Effects of extraction methods on yam (Dioscorea alata) starch characteristics

Starch extraction from roots and tubers uses grating with water and sieves to separate the starch slurry from residual mass. The starch is recovered by decantation or centrifugation. The yam starch extraction is difficult due to high viscosity of the slurry caused by non-starch polysaccharides (NSP). The establishment of an efficient extraction process may turn yam into a competitive raw material. In this paper Dioscorea alata starch extracted by four methods was characterized in order to establish the impact of treatments. When the tubers were digested with an aqueous oxalic acid/ammonium oxalate (OA/AO) 1/1 solution, it was easier to separate the starch slurry from residual mass, because viscosity was reduced. For all the others methods tested, the viscosity remained almost the same. The nitrogen present in yam tubers was removed during the different extractions to a different extent. The largest nitrogen reduction was observed with ONAO followed by the control (water). The spectrum of starch granules sizes obtained also varied according to the treatment. Results proved that NSP carries small starch granules over to the waste water. The smaller starch granules diameter varied from 1.9 mu m (OA/AO extraction) to 13.5 mu m (water and pectinase extractions). The larger diameter varied from 41.0 mu m (NaOH treatment) to 67.7 mu m (ONAO). All starches extracted showed a RVA behavior in agreement with literature for yam starch, but with small differences due to the influence of methods. ONAO extraction showed the best recovery (18 g of starch/100 g tuber yam) and granular variation but it interfered with the rheological behavior of starch.

Distribution, management and diversity of yam local varieties in Brazil: a study on Dioscorea alata L.

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Distribution, management and diversity of the endangered Amerindian yam (Dioscorea trifida L.)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Aspectos sensoriais e físico-químicos de “iogurtes” de soja com espessantes/estabilizantes a base de fécula de inhame (Dioscorea alata), amido modificado e gelatina

This study had as objective to evaluate the effect of yam starch, modified starch from Cargill-Brasil (Amidomax 4800 (R)) and gelatin from Gelita-Brasil (GEL-LAC) as stabilizers/thickeners in different ratios and combinations in the soy yoghurt fermented with Enterococcus faecium and Lactobacillus helveticus ssp jugurti. Ten soy yoghurt formulations containing these different stabilizers/thickeners, always totalizing 0.5% in relation to the final formulation, were analyzed in sensorial and physical-chemical terms. Based on the observed results, it was concluded in relation to the sensorial point of view that the more appropriate product was processed only with gelatin at 0.5% concentration. This product also presented the best physical-chemical results related to consistency, syneresis and water holding capacity. However, the isolated use of gelatin increased fermentation time of the soy yoghurt.

Análise da forma e tamanho de grânulos de amidos de diferentes fontes botânicas

Neste trabalho, objetivou-se avaliar a forma e tamanho de grânulos de amido de diferentes fontes botânicas, visando fornecer informações que contribuam para aplicabilidade destas como matérias-primas amiláceas. As féculas foram obtidas a partir do processamento das tuberosas em planta piloto de extração. Para a análise da forma dos grânulos utilizou-se o microscópio eletrônico de varredura, com as amostras diluídas em álcool etílico e metalizadas com ouro. A análise do tamanho dos grânulos foi realizada em microscópio ótico, sendo as amostras diluídas em solução de água e glicerina. Foram realizadas 500 determinações das medidas de tamanho (diâmetro menor, diâmetro maior e diferenças entre diâmetros) por fonte botânica. Os resultados obtidos mostraram diferentes formas para os grânulos de amidos e das tuberosas estudadas. Os grânulos de amido de menor tamanho foram os de taioba (Xanthosoma sp.) 12,87 µm, e os de maior tamanho os de biri (Canna edulis) 59,61 µm. Observou-se distribuição bastante regular para os grânulos de amido de ahipa (Pachyrhizus ahipa).

Caracterização físico-química de algumas tuberosas amiláceas

As principais fontes de amido comercial no mundo são o milho, a batata e a mandioca. Entretanto, nos últimos anos vem crescendo o interesse em amidos naturais que possam ser utilizados pela indústria alimentícia. Assim, este trabalho teve por objetivo caracterizar, quanto à composição físico-química, açafrão, ahipa, araruta, batata-doce, biri, inhame e mandioquinha-salsa, tuberosas amiláceas potencialmente passíveis de introdução como matérias-primas de interesse comercial. Amostras das tuberosas foram analisadas quanto ao teor de umidade, cinzas, proteína, matéria graxa, açúcares redutores e totais, fibras e amido. Os resultados obtidos mostraram que das tuberosas analisadas as que apresentaram maior teor de amido foram a araruta (Maranta arundinacea), o inhame (Dioscorea sp) e o biri (Canna edulis), sendo que o inhame e o biri apresentaram também o maior rendimento potencial em toneladas de amido/hectare.

Caracterização físico-química da mucilagem de inhame liofilizada

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Peroxidase activity and total phenol content in citrus cuttings treated with different copper sources

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Uso de nomes populares para as espécies de Araceae e Dioscoreaceae no Brasil

A origem dos nomes vulgares das espécies muitas vezes é obscura ou mesmo impossível de ser identificada. Face à semelhança que apresentam alguns tipos de sistema subterrâneo de Dioscorea com aqueles das espécies de Colocasia, observa-se em muitos trabalhos publicados na literatura brasileira uma certa confusão na terminologia usada para definir estruturas principalmente em algumas espécies de inhame e cará. A padronização no Brasil da nomenclatura das estruturas subterrâneas destas hortaliças, à luz dos Códigos Internacionais de Nomenclatura Botânica e das Plantas Cultivadas, permitirá melhor entendimento para pesquisadores, extensionistas, sociedades civis organizadas, importadores, produtores, comerciantes e consumidores, na identificação das espécies cultivadas de cada família botânica e na interpretação das informações.

Postharvest conservation of the tuberous roots of Pachyrhizus Ahipa (Wedd) Parodi

O objetivo deste trabalho foi avaliar o período de armazenamento em diferentes temperaturas e embalagens na conservação das raízes de Pachyrhizus ahipa. As raízes foram colhidas, lavadas e armazenadas em bandejas de isopor, no refrigerador, câmara fria e à temperatura ambiente. As embalagens utilizadas foram PVC, saco plástico e sem embalagem (controle). As bandejas foram retiradas do seu ambiente de armazenamento e analisadas quanto a acidez total titulável, sólidos solúveis totais, pH, teores de cinzas, lipídios, carboidrato total e proteínas em base seca. A menor perda de massa das raízes foi em câmara fria e em saco plástico. A ATT manteve-se maior nas raízes armazenadas em câmara fria e na embalagem de PVC; os menores teores de SST foram observados em câmara fria não variando entre as embalagens. em todos os tratamentos a porcentagem média de carboidratos foi 84,9%. A porcentagem de lipídios foi maior nas raízes armazenadas em temperatura ambiente, entretanto, o teor de proteína e cinzas foram maiores nas armazenadas na geladeira. A melhor condição para o armazenamento das raízes é em câmara fria e embaladas com saco plástico, onde as raízes mantiveram a qualidade apropriada para comercialização durante até 30 dias de armazenamento.

Some structural and physicochemical characteristics of tuber and root starches

Starches from six different species (cassava, arrowroot, sweet potato, yam, canna and ginger) were isolated and some structural and physicochemical characteristics analysed and correlated. Phosphorous and amylose contents were determined using a colorimetric method and measuring iodine affinity, respectively. Molecular weight distributions of starches were analysed by Sepharose CL 2B. Granular shape and size distribution were performed using an image analyser system attached to a light microscope. Swelling power was determined at 60, 70, 80 and 90 degrees C. Pasting and thermal properties were measured using a rapid viscoanalyser, and a differential scanning calorimeter, respectively. Phosphorous content varied from 0.007 to 0.031% for cassava and canna starches, respectively. Yam, canna and ginger starches displayed higher amylose contents (32.6, 31.7 and 26.5%, respectively) than cassava, arrowroot and sweet potato starches (19.8, 20.8 and 22.6%, respectively). These last three starches displayed amylose molecules of higher molecular weight than those shown for yam, canna and ginger starches. Canna starch showed higher proportions of longer branch chains of amylopectin than others starches. The size and shape of granules were quite variable among all starches and the average size of granules varied from 13.9 to 42.3 mu m for sweet potato and canna, respectively. Swelling power, pasting, and thermal properties were affected by structural characteristics of the starches.

Efeitos de parâmetros de extrusão nas propriedades físicas de produtos expandidos de inhame

Effect of extrusion parameters was studied on the expansion index, specific volume, water absorption index (WAI) and water solubility index (WSI) of expanded yam snacks. The central composite design was used to study the parameters effect. It was verified three levels of temperature in the barrel (100, 115 and 130°C), three levels of screw speed (163, 204 and 245 rpm) and three levels of flour moisture (12, 15 and 18%). The results showed that expansion properties (expansion index and specific volume) depend on flour moisture and extrusion temperature. The WSI was dependant of three parameters. Higher levels of temperature and screw speed increase the water solubility index (WSI). The studied parameters did not influence the water absorption index (WAI).

Effect of Storage Time and Temperature of Equine Epididymis on the Viability, Motion Parameters, and Freezability of Epididymal Sperm

The recovery of sperm from the epididymal cauda may be the last chance to obtain genetic material when sudden death or serious injuries occur in valuable stallions. However, the lack of technical knowledge regarding the storage and transportation of the epididymis often prevents the preservation of the sperm. Therefore, the aim of this study was to compare sperm parameters of sperm obtained immediately after orchiectomy with sperm recovered from epididymal cauda at different times after storage at 5°C and at room temperature (RT). For that, 48 stallions of different breeds were used. In group 1 (control group), eight stallions were used, and the harvest of the epididymal sperm was performed immediately after orchiectomy. In group 2, 40 stallions were used, which were divided into five groups according to the storage time of the epididymis after orchiectomy (6, 12, 18, 24, or 30 hours), making a total of eight stallions per group. One epididymis of each stallion was stored at 5°C, and the contralateral epididymis was stored at RT, both for the same period. The sperm parameters of total motility, progressive motility, progressive linear velocity, curvilinear velocity, percentage of rapid sperm, and plasma membrane integrity were evaluated in all the groups after sperm recovery, resuspension in a sperm freezing diluent, and thawing. In conclusion, the storage of the testis-epididymis complex at 5°C provided better preservation of epididymal sperm than the storage at RT, and regardless of the temperature, the progressive motility is the sperm parameter that is most sensitive to storage time. © 2013 Elsevier Inc.

Aspectos sensoriais e físico-químicos de iogurtes de soja com espessantes/estabilizantes à base de fécula de inhame (Dioscorea alata), amido modificado e gelatina

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Características estruturais e físico-químicas de amidos obtidos de diferentes fontes botânicas

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)