soil amount in the bales increased with successive windrowing. The baling operation in the triple windrowing treatment obtained better results, presenting the effective capacities of 20.29t.h -1 and 1.45ha.h-1 and fuel consumption of for baled in 1.37L.t-1. The high total energetic efficiency of 99.53% indicates that is technically viable the withdrawal of the vegetal residues.