Portable MP3 player as low-cost data logger

Non-audio signals have been recorded in the flash ROM memory of a portable MP3 player, in WAV format file, to examine the possibility of using these cheap and small instruments as general-purpose portable data loggers. A 1200-Hz FM carrier modulated by the non-audio signal has replaced the microphone signal, while using the REC operating mode of the MP3 player, which triggers the voice recording function. The signal recovery was carried out by a PLL-based FM demodulator whose input is the FM signal captured in the coil leads of the MP3 player's earphone. Sinusoidal and electrocardiogram signals have been used in the system evaluation. Although the quality of low frequency signals needs improvement, overall the results indicate the viability of the proposal. Suggestions are made for improvements and extensions of the work.

O efeito das orelhas externa e média nas emissões otoacústicas

Características como a freqüência de ressonância da orelha externa e da orelha média podem interferir na captação das emissões otoacústicas. OBJETIVO: Investigar a influência da freqüência de ressonância da orelha externa e da orelha média na resposta das emissões otoacústicas. DESENHO CIENTÍFICO: Estudo de série, prospectivo, clínico. MATERIAL E MÉTODO: Foram feitas medidas com microfone-sonda na orelha externa, timpanometria de multifreqüência e teste de emissões otoacústicas por transitório e produto de distorção em 19 orelhas direitas e 20 orelhas esquerdas de indivíduos do sexo masculino e 23 orelhas direitas e 23 orelhas esquerdas de indivíduos do sexo feminino com 17 a 30 anos. As 85 orelhas eram audiologicamente normais. RESULTADOS: Não foram observadas relações estatisticamente significantes entre a melhor freqüência de emissões otoacústicas e a freqüência de ressonância da orelha externa oclusa e da orelha média. CONCLUSÃO: Os níveis de respostas das emissões otoacústicas por transitório e produto de distorção não são influenciadas apenas pela ressonância da orelha externa e da orelha média.

Two thermal methods to measure the energy fluence of a brief exposure of diagnostic x rays

This paper describes two simple thermal methods for measuring the energy fluence in J/cm 2 from a diagnostic x-ray exposure. Both detectors absorb essentially 100% of the radiation and give a signal that is directly proportional to the energy fluence of the x-ray beam. One detector measures the thermal effect when a pulse of x rays is totally absorbed in the pyroelectric detector of lead-zirconium-titanate (PZT). The other detector measures the expansion of a gas surrounding a lead disk detector in a photoacoustic chamber. The increased pressure of the gas is transmitted through a 1-mm duct to a sensitive microphone. Both detectors have previously been used to measure the energy fluence rate of continuous x-ray beams in the same energy region using a chopped beam and a lock-in amplifier. Measurement of the energy fluence of a pulse of radiation eliminates the need for the beam chopper and lock-in amplifier and results in a simple, rugged, and inexpensive dosimeter. Either method can be combined with the area of the beam to give an estimate of the imparted energy to the patient from a diagnostic x-ray exposure.

Laser ultrasonics system for measurement of speed of sound in gases

In this work we developed a setup to measure the speed of sound in gases using a laser ultrasonics system. The mentioned setup is an all optical system composed by a Q-switched Nd:YAG laser to generate the sound waves, and a fiber optical microphone to detect them. The Nd:YAG provided a laser pulse of approximately 420 mJ energy and 9 ns of pulse width, at the wavelength of 1064 nm. The pulsed laser beam, focused by a positive lens, was used to generate an electrical breakdown (in the gas) which, in turn, generates an sound wave that traveled through a determined distance and reached the fiber optical microphone. The resulting signal was acquired in an oscilloscope and the time difference between the optical pulse and the arrival of the sound waves was used to calculate the speed of sound, since the distance was known. The system was initially tested to measure the speed of sound in air, at room pressure and temperature and it presented results in agreement with the theory, showing to be suitable to measure the speed of sound in gases. © 2012 American Institute of Physics.

Components of the acoustic swallowing signal: Preliminary study

Purpose: To analyze the components of the acoustic signal of swallowing using a specific software. Methods: Fourteen healthy subjects ranging in age from 20 to 50 years (mean age 31±10 years), were evaluated. Data collection consisted on the simultaneous capture of the swallowing audio with a microphone and of the swallowing videofluoroscopic image. The bursts of the swallowing acoustic signal were identified and their duration and the interval between them were later analyzed using a specific software, which allowed the simultaneous analyses between the acoustic wave and the videofluoroscopic image. Results: Three burst components were identified in most of the swallows evaluated. The first burst presented mean time of 87.3 milliseconds (ms) for water and 78.2 for the substance. The second burst presented mean time of 112.9 ms for water and 85.5 for the pasty substance. The mean interval between first and second burst was 82.1 ms for water and 95.3 ms for the pasty consistency, and between second and third burst was 339.8 ms for water and 322.0 ms for the pasty consistency. Conclusion: The software allowed the visualization of three bursts during the swallowing of healthy individuals, and showed that the swallowing signal in normal subjects is highly variable.

Análise da intensidade e frequencia dos ruídos articulares da articulação temporomandibular no movimento de lateralidade

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise da intensidade e frequências dos ruídos articulares da articulação temporomandibular

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Análise do fluxo sanguíneo da artéria braquial em diferentes pressões no manguito do esfigmomanômetro

Pós-graduação em Engenharia Mecânica - FEG

Análise dos Sinais dos Ruídos Articulares das Patologias Discais da Articulação Temporomandibular

Pós-graduação em Engenharia Mecânica - FEG

Comparação da análise miográfica sonora com a força muscular

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização da escrita no ciberespaço: convergências e divergências em salas de bate-papo brasileiras

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Evaluation of hearing protection used by police officers in the shooting range

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Registrador de sinais analógicos usando MP3 player portátil com entrada para voz

Neste trabalho se propôs a utilização do MP3 player portátil para gravação de sinal nãoáudio em sua memória, utilizando-se seu recurso para gravação de voz. Para avaliar a proposta, retirou-se o microfone de eletreto do MP3 player e em seu lugar injetou-se um sinal de FM, com portadora de áudio de 1200 Hz modulada pelo sinal de interesse. O sinal é gravado no aparelho em arquivo no formato WAV. Sua recuperação se fez usando um demodulador de FM a PLL cuja entrada é o sinal de FM captado nos terminais da bobina do fone de ouvido do MP3 player. Nos testes, usou-se sinal senoidal e sinal de eletrocardiograma. Embora a qualidade dos sinais de baixa freqüência precise ser melhorada, em geral os resultados apontam para a viabilidade da proposta. Fazem-se sugestões para melhorias e extensões do trabalho.

Instrumentação eletrônica para experimentação do modelo Bouncer Ball dissipativo

In our experiments, we studied the classical dynamic of a particle in vertical motion subject to a constant gravitational field and the partial shock with an elastic wall with oscillatory motion located below the particle. The motion of the particle was confined to the vertical direction by a glass guide tube, which was initially evacuated, allowing viscous drag forces to be disregarded. The time between impacts, as well as the time between the reference phase of the movement of the base and the moment of impact and the period of oscillation of the base will be acquired by a hardware and software to obtain the phases space to be compared later with the description of the system through mapping discrete variables via the 'particle velocity immediately after shock 'and' phase of the movement of the base at the instant of shock 'obtained by computer simulation. This requires developing an electronic analog system followed by Digital implemented in reconfigurable logic, more specifically a sequential machine able to discriminate the impact with the metal base from the impacts of the glass guide tube, based on the frequency spectrum of the response of the microphone to these different impacts

From acoustic waves to microwaves

We present here some results of our research related to the optoelectronics and photonics and show all the experimental setups used. Starting with a discussion on the importance of the waves, we demonstrate our achievements based on employment of acoustic, optical, and microwaves and their technological use. The results concern the acousto-optic and electro-optic effects. The generalized analysis of the electro-optic effect reveals a new high induced birefringence in lithium niobate. A patented optical fiber microphone is presented, and its applications to the measurements of acoustic wave velocity in gases and in the laser ultrasound non-destructive evaluation system are discussed. Finally, the generation of microwaves by an optical method with substantial cost reduction is presented.