Stand-alone posterior ressection of lumbar hemivertebrae: case report

Background: In this case report we presented the stand-alone posterior approach for hemivertebra resection with unilateral laminar hooks.Case report: The patient was male and five years old. The coronal and sagital X-Rays images showed a failure of vertebral formation, segmented hemivertebra of third lumbar vertebra. The segmented hemivertebra caused a thoracolumbar scoliosis from T12 to L4 (rightside convexity), of 30 degrees (Cobb angle). The patient was submitted to a hemivertebra resection from posterior approach with two unilateral laminars hooks stabilization (superior lamina in L2 and inferior lamina of L4) in association to a compression system and autologus bone graft. The coronal X-Ray image after surgery showed a partial improvement to 25 degrees (Cobb angle) between L2 and L4. After three years of follow up it was not observed system failure (hook pull-out), maintance of curve (25 degrees of Cobb angle) and correction of trunk inbalance.Conclusion: The hemivertebra resection with posterior approach is safe, with satisfactory correction of scoliosis curve, which means is a good choice for congenital scoliosis surgical treatment.

Single stage converters for low power stand-alone and grid-connected PV systems

This work presents the evaluation of different power electronic integrated converters suitable for photovoltaic applications, in order to reduce complexity and improve reliability. The rated voltages available in Photovoltaic (PV) modules have usually low values for applications such as regulated output voltages in stand-alone or grid-connected configurations. In these cases, a boost stage or a transformer will be necessary. Transformers have low efficiencies, heavy weights and have been used only when galvanic isolation is mandatory. Furthermore, high-frequency transformers increase the converter complexity. Therefore, the most usual topologies use a boost stage and one inverter stage cascaded. However, the complexity, size, weight, cost and lifetime might be improved considering the integration of both stages. In this context, some integrated converters are analyzed and compared in this paper in order to support future evaluations and trends for low power single-phase inverters for PV systems. Power decoupling, MPPT and Tri-State modulations are also considered. Finally, simulation and experimental results are presented and compared for the analyzed topologies. © 2011 IEEE.

Paralelismo de inversores monofásicos, isolados ou em conexão com a rede, com otimização da resposta dinâmica

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Inversores integrados monofásicos e trifásicos para aplicações fotovoltaicas: técnicas para obtenção de mppt, detecção e proteção de ilhamento, sincronização e paralelismo com a rede de distribuição de energia elétrica

Pós-graduação em Engenharia Elétrica - FEIS

Live and formulated diet evaluation through initial growth and survival of jundiá larvae, Rhamdia quelen

A larvicultura da maioria das espécies de peixes enfrenta o desafio da dependência do alimento vivo (AL) e da falta de dietas formuladas (DF) que atendam plenamente às necessidades das larvas. A baixa digestibilidade e a qualidade nutricional das DFs são alguns dos fatores que explicam o insucesso quando as larvas recebem apenas FD. Para avaliar o efeito da combinação da DF com o AL no crescimento e na sobrevivência de larvas de jundiá (Rhamdia quelen), comparando com o uso separado da DF ou do AL, larvas recém eclodidas (5,57 mm; 1,41 mg) foram estocadas inicialmente em 12 aquários de 10 L (100 larvas por aquário). Quatro réplicas foram alimentadas ad libitum com uma das três dietas por 20 (para DF) ou 48 dias (para AL ou a combinação DF + AL). As larvas alimentadas com apenas DF apresentaram crescimento e sobrevivência reduzidos quando comparadas àquelas alimentadas com AL ou a combinação DF + AL. Adicionalmente, as larvas do tratamento DF + AL apresentaram maior crescimento em peso (170 mg) que aquelas alimentadas apenas com AL (110 mg). O melhor desempenho das larvas alimentadas com DF + AL mostra que a maioria dos nutrientes exigidos pelas larvas é fornecida mais adequadamente quando ambas as dietas são fornecidas juntamente. Contudo, trabalhos sobre nutrição larval poderão contribuir ainda mais sobre a elucidação deste tema quando feitas comparações com o uso combinado de DF + AL, do que apenas testando isoladamente novos ingredientes e fontes protéicas normalmente utilizadas na elaboração de dietas para juvenis e adultos.

Simple heuristics for the assembly line worker assignment and balancing problem

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Evaluation of integrated inverter topologies for low power PV systems

This work presents the stage integration in power electronics converters as a suitable solution for solar photovoltaic inverters. The rated voltages available in Photovoltaic (PV) modules have usually low values for applications such as regulated output voltages in stand-alone or grid-connected configurations. In these cases, a boost stage or a transformer will be necessary. Transformers have low efficiencies, heavy weights and have been used only when galvanic isolation is mandatory. Furthermore, high-frequency transformers increase the converter complexity. Therefore, the most usual topologies use a boost stage and one inverter stage cascaded. However, the complexity, size, weight, cost and lifetime might be improved considering the integration of both stages. These are the expected features to turn attractive this kind of integrated structures. Therefore, some integrated converters are analyzed and compared in this paper in order to support future evaluations and trends for low power single-phase inverters for PV systems. © 2011 IEEE.

New integrated Zeta and Cuk inverters intended for standalone and grid-connected applications

This paper presents new inverter topologies based on the integration of a DC to DC Zeta or Cuk converter with a voltage source inverter (VSI). The proposed integration procedure aims to reduce the amount of components, meaning lower volume, weight and costs. In this context, new families of single-phase and three-phase integrated inverters are also presented. Therefore, considering the novelty for Zeta and Cuk integrated inverters structures, the proposed single-phase and three-phase inverters versions are analyzed for grid-tied and stand-alone applications. Furthermore, in order to demonstrate the feasibility of the proposal, the main simulation and experimental results are presented. © 2011 IEEE.

A comparative study of MPPT strategies and a novel singlephase integrated buck-boost inverter for small wind energy conversion systems

This paper presents the analysis of some usual MPPT (Maximum Power Point Tracking) strategies intended for small wind energy conversion (up to 1kW) based on permanent magnet synchronous generators (PMSG), considering the stand-alone application for a novel buck-boost integrated inverter. Each MPPT method is analytically introduced and then it is simulated using MatLab/Simulink considering standard conditions of wind and also commercially available turbines and generators. The extracted power in each case is compared with the maximum available power, so the tracking factor is calculated for each method. Thus, the focus is on the application to improve the efficiency of stand-alone wind energy conversion systems (WECS) with battery chargers and AC load supplied by inverter. Therefore, for this purpose a novel single phase buck-boost integrated inverter is introduced. Finally, the main experimental results for the introduced inverter are presented. © 2011 IEEE.

Three-phase tri-state integrated boost inverter with special space vector and dq0 control

This paper presents a three-phase integrated inverter suitable for stand-alone and grid-connected applications. Furthermore, the utilization of the special features of the tri-state coupled with the new space vector modulation allows the converter to present an attractive degree of freedom for the designing of the controllers. Additionally, the control is derived through dq0 transformation, all the system is described and interesting simulation results are available to confirm the proposal. © 2012 IEEE.

Three-phase tri-state buck-boost integrated inverter

This paper presents a three-phase integrated inverter suitable for stand-alone and/or grid-connected applications. The usage of the special features of the tri-state coupled with the special space vector modulation allows the inverter to present an attractive degree of freedom for the controllers' design, i.e. input and output can be controlled independently. Additionally all controllers are based on dq0 transformation, the system are described and interesting simulation results are available to confirm the proposal. Finally, this paper presents experimental evaluations of the inverter feeding a three-phase stand-alone load confirming the remarkable features of the decoupling control. © 2013 IEEE.

Protecting the root SWAP operation from general and residual errors by continuous dynamical decoupling

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Protecting the √SWAP operation from general and residual errors by continuous dynamical decoupling

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Protecting the √SWAP operation from general and residual errors by continuous dynamical decoupling

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)