Carbon dioxide evaporation in a single microchannel

Despite its importance for designing evaporators and condensers, a review of the literature shows that heat transfer data during phase change of carbon dioxide is very limited, mainly for microchannel flows. In order to give a contribution on this subject, an experimental study of CO 2 evaporation inside a 0.8 mm-hydraulic diameter microchannel was performed in this work. The average heat transfer coefficient along the microchannel was measured and visualization of the flow patterns was conducted. A total of 67 tests were performed at saturation temperature of 23.3°C for a heat flux of 1800 W/(m2°C). Vapor qualities ranged from 0.005 to 0.88 and mass flux ranged from 58 to 235 kg/(m2s). An average heat transfer coefficient of 9700 W/(m2°C) with a standard deviation of 35% was obtained. Nucleate boiling was found to characterize the flow regime for the test conditions. The dryout of the flow, characterized by the sudden reduction in the heat transfer coefficient, was identified at vapor qualities around 0.85. Flow visualization results showed three flow patterns. For low vapor qualities (up to about 0.25), plug flow was predominant, while slug flow occurred at moderated vapor qualities (from about 0.25 to 0.50). Annular flow was the flow pattern for higher vapor qualities. Copyright © 2006 by ABCM.

Estudo experimental do funcionamento de um sistema gas-lif

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização da condutividade hidráulica do embasamento cristalino alterado saturado na região metropolitana de São Paulo

Pós-graduação em Geociências e Meio Ambiente - IGCE

Avaliação hidrogeológica para determinação da vulnerabilidade natural do aquífero freático em área selecionada na cidade de Londrina (PR)

Pós-graduação em Geociências e Meio Ambiente - IGCE

Estudo da permeabilidade dos solos de fundação do aterro de resíduos sólidos urbanos de Bauru

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo hidrofaciológico do aqüífero Rio Claro no município de Rio Claro - SP

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

It's not what it looks like: molecular data fails to substantiate morphological differences in two sea hares (Mollusca, Heterobranchia, Aplysiidae) from southern Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Investigação da condutividade hidráulica dos solos de uma área de aterro de resíduos sólidos urbanos por meio de ensaios de campo e laboratório

A contaminant plume due to leachate infiltration was found in the solid waste landfill from Bauru, SP. The soil hydraulic conductivity (K) is an important parameter to understand the moving of this plume. This paper intends to show representative K values for the soils that occur in the vicinity of this landfill determined by field and laboratory tests. There are four soil types in the area: colluvium, alluvium, sandstone residual soil and the sandstone. Laboratory tests were performed using constant and variable head in rigid and flexible wall permeameters. Slug tests and hydraulic conductivity tests with the Guelph permeameter were also carried out in situ in the area. Representative K values of 3.7x10-7 m/s for the saturated zone and 2.4x10-8 m/s for the unsaturated zone were determined for the residual soil. A K value of 5.3x10-5 m/s was obtained for the colluvium soil. A great variation of K with depth was observed for the alluvium and the assumed average values for the saturated zone were 7.9x10-7 m/s and 1.1x10-4 m/s for the unsaturated surficial layer. An average K value of 3.3x10-8 m/s was determined in laboratory for the sandstone and it was assumed representative for this material.

Aplicação de métodos ergonômicos na avaliação de ferramentas produzidas e utilizadas por homens na Pré-História

The study of prehistoric artifacts may contribute to understand the development of these artifacts, and also of ergonomics. This study aims to investigate and identify the types of grips of two Brazilian stone tools (scraper / piercer and a slug) approximately 5000 years old through the use of gloves with sensors and contact maps of the hand palm, exploring the best method for research of ergonomics in prehistory. Hence it can contribute to the discussion of a part of the ergonomics’ history that remains underexplored.