Kinetics of interface state-limited hole injection in alpha-naphthylphenylbiphenyl diamine (alpha-NPD) thin layers

Injection-limited operation is identified in thin-film, alpha-NPD-based diodes. A detailed model for the impedance of the injection process is provided which considers the kinetics of filling/releasing of interface states as the key factor behind the injection mechanism. The injection model is able to simultaneously account for the steady-state, current-voltage (J-V) characteristics and impedance response. and is based on the sequential injection of holes mediated by energetically distributed surface states at the metal-organic interface. The model takes into account the vacuum level offset caused by the interface dipole, along with the partial shift of the interface level distribution with bias voltage. This approach connects the low-frequency (similar to 1 Hz) capacitance spectra, which exhibits a transition between positive to negative values, to the change in the occupancy of interface states with voltage. Simulations based on the model allow to derive the density of interface states effectively intervening in the carrier injection (similar to 5 x 10(12) cm(-2)), which exhibit a Gaussian-like distribution. A kinetically determined hole barrier is calculated at levels located similar to 0.4 eV below the contact work function. (C) 2008 Elsevier B.V. All rights reserved.

Effect of fluoridated varnish and silver diamine fluoride solution on enamel demineralization: pH-cycling study

Objective: In the present investigation, the anticariogenic effect of fluoride released by two products commonly applied in infants was evaluated. Methods: Bovine sound enamel blocks were randomly allocated to each one of the treatment groups: control (C), varnish (V) and diamine silver fluoride solution (D). The blocks were submitted to pH cycles in an oven at 37°C. Next, surface and cross-sectional microhardness were assessed to calculate the percentage loss of surface microhardness (%SML) and the mineral loss (ΔZ). The fluoride present in enamel was also determined. Results: F/Px10 -3 (ANOVA, p<0.05) in the 1 st layer of enamel before pH-cycling were (C, V and D): 1.61 a; 21.59 b and 3.98 c. The %SMH (Kruskal-Wallis, p<0.05) were: -64.0 a, -45.2 b and -53.1 c. %ΔZ values (ANOVA, p<0.05) were: -18.7 a, -7.7 b and -17.3 a. Conclusion: The data suggested that the fluoride released by varnish showed greater interaction with sound enamel and provided less mineral loss when compared with silver diamine solution.

Hydrothermal synthesis and crystal structure of a copper(ii) coordination polymer with bridging dicarboxylate and diamine ligands

This work reports on the synthesis of a copper(II) coordination compound with 4,4-oxibis(benzoate) (obb) and trans-1,2- bis(4-pyridyl)ethene (bpe) ligands. The complex was characterized by single-crystal X-ray diffraction, which showed a 3D polymeric structure. Each copper center is surrounded by four oxygen atoms at the basal plane and one nitrogen atom and one copper atom at the axial positions, revealing a distorted octahedral geometry. Four carboxylic groups bridge two copper atoms, forming a cage-like structure, with the distance between the metallic centers being 2.656(1)Å. 2008 © The Japan Society for Analytical Chemistry.

Synthesis of 4-aminoquinoline analogues and their platinum(II) complexes as new antileishmanial and antitubercular agents

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Magnetic field effects on the conductivity of organic bipolar and unipolar devices at room temperature

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A three-dimensional network constructed from the assembly of 1,3-diaminopropane-copper(II) and tetracyanopalladate(II) moieties

The coordination polymer [Cu(Pd(CN)(4))(pn)](n) (pn = 1,3-diaminopropane) has been synthesized and characterized by elemental analysis, infrared spectroscopy and single-crystal X-ray diffraction. The crystal structure showed that three cyano groups of each [Pd(CN)(4)] unit bridge Cu(II) centers leading to the formation of a three-dimensional network. A series of bifurcated hydrogen bonds between the amino groups of the diamine and the nonbridging cyano groups of the cyanometallate result in the organization of suprarnolecular chains and rings along the polymer. (c) 2008 Elsevier B.V. All rights reserved.

Qualidade de couve-chinesa minimamente processada e tratada com diferentes produtos

O objetivo deste trabalho foi avaliar a qualidade de couve-chinesa minimamente processada e tratada com cloreto de cálcio (CaCl2), ácido ascórbico (vitamina C), ácido etileno-diamino-tetracético (EDTA) e mantida sob refrigeração. Foram realizados os seguintes tratamentos: T1: testemunha (imersão em água contendo 50 mg L-1 clorin/5 minutos); T2: imersão em solução contendo CaCl2 a 1%/5 minutos; T3: imersão em solução contendo CaCl2 a 2%/5 minutos; T4: imersão em solução contendo vitamina C a 1%/5 minutos; T5: imersão em solução contendo Vitamina C a 2%/5 minutos; T6: imersão em solução contendo EDTA a 1%/5 minutos; e T7: imersão em solução contendo EDTA a 2%/5 minutos. Após a realização dos tratamentos a couve-chinesa foi centrifugada, embalada em bandejas de polietileno expandido, recoberta com policloreto de vinila (PVC) e armazenada em temperatura de 5 ± 1 °C e umidade relativa (UR) de 90 ± 2% por 8 dias. As análises físico-químicas, químicas e sensoriais foram realizadas de dois em dois dias. A presença de Salmonella foi verificada somente após a realização dos tratamentos. A partir dos resultados obtidos procedeu-se à análise de variância (ANAVA) e aplicou-se o teste de Tukey considerando-se um nível de significância p < 0,05. Houve influência significativa dos diferentes tratamentos nas características físico-químicas e químicas, como também nas avaliações da aparência geral e escurecimento. Não foi detectada presença de Salmonella em nenhum dos tratamentos realizados. de acordo com os resultados obtidos conclui-se que a couve-chinesa minimamente processada nas condições experimentais utilizadas só estaria apta para o consumo até o quarto dia de armazenamento.

Modeling of organic light-emitting diodes with graded concentration in the emissive multilayer

We model the electrical behavior of organic light-emitting diodes whose emissive multilayer is formed by blends of an electron transporting material, tris-(8-hydroxyquinoline) aluminum (Alq(3)) and a hole transporting material, N,N-'-diphenyl-N,N-'-bis(1,1(')-biphenyl)-4,4-diamine. The multilayer is composed of layers of different concentration. The Alq(3) concentration gradually decreases from the cathode to the anode. We demonstrate that these graded devices have higher efficiency and operate at lower applied voltages than devices whose emissive layer is made of nominally homogeneous blends. Our results show an important advantage of graded devices, namely, the low values of the recombination rate distribution near the cathode and the anode, so that electrode quenching is expected to be significantly suppressed in these devices. (C) 2004 American Institute of Physics.

Variação nos níveis de prolina, diamina e poliaminas em cultivares de trigo submetidas a déficits hídricos

O objetivo deste trabalho foi avaliar duas cultivares de trigo (Triticum aestivum L.) Anahuac e IAC-24, cultivadas em solo arenoso, sob três regimes de umidade do solo (-0,027 a -0,1 MPa; -0,027 a -0,045 MPa; e -0,027 MPa -- irrigação constante). Foram analisadas as variações nos níveis de prolina, da diamina (putrescina) e das poliaminas (espermina e espermidina) e o teor relativo de água (TRA) durante o perfilhamento, emborrachamento, floração e no enchimento dos grãos. Nas plantas submetidas a déficits hídricos foi verificada menor TRA e acúmulo de prolina e putrescina; em relação às poliaminas não foram observadas diferenças entre os tratamentos. Nos tratamentos sob déficit hídrico, a cultivar IAC-24 apresentou teores mais elevados de prolina e putrescina, o mesmo sendo verificado com a cultivar Anahuac quando submetida a tratamento sem déficit hídrico.

Electroluminescence of a device based on europium beta-diketonate with phosphine oxide complex

Rare earth (RE) ions have spectroscopic characteristics to emit light in narrow lines, which makes RE complexes with organic ligands candidates for full color OLED (Organic Light Emitting Diode) applications. In particular, beta-diketone rare earth (RE(3+)) complexes show high fluorescence emission efficiency due to the high absorption coefficient of the beta-diketone and energy transfer to the central ion. In this work, the fabrication and the electroluminescent properties of devices containing a double and triple-layer OLED using a new beta-diketone complex, [Eu(bmdm)(3)(tppo)(2)], as transporting and emitting layers are compared and discussed. The double and triple-layer devices based on this complex present the following configurations respectively: device 1: ITO/TPD (40 nm)/[Eu(bmdm)(3)(tppo)(2)] (40 nm)/Al (150 nm); device 2: ITO/TPD (40 nm)/[Eu(bmdm)(3) (tppo)(2)] (40 nm)/Alq(3) (20 nm)/Al (150 nm) and device 3: ITO/TPD (40 nm)/bmdm-ligand (40 nm)/Al (150 nm), were TPD is (N,N'-diphenyl-N,N'-bis(3-methylphenyl)-1,1-biphenil-4,4-diamine) and bmdm is butyl methoxy-dibenzoyl-methane. All the films were deposited by thermal evaporation carried out in a high vacuum system. These devices exhibit high intensity photo- (PL) and electro-luminescent (EL) emission. Electroluminescence spectra show emission from Eu(3+) ions attributed to the (5)D(0) to (7)F(J) (J = 0, 1, 2, 3 and 4) transitions with the hypersensitive (5)D(o) -> (7)F(2) transition (around 612 nm) as the most prominent one. Moreover, a transition from (5)D(1) to (7)F(1) is also observed around 538 nm. The OLED light emission was almost linear with the current density. The EL CIE chromaticity coordinates (X = 0.66 and Y = 0.33) show the dominant wavelength, lambda(d) = 609 nm, and the color gamut achieved by this device is 0.99 in the CIE color space. (c) 2006 Elsevier B.V. All rights reserved.

Influence of different solvents on the structural, optical and morphological properties of CdS nanoparticles

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Tetradentate schiff base copper(II) complexes

Ten copper(II) complexes of tetradentate Schiff bases obtained by condensing two moles of an o-hydroxyphenylcarbonyl compound with a diamine have been prepared and characterized by elemental analyses, melting points, IR and electronic spectra. The IR and electronic spectra of the free ligand and the complexes are compared and discussed. The deconvolution of the visible spectra of the complexes in CHCl3, approximately C2v or C1, yielded four peaks at ca. 15000, 17000, 18000-19000, and 20000-22000 cm-1, assigned to the four d-d transitions.

Avaliação das estruturas químicas derivadas de diaminas do ferroceno no metabolismo oxidativo em cepas de Trypanosoma cruzi

Pós-graduação em Biociências e Biotecnologia Aplicadas à Farmácia - FCFAR

Avaliação do potencial tripanocida de diaminas, diaminas de ferroceno e derivados de 1,4-naftoquinonas em cepas de Trypanosoma brucei

Pós-graduação em Biotecnologia - IQ