Unbalanced Three-Phase Induction Motors Starting and Arc Welding Machines Short-Circuit Modeling

Three-Phase Induction Motors (TIM) and Arc Welding Machines (AWM) are loads of special behavior widely used in industrial and commercial installations, and therefore may contribute significantly to the deterioration of the quality of energy supplied by utilities. This paper proposes a modeling in constant power of the unbalanced TIM starting using Genetic Algorithm (GA) and AWM short-circuit based on their statics characteristics curves. The proposed models are compared with the conventional models in the literature. The results showed the good performance of the proposed models, allowing a more precise analysis of the real requests of these loads.

Generalised single-equation load flow method for unbalanced distribution systems

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Distributed generation modelling for unbalanced three-phase power flow calculations in smart grids

Distributed Generators (DG) are generally modeled as PQ or PV buses in power flow studies. But in order to integrate DG units into the distribution systems and control the reactive power injection it is necessary to know the operation mode and the type of connection to the system. This paper presents a single-phase and a three-phase mathematical model to integrate DG in power flow calculations in distribution systems, especially suited for Smart Grid calculations. If the DG is in PV mode, each step of the power flow algorithm calculates the reactive power injection from the DG to the system to keep the voltage in the bus in a predefined level, if the DG is in PQ mode, the power injection is considered as a negative load. The method is tested on two well known test system, presenting single-phase results on 85 bus system, and three-phase results in the IEEE 34 bus test system. © 2011 IEEE.

Practical comparisons among electronic energy meters, a precision energy meter and IEEE1459 for reactive energy measurements, under unbalanced and non-sinusoidal conditions

This paper presents a practical experimentation for comparing reactive/non-active energy measures, considering three-phase four-wire non-sinusoidal and unbalanced circuits, involving five different commercial electronic meters. The experimentation set provides separately voltage and current generation, each one with any waveform involving up to fifty-first harmonic components, identically compared with acquisitions obtained from utility. The experimental accuracy is guaranteed by a class A power analyzer, according to IEC61000-4-30 standard. Some current and voltage combination profiles are presented and confronted with two different references of reactive/non-active calculation methodologies; instantaneous power theory and IEEE 1459-2010. The first methodology considers the instantaneous power theory, present into the advanced mathematical internal algorithm from WT3000 power analyzer, and the second methodology, accomplish with IEEE 1459-2010 standard, uses waveform voltage and current acquisition from WT3000 as input data for a virtual meter developed on Mathlab/Simulink software. © 2012 IEEE.

The dynamic behavior of a cantilever beam coupled to a non-ideal unbalanced motor through numerical and experimental analysis

An excitation force that is not influenced by the system state is said to be an ideal energy source. In real situations, a direct and feedback coupling between the excitation source and the system must always exist at a certain level. This manifestation of the law of conservation of energy is known as the Sommerfeld effect. In the case of obtaining a mathematical model for such a system, additional equations are usually necessary to describe the vibration sources with limited power and its coupling with the mechanical system. In this work, a cantilever beam and a non-ideal DC motor fixed to its free end are analyzed. The motor has an unbalanced mass that provides excitation to the system which is proportional to the current applied to the motor. During the coast up operation of the motor, if the drive power is increased slowly, making the excitation frequency pass through the first natural frequency of the beam, the DC motor speed will remain the same until it suddenly jumps to a much higher value (simultaneously its amplitude jumps to a much lower value) upon exceeding a critical input power. It was found that the Sommerfeld effect depends on some system parameters and the motor operational procedures. These parameters are explored to avoid the resonance capture in the Sommerfeld effect. Numerical simulations and experimental tests are used to help gather insight of this dynamic behavior. (C) 2014 Elsevier Ltd. All rights reserved.

Pruning methods to MLP neural networks considering proportional apparent error rate for classification problems with unbalanced data

This article deals with classification problems involving unequal probabilities in each class and discusses metrics to systems that use multilayer perceptrons neural networks (MLP) for the task of classifying new patterns. In addition we propose three new pruning methods that were compared to other seven existing methods in the literature for MLP networks. All pruning algorithms presented in this paper have been modified by the authors to do pruning of neurons, in order to produce fully connected MLP networks but being small in its intermediary layer. Experiments were carried out involving the E. coli unbalanced classification problem and ten pruning methods. The proposed methods had obtained good results, actually, better results than another pruning methods previously defined at the MLP neural network area. (C) 2014 Elsevier Ltd. All rights reserved.

Predictive maintenance of a worm reducer with an unbalanced load

Among all predictive maintenance techniques the oil analysis and vibration analysis are the most important for monitoring some mechanical systems. The integration of these techniques has potential to improve industrial maintenance practices and provide a better economic gain for industries. To study the integration of these two techniques, a test rig was set up to obtain an extreme working condition for the worm reducer used in this paper. The test rig was composed by a motor connected to a reducer through a flexible coupling and with an unbalanced load. The analysis of the results carried out by using a sample of the oil recommended by the manufacturer in extreme conditions, and using liquid contaminant is presented. From the results it was observed that if there is an abnormal instantaneous load in a system, the subsequent vibration analysis may not perceive what occurred if there was no permanent damage, which is not the case with the lubricant analysis.

On nonlinear dynamics behavior and control of a new model of a magnetically levitated vibrating system, excited by an unbalanced DC motor of limited power supply

We analyze new results on a magnetically levitated body (a block including a magnet whose bottom pole is set in such a way as to repel the upper pole of a magnetic base) excited by a non-ideal energy source (an unbalanced electric motor of limited power supply). These new results are related to the jump phenomena and increase of power required of such sources near resonance are manifestations of a non-ideal system and they are referred as the Sommerfeld effect, which emulates an energy sink. In this work, we also discuss control strategies to be applied to this system, in resonance conditions, in order to decrease its vibration amplitude and avoiding this apparent energy sink.

Osteocondrite dissecante da cabeça do úmero em cães: Estudo retrospectivo de 36 casos (1991-1996)

A osteocondrite dissecante da cabeça do úmero (OCD) é uma condição patológica da cartilagem articular, decorrente de distúrbio da ossificação endocondral. Foram analisados 36 casos de OCD em cães com idades compreendidas entre 5 e 24 meses, observando-se maior representação entre machos comparados com fêmeas (3,5:1). A maioria destes animais (80,6%) tinha recebido suplementação alimentar. Oito cães foram tratados conservativamente através de repouso e restrição alimentar, enquanto os demais foram submetidos a intervenção cirúrgica por meio de artrotomia e remoção do retalho de superfície articular da cabeça do úmero. Concluiu-se que a predisposição de algumas raças, associada ao desequilíbrio nutricional durante os primeiros meses de vida, são as causas determinantes da OCD, e que a cirurgia é a melhor terapia a ser empregada.

Calagem e diagnose foliar em sorgo sacarino (Sorghum bicolor L. moench)

Os efeitos da aplicação de cinco níveis de calcário dolomítico (0 - 1,25 - 2,50-5,00 e 10,00 t/ha) foram estudados em um Latossol Vermelho Escuro textura média. A calagem aumentou a produção de colmos de sorgo sacarino, sendo que as produções mais elevadas foram obtidas quando a soma de cálcio e magnésio, saturação em bases e valor pH do solo eram, respectivamente, 2,93 meq/100 cm³, 59% e 5,71. Foram observados desequilíbrios na nutrição potássica com a aplicação de 10 t/ha de calcário dolomítico. Os níveis críticos de Mg nas folhas + 4e + 3, coletadas, respectivamente, aos 45e 83 dias, foram 0,19 e 0,31% A qualidade do caldo não foi alterada significativamente pelas doses de calcário dolomítico empregadas.

Mapeamento do biovolume de plantas aquáticas submersas a partir de dados hidroacústicos e imagem multiespectral de alta resolução

As plantas aquáticas têm papel fundamental no equilíbrio dos ecossistemas, porém seu crescimento desequilibrado pode obstruir canais, represas e reservatórios e afetar múltiplos usos da água. em relação a plantas aquáticas submersas, a utilização de medidas de controle torna-se mais complexa, em face da dificuldade em mapear e quantificar volumetricamente as áreas colonizadas. Nessas situações, considera-se que o uso de dados hidroacústicos possibilite o mapeamento e a mensuração dessas áreas, auxiliando na elaboração de propostas de manejo sustentáveis desse tipo de vegetação aquática. Assim, o presente trabalho utilizou dados acústicos e a técnica de krigagem para realizar a inferência espacial do biovolume de plantas aquáticas submersas. Os dados foram obtidos em três levantamentos ecobatimétricos realizados em uma área de estudos localizada no rio Paraná, caracterizada por condições favoráveis para proliferação de vegetação aquática submersa e dificuldade de navegação. Para delimitar as áreas caracterizadas pela presença de plantas aquáticas submersas, utilizou-se uma imagem multiespectral de alta resolução espacial World View-2. O mapeamento do biovolume das plantas aquáticas submersas nas áreas de ocorrência do fenômeno foi realizado a partir da inferência do biovolume por krigagem e do fatiamento dos valores inferidos em intervalos de 15%. A partir do mapa gerado, foi possível identificar os locais de maior concentração de macrófitas submersas, com predominância de valores de biovolume entre 15-30% e 30-45%, confirmando a viabilidade da utilização da krigagem na inferência espacial do biovolume, a partir de medidas ecobatimétricas georreferenciadas e com o suporte de imagem de alta resolução espacial.

A new method for real time computation of power quality indices based on instantaneous space phasors

One of the important issues about using renewable energy is the integration of dispersed generation in the distribution networks. Previous experience has shown that the integration of dispersed generation can improve voltage profile in the network, decrease loss, etc. but can create safety and technical problems as well. This work report the application of the instantaneous space phasors and the instantaneous complex power in observing performances of the distribution networks with dispersed generators in steady state. New IEEE apparent power definition, the so-called Buchholz-Goodhue effective apparent power, as well as new proposed power quality (oscillation) index in the three-phase distribution systems with unbalanced loads and dispersed generators, are applied. Results obtained from several case studies using IEEE 34 nodes test network are presented and discussed. (C) 2006 Elsevier B.V. All rights reserved.

Load compensation in four-wire electrical power systems

This work describes a methodology for power factor control and correction of the unbalanced currents in four-wire electric circuits. The methodology is based on the insertion of two compensation networks, one wye-grounded neutral and another in delta, in parallel to the load. The mathematical development has been proposed in previous work [3]. In this paper, however, the methodology was adapted to accept different power factors for the system to be compensated. on the other hand, the determination of the compensation susceptances is based on the instantaneous values of the load currents. The results are obtained using the MatLab - Simulink environment.

ALGORITHM FOR PROBABILISTIC ANALYSIS of DISTRIBUTION SYSTEMS WITH DISTRIBUTED GENERATION

In this paper an efficient algorithm for probabilistic analysis of unbalanced three-phase weakly-meshed distribution systems is presented. This algorithm uses the technique of Two-Point Estimate Method for calculating the probabilistic behavior of the system random variables. Additionally, the deterministic analysis of the state variables is performed by means of a Compensation-Based Radial Load Flow (CBRLF). Such load flow efficiently exploits the topological characteristics of the network. To deal with distributed generation, a strategy to incorporate a simplified model of a generator in the CBRLF is proposed. Thus, depending on the type of control and generator operation conditions, the node with distributed generation can be modeled either as a PV or PQ node. To validate the efficiency of the proposed algorithm, the IEEE 37 bus test system is used. The probabilistic results are compared with those obtained using the Monte Carlo method.