Rod length influence in torque measurement of SPT-T test

Since Ranzini suggested supplementing the SPT test with measurement of the torque required to turn the split spoon sampler after driving, many Brazilian engineers have been using this in the design of pile foundations. This paper presents a study of the rod length influence in the torque measurement. A theoretical study of material resistance considering torsion and bending in a thin wall tubular steel shaft was performed. It makes possible to conclude that the shearing tension caused by the proper weight represents less than 1% of the shearing tension caused by the turning moment. In addition, an experimental study was done with electric torquemeters fixed in a horizontal rod system. The tests were being carried out to analyze rods of one meter to twenty meters in length and the measurements were collected at the ends of each rod length verifying the efficiency data. As a result, it is possible to verify that the torque difference through rod length is lower than minimum scales of mechanical torquemeters that are used on practical engineering. Also a fact to be considered is a big torque loss for values under 20 N.m of applied torque. This way, the SPT-T is not adequate to low consistency soil. Copyright ASCE 2007.

Theoretical and experimental evaluation of the influence of the length of drill rods in the SPT-T test

The influence of soil drill rod length on the N value in the SPT-T test has been studied extensively by Mello (1971), Schmertmann & Palacios (1979), Odebrecht et al. (2002) and Cavalcante (2002). This paper presents an analysis of the Standard Penetration Test supplemented with torque measurement (SPT-T). A theoretical study of the resistance of the rod material to torsion and bending indicated that the shear stress caused by the rod self-weight represents less than 1% of that caused by the torsional moment. An experimental study with electric torquemeters attached to a horizontal rod system, as well as two field tests in the vertical direction, were also carried out to compare and substantiate the results. The purpose of these tests was to analyze changes along the length of the rod in response to successive increments at 1-meter intervals. Torque measurements were taken at each increment of the length to ascertain the accuracy of the theoretical data. The difference between the applied torque and the measured torque at the end of rod system was lower than the minimum scale of mechanical torquemeters used in practice.

Compression waves and kinetic energy losses in collisions between balls and rods of different lengths

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effects of seasonal variation on the central nervous system activity of Ocimum gratissimum L. essential oil

Ocimum gratissimum L. (Lamiaceae) and other species of the same genus are used as medicines to treat central nervous system (CNS) diseases, commonly encountered in warm regions of the world. The chemical composition of Ocimum gratissimum essential oil varies according to their chemotypes: timol, eugenol or geraniol. In this study, the essential oil type eugenol was extracted by hydrodistillation in each of the four seasons of the year. Activity upon CNS was evaluated in the open-field and rota-rod tests; sleeping time induced by sodium pentobarbital (PBS, 40 mg/kg, intraperitoneally, i.p.) and anticonvulsant activity against seizures induced by both pentylenetetrazole (PTZ; 85 mg/kg, s.c.) and maximal electroshock (MES, 50 mA, 0.11 s) were determined. Essential oils obtained in each season were effective in increasing the sleeping duration and a preparation obtained in Spring was able to protect animals against tonic seizures induced by electroshock. In each season, eugenol and 1,8-cineole were the most abundant compounds, and in Spring the essential oil presented the greatest relative percentage of sesquiterpenes, suggesting that these compounds could explain the differences observed in the biological activity in essential oils obtained in different seasons of the year. (c) 2005 Elsevier B.V.. All rights reserved.

The GABAergic system contributes to the anxiolytic-like effect of essential oil from Cymbopogon citratus (lemongrass)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Quality of mechanized coffee harvesting in circular planting system

A colheita mecanizada de café se destaca como um dos principais avanços tecnológicos em benefício dos produtores, porém, problemas com planejamento no plantio e desenvolvimento da cultura, bem como falhas na regulagem da colhedora, podem acarretar em redução na eficiência da operação, tornando-a mais estressante para a cultura que a colheita manual. Diante disso, o presente trabalho foi realizado no município de Patos de Minas, MG, com o objetivo de avaliar os danos na parte vegetativa e a qualidade da colheita mecanizada do café cultivado em plantio circular sob pivô central, com duas frequências de vibração das hastes, sob o controle estatístico do processo. Observou-se que a bienalidade negativa sobre a cultura reduziram a carga inicial de café, eliminando o efeito das condições de insolação. Os índices de qualidade da colheita apresentaram distribuição assimétrica, com grande variabilidade nas amostras, sendo apenas a eficiência de derriça influenciada pelos eixos avaliados, e se mostrando estável pelo controle estatístico. Os danos causados às plantas pela colheita apresentaram valores desejáveis, não variando em função dos fatores analisados, mas sendo considerado sob controle estatístico.

The fractional and nonlinear magneto-flexible rod

This paper deals with a system involving a flexible rod subjected to magnetic forces that can bend it while simultaneously subjected to external excitations produces complex and nonlinear dynamic behavior, which may present different types of solutions for its different movement-related responses. This fact motivated us to analyze such a mechanical system based on modeling and numerical simulation involving both, integer order calculus (IOC) and fractional order calculus (FOC) approaches. The time responses, pseudo phase portraits and Fourier spectra have been presented. The results obtained can be used as a source for conduct experiments in order to obtain more realistic and more accurate results about fractional-order models when compared to the integer-order models. © Published under licence by IOP Publishing Ltd.