Photoluminescence in amorphous zirconium titanate

Photoluminescence at room temperature was observed in amorphous zirconium titanate obtained from the polymeric precursor method. This was the first time in which PL was noticed in an amorphous compound made of two network formers. The PL spectra could be deconvoluted into two bands, whose center 1 was located from 540 nm to 552 nm and center 2 from 625 nm to 641 nm. The co-existence of fivefold and sixfold oxygen coordination of titanium and/or zirconium could be the origin of the radiative recombination of electron-hole pairs in amorphous ZT, which may be responsible for the emission of the photoluminescence.

Epitaxial growth of LiNbO3 thin films in a microwave oven

Oriented LiNbO3 thin films were prepared using a polymeric precursor solution deposited on (0001) sapphire substrate by spin coating and crystallized in a microwave oven. Crystallization of the films was carried out in a domestic microwave oven. The influence of this type of heat treatment on the film orientation was analyzed by X-ray diffraction and electron channeling patterns, which revealed epitaxial growth of films crystallized at 550 and 650 degreesC for 10 min. A microstructural study indicated that the films treated at temperatures below 600 degreesC were homogeneous and dense, and the optical properties confirmed the good quality of these films. (C) 2003 Elsevier B.V. B.V. All rights reserved.

Foundry sand recycling in the troughs of blast furnaces: a technical note

The foundry sand agglomerated with alkaline phenolic resin, used for the manufacture of molds, was found to be a residue which is able to be recycled, minimizing the costs of disposal and the environmental impact. This paper analyzes the thermomechanical regeneration and leaching processes and also assesses the influence of additives on the improvement of the mechanical properties of the sands. Besides, the industrial experiments carried out at CSN aiming at the foundry sand recycling in the covering of the blast furnace troughs are presented. (C) 2003 Elsevier B.V. All rights reserved.

Photoluminescence in disordered Zn2TiO4

In this work, the polymeric precursor method Was used to obtain disordered Zn2TiO4 powders, either Undoped or doped with Sn4+, Cr3+ and V5+, to be applied its photoluininescent material. The characterization was undertaken by means of thermal analysis (TG and DTA), X-ray diffraction (XRD), infrared spectroscopy (IR) and photoluminescence (PL). Previous works stated that titanate octahedra containing a short Ti-O distance show efficient luminescence at roorn temperature if these octahedra are isolated from each other. In the present work, the phenomenon was observed in condensed octahedra, sharing edges. The room temperature PL noticed in undoped Zn2TiO4 had its intensity increased by the dopant addition-the increase was of about 300% for V5+ doping 400% for Cr3+ and 800% for Sn4+. (c) 2005 Elsevier B.V. All rights reserved.

Photoluminescence in amorphous TiO2-PbO systems

Photoluminescence (PL) at room temperature has been achieved in amorphous thin films and powders of the TiO2-PbO system. They were prepared by the polymeric precursor method with [PbO]/[TiO2] molar ratios ranging from 0.0 to 1.0. The energy position of maximum PL emission and the PL intensity showed dependence on Pb concentration. The Pb addition suggests an increase in the number of nonbridging oxygens (NBO) in the amorphous TiO2 network. These results support the relationship between photoluminescence and structure in TiO2-based amorphous materials.

Influence of heat treatment on the optical properties of SnO2 : Sb thin films deposited by dip coating using aqueous solution

Antimony doped tin oxide thin films were deposited on glass by a chemical route derived from Pechini method. Particular emphasis was given to the microstructure of crystallized films. Crystalline phase formation was studied by grazing incident X-ray diffraction and by thermal analyses. Scanning electron microscopy was carried out for microstructure characterization, surface roughness was observed using scanning tunneling microscope and the optical transmittance measurements were performed in the wavelength range of 200-800 nm. (C) 2002 Kluwer Academic Publishers.

Structural and ferroelectric properties of Pb1-xSrxTiO3 thin films

Strontium-modified lead titanate (PST) thin films with composition Pb1-xSrxTiO3 (0.10 < x &LE; 0.60) were grown on Pt/Ti/SiO2/Si substrates using a soft chemical process. The crystallization of the PST thin films was achieved by heat treatment at 600&DEG;C. The structural and microstructural modifications in the films were studied using X-ray diffraction (XRD) and atomic force microscopy, respectively. The XRD study shows that the lattice parameters of polycrystalline PST thin films calculated from X-ray data indicate a decrease in lattice tetragonality with the increase in strontium content in these films. This indicates a gradual change from tetragonal to cubic structure. By atomic force microscopy analysis, the average grain size of the thin films was systematically reduced with the increase in Sr content. The dielectric property of the thin films was found to be strongly dependent on the Sr concentration. With 60 at.% Sr content, a ferroelectric to paraelectric phase transition was observed at room temperature.

Microstructural and optical characterization of CaWO4 and SrWO4 thin films prepared by a chemical solution method

Stoichiometric CaWO4 and SrWO4 thin films were synthesized using a chemical solution processing, the so-called polymeric precursor method. In this soft chemical method, soluble precursors such as strontium carbonate, calcium carbonate and tungstic acid, as starting materials, were mixed in an aqueous solution. The thin films were deposited on glass substrates by means of the spinning technique. The surface morphology and crystal structure of the thin films were investigated using X-ray diffraction (XRD), scanning electron microscopy (SEM), and atomic force microscopy (AFM). Nucleation stages and surface morphology evolution of the thin films on glass substrates were studied by atomic force microscopy. The films nucleate at 300 degreesC, after the coalescence of small nuclei into larger grains yielding a homogeneous dense surface. XRD characterization of these films showed that the CaWO4 and SrWO4 phases crystallize at 400 degreesC from an inorganic amorphous phase. No intermediate crystalline phase was identified. The optical properties were also studied. It was found that CaWO4 and SrWO4 thin films have an optical band gap, E-gap=5.27 and 5.78 eV, respectively, of a direct transition nature. The excellent microstructural quality and chemical homogeneity confirmed that this soft solution processing provides an inexpensive and environmentally friendly route for the preparation of CaWO4 and SrWO4 thin films. (C) 2003 Elsevier B.V. All rights reserved.

Fenótipo Lewis negativo: potencial fator de risco para infecção por cepa RH de Toxoplasma gondii em gestantes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Variação da ocorrência da rinotraqueíte infecciosa bovina pela associação com a diarréia viral bovina e a leucose enzoótica bovina

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Geomorfologia do baixo curso do rio Ivinhema, MS: uma abordagem morfogenética e morfoestrutural

Pós-graduação em Geociências e Meio Ambiente - IGCE

Le(a-b-) phenotype: potential risk factor for infection by the RH strain of Toxoplasma gondii in pregnancy

The Lewis histo-blood group system is characterized by the expression of the Lea and Le(b) antigens in the gastrointestinal tract, whose synthesis results in interactions between alpha 2-L-fucosyltransferase (FUTII) and alpha 3/4-L-fucosyltransferase (FUTIII) enzymes coded by the FUT2 (19q. 13.3) and FUT3 (19p13.3) genes. FUTII and FUTIII fucosylate the type 1 oligosaccharide precursor (Gal beta 1 -> 3NAcGlc beta 1 -> 3-R) at distinct positions to form H type 1 (Fuc alpha 1. 2Gal beta 1. 3NAcGlc beta 1 -> 3-R) and Le(a) (Gal beta 1 -> 3[Fuc alpha 1 -> 4] NAcGlc beta 1 -> 3-R) antigens, respectively. The fucosylation of H type 1 antigens by FUTIII results in the Leb antigen (Fuc alpha 1. 2Gal beta 1. 3[Fuca1. 4] NAcGlc beta 1. 3-R). Thus, the presence of the FUTII and FUTIII enzymes leads to the expression of the Le(a+b+) phenotype, while the presence of only FUTIII allows the expression of the Le(a+b-) phenotype. The absence of the FUTIII enzyme leads to the expression of the Le(a-b-) phenotype, independent of the presence or absence of FUTII. Point mutations in FUT2 and FUT3 genes change the activity of these enzymes, impair the synthesis of Le(a) and Le(b) antigens, and contribute to the variability of Lewis phenotypes in the gastrointestinal tract. Toxoplasma gondii, an apicomplexan parasite that infects a large proportion of the world's population, utilizes the gastrointestinal tract as an infection route and seems to adhere to glycosylated molecules to invade human cells. These apparently independent events may be related. The aim of this study was to test the hypothesis that there is an association between the Lewis histo-blood group system and infection by T. gondii. Two hundred and nine serum samples collected from pregnant women were submitted to screening tests to detect anti-T. gondii antibodies, employing the indirect hemagglutination method. ELISA was utilized to identify IgG class anti-T. gondii antibodies specific for the RH strain. A hundred and ninety-five samples with concordant results for both methods were selected to form two groups: seropositive (G1) and seronegative (G2). The G428A mutation of the FUT2 gene, and T202C and C314T of the FUT3 gene, which allow inference of the gastrointestinal tract Lewis phenotypes, were identified using PCR-RFLP and PCR-SSP methods, respectively. Among the 195 samples selected, 116 (59.5%) were seropositive and 79 (40.5%) were seronegative. In G1, 68 (58.6%) were classified as Le(a+b+), 30 (25.9%) as Le(a+b-), and 18 (15.5%) as Le(a-b-), and in G2, 67 (84.8%) were classified as Le(a+b+), 12 (15.2%) as Le(a+b-), and 0 (0%) as Le(a-b-) (P < 0.0001). The Le(a-b-) phenotype is associated with a high risk of RH strain T. gondii infection when compared with the Le(a+b+) [P = 0.0001; OR = 36,460; 95%CI = 2.152-617,680] and Le(a+b-) phenotypes [P = 0.0118; OR = 15,165; 95%CI = 0.8463-271,710]. The Le(a+b-) phenotype showed a higher risk compared to the Le(a+b+) phenotype [P = 0.0206; OR = 2463; 95%CI = 2463-5214]. The results suggest that the Le(a-b-) phenotype is strongly associated with a greater risk of infection by the RH strain of T. gondii compared to the other phenotypes. It is possible that the absence of fucosylation of the type 1 oligosaccharide precursor as well as the variations in the structures of the Le(a) and Le(b) antigens influence susceptibility to infection by this parasite.