Evaluation of Lubricating Oil Preparation Procedures for the Determination of Al, Ba, Mo, Si and V by High-Resolution Continuum Source FAAS

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Determination of Zinc in Lubricating Oil by Flame MS Employing Ultrasonic Extraction

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Characterization of lubricating oil using ultrasound

This paper presents an ultrasonic method to measure small concentrations of water in lubricating oil. It uses an ultrasonic measurement cell composed by a piezoceramic emitter (5 and 10 MHz), and a large aperture PVDF receiver that eliminates diffraction effects. The propagation velocity, attenuation coefficient and density of several samples of water-in-oil emulsion were measured. The concentrations of water of the samples were in the range of 0 to 5% in volume, and the results showed that these low concentrations can be discriminated within a resolution of 0.2% in the studied range, using the measurement of the propagation velocity.

Transient flow of the oil-refrigerant mixture through the radial clearance in rolling piston compressors

Unsteady flow of oil and refrigerant gas through radial clearance in rolling piston compressors has been modeled as a heterogeneous mixture, where the properties are determined from the species conservation transport equation coupled with momentum and energy equations. Time variations of pressure, tangential velocity of the rolling piston and radial clearance due to pump setting have been included in the mixture flow model. Those variables have been obtained by modeling the compression process, rolling piston dynamics and by using geometric characteristics of the pump, respectively. An important conclusion concerning this work is the large variation of refrigerant concentration in the oil-filled radial clearance during the compression cycle. That is particularly true for large values of mass flow rates, and for those cases the flow mixture cannot be considered as having uniform concentration. In presence of low mass flow rates homogeneous flow prevail and the mixture tend to have a uniform concentration. In general, it was observed that for calculating the refrigerant mass flow rate using the difference in refrigerant concentration between compression and suction chambers, a time average value for the gas concentration should be used at the clearance inlet.

Development and validation of an environmentally friendly attenuated total reflectance in the mid-infrared region method for the determination of ethanol content in used engine lubrication oil

Lubricating oils are crucial in the operation of automotive engines because they both reduce friction between moving parts and protect against corrosion. However, the performance of lubricant oil may be affected by contaminants, such as gasoline, diesel, ethanol, water and ethylene glycol. Although there are many standard methods and studies related to the quantification of contaminants in lubricant oil, such as gasoline and diesel oil, to the best of our knowledge, no methods have been reported for the quantification of ethanol in used Otto cycle engine lubrication oils. Therefore, this work aimed at the development and validation of a routine method based on partial least-squares multivariate analysis combined with attenuated total reflectance in the mid-infrared region to quantify ethanol content in used lubrication oil. The method was validated based on its figures of merit (using the net analyte signal) as follows: limit of detection (0.049%), limit of quantification (0.16%), accuracy (root mean square error of prediction=0.089% w/w), repeatability (0.05% w/w), fit (R 2 =0.9997), mean selectivity (0.047), sensitivity (0.011), inverse analytical sensitivity (0.016% w/w-1) and signal-to-noise ratio (max: 812.4 and min: 200.9). The results show that the proposed method can be routinely implemented for the quality control of lubricant oils. © 2013 Elsevier B.V. All rights reserved.

Detecção dos efeitos subletais da exposição a óleos lubrificantes automativos em Tilápia-do-Nilo (Oreochromis niloticus, Linneaus, 1758, Cichlidae)

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo comparativo do estresse oxidativo entre tilápias (Oreochromis niloticus) e cascudos (Pterygoplichthys anisitsi) expostos a óleo diesel e a biodiesel

Pós-graduação em Biologia Animal - IBILCE

Desenvolvimento de método analítico para determinação do teor de etanol em óleo lubrificante usado proveniente de motores ciclo Otto

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desenvolvimento de um tribômetro, tipo cilindro sob disco, para ensaios tribológicos em formulações com óleos vegetais

Pós-graduação em Engenharia Mecânica - FEIS

Rerrefino de óleo lubrificante usado

The lubricant oil used in engines of internal combustion must be, periodically, changed. Its mainly function in the engines is to reduce the friction between the pieces, but its presence also promotes the cleanness and the refrigeration of the equipment. These attributions, at the end of some cycles of operation, make the oil to be dirty, that is, full of contaminating substances such as water, gasoline, diesel, additives, oxidized hydro-carbons and rests of metals, not being recommended, therefore, its discarding in the environment. Thus, all the used lubricant oil that leaves the automobiles engine has been thrust, waiting for a solution. The pollution generated by the discarding of a ton of used oil per day in the soil or in the rivers is equivalent to a domestic sewer of 40 thousand of people. The indiscriminate burning of the used lubricant oil generates significant emissions of metallic oxides, besides other toxic gases, like the dioxin and sulphur oxides. In this context, the mean objective of this essay was to effectuate the rerrefine of the used lubricant oil, aiming the increase of its life cycle and consequently contributing for the reduction of the environmental pollution. According to the used process, it was possible to get a rerrefine oil, of good quality, which physicistchemistries properties are in compliance with the norms of NBR and ASTM

Effect of oils sources on blood lipid parameters of commercial laying hens

The experiment was carried out to verify if total cholesterol, HDL-cholesterol and triacylglicerol plasma levels are affected when laying hens are fed rations containing different dietary oil sources. One hundred sixty 50 week-old hens, assigned to four treatments with five replicates using 8 hens per replicate were used. The experimental period was of 84 days divided in 3 cycles of 28 days each. In the last day of each cycle, blood samples of 2 hens per replicate were randomly choose and blood samples were collected. on the other hand, blood was also collected at 7 am, 11 am and 3 pm aiming to study the daily changes of these lipids. Blood lipid parameters were not affected by different dietary oil sources (p > 0.05); however, HDL-cholesterol did change during the day, giving evidence that this lipid is indeed involved in the egg yolk formation.

Performance and carcass characteristics of Nellore young bulls fed different sources of oils, protected or not from rumen degradation

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Selectivity of Workers of the Grass-Cutting Ants Atta bisphaerica and Atta capiguara (Hymenoptera: Formicidae) to Vegetable Oils

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Cholesterol levels and nutritional composition of commercial layers eggs fed diets with different vegetable oils

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)