Scaling and branching in wet sonogels as a function of the volume fraction of the liquid phase

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Determination of the volume fraction of retained austenite in a 300m steel by heat tinting technique

Applying the Heat Tinting Technique the microestrutural characterization of a 300M steel (medium carbon steel) was accomplished. The steel was austenitized for 20 min to 900°C, followed by holding at 400°C (in the bainitic temperature), with maintenance time of the material in the temperature of 1min, 5min and 30min, aiming at the formation of a multiphase structure. Through the metallographic analysis it is verified that, with the use of this technique, it is possible the determination of the volume fraction of the present phases in the 300M steel, especially in the identification and quantification of the retained austenite. Copyright © 2007 SAE International.

The volumetric fraction of inorganic particles and the flexural strength of composites for posterior teeth

Objective. To evaluate the content of inorganic particles and the flexural strength of new condensable composites for posterior teeth in comparison to hybrid conventional composites.Method. The determination of the content of inorganic particles was performed by mass weighing of a polymerized composite before and after the elimination of the organic phase. The volumetric particle content was determined by a practical method based on Archimedes' principle, which calculates the volume of the composite and their particles by differential mass measured in the air and in water. The flexural. strength of three points was evaluated according to the norm ISO 4049:1988.Results. The results showed the following filter content: Alert, 67.26%; Z-100, 65.27%; Filtek P 60, 62.34%; Ariston pHc, 64.07%; Tetric Ceram, 57.22%; Definite, 54.42%; Solitaire, 47.76%. In the flexural strength test, the materials presented the following decreasing order of resistance: Filtek P 60 (170.02 MPa) > Z-100 (151.34 MPa) > Tetric Ceram (126.14 MPa) = Alert (124.89 MPa) > Ariston pHc (102.00 MPa) = Definite (93.63 MPa) > Solitaire (56.71 MPa).Conclusion. New condensable composites for posterior teeth present a concentration of inorganic particles similar to those of hybrid composites but do not necessarily present higher flexural strength. (C) 2003 Elsevier B.V. Ltd. Alt rights reserved.

Mineralogy of the clay fraction of Alfisols in two slope curvatures: III - spatial variability

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Mineralogy of the clay fraction of alfisols in two slope curvatures: IV - spatial correlation with physical properties

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Optimization of acid hydrolysis from the hemicellulosic fraction of Eucalyptus grandis residue using response surface methodology

Biotechnological conversion of biomass into fuels and chemicals requires hydrolysis of the polysaccharide fraction into monomeric sugars. Hydrolysis can be performed enzymatically and with dilute or concentrate mineral acids. The present study used dilute sulfuric acid as a catalyst for hydrolysis of Eucalyptus grandis residue. The purpose of this paper was to optimize the hydrolysis process in a 1.41 pilot-scale reactor and investigate the effects of the acid concentration, temperature and residue/acid solution ratio on the hemicellulose removal and consequently on the production of sugars (xylose, glucose and arabinose) as well as on the formation of by-products (furfural, 5-hydroxymethylfurfural and acetic acid). This study was based on a model composition corresponding to a 2 3 orthogonal factorial design and employed the response surface methodology (RSM) to optimize the hydrolysis conditions, aiming to attain maximum xylose extraction from hemicellulose of residue. The considered optimum conditions were: H2SO4 concentration of 0.65%, temperature of 157 degrees C and residue/acid solution ratio of 1/8.6 with a reaction time of 20 min. Under these conditions, 79.6% of the total xylose was removed and the hydrolysate contained 1.65 g/l glucose, 13.65 g/l xylose, 1.55 g/l arabinose, 3.10 g/l acetic acid, 1.23 g/l furfural and 0.20 g/l 5-hydroxymethylfurfural. (c) 2006 Published by Elsevier Ltd.

Stratified Sampling Applied to Estimation of the Volumetric Fraction of Alumina in Cast Metal Matrix Composites

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influence of voids on the flexural resistance of the NCF/RTM6 composites

A major difficulty to achieve maximum weight savings in the manufacture of composite structural components, is the tendency of these materials have the formation of voids and cracks in the interior and surface components. In aeronautical applications, controlling the volume fraction of fibers, resins and empty the components of composite is very hard. In this work, composites of epoxy matrix RTM6 reinforced with NCF (non crimp fabric carbon) processed by resin transfer molding (RTM) were characterized for porosity (P-ap) and density (rho(ad)). We used a method based on Archimedes' principle (ASTM C830) and the technique of helium pycnometer. The porosity values were compared with those determined by acid digestion (ASTM D3171). The mechanical properties of processed composites was evaluated by testing on the performing flexural and the results were correlated with the porosity value. All techniques tested to determine void content are satisfactory. The differents results can be justified for heterogeneous void distribution on laminate and differences among techniques characteristics. (C) 2011 Published by Elsevier Ltd. Selection and/or peer-review under responsibility of ICM11

Applications of the hexanic fraction of Agave sisalana Perrine ex Engelm (Asparagaceae): control of inflammation and pain screening

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Bioactive substance contents and antioxidant capacity of the lipid fraction of Annona crassiflora Mart. seeds

Annona crassiflora Mart. is a typical fruit of the Brazilian cerrado, considered to be a species of economic interest, mainly for its use in cooking, which is widespread among the inhabitants of that region, and can be found in many typical local dishes, especially sweets, jellies, liqueurs, soft drinks, ice creams and juices. Thus, the objective of this study was to determine the bioactive substance contents and the antioxidant capacity of the lipid fraction of A. crassiflora Mart. seeds in the interest of better identifying the quality of this raw material from the Brazilian cerrado. After the receipt of the fruits, the seeds were removed manually and, then, the lipid fraction was obtained by cold extraction with chloroform:methanol:water (2:1:0.8, v/v/v) and analyzed for the composition of phytosterols, tocopherols, fatty acids, total carotenoids, antioxidant activity and oxidative stability index. The lipid fraction showed significant quantity of bioactive substances, especially phytosterols, tocopherols and unsaturated fatty acids, as well as significant antioxidant capacity and oxidative stability, influenced by the content of phytosterols and the composition of fatty acids present in the analyzed fraction. © 2012 Elsevier B.V.

Antiulcerogenic activity of the aqueous fraction of Anacardium humile St. Hil (Anacardiaceae)

Anacardium humile St. Hil. is being used in traditional medicine to treat ulcer. The present work evaluated the mechanisms of action involved in the anti-ulcer properties of the aqueous fraction from leaves of A. humile (AHQ). Gastroprotection of A. humile was evaluated in ethanol and piroxicam models. Mechanisms of action such as mucus production, nitric oxide (NO), sulfhydryl compounds (SH) and the anti-secretory action were evaluated. The acetic acid-induced gastric ulcer model was used to evaluate the A. humile healing properties. Results obtained in the ethanol model showed that AHQ provided significant gastroprotection at all the tested doses (50, 100, and 200 mg/kg). Thereby, the following protocols were performed using the dose capable of producing the most effective gastroprotection, which was the AHQ 200 mg/kg (P < 0.001). Moreover, AHQ (200 mg/kg) protected the mucosa from piroxicam-induced damage. Mucus, NO, and SH did not participate on this gastroprotection. AHQ interfere in H+ secretion in gastric mucosa, thus exerting an anti-secretory activity. Our results suggest that the gastroprotection and cicatrisation process executed by AHQ occurred due to its anti-secretory activity. This study reinforces its traditional medicinal use. Considering that the current therapies are based on the use of anti-secretory agents, the A. humile arises as a promising alternative antiulcer therapy.

Involvement of GABA(A)-benzodiazepine receptor in the anxiolytic effect induced by hexanic fraction of Rubus brasiliensis

To investigate the ability of hexanic ethanolic fraction of Rubus brasiliensis Martius (Roseceae), to induce anxiolytic effect and also the possible involvement of the GABA(A)-benzodiazepine receptor complex, male Wistar rats and Swiss mice behaviour were tested in the elevated plus maze (EPM). All the doses of the extract, 50, 100 and 150 mg/kg, administered per gavage (vo), 30 min before the behavioural evaluation, induced an anxiolytic effect expressed by: increased number of entries in and time spent in the open arms and percentage of open arm entries: and decreased number of entries and time spent in the closed arms. The treatment of mice with flumazenil (Ro 15-1788), 0.5, 1.0 and 1.5 mg/kg, i.p., 15-min before the administration of hexanic fraction, 100 mg/kg, vo, blocked the hexanic fraction-induced anxiolytic effect. The LD50 for the hexanic fraction was 1512 mg/kg. In conclusion, it was shown that the hexanic fraction of R. brasiliensis induced an anxiolytic effect in rats and mice. This effect can be attributed to a liposoluble principle with low toxicity which may be acting as an agonist on GABA(A)-benzodiazepine receptor complex. (C) 1998 Elsevier B.V. Ireland Ltd. All rights reserved.

Photoelastic Analysis of the Influence of Platform Switching on Stress Distribution in Implants

The aim of this study was to evaluate the stress distribution of platform switching implants using a photoelastic method. Three models were constructed of the photoelastic resin PL-2, with a single implant and a screw-retained implant-supported prosthesis. These models were Model A, platform 5.0 mm/abutment 4.1 mm; Model B, platform 4.1 mm/abutment 4.1 mm; and Model C, platform 5.00 mm/abutment 5.00 mm. Axial and oblique (45 degrees) loads of 100 N were applied using a Universal Testing Machine (EMIC DL 3000). Images were photographed with a digital camera and visualized with software (AdobePhotoshop) to facilitate the qualitative analysis. The highest stress concentrations were observed at the apical third of the 3 models. With the oblique load, the highest stress concentrations were located at the implant apex, opposite the load application. Stress concentrations decreased in the cervical region of Model A (platform switching), and Models A (platform switching) and C (conventional/wide-diameter) displayed similar stress magnitudes. Finally, Model B (conventional/regular diameter) displayed the highest stress concentrations of the models tested.

The neurotoxicological effects of mastoparan Polybia-MPII at the murine neuromuscular junction: an ultrastructural and immunocytochemical study

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effect of the temperature on the TMOS sono-hydrolysis and a study of the structure of the resulting aged sonogels

The effect of temperature on the oxalic acid catalyzed sono-hydrolysis of tetramethoxysilane (TMOS) was studied by means of a heat flux calorimetric method. The activation energy of the process was measured as (24.5 +/- 0.8) kJ/mol in the temperature range between 10 and 50 degreesC. The structural characteristics of the resulting sonogels, after long period of aging in saturated conditions, were studied by means of small angle X-ray scattering. The structure can be described as formed by similar to2.7 nm mean size mass fractal-like aggregates (clusters) of primary silica particles of similar to0.3 nm mean size, all imbibed in a liquid phase. The average mass fractal dimension of the clusters was found to be 2.58. The primary particle density was estimated as 2.23 g/cm(3), in good agreement with the value frequently quoted for fused silica. The volume fraction of the clusters, in the saturated sonogels was estimated as about 28%. The moment in which the meniscus of the liquid phase penetrates into the clusters under rapid evaporation process has been detected by an inflection in the first derivative of the curve of weight loss in a simple thermogravimetric test. (C) 2003 Elsevier B.V. All rights reserved.