Qualidade de dados fluviométricos obtidos através de perfilamento acústico

Acoustic Doppler current profilers are currently the main option for flow measurement and hydrodynamic monitoring of streams, replacing traditional methods. The spread of such equipment is mainly due to their operational advantages ranging from speed measurement to the greatest detail and amount of information generated about the hydrodynamics of hydrometric sections. As in the use of traditional methods and equipments, the use of acoustic Doppler profilers should be guided by the pursuit of data quality, since these are the basis for project and management of water resources constructions and systems. In this sense, the paper presents an analysis of measurement uncertainties of a hydrometric campaign held in Sapucaí River (Piranguinho-MG), using two different Doppler profilers - a Rio Grande ADCP 1200 kHz and a Qmetrix Qliner. 10 measurements were performed with each equipment consecutively, following the literature quality protocols, and later, a Type A uncertainty analysis (statistical analysis of several independent observations of the input under the same conditions). The measurements of the ADCP and Qliner presented, respectively, standard uncertainties of 0.679% and 0.508% compared with the averages. These results are satisfactory and acceptable when compared to references in the literature, indicating that the use of Doppler profilers is valid for expansion and upgrade of streamflow measurement networks and generation of hydrological data.

Measurement of the top quark mass in the lepton plus jets final state with the matrix element method

We present a measurement of the top quark mass with the matrix element method in the lepton+jets final state. As the energy scale for calorimeter jets represents the dominant source of systematic uncertainty, the matrix element likelihood is extended by an additional parameter, which is defined as a global multiplicative factor applied to the standard energy scale. The top quark mass is obtained from a fit that yields the combined statistical and systematic jet energy scale uncertainty. Using a data set of 0.4 fb(-1) taken with the D0 experiment at Run II of the Fermilab Tevatron Collider, the mass of the top quark is measured using topological information to be: m(top)(center dot+jets)(topo)=169.2(-7.4)(+5.0)(stat+JES)(-1.4)(+1.5)(syst) GeV, and when information about identified b jets is included: m(top)(center dot+jets)(b-tag)=170.3(-4.5)(+4.1)(stat+ JES)(-1.8)(+1.2)(syst) GeV. The measurements yield a jet energy scale consistent with the reference scale.

Measurement of the top quark mass in the dilepton channel

We present a measurement of the top quark mass in the dilepton channel based on approximately 370 pb(-1) of data collected by the DO experiment during Run R of the Fermilab Tevatron collider. We employ two different methods to extract the top quark mass. We show that both methods yield consistent results using ensemble tests of events generated with the DO Monte Carlo simulation. We combine the results from the two methods to obtain a top quark mass m(t) = 178.1 +/- 8.2 GeV. The statistical uncertainty is 6.7 GeV and the systematic uncertainty is 4.8 GeV. (c) 2007 Elsevier B.V. All rights reserved.

Precise Measurement of the Top-Quark Mass from lepton plus jets Events

We measure the mass of the top quark using top-quark pair candidate events in the lepton+jets channel from data corresponding to 1 fb(-1) of integrated luminosity collected by the D0 experiment at the Fermilab Tevatron collider. We use a likelihood technique that reduces the jet energy scale uncertainty by combining an in situ jet energy calibration with the independent constraint on the jet energy scale (JES) from the calibration derived using photon+jets and dijet samples. We find the mass of the top quark to be 171.5 +/- 1.8(stat.+JES)+/- 1.1(syst.) GeV.

Measurement of the B+ Production Cross Section in pp Collisions at root s=7 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of the B-0 Production Cross Section in pp Collisions at root s=7 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of the B-s(0) Production Cross Section with B-s(0) -> J/psi phi Decays in pp Collisions at root s=7 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of the inclusive jet cross section in p(p)over-bar collisions at root s=1.96 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of the inclusive jet cross section in pp̄ collisions at s=1.96TeV

We report on a measurement of the inclusive jet cross section in pp̄ collisions at a center-of-mass energy s=1.96TeV using data collected by the D0 experiment at the Fermilab Tevatron Collider corresponding to an integrated luminosity of 0.70fb-1. The data cover jet transverse momenta from 50 to 600 GeV and jet rapidities in the range -2.4 to 2.4. Detailed studies of correlations between systematic uncertainties in transverse momentum and rapidity are presented, and the cross section measurements are found to be in good agreement with next-to-leading order QCD calculations. © 2008 The American Physical Society.

Calibration uncertainty estimation for internal aerodynamic balance

Aerodynamic balances are employed in wind tunnels to estimate the forces and moments acting on the model under test. This paper proposes a methodology for the assessment of uncertainty in the calibration of an internal multi-component aerodynamic balance. In order to obtain a suitable model to provide aerodynamic loads from the balance sensor responses, a calibration is performed prior to the tests by applying known weights to the balance. A multivariate polynomial fitting by the least squares method is used to interpolate the calibration data points. The uncertainties of both the applied loads and the readings of the sensors are considered in the regression. The data reduction includes the estimation of the calibration coefficients, the predicted values of the load components and their corresponding uncertainties, as well as the goodness of fit.

Measurement of associated production of vector bosons and top quark-antiquark pairs in pp collisions at √s=7 TeV

The first measurement of vector-boson production associated with a top quark-antiquark pair in proton-proton collisions at √s=7 TeV is presented. The results are based on a data set corresponding to an integrated luminosity of 5.0 fb-1, recorded by the CMS detector at the LHC in 2011. The measurement is performed in two independent channels through a trilepton analysis of tt̄Z events and a same-sign dilepton analysis of tt̄V (V=W or Z) events. In the trilepton channel a direct measurement of the tt̄Z cross section σtt̄Z=0.28-0.11+0.14 (stat)-0.03+0.06 (syst) pb is obtained. In the dilepton channel a measurement of the tt̄V cross section yields σtt̄V=0.43-0.15+0.17 (stat)-0.07+0.09 (syst) pb. These measurements have a significance, respectively, of 3.3 and 3.0 standard deviations from the background hypotheses and are compatible, within uncertainties, with the corresponding next-to-leading order predictions of 0.137-0.016+0.012 and 0.306-0.053+0.031 pb. © 2013 CERN. Published by the American Physical Society.

Measurement of the Bs0→μ+μ- branching fraction and search for B0→μ+μ- with the CMS experiment

Results are presented from a search for the rare decays Bs0→μ+μ- and B0→μ+μ - in pp collisions at √s=7 and 8 TeV, with data samples corresponding to integrated luminosities of 5 and 20 fb-1, respectively, collected by the CMS experiment at the LHC. An unbinned maximum-likelihood fit to the dimuon invariant mass distribution gives a branching fraction B(Bs0→μ+μ-)=(3.0-0.9+1.0) ×10-9, where the uncertainty includes both statistical and systematic contributions. An excess of Bs0→μ+μ- events with respect to background is observed with a significance of 4.3 standard deviations. For the decay B0→μ+μ- an upper limit of B(B0→μ+μ-)<1.1×10 -9 at the 95% confidence level is determined. Both results are in agreement with the expectations from the standard model. © 2013 CERN. Published by the American Physical Society under the terms of the.

Measurement of the Upsilon(1S), Upsilon(2S), and Upsilon(3S) cross sections in pp collisions at root s=7 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of the production cross section ratio sigma(chi b2(1P))/sigma(chi b1(1P)) in pp collisions at √s=8TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)