Epitaxially grown LiNbO3 thin films by polymeric precursor method

LiNbO3 thin films were grown on (0001) sapphire substrates by a chemical route, using the polymeric precursor method. The overall process consists of preparing a coating solution from the Pechini process, based on metallic citrate polymerization, the precursor films, deposited by dip coating, are then heat treated to eliminate the organic material and to synthesize the phase. In this work, we studied the influence of the heat treatment on the structural and optical properties of single-layered films. Two routes were also investigated to increase the film thickness: increasing the viscosity of the coating solution and/or increasing the number of successively deposited layers. The x-ray diffraction theta -2 theta scans revealed the c-axis orientation of the single- and multilayered films and showed that efficient crystallization can be obtained at temperatures as low as 400 degreesC, the phi-scan diffraction evidenced the epitaxial growth with two in-plane variants, A microstructural study revealed that the films were crack free, homogeneous, and relatively dense. Finally, the investigation of the optical properties (optical transmittance and refractive index) confirmed the good quality of the films. These results indicate that the polymeric precursor method is a promising process to develop lithium niobate waveguides.

Multi-layered LiNbO3 films prepared by a polymeric precursor method

The polymeric precursor method was used to prepare multi-layered LiNbO3 films. The overall process consists of preparing a coating solution from the Pechini process and the deposited film is subsequently heat-treated. Two-layered films were prepared by this process, onto (0001) sapphire substrates. Two different routes were investigated for the heat-treatment. The amorphous route consisted of performing, after each deposition, a pre-treatment at low temperature to eliminate the organic material. In this case, the crystallization heat-treatment was performed only after the two layers had been deposited. on the other hand, a process layer-after-layer crystallization was used. Both routes led to (0001) LiNbO3 oriented films. However, only the film prepared by the layer-after-layer crystallization presented an epitaxial growth and a crack-free morphology. Moreover, the layer-after-layer crystallization process led to a film exhibiting the best optical properties. (C) 2001 Elsevier B.V. Ltd. All rights reserved.

Optical properties of Mg doped LiNbO3 thin films grown by polymeric precursor method.

Polymeric precursor solution was used to deposit by spin-coating pure and Mg doped LiNbO3 thin films on sapphire substrates. The effects of magnesium addition on crystallinity, morphology and optical properties of the annealed films were investigated. X-ray diffraction patterns indicate the oriented growth of the films. AFM studies show that the films are very homogeneous, dense and present smooth surfaces. The refractive index and optical losses obtained by the prism coupling method were influenced by the magnesium addition.

Structural and surface morphology characterizations of oriented LiNbO3 thin films grown by polymeric precursor method

Polymeric precursor solution was used to deposit LiNbO3 thin films by dip coating on sapphire substrates. The effects of processing variables, such as heat treatment conditions and number of deposited layers, on crystallinity and morphology of the final films were investigated. X-ray diffraction patterns show the oriented growth of the films. The rocking curves, obtained around the (006) LiNbO3 peak, revealed that the shape peak and the FWHM value were influenced by the processing variables. According to these parameters, some films presented very homogeneous dense and smooth surfaces, as shown by the SEM and AFM studies.

Influence of Mg on the structural and optical properties of LiNbO3 thin films grown by polymeric precursor method

A polymeric precursor solution was used to deposit pure and Mg doped LiNbO3 thin films on sapphire substrates by spin-coating. The effects of magnesium addition on crystallinity, morphology and optical properties of the annealed films were investigated. X-ray diffraction patterns indicate the oriented growth of the films. Phi-scan diffraction evidenced the epitaxial growth with two in-plane variants. AFM studies show that the films are very homogeneous, dense and present smooth surfaces. The refractive index and optical losses obtained by the prism coupling method were influenced by the magnesium addition.

Quali/quantitative characterization of biogas produced in batch digesters supplied with six distinct substrates

Com a finalidade de se analisar quali/quantitativamente o biogás produzido por 6 tipos de substratos, efetuou-se a presente pesquisa no DER/FCAV/UNESP- SP, Brasil. Os substratos utilizados na digestão anaeróbia foram caracterizados como: 1- Esterco de aves de postura (EAP); 2- Esterco de aves de postura triturado (EAPT); 3- Esterco de aves de corte com cama de maravalha (EACM); 4- Esterco de aves de corte com cama de maravalha triturado (EACMT); 5- Esterco de aves de corte com cama de casca de amendoim (EACA), e 6- Esterco de aves de corte com cama de casca de amendoim triturado (EACAT). Dos resultados obtidos, concluiu-se que, em relação à produção acumulada de biogás, o substrato EAPT foi superior aos demais, enquanto EACM apresentou produção acumulada inferior. em geral, os substratos triturados apresentaram maior quantidade de biogás acumulado em relação aos não triturados, exceto o EACAT, com 20,9 m³ inferior ao EACA. O período de produção máxima de biogás teve início entre 45 e 60 dias, começando a decair a partir dos 120 dias. Aos 57 dias após o enchimento dos biodigestores, o gás produzido possuía teores de CH4 superiores a 53%, e a partir dos 99 dias, todos produziram biogás com teores de CH4 superiores a 70%. Os substratos EAP e EAPT apresentaram maiores concentrações de metano no biogás.

Seedlings production of Tabebuia heptaphylla in different substrates and levels of irrigation, in greenhouse conditions

The objective of this research was to evaluate the growth of Tabebuia heptaphylla seedlings in distinct substrates with different amounts of urban waste compost and the relation between this growth and irrigation. A completely randomized experimental design was used, with a factorial arrangement of 15 substrates and 2 irrigation levels. The substrates were composed by the combination of different materials: urban waste, tanned cattle manure, vermiculite, soil and the commercial form Plantmax (R). For the study of the seedlings development, the following characteristics were evaluated: plant height, stem diameter at soil level, number of leaves, above ground dry matter, root system dry matter, relation between plant height and stem base diameter, Dickson quality index and relation between plant height and above ground dry matter. Evaluations of plant height, stem diameter at soil level and number of leaves were made at 75, 90, 105, 120, 135 and 150 days after sowing. According to the results, it was concluded that urban waste compost does not increase plant development. Significant differences in relation to the irrigation levels were found, with better results for the 150% irrigation level compared to 100% evapotranspiration.

MYCELIAL DEVELOPMENT of Lentinula edodes IN CULTURE MEDIA WITH DIFFERENT ORGANIC SUBSTRATES

The radial mycelial growth of Lentinula edodes (Berk) Pegler, strain LE-96/13, was studied in culture media prepared with organic residues extract, by using substrates prepared with pineapple (Ananas comosus (L.) Merril) crown, Astrocaryum aculeatum Meyer peel, Theobroma grandiflorum Schum shell, Musa sp. (genomic group AAB, subgroup Pacovan) peel, and Musa sp. (genomic group AAB, subgroup Praia) peel, with three supplementation levels with wheat bran (0, 10 and 20%), and incubated at 25 degrees C. The experimental design was totally randomized, in a 5x3 factorial scheme, adding up 15 treatments with 4 repetitions, and each repetition corresponding to a Petri dish. The diameter of the colony was evaluated daily during nine days of incubation. After that period, it was verified that the highest mycelial growth averages of strain LE-96/13 of L. edodes were found in culture media prepared with T. grandiflorum Schum shell (whose supplementation with wheat bran was favorable for Mushroom development) and A. aculeatum Meyer peel (whose supplementation did not favor the mycelial growth of L. edodes in relation to the medium not supplemented).

Growth of populations and the fungus garden of Atta sexdens rubropilosa (Hymenoptera, Formicidae) response to foraged substrates

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Feeding substrates to black coconut bunch weevil, Homalinotus coriaceus (Gyllenhal) (Coleoptera: Curculionidae), rearing in laboratory

A broca do cacho do coqueiro, Homalinotus coriaceus (Gyllenhal), é uma praga limitante da produção de coco no Brasil, sendo que tanto as larvas como os adultos provocam a queda das flores femininas e dos frutos imaturos, pela interceptação do fluxo de seiva ou pela alimentação direta nas estruturas reprodutivas. em virtude da escassez de informações sobre sua biologia, realizou-se esse trabalho com o objetivo de desenvolver uma metodologia mais adequada para a criação da praga em laboratório. Foram utilizados os parâmetros biológicos para avaliação e comparação dos sistemas de criação estudados.Toletes de cana-de-açúcar foram utilizados como substrato para alimentação dos adultos coletados no campo e obtenção dos ovos. As larvas foram criadas em três substratos alimentares no Laboratório de Entomologia da Empresa Brasileira de Pesquisa Agropecuária (EMBRAPA)-CPATC (Centro de Pesquisa Agropecuária dos Tabuleiros Costeiros), em Aracaju, SE. Os substratos alimentares estudados foram: o mesocarpo do coco, dieta para criação da broca dos citros e dieta para criação da broca do olho do coqueiro, sendo esta a que proporcionou o melhor desenvolvimento larval num menor tempo, com boa viabilidade, maior facilidade no preparo e manutenção.

Chemical deposition of La0.7Ca0.3MnO3±δ films on ceramic substrates

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of the microwave oven on structural, morphological and electrical properties of SrBi4Ti4O15 thin films grown on Pt/Ti/SiO2/Si substrates by a soft chemical method

Thin films of SrBi4Ti4O15 (SBTi), a prototype of the Bi-layered-ferroelectric oxide family, were obtained by a soft chemical method and crystallized in a domestic microwave oven. For comparison, films were also crystallized in a conventional method at 700 degrees C for 2 h. Structural and morphological characterization of the SBTi thin films were investigated by Xray diffraction (XRD) and atomic force microscopy (AFM), respectively. Using platinum coated silicon substrates, the ferroelectric properties of the films were determined. Remanent polarization P-r and a coercive field E-c values of 5.1 mu C/cm(2) and 135 kV/cm for the film thermally treated in the microwave oven and 5.4 mu C/cm(2) and 85 kv/cm for the film thermally treated in conventional furnace were found. The films thermally treated in the conventional furnace exhibited excellent fatigue-free characteristics up to 10(10) switching cycles indicating that SBTi thin films are a promising material for use in non-volatile memories. (C) 2007 Elsevier B.V. All rights reserved.

Enhanced ferroelectric properties of La-substituted BiFeO3 thin films on LaSrCoO3/Pt/TiO2/SiO2/Si (100) substrates prepared by the soft chemical method

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Giardia duodenalis: protein substrates degradation by trophozoite proteases

The present investigation was undertaken to identify and characterize trophozoite proteases of five axenic strains of Giardia duodenalis isolated in Brazil and the reference strain Portland 1 isolated in the United States. Trophozoite cell lysates of each strain were analysed for the pattern of proteins and for proteolytic activity. Samples were tested in SDS-polyacrylamide gel electrophoresis for the protein profiles, and the detection of proteases in cell lysates was performed using substrate gel electrophoresis [gelatin, collagen, bovine serum albumin (BSA) and haemoglobin] and azocasein assays. Indeed, synthetic inhibitors were included in the assays to characterize the protease classes. Differences on the hydrolysis patterns of protein substrates were observed in relation to the substrate composition as much as the Giardia trophozoite strain. The substrate-containing gels revealed hydrolysis bands with molecular masses ranging from > 97 to 20-15 kDa, and most zones were common to the five strains. However, some pronounced differences could be detected in the BTU-11 pattern. Azocasein was also degraded; however, depending on the lysate assayed, the degree of substrate degradation was variable. It was observed that inhibitory effects are substrate-dependent since the activity was predominantly due to cysteine proteases against gelatin, collagen, BSA and azocasein substrates and due to serine against haemoglobin. The presence of aspartic protease and aminopeptidase activity in the lysates was also indicated.

Colonization of rocky and leaf pack substrates by benthic macroinvertebrates in a stream in southeast Brazil.

A comparative analysis was conducted of the colonization by benthic macroinvertebrates of rocky and leaf pack substrates, both natural and artificial. This colonization was evaluated by season, with the objective of ascertaining the influence of rainfall on the rate of colonization. The total density of macroinvertebrates after 21 days of colonization was significantly greater in the dry than in the wet season. When the substrate types were compared, artificial leaf pack substrate presented the smallest density for both seasons. In the wet season, Chironomidae, Leptohyphidae, Hydropsychidae, Elmidae, immature stages of Trichoptera, and Hydroptilidae showed a more representative density. In the dry season, Chironomidae, Baetidae and Oligochaeta were the most abundant taxa. The artificial rocky substrate used in this experiment was the most appropriate, due to its resemblance with natural substrate conditions in terms of the maintenance of the structural integrity of the substrate throughout the experimental period. Successional and seasonal effects were of great relevance, playing an important role in the colonization process.