A novel voltage step-down/up ZCS-PWM Zeta converter

This paper presents an analysis of a novel pulse-width-modulated (PWM) voltage step-down/up Zeta converter, featuring zero-current-switching (ZCS) at the active switches. The applications in de to de and ac to de (rectifier) operation modes are used as examples to illustrate the performance of this new ZCS-PWM Zeta converter. Regarding to the new ZCS-PWM Zeta rectifier proposed, it should be noticed that the average-current mode control is used in order to obtain a structure with high power-factor (HPF) and low total harmonic distortion (THD) at the input current.Two active switches (main and auxiliary transistors), two diodes, two small resonant inductors and one small resonant capacitor compose the novel ZCS-PWM soft-commutation cell, used in these new ZCS-PWM Zeta converters. In this cell, the turn-on of the active switches occurs in zero-current (ZC) and their turn-off in zero-current and zero-voltage (ZCZV). For the diodes, their turn-on process occurs in zero-voltage (ZV) and their reverse-recovery effects over the active switches are negligible. These characteristics make this cell suitable for Insulated-Gate Bipolar Transistors (IGBTs) applications.The main advantages of these new Zeta converters, generated from the new soft-commutation cell proposed, are possibility of obtaining isolation (through their accumulation inductors), and high efficiency, at wide load range. In addition, for the rectifier application, a high power factor and low THD in the input current ran be obtained, in agreement with LEC 1000-3-2 standards.The principle of operation, the theoretical analysis and a design example for the new de to de Zeta converter operating in voltage step-down mode are presented. Experimental results are obtained from a test unit with 500W output power, 110V(dc) output voltage, 220V(dc) input voltage, operating at 50kHz switching frequency. The efficiency measured at rated toad is equal to 97.3%for this new Zeta converter.Finally, the new Zeta rectifier is analyzed, and experimental results from a test unit rated at 500W output power, 110V(dc) output voltage, 220V(rms) input voltage, and operating at 50kHz switching frequency, are presented. The measured efficiency is equal to 96.95%, the power-factor is equal to 0.98, and the input current THD is equal to 19.07%, for this new rectifier operating at rated load.

DNA Psi-condensation and reentrant decondensation: Effect of the PEG degree of polymerization

psi-Condensation of DNA fragments of about 4 kbp was induced by poly(ethylene glycol) (PEG), with degrees of polymerization ranging from 45 to 182, and univalent salt (NaCl). Using circular dichroism spectroscopy, we were able to accurately determine the critical amount of PEG needed to induce condensation, as a function of the NaCl concentration. A significant dependence on the PEG degree of polymerization was found. Phase boundaries determined for the multimolecular condensation were very similar to those observed previously for the monomolecular collapse, with two asymptotic regimes at low and high salt concentrations. We analyze our data using a theoretical model that properly takes into account both the polyelectrolyte nature of the DNA and the liquid crystallinity of the condensed phase. The model assumes that all PEG is excluded from the condensates and shows reentrant decondensation only at low salt. We also systematically study reentrant decondensation and find a very strong dependence on PEG molecular weight. At low PEG molecular weight, decondensation occurs at relatively low concentrations of PEG, and over a wide range of salt concentrations. This suggests that in the reentrant decondensation the flexible polymers used are not completely excluded from the condensed phase.

Color evaporation description of inelastic photoproduction of J/psi at DESY HERA

The H1 Collaboration recently reported a new analysis of data on the inelastic photoproduction of J/psi mesons at DESY's HERA ep collider. We show that these new experimental results are well described by the color evaporation model for quarkonium production. Moreover, these new data require the introduction of resolved photon contributions in order to accommodate the results in the kinematic region where the fractional energy carried by the J/psi is small, demonstrating that colored perturbative c (c) over bar states contribute to the production of a color singlet.

Hadronic form factors and the J/psi secondary production cross section: An update

Improving previous calculations, we compute the D + (D) over bar J/psi + pi cross section using the most complete effective Lagrangians available. The new crucial ingredients are the form factors on the charm meson vertices, which are determined from QCD sum rules calculations. Some of them became available only very recently, and the last one, needed for our present purpose, is calculated in this work.

Measurement of the B-s(0) lifetime in the exclusive decay channel B-s(0)-> J/psi phi

Using the exclusive decay B-s(0)-->J/psi(mu(+)mu(-))phi(K+K-), we report the most precise single measurement of the B-s(0) lifetime. The data sample corresponds to an integrated luminosity of approximately 220 pb(-1) collected with the D0 detector at the Fermilab Tevatron Collider in 2002-2004. We reconstruct 337 signal candidates, from which we extract the B-s(0) lifetime, tau(B-s(0))=1.444(-0.090)(+0.098)(stat)+/-0.020(sys) ps. We also report a measurement for the lifetime of the B-0 meson using the exclusive decay B-0-->J/psi(mu(+)mu(-))K-*0(892)(K(+)pi(-)). We reconstruct 1370 signal candidates, obtaining tau(B-0)=1.473(-0.050)(+0.052)(stat)+/-0.023(sys) ps, and the ratio of lifetimes, tau(B-s(0))/tau(B-0)=0.980(-0.071)(+0.076)(stat)+/-0.003(sys).

Measurement of the Lambda(b) lifetime in the exclusive decay Lambda(b)-> J/psi Lambda

We have measured the Lambda(b) lifetime using the exclusive decay Lambda(b)-> J/psi Lambda, based on 1.2 fb(-1) of data collected with the D0 detector during 2002-2006. From 171 reconstructed Lambda(b) decays, where the J/psi and Lambda are identified via the decays J/psi ->mu(+)mu(-) and Lambda -> p pi, we measured the Lambda(b) lifetime to be tau(Lambda(b))=1.218(-0.115)(+0.130)(stat)+/- 0.042(syst) ps. We also measured the B-0 lifetime in the decay B-0 -> J/psi(mu(+)mu(-))K-S(0)(pi(+)pi(-)) to be tau(B-0)=1.501(-0.074)(+0.078)(stat)+/- 0.050(syst) ps, yielding a lifetime ratio of tau(Lambda(b))/tau(B-0)=0.811(-0.087)(+0.096)(stat)+/- 0.034(syst).

Testing color evaporation in photon-photon production of J/psi at CERN LEP II

The DELPHI Collaboration has recently reported the measurement of J/psi production in photon-photon collisions at CERN LEP II. These newly available data provide additional proof of the importance of colored c (c) over bar pairs for the production of charmonium, because these data can be explained only by considering resolved photon processes. We show here that the inclusion of color octet contributions to J/psi production in the framework of the color evaporation model is able to reproduce these data. In particular, the transverse-momentum distribution of the J/psi mesons is well described by this model.

Observation and properties of the X(3872) decaying to J/psi pi(+)pi(-) in p(p)over-bar collisions at root s=1.96 TeV

We report the observation of the X(3872) in the J/psipi(+)pi(-) channel, with J/psi decaying to mu(+)mu(-), in p (p) over bar collisions at roots=1.96 TeV. Using approximately 230 pb(-1) of data collected with the Run II D0 detector, we observe 522+/-100 X(3872) candidates. The mass difference between the X(3872) state and the J/psi is measured to be 774.9+/-3.1(stat)+/-3.0(syst) MeV/c(2). We have investigated the production and decay characteristics of the X(3872) and find them to be similar to those of the psi(2S) state.

Measurement of the Lambda(0)(b) lifetime in the decay Lambda(0)(b)-> J/psi Lambda(0) with the D0 detector

We present measurements of the Lambda(b)(0) lifetime in the exclusive decay channel Lambda(b)(0)-> J/psi Lambda(0), with J/psi ->mu(+)mu(-) and Lambda(0)-> p pi(-), the B-0 lifetime in the decay B-0-> J/psi K-S(0) with J/psi ->mu(+)mu(-) and K-S(0)->pi(+)pi(-), and the ratio of these lifetimes. The analysis is based on approximately 250 pb(-1) of data recorded with the D0 detector in p (p) over bar collisions at root s = 1.96 TeV. The Lambda(b)(0) lifetime is determined to be tau(Lambda(b)(0))=1.22(-0.18)(+0.22)(stat)+/- 0.04(syst) ps, the B-0 lifetime tau(B-0)=1.40(-) (+0.11)(0.10)(stat)+/- 0.03(syst) ps, and the ratio tau(Lambda(b)(0))/tau(B-0)=0.87(-) (+0.17)(0.14)(stat)+/- 0.03(syst). In contrast with previous measurements using semileptonic decays, this is the first determination of the Lambda(b)(0) lifetime based on a fully reconstructed decay channel.

New physics in B-s(0) -> J/psi phi decays?

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Measurement of the Lambda(b) cross section and the (Lambda)over-bar(b) to Lambda(b) ratio with J/psi Lambda decays in pp collisions at root s=7 TeV CMS Collaboration

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

J/Psi mass shift in nuclear matter

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relative rates of B meson decays into psi(2S) and J/psi mesons

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of B-s(0) Mixing Parameters from the Flavor-Tagged Decay B-s(0)-> J/psi phi

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

J/Psi-nuclear bound states

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)