Efeito da fase em técnicas de redução de ruídos em sinais de voz baseadas na SNR a priori

Pós-graduação em Engenharia Elétrica - FEIS

Alocação de modem PLC utilizando SNR em uma rede elétrica de baixa tensão

Pós-graduação em Engenharia Elétrica - FEIS

Assessment of modernized GPS L5 SNR for ground-based multipath reflectometry applications

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Atributos bioquímicos e químicos do solo rizosférico e não rizosférico de culturas em rotação no sistema de semeadura direta

Sistemas autossustentáveis favorecem as populações microbianas devido à conservação e ao aumento da matéria orgânica no solo. Além disso, as plantas que fazem parte desses sistemas promovem o efeito rizosférico, por meio da zona de influência das raízes, que resulta no aumento da atividade e na modificação da população microbiana. O objetivo deste trabalho foi avaliar o efeito da rotação de culturas de inverno sobre sequências de verão, em sistema de semeadura direta, nos atributos bioquímicos (amilase, urease, celulase e protease) e químicos (carbono orgânico total - COT, carboidratos totais e proteínas totais) em solo rizosférico (SR) e não rizosférico (SNR). Este estudo foi constituído de três culturas de inverno: milho (Zea mays L.), girassol (Helianthus anuus L.) e guandu (Cajanus cajan (L.) Millsp), que estavam em rotação sobre três sequências de verão: soja/soja (Glycine max L.), milho/milho e soja/milho, e duas posições no solo: solo aderido às raízes das plantas (SR) e solo da entrelinha de plantio (SNR). As atividades da amilase, celulase, protease e urease no SR foram 16, 85, 62 e 100 % maiores do que no SNR; para COT e proteínas totais a diferença foi de 21 %. Das culturas de inverno, o milho foi a que mais estimulou as atividades das enzimas amilase, celulase, urease e protease no SR, bem como a atividade das enzimas amilase, urease e protease no SNR. de modo geral, os teores de proteínas totais não foram influenciados pelas culturas de inverno e pelas sequências de verão; os carboidratos totais foram influenciados pelas culturas de inverno milho e girassol. Para o COT houve influência apenas da sequência de verão milho/milho. Os atributos bioquímicos e químicos avaliados neste estudo podem ser utilizados como indicadores das alterações no solo promovidas pelas culturas de inverno e pelas sequências de verão.

Gene expression profiling reveals molecular marker candidates of laryngeal squamous cell carcinoma

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Optimisation of a fermentation process for butanol production by particle swarm optimisation (PSO)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A low-voltage programmable-gain current-mode amplifier

A CMOS low-voltage, wide-band continuous-time current amplifier is presented. Based on an open-loop topology, the circuit is composed by transresistance and transconductance stages built around triode-operating transistors. In addition to an extended dynamic range, the amplifier gain can be programmed within good accuracy by the rapport between the aspect-ratio of such transistors and tuning biases Vxand Vy. A balanced current-amplifier according to a single I. IV-supply and a 0.35μm fabrication process is designed. Simulated results from PSPiCE and Bsm3v3 models indicate a programmable gain within the range 20-34dB and a minimum break-frequency of IMHz @CL=IpF. For a 200 μApp-level, THD is 0.8% and 0.9% at IKHz and 100KHz, respectively. Input noise is 405pA√Hz @20dB-gain, which gives a SNR of 66dB @1MHz-bandwidth. Maximum quiescent power consumption is 56μ W. © 2002 IEEE.

Avaliação do nível de multicaminho no posicionamento relativo GPS e sua atenuação através da análise de multiresolução

The multipath effect affects the differential and relative positioning, even that one involving short baselines. So it is necessary to detect this effect, check the caused error level, and mainly, its removal. This paper aims at analysing and comparing some useful components in the detection of this effect. These components are the Signal to Noise Ratio (SNR), the values of MP1 and MP2 obtained from the TEQC software that indicates the multipath level in the carriers L1 and L2, the multipath repeatability in consecutive days and the elevation angle and the azimuth of the satellites. For this purpose, an experiment is carried out, comparing such components in the presence and the absence of reflector objects that cause the multipath. Not only there is clear multipath repeatability in the residuals, but it also appears in the measures SNR, MP1 and MP2, reaching up 99% of correlation. For reduction, at least, of the high frequency multipath effect, the Multi-Resolution Analysis using wavelets is applied in the double differences (DD) measures. Some statistical tests were accomplished, which indicate results improvement, and mainly, larger reliability in the solution of the ambiguities, reaching up 49% of improvement concerning the Ratio test without applying the proposed method.

Substitution-newton-Raphson method for the solution of electric network equations

The power flow problem, in transmission networks, has been well solved, for most cases, using Newton-Raphson method (NR) and its decoupled versions. Generally speaking, the solution of a non-linear system of equations refers to two methods: NR and Successive Substitution. The proposal of this paper is to evaluate the potential of the Substitution-Newton-Raphson Method (SNR), which combines both methods, on the solution of the power flow problem. Simulations were performed using a two-bus test network in order to observe the characteristics of these methods. It was verified that the NR is faster than SNR, in terms of convergence, considering non-stressed scenarios. For those cases where the power flow in the network is closed to the limits (stressed system), the SNR converges faster. This paper presents the power flow formulation of the SNR and describes its potential for its application in special cases such as stressed scenarios. © 2006 IEEE.

CMOS-based active pixel for low-light-level detection: Analysis and measurements

An analysis of the active pixel sensor (APS), considering the doping profiles of the photodiode in an APS fabricated in a 0.18 μm standard CMOS technology, is presented. A simple and accurate model for the junction capacitance of the photodiode is proposed. An analytic expression for the output voltage of the APS obtained with this capacitance model is in good agreement with measurements and is more accurate than the models used previously. A different mode of operation for the APS based on the dc level of the output is suggested. This new mode has better low-light-level sensitivity than the conventional APS operating mode, and it has a slower temporal response to the change of the incident light power. At 1μW/cm2 and lower levels of light, the measured signal-to-noise ratio (SNR) of this new mode is more than 10 dB higher than the SNR of previously reported APS circuits. Also, with an output SNR of about 10 dB, the proposed dc level is capable of detecting light powers as low as 20 nW/cm2, which is about 30 times lower than the light power detected in recent reports by other groups. © 2007 IEEE.

Wavelets in a problem of signal processing

In this work a new method is proposed for noise reduction in speech signals in the wavelet domain. The method for signal processing makes use of a transfer function, obtained as a polynomial combination of three processings, denominated operators. The proposed method has the objective of overcoming the deficiencies of the thresholding methods and the effective processing of speech corrupted by real noises. Using the method, two speech signals are processed, contaminated by white noise and colored noises. To verify the quality of the processed signals, two evaluation measures are used: signal to noise ratio (SNR) and perceptual evaluation of speech quality (PESQ).

Estudo e implementação de uma técnica de redução de ruído em sinais de voz baseada na subtração espectral e em critérios psicoacústicos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Atributos microbiológicos do solo sob rotação e sequências de culturas em semeadura direta

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Identificação de genes diferencialmente expressos em câncer de laringe

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Quantification of Biological Tissue and Construction of Patient Equivalent Phantom (Skull and Chest) for Infants (1-5 years old)

Our main purpose in this study was to quantify biological tissue in computed tomography (CT) examinations with the aim of developing a skull and a chest patient equivalent phantom (PEP), both specific to infants, aged between 1 and 5 years old. This type of phantom is widely used in the development of optimization procedures for radiographic techniques, especially in computed radiography (CR) systems. In order to classify and quantify the biological tissue, we used a computational algorithm developed in Matlab (R). The algorithm performed a histogram of each CT slice followed by a Gaussian fitting of each tissue type. The algorithm determined the mean thickness for the biological tissues (bone, soft, fat, and lung) and also converted them into the corresponding thicknesses of the simulator material (aluminum, PMMA, and air). We retrospectively analyzed 148 CT examinations of infant patients, 56 for skull exams and 92 were for chest. The results provided sufficient data to construct a phantom to simulate the infant chest and skull in the posterior anterior or anterior posterior (PA/AP) view. Both patient equivalent phantoms developed in this study can be used to assess physical variables such as noise power spectrum (NPS) and signal to noise ratio (SNR) or perform dosimetric control specific to pediatric protocols.