Analysis of the serological variability of Lettuce mosaic virus using monoclonal antibodies and surface plasmon resonance technology

A panel of 19 monoclonal antibodies (mAbs) was used to study the immunological variability of Lettuce mosaic virus (LMV), a member of the genus Potyvirus, and to perform a first epitope characterization of this virus. Based on their specificity of recognition against a panel of 15 LMV isolates, the mAbs could be clustered in seven reactivity groups. Surface plasmon resonance analysis indicated the presence, on the LMV particles, of at least five independent recognition/ binding regions, correlating with the seven mAbs reactivity groups. The results demonstrate that LMV shows significant serological variability and shed light on the LMV epitope structure. The various mAbs should prove a new and efficient tool for LIVIV diagnostic and field epidemiology studies.

Genetic variability of porcine parvovirus isolates revealed by analysis of partial sequences of the structural coding gene VP2

The 3'-terminal 853 nt (and the putative 283 aa) sequence of the VP2-encoding gene from 29 field strains of porcine parvovirus (PPV) were determined and compared both to each other and with other published sequences. Sequences were examined using maximum-parsimony and statistical analyses for nucleotide diversity and sequence variability. Among the nucleotide sequences of the PPV field strains, 26 polymorphic sites were encountered; 22 polymorphic sites were detected in the putative amino acid sequence. Mapping polymorphic sites of protein data onto the three-dimensional (3D) structure of PPV VP2 revealed that almost all substitutions were located on the external surface of the viral capsid. Mapping amino acid substitutions to the alignment between PPV VP2 sequences and the 3D structure of canine parvovirus (CPV) capsid, many PPV substitutions were observed to map to regions of recognized antigenicity and/or to contain phenotypically important residues for CPV and other parvoviruses. In spite of the high sequence similarity, genetic analysis has shown the existence of at least two virus lineages among the samples. In conclusion, these results highlight the need for close surveillance on PPV genetic drift, with an assessment of its potential ability to modify the antigenic make-up of the virus.

Simulation of within field variability of corn yield with Ceres-Maize model

The CERES-Maize model was used to estimate the spatial variability in corn (Zea mays L.) yield for 1995 and 1996 using data measured on soil profiles located on a 30.5 m grid within a 3.9 ha field in Michigan. The model was calibrated for one grid profile for the 1995 and then used to simulate corn yield for all grid points for the 2 yrs. For the calibration for 1995, the model predicted corn yield within 2%. For 1995, the model predicted yield variability very well (r(2) = 0.85), producing similar yield maps with differences generally within +/- 300 kg ha(-1). For 1996, the model predicted low grain yields (1167 kg ha(-1)) compared with measured (8928 kg ha(-1)) because the model does not account for horizontal water movement within the landscape or water contributions from a water table. Under nonlimiting water conditions, the model performed well (average of 8717 vs. 8948 kg ha(-1)) but under-estimated the measured yield variability.

Spatial variability of infiltration and its relationship to some physical properties

Water infiltration into soil is one of the basic factors for estimating irrigation intensity according to the plants' requirements; this is aimed at avoiding problems of surface run-off and degradation. The purpose of the present investigation was to determine the spatial variation of infiltration and its relationship to some physical properties of soil by means of geostatistical techniques in Typic Plinthaquult soils having average texture and flat relief. A 113 point mesh was designned, having a regular distance of 10 m between points, samples being taken from 0 to 0.20 meters depth. Sand, silt and clay content, bulk density, macroporosity, microporosity and total porosity were determined. Infiltration tests were carried out in the field by means of a 15 cm diameter ring. Descriptive statistics and geostatistics were used for analysing the data. Infiltration, silt and microporosity data did not fit a normal distribution curve. Infiltration had high variability, having an average 36.03 mm h(-1). Total porosity was 56.73%, this being the only property that did not show spatial dependency. The smallest ranges were observed for bulk density, macroporosity and microporosity, having values of less than 40 m. The smallest degrees of spatial dependence were observed for infiltration, silt and clay, evidence also being shown of the influence of silt and clay on infiltration rate. Contour maps were constructed; fitting them to the semivariogram models, together with studying the correlations, led to establishing relationships between the properties.

Time-series-based maximization of distributed wind power generation integration

Energy policies and technological progress in the development of wind turbines have made wind power the fastest growing renewable power source worldwide. The inherent variability of this resource requires special attention when analyzing the impacts of high penetration on the distribution network. A time-series steady-state analysis is proposed that assesses technical issues such as energy export, losses, and short-circuit levels. A multiobjective programming approach based on the nondominated sorting genetic algorithm (NSGA) is applied in order to find configurations that maximize the integration of distributed wind power generation (DWPG) while satisfying voltage and thermal limits. The approach has been applied to a medium voltage distribution network considering hourly demand and wind profiles for part of the U.K. The Pareto optimal solutions obtained highlight the drawbacks of using a single demand and generation scenario, and indicate the importance of appropriate substation voltage settings for maximizing the connection of MPG.

Spatial variability of soil water content and mechanical resistance of Brazilian ferralsol

The spatial variability of mechanical resistance to penetration (PR) and gravimetric moisture (GM) was studied at a depth of 0-0.40 m, in a ferralsol cropped with corn, and under conventional tillage in llha Solteira, Brazil (latitude 20 degrees 17'S, and longitude 52 degrees 25'W). The purpose of this study was to analyse and to try explaining the spatial variability of the mentioned soil physical properties using geostatistics. Soil data was collected at points arranged on the nodes of a mesh with 97 points. Geostatistics was used to analyse the spatial variability of PR and GM at four depths: 0-0. 1, 0.1-0.2, 0.2-0.3 and 0.3-0.4 m. PR showed a higher variability of data, with coefficients of variation of 52.39, 30.54, 16.91, and 15.18%, from the surface layers to the deepest layers. The values of the coefficients of variation for GM were lower: 9.99, 5.13, 5.59, and 5.69%. Correlation between GM and PR for the same soil layers was low. Penetration resistance showed spatial structure only in the 0.30-0.40 m layer, while gravimetric moisture showed spatial structure at all depths except for 0-0. 10 m. All the models of fitted semivariograms were spherical and exponential, with ranges of 10-80 m. Data for the variable 'GM' in the 0.20-0.30 and 0.30-0.40 m layers revealed a trend in data attributed to the occurrence of subsurface water flow. (C) 2005 Elsevier B.V. All rights reserved.

Short-term variability of copepod abundance in Jurumirim Reservoir, São Paulo, Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Variability of non-mutualistic filamentous fungi associated with Atta sexdens rubropilosa nests

A survey of the filamentous fungi other than the symbiotic one found in association with Atta sexdens rubropilosa colonies was carried out. Different fungal species (27 taxa) were isolated a few days after treating the workers with toxic baits (sulfluramid; Mirex-SO), from 40 laboratory and 20 field nests. Syncephalastrum racemosum (54 %) and Escovopsis weberi (21 %), Trichoderma harzianum (38 %) and Fusarium oxysporum (23 %) were the prevalent species in laboratory and field nests, respectively. Acremonium kiliense, Acremonium strictum, E. weberi, F oxisporum, Fusarium solani, Moniliella silaveolens and T harzianum were found in both nests' groups. We revealed that many filamentous fungi can co-exist in a dormant state inside the nests of these insects and some of them appear to be tightly associated with this environment.

Spatial variability of soil attributes and sugarcane yield in relation to topographic location

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Spatial and temporal variability of soil CO2 emission in a sugarcane area under green and slash-and-burn managements

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Mechanisms of surface-relief gratings formation in layer-by-layer films from azodyes

Surface-relief gratings are photoinscribed on ionically adsorbed layer-by-layer (LBL) films of an azodye, Brilliant Yellow (BY), which was layered alternately with a polyelectrolyte. Photoinscription is performed by impinging an interference pattern of p- or s-polarized laser light with moderate intensity onto the LBL film, which is unlikely to cause thermal effects. Large-scale mass transport occurs due to the force associated with the field gradient of the light pattern. The ionic interactions between adjacent layers appear to provide the means for the chromophores to drag the polymer chains upon photoizomerization. LBL films were produced from two different polyelectrolytes and under two distinct pH values leading to markedly different film properties especially concerning photodegradation. Exposure to the laser light, for instance, leads to higher photodegradation in the poly(dimethyl diallylammonium chloride)/BY system, in comparison to the poly(allylamine hydrochloride)/BY films. Mass transport in the latter case is predominantly light-driven, which is consistent with the higher amplitude of modulation for p-polarized light (70 nm) compared to that caused by s-polarized light (18 nm). © 2003 Elsevier Ltd. All rights reserved.

Temporal and Spatial Variability of Limnological Characteristics in Areas under the Influence of Tilapia Cages in the Chavantes Reservoir, Paranapanema River, Brazil

The influence of tilapia cages on limnological characteristics of the Chavantes Reservoir, Paranapanema River, Brazil, was investigated in March and June 2007. Principal components analysis was used to compare the transparency; dissolved oxygen; temperature; total organic nitrogen, phosphorus, and dissolved solids; chlorophyll aand electrical conductivity of fish farm 1 (239.3m.t.), 2 (461.5m.t.) and areas without cages, in the lacustrine and river-reservoir transition regions. The variables differentiated the regions and areas with and without cages. In March, in the lacustrine region, there was a thermal and chemical stratification, and in the transition region, there was a temperature and oxygen reduction gradient between the surface and bottom that was also observed in June in fish farm 1. The higher transparency confirmed the increased light penetration in the lacustrine region. In the transition region, there were higher turbidity, total dissolved solid, and conductivity values that are likely related to allochthonous material flow and transport. In fish farms, lower oxygen and pH values indicate intense decomposition and respiration. The generally higher total dissolved solid and nutrient values, turbidity, and conductivity and the lower transparency in one or both fish farms indicate their contribution to eutrophication, demonstrating the need for careful monitoring.

Finite time blow-up and breaking of solitary wind waves

The evolution of surface water waves in finite depth under wind forcing is reduced to an antidissipative Korteweg-de Vries-Burgers equation. We exhibit its solitary wave solution. Antidissipation accelerates and increases the amplitude of the solitary wave and leads to blow-up and breaking. Blow-up occurs in finite time for infinitely large asymptotic space so it is a nonlinear, dispersive, and antidissipative equivalent of the linear instability which occurs for infinite time. Due to antidissipation two given arbitrary and adjacent planes of constant phases of the solitary wave acquire different velocities and accelerations inducing breaking. Soliton breaking occurs in finite space in a time prior to the blow-up. We show that the theoretical growth in amplitude and the time of breaking are both testable in an existing experimental facility.