3 resultados para ORGANOPHOSPHINIC ACID EXTRACTANTS
em Repositório Institucional UNESP - Universidade Estadual Paulista "Julio de Mesquita Filho"
Resumo:
In this paper, we report on a field experiment being carried out in a Typic Eutrorthox. The experiment was initiated in the 1997-98 agricultural season as a randomized block design with four treatments (0, 5, 10, and 20 t ha -1) of sewage sludge and five replicates. Compound soil samples were obtained from 20 subsamples collected at depths of 0-0.1 and 0.1-0.2 m. Cu, Fe, Mn, and Zn concentrations were extracted with DTPA pH 7.3; 0.1 mol L -1 HCl, Mehlich-I, Mehlich-III, and 0.01 mol L-1 CaCl 2. Metal concentrations were determined via atomic absorption spectrometry. Diagnostic leaves and the whole above-ground portion of plants were collected to determine Cu, Fe, Mn, and Zn concentrations extracted by nitric-perchloric digestion and later determined via atomic absorption spectrometry. Sewage sludge application caused increases in the concentrations of soil Cu, Fe, and Mn in samples taken from the 0-0.1 m depth evaluated by the extractants Mehlich-I, Mehlich-III, 0.01 mol L-1 HCl and DTPA pH 7.3. None of the extractants provided efficient estimates of changes in Mn concentrations. The acid extractants extracted more Cu, Fe, Mn, and Zn than the saline and chelating solutions. The highest concentrations of Cu, Fe, and Zn were obtained with Mehlich-III, while the highest concentrations of Mn were obtained with HCl. We did not observe a correlation between the extractants and the concentrations of elements in the diagnostic leaves nor in the tissues of the whole maize plant (Zea mays L.). © 2013 Springer Science+Business Media Dordrecht.
Resumo:
Fifteen soil samples and four extradants (DTPA, Na 2EDTA, HCl and Mehlich 1) were used to study soil extraction methods for available zinc. Each extradant was studied in three soil:solution ratios (1:2, 1:4 and 1:10) and in three extraction periods in the ratio most frequently used. The zinc extracted by DTPA, Na 2EDTA and HCl was not affected by use of soil:solution ratios 1:2 and 1:4, but the amount extracted increased with the 1:10 ratio. In this relation, the variation coefficients increased. With Mehlich, no definite tendency was observed. The increase of extraction period for DTPA extractant, in 1:2 ratio, had little effect on the amount of zinc extracted and on the precision. As to Na 2EDTA extractant in 1:10 ratio, with the increase of extraction time, both increased. As to HCl and Mehlich, both in 1:4 ratio, the increase in extraction period had no effect on the amount of zinc extracted and no definite effect on the precision. Thus, the use of 1:2 ratio for DTPA and Na 2EDTA and 1:4 ratio for acid extractants is recommended. Concerning the period of extraction, 120 min should be used with DTPA and Na 2EDTA, 15 min with HCl and 5 min with Mehlich.
Resumo:
In Brazil, plant-available micronutrients in the soil can be determined by several chemical extractants, the most common of which are dilute acid and chelating solutions. The purpose of this study was to assess the extractants 0.1 mol L-1 HCl, Mehlich-1, Mehlich-3 and DTPA for analysis of the micronutrients Cu, Zn, Fe, and Mn in soils from the state of Parana. In samples from 12 soils (0-20 cm layer), wheat was planted (Triticum aestivum), grown for 42 days after emergence, and then bean (Phaseolus vulgaris) for 38 days. At the end of each planting period, the soil was sampled again. All extractants tested to assess the availability of Cu, Zn, Fe, and Mn correlated with each other. The efficiency of the extractants HCl, Mehlich-3 and DTPA in assessing plant-available Cu was similar, unlike Mehlich-1, which proved less efficient. The extractants HCl, Mehlich-1 and Mehlich-3 were less efficient in estimating plant-available Zn and Fe, and the most indicated extractant is DTPA. The efficiency of the extractants HCl, Mehlich-1, Mehlich-3 and DTPA in assessing plant-available Mn in soils from Parana was similar.