NOTES on THE BIOLOGY and BEHAVIOUR of THE JEWEL WASP, AMPULEX COMPRESSA (FABRICIUS, 1781) (HYMENOPTERA; AMPULICIDAE), IN THE LABORATORY, INCLUDING FIRST RECORD of GREGARIOUS REPRODUCTION

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Life cycle and behaviour of the predaceous mite Cunaxatricha tarsospinosa (Acari: Prostigmata: Cunaxidae)

Life cycle and behaviour of Cunaxatricha tarsospinosa Castro & Den Heyer from rubber trees in Brazil were studied, with Tenuipalpus heveae Baker offered as prey. The study was conducted at 25.4 +/- A 0.2A degrees C, 83 +/- A 5% RH and 12:12 h L:D photophase. The egg stage was the longest immature stage, lasting 17.1 +/- A 1.3 days (mean +/- A SE); total juvenile development was completed in 33.2 +/- A 2.8 days. Lifetime fecundity was 12.0 +/- A 2.2 eggs. Intrinsic rate of population increase was low, suggesting that T. heveae may not be a good prey for the predator. All specimens of C. tarsospinosa collected in the field for this study were females, no males were found. Concurrently, only females were obtained in the laboratory. This seems to be the first report of thelytokous parthenogenesis for cunaxids. Similar to earlier reports for some Cunaxinae and Coleoscirinae, prey were captured when predators were actively searching for them.

Suckling behaviour of Nelore, Gir and Caracu calves and their crosses

It is reasonable to assume that the knowledge of suckling behaviour contributes to optimal management and selection of beef cattle. However, there is little information about suckling behaviour of some beef cattle breeds. The aim of this study was to describe the suckling behaviour of two zebu (Bos indicus) and one criollo (Bos taurus) breeds, analysing the potential effects of breed and some environmental factors on suckling frequency and duration. Forty cows, 17 Nelore, 14 Gir (both zebu) and 9 Caracu (criollo) were bred in a diallelic crossing design. The cows and resulting calves were kept on pasture from birth to weaning. Their behaviour was recorded weekly during daylight. Three behavioural traits were considered: number of suckling meals (NSM), duration of each suckling meal (DSM) and total suckling duration (TSD). Allosuckling was not observed. The calves suckled at any time during the daylight and the overall means were: NSM = 2.57 +/- 0.05 meals/12 h (from back transformed data), DSM = 9.25 +/- 0.11 min/suckling meal and TSD = 23.76 +/- 0.47 min/12 h. There was an effect of dam's breed on NSM and DSM; the calf's genetic group within breed of cow influenced NSM and TSD when the dams were from the Nelore breed. The age of calf had significant effects on all traits. Males averaged higher NSM and TSD (2.60 +/- 0.03 meals and 25.05 +/- 1.37 min/12 h, respectively) than females (2.12 +/- 0.04 meals and 21.51 +/- 1.55 min/12 h, respectively). The differences in suckling behaviour seem to be produced by a complex combination of genetic and environmental factors, which result in a particular behavioural relationship within mother-offspring pairs. (c) 2006 Elsevier B.V. All rights reserved.

Synthesis, characterization and thermal behaviour of solid-state compounds of benzoates with some bivalent transition metal ions

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Synthesis, characterization and thermal behaviour of solid-state compounds of 4-methoxybenzoate with lanthanum (III) and trivalent lighter lanthanides

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Behaviour of displacement, cast-in-place piles on collapsible soil

The paper presents the results of instrumented compression load tests carried out in three uncased cast-in-place piles (pounded piles, called apiloadas in Brazil) which is largely used in interior part of the state of São Paulo. The tests were conducted with the soil in the natural condition and after soaking with water, before loading, in order to evaluate the influence of the soil collapsibility in the results. The values of the ultimate loads (total, point and lateral loads) obtained in the tests are presented and compared with the values predicted by empirical methods that utilize SPT and CPT results.

Thermal and mechanical behaviour of sisal/phenolic composites

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Evaluation of the fretting fatigue behaviour of commercially pure titanium

Fretting fatigue occurs when the contact surfaces of two components undergo small oscillatory movement while they are subjected to a clamping force. A cyclic external load gives rise to the early initiation of fatigue cracks, thus reducing their service life. In this paper, the fretting fatigue behaviour of commercially pure titanium flat samples (1.5 mm thick) is evaluated. A fretting device composed of a frame, load cell, and two screw-mounted cylindrical fretting pads with convex extremities was built and set to a servo-hydraulic testing machine. The fatigue tests were conducted under load control at a frequency of 10 Hz and stress ratio R = 0.1, with various contact load values applied to the fretting pads. Additional tests under inert environment allowed assessing the role of oxidation on the wear debris formation. The fracture surfaces and fretting scars were analysed via scanning electron microscopy in order to evaluate the surface damage evolution and its effect on the fatigue crack features. The effect of the fretting condition on the S-N curve of the material in the range of 10(4)-10(6) cycles is described. Fatigue crack growth calculations allowed estimating the crack initiation and propagation lives under fretting conditions. The effect of the fretting condition in fatigue life is stronger for the lower values of cyclic stress and does not seem to depend on the contact loading value.

On the dynamic behaviour of a mass supported by a parallel combination of a spring and an elastically connected damper

This paper presents a consistent and concise analysis of the free and forced vibration of a mass supported by a parallel combination of a spring and an elastically supported damper (a Zener model). The results are presented in a compact form and the physical behaviour of the system is emphasised. This system is very similar to the conventional single-degree-of freedom system (sdof)-(Voigt model), but the dynamics can be quite different depending on the system parameters. The usefulness of the additional spring in series with the damper is investigated, and optimum damping values for the system subject to different types of excitation are determined and compared.There are three roots to the characteristic equation for the Zener model; two are complex conjugates and the third is purely real. It is shown that it is not possible to achieve critical damping of the complex roots unless the additional stiffness is at least eight times that of the main spring. For a harmonically excited system, there are some possible advantages in using the additional spring when the transmitted force to the base is of interest, but when the displacement response of the system is of interest then the benefits are marginal. It is shown that the additional spring affords no advantages when the system is excited by white noise. (c) 2007 Elsevier Ltd. All rights reserved.

On the dynamic behaviour of the "click" mechanism in dipteran flight

In this paper, the dynamic behaviour of the "click" mechanism is analysed. A more accurate model is used than in the past, in which the limits of movement due to the geometry of the flight mechanism are imposed. Moreover, the effects of different damping models are investigated. In previous work, the damping model was assumed to be of the linear viscous type for simplicity, but it is likely that the damping due to drag forces is nonlinear. Accordingly, a model of damping in which the damping force is proportional to the square of the velocity is used, and the results are compared with the simpler model of linear viscous damping. Because of the complexity of the model an analytical approach is not possible so the problem has been cast in terms of non-dimensional variables and solved numerically. The peak kinetic energy of the wing root per energy input in one cycle is chosen to study the effectiveness of the "click" mechanism compared with a linear resonant mechanism. It is shown that, the "click" mechanism has distinct advantages when it is driven below its resonant frequency. When the damping is quadratic, there are some further advantages compared to when the damping is linear and viscous, provided that the amplitude of the excitation force is large enough to avoid the erratic behaviour of the mechanism that occurs for small forces. (C) 2011 Elsevier Ltd. All rights reserved.

Fruit and seed ontogeny related to the seed behaviour of two tropical species of Caesalpinia (Leguminosae)

Caesalpinia echinata and C ferrea var. ferrea have different seed behaviours and seed and fruit types. Comparison of the seed ontogeny and anatomy partly explained the differences in seed behaviour between these two species of Brazilian legumes; some differences were also related to fruit development. The seed coat in C. ferrea consisted of two layers of osteosclereids, as well as macrosclereids and fibres, to form a typical legume seed coat, whereas C. echinata had only macrosclereids and fibres. In C. echinata, the developing seed coat had paracytic stomata, a feature rarely found in legume seeds. These seed coat features may account for the low longevity of C. echinata seeds. The embryogeny was similar in both species, with no differences in the relationship between embryo growth and seed growth. The seeds of both species behaved as typical endospermic seeds, despite their different morphological classification (exendospermic orthodox seeds were described for C. echinata and endospermic orthodox seeds for C. ferrea). Embryo growth in C. ferrea accelerated when the sclerenchyma of the pericarp was developing, whereas embryonic growth in C. echinata was associated with the conclusion of spine and secretory reservoir development in the pericarp. Other features observed included an endothelial layer that secreted mucilage in both species, a nucellar summit, which grew up into the micropyle, and a placental obturator that connected the ovarian tissue to the ovule in C. ferrea. (C) 2004 the Linnean Society of London.

Early social environment and the fighting behaviour of young Oreochromis niloticus (Pisces, Cichlidae)

This study examines the influence of early experience with different forms of aggressive behaviour on the fighting behaviour of young fish. Fry of the cichlid fish, Oreochromis niloticus, were raised from hatching in small groups consisting of a normal individual (the test fish) and either mutant conspecifics lacking the dorsal fin and thereby the ability to perform fin displays, or normal ones. Following a 63-day period of development in groups the test fish were confronted in their home tanks with an unfamiliar normal fish for 10 min. The fighting behaviour of the test fish was analyzed considering their previous group type (mutant or normal) and rank (alpha or beta). There was no difference between test fish in the rate and sequence of behaviour patterns used in fighting. However, test fish that had developed in mutant groups were rarely the first to bite in contests and had a longer latency to biting following the first bite of the stimulus fish than rest fish with normal experience. This finding is attributable to the form of aggressive behaviour experienced by the test fish during development but not to existing differences in the amount of aggression previously experienced, nor to previous rank, sex, or size relative to the stimulus fish. The results suggest that early experience influenced decision making by the test fish during the fight. The involvement of the fin displays and the possible mechanism of this influence are discussed.

Tunnelling behaviour of the Asian subterranean termite in heterogeneous soils: presence of cues in the foraging area

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Cannibalism as the main feeding behaviour of tucunares introduced in Southeast Brazil

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

On the behaviour of zeros of Jacobi polynomials

Denote by x(n,k)(alpha, beta) and x(n,k) (lambda) = x(n,k) (lambda - 1/2, lambda - 1/2) the zeros, in decreasing order, of the Jacobi polynomial P-n((alpha, beta))(x) and of the ultraspherical (Gegenbauer) polynomial C-n(lambda)(x), respectively. The monotonicity of x(n,k)(alpha, beta) as functions of a and beta, alpha, beta > - 1, is investigated. Necessary conditions such that the zeros of P-n((a, b)) (x) are smaller (greater) than the zeros of P-n((alpha, beta))(x) are provided. A. Markov proved that x(n,k) (a, b) < x(n,k)(α, β) (x(n,k)(a, b) > x(n,k)(alpha, beta)) for every n is an element of N and each k, 1 less than or equal to k less than or equal to n if a > alpha and b < β (a < alpha and b > beta). We prove the converse statement of Markov's theorem. The question of how large the function could be such that the products f(n)(lambda) x(n,k)(lambda), k = 1,..., [n/2] are increasing functions of lambda, for lambda > - 1/2, is also discussed. Elbert and Siafarikas proved that f(n)(lambda) = (lambda + (2n(2) + 1)/ (4n + 2))(1/2) obeys this property. We establish the sharpness of their result. (C) 2002 Elsevier B.V. (USA).