Clinical Viability for Immediate Loading of Dental Implants: Part II-Treatment Alternatives

The treatment with implants aims to obtain a direct interface between bone and implant. The implant is kept load-free during 4 to 6 months in the 2-stage procedure, which is considered a requisite for osseointegration. However, this period is based on empirical principles and uncomfortable for patient. So, the immediate loading protocol was Suggested to submit implants to occlusal function after placement. This protocol has been applied for several conditions of edentulism. The aim of this study was to evaluate the treatment alternatives for immediate loading of complete and partial edentulous patients. In general, the studies have demonstrated high previsibility for rehabilitation of complete edentulous arches with full-arch, implant-supported prosthesis. The rehabilitation with immediate loading for maxillary overdenture is questionable because there is no longitudinal study in literature. The studies with partial edentulous arches have demonstrated high success rates for implants placed in the mandibular and maxillary anterior region. Additional care is recommended for posterior region mainly in the maxillary arch, and further studies are suggested to corroborate this treatment.

Cr3C2-NiCr and WC-Ni thermal spray coatings as alternatives to hard chromium for erosion-corrosion resistance

Cr3C2-NiCr and WC-Ni coatings are widely used for wear applications at high and room temperature, respectively. Due to the high corrosion resistance of NiCr binder, Cr3C2-NiCr coatings are also used in corrosive environments. The application of WC-Ni coatings in corrosive media is 14 not recommended due to the poor corrosion resistance of the (pure Ni) metallic matrix. It is well known that the addition of Cr to the metallic binder improves the corrosion properties. Erosion-corrosion performance of thermal spray coatings is widely influenced by ceramic phase composition, the size of ceramic particles and also the composition of the metallic binder. In the present work, two types of HVOF thermal spray coatings (Cr3C2-NiCr and WC-Ni) obtained with different spray conditions were studied and compared with conventional micro-cracked hard chromium coatings. Both as-sprayed and polished samples were tested under two erosion-corrosion conditions with different erosivity. Tungsten carbide coatings showed better performance under the most erosive condition, while chromium carbide coatings were superior under less erosive conditions. Some of the tungsten carbide coatings and hard chromium showed similar erosion-corrosion behaviour under more and less erosive conditions. The erosion-corrosion and electrochemical results showed that surface polishing improved the erosion-corrosion properties of the thermally sprayed coatings. The corrosion behaviour of the different coatings has been compared using Electrochemical Impedance Spectroscopy (EIS) and polarization curves. Total material loss due to erosion-corrosion was determined by weight loss measurements. An estimation of the corrosion contribution to the total weight loss was also given. (c) 2007 Elsevier B.V. All rights reserved.

Alternatives Panels from Waste Plastics Reinforced With Fibers of Pupunha Palm for Use in Civil Construction and Furniture Industry

In order to cooperate in minimizing the problems of the current and growing volume of waste, this work aims at the production of panels made from industrial waste -thermoplastic (Polypropylene - PP; Polyethylene - PE and Acrylonitrile Butadiene Styrene - ABS) reinforced with agro-industrial waste - pupunha palm waste (shells and sheaths). The properties of the panels were evaluated: density, thickness swelling, water absorption and moisture content. It was used the ASTM D1037; EN 317; and ANSI A208.1 standards regarding particle boards. The best results in physical tests were treatments 1 (100% waste plastic), 6 (60% plastic waste and 40% waste of pupunha) and 7 (70% waste plastic and 30% waste of pupunha). The best results in the mechanical tests were treatments 3 (30% de residuos plasticos e 70% de residuos da pupunha), 4 (40% de residuos plasticos c 60% de residuos da pupunha) and 5 (50% de residuos plasticos e 50% de residuos da pupunha). For mechanical tests it was concluded that the results of modulus of rupture and of modulus of elasticity the best treatments were those with more fibers. In the tensile tests perpendicular to the surface, it is clear that using more waste plastics leads to the best results. It was concluded that the waste can be used as raw material for the production of alternative materials mainly in civil construction and furniture industries, and it can be employed in urban or rural environment, given the concept of eco-efficient products.

Alternatives for the Treatment of Schistosomiasis: Physico-Chemical Characterization of an Inclusion Complex Between Praziquantel and Hydroxypropyl-beta-Cyclodextrin

"Alternatives for the Treatment of Schistosomiasis: Physico-Chemical Characterization of an Inclusion Complex Between Praziquantel and Hydroxypropyl-beta-Cyclodextrin". Praziquantel (PZQ) is the drug of choice commonly used for the treatment of shistosomiasis. However, it has low aqueous solubility, which could limit its bioavailability in the body. To circumvent these features, an inclusion complex with hydroxypropyl-beta-cyclodextrin (HP-beta-CD) was prepared. Thus, the objective of this work was to prepare and characterize the PZQ/HP-beta-CD inclusion complex. Morphological, spectroscopic, and calorimetric analysis showed the first signs of the guest/host interaction. The complexation kinetic analysis was used to determine the kinetic constant and, besides that, it was possible to establish the time consumed to reach equilibrium. Using the solubility isotherm, it was observed that the interaction with HP-beta-CD increased 2.4 fold the aqueous solubility of plain PZQ. In vitro cytotoxicity tests, using fibroblast cells, evidenced no toxicity for these cells at the concentrations tested. These results demonstrated that there is a potential use of PZQ in formulations with HP-beta-CD.

The no-tillage system and cover crops-Alternatives to increase upland rice yields

Upland rice (Oryza sativa L.) cultivation has been increasing in importance in Asia while water availability for irrigation has been decreasing because of rapid growth in industry and urban centers. Therefore, the development of technologies that increase upland rice yields under aerobic conditions, thereby saving water, would be an effective strategy to avoid a decrease in global rice grain production. The use of the no-tillage system (NTS) and cover crops that maintain soil moisture would prove advantageous in the move toward sustainable agriculture. However, upland rice develops better in plowed soil, and it has been reported that this crop does not perform well under the NTS. Therefore, the aim of this study was to investigate the effect of cover crops on upland rice grain yield and yield components sowed in a NTS. A field experiment was conducted during two growing seasons (2008-2009 and 2009-2010), and treatments consisted of growing rice under five cover crops in a NTS and two control treatments under the conventional tillage system (plowing once and disking twice). Treatments were carried out in a randomized block design with three replications. Our findings are as follows: On average, Brachiaria brizantha (12.32Mgha-1), Brachiaria ruziziensis (11.08Mgha-1) and Panicum maximum (11.62Mgha-1) had outstanding biomass production; however, these grasses provided the worst upland rice yields (2.30, 2.04, and 2.67Mgha-1, respectively) and are not recommended as cover crops before upland rice. Millet and fallow exhibited the fastest straw degradation (half-lives of 52 and 54 days, respectively), and millet exhibited the fastest nitrogen release (N half-life of 28 days). The use of a NTS was promising when millet was used as a cover crop; this allowed the highest upland rice yield (3.94Mgha-1) and did not statistically differ from plowed fallow (3.52Mgha-1). © 2012 Elsevier B.V.

Cryptococcosis: epidemiology, fungal resistance, and new alternatives for treatment

Cryptococcosis is an important systemic mycosis and the third most prevalent disease in human immunodeficiency virus (HIV)-positive individuals. The incidence of cryptococcosis is high among the 25 million people with HIV/acquired immunodeficiency syndrome (AIDS), with recent estimates indicating that there are one million cases of cryptococcal meningitis globally per year in AIDS patients. In Cryptococcus neoformans, resistance to azoles may be associated with alterations in the target enzyme encoded by the gene ERG11, lanosterol 14α-demethylase. These alterations are obtained through mutations, or by overexpressing the gene encoding. In addition, C. gattii and C. neoformans present a heteroresistance phenotype, which may be related to increased virulence. Other species beyond C. neoformans and C. gattii, such as C. laurentii, have been diagnosed mainly in patients with immunosuppression. Infections of C. albidus have been isolated in cats and marine mammals. Recent evidence suggests that the majority of infections produced by this pathogen are associated with biofilm growth, which is also related with increased resistance to antifungal agents. Therefore, there is a great need to search for alternative antifungal agents for these fungi. The search for new molecules is currently occurring from nanoparticle drugs of plant peptide origin. This article presents a brief review of the literature regarding the epidemiology of cryptococcosis, as well as fungal resistance and new alternatives for treatment. © 2013 Springer-Verlag Berlin Heidelberg.

Isolate((R)) and Optiprep((R)) minigradients as alternatives for sperm selection in bovine in vitro embryo production

The objective of this study was to evaluate alternatives in small volumes to conventional gradient of Percoll((R)) on semen quality, in vitro embryo production, sex ratio and embryo survival after vitrification. Thawed semen was randomly allocated to one of four density gradient selection methods: (1) conventional Percoll((R)) (P), (2) MiniPercoll (MP), (3) MiniIsolate (MI), and (4) MiniOptiprep (MO). Sperm kinetics and quality were evaluated. Use of P, MP and MI gradients did not affect sperm motility (P > 0.05). However, there was a decrease in total and progressive sperm motility in MO (70.8 and 51.3% vs. 87.3 and 69.5% for P; 87.3 and 73% for MP; 92.3 and 78.8% for MI; P < 0.05). The MO had lower membrane integrity compared with P, MP and MI (39.7 vs. 70.5, 72.3, 63.8%, respectively, P < 0.05). The percentage of blastocysts produced was higher in MI than in MP and MO (21.1 vs. 16.1 and 16.9%, P < 0.05) and similar to P (18.4%; P > 0.05). Sex ratio and embryo survival after vitrification were similar among groups (P > 0.05). Semen selected by Isolate and Optiprep gradient, at the concentrations and small volumes used, demonstrated similar characteristics and in vitro embryo production to conventional Percoll((R)) gradient.

Site Selection for Restoration Planning: A Protocol With Landscape and Legislation Based Alternatives

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Critical discourses on resilience: exploring alternatives strategies used by young people at-risk

The concept of resilience is often situated in a dominant discourse that reflects medical and developmentalist epistemology, in Western models, with the ideology of white people, and middle class hegemonic norms. Behavior that falls outside of the normal, or what is socially acceptable, is associated with riskiness and tacitly if not explicitly labeled as pathological, and then, not resilient. However, the context of social injustice of many young people at-risk can have drastic effects on them. When we offer institutions such as schools that do not understand their needs, they may refuse our services and some of them may engage in antisocial activities, since they are looking for personal validation, pathways to recognize themselves, and places and organizations that contribute to the building of their social identity. This paper analyses how the denial of support and resources for the wellbeing of young people can lead them to situations that are socially unacceptable, such as sexual exploitation and drug trafficking. The main argument is that these activities, in the absence of conventional mechanisms, may bring some benefit to the subjects. Benefits may be in material conditions, though strongly marked by issues of social inequality; or subjective, in gaining relationships with people outside the normative places and institutions for young people. Unconventional circumstances produce unconventional attitudes that are expressed in alternative forms of resilience.