Baroreflex control of heart rate in the broad-nosed caiman Caiman latirostris is temperature dependent

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Sensibilidade de Metarhizium anisopliae à temperatura e umidade em três tipos de solos

Este trabalho teve como objetivo investigar o efeito da temperatura e do teor de umidade do solo na sobrevivência de Metarhizium anisopliae (Metsch.) Sorok. em três tipos de solos. Foram utilizados o Latossolo Vermelho textura argilosa, Latossolo Vermelho textura média e Argissolo Vermelho Amarelo textura arenosa média. As temperaturas empregadas foram 21,5; 26,8 e 31,5°C, e os teores de umidade foram 35, 65 e 100% de saturação. A sobrevivência do fungo foi avaliada após zero, 20, 40, 60, 80, 100 e 120 dias de incubação em cada temperatura estudada. Na análise do efeito do teor de umidade, a sobrevivência foi avaliada após zero, 14, 28, 42, 56, 70, 84, 98 e 112 dias de incubação à temperatura de 27,0±1,0°C. em ambos os ensaios, foi determinado o número de unidades formadores de colônias (UFC) em placa de Petri. Houve influência significativa da temperatura e do teor de umidade na sobrevivência do fungo. O maior crescimento e a maior sobrevivência ocorreram nas temperaturas de 21,5 e 26,8°C, enquanto que, no solo incubado a 31,5°C, o fungo cresceu pouco, e a população declinou rapidamente. No teor de 65% de umidade, houve rápido crescimento do fungo, mas no 112° dia foi observado um declínio da população nos três tipos de solos. Nos teores de 35 e 100% de umidade, o crescimento foi menor, mas obteve-se maior sobrevivência do fungo no solo.

Continuous ethanol production in a nonconventional five-stage system operating with yeast cell recycling at elevated temperatures

Three ranges of increasing temperatures (35-43, 37-45, 39-47degreesC) were sequentially applied to a five-stage system continuously operated with cell recycling so that differences of 2degreesC (between one reactor to the next) and 8degreesC (between the first reactor at the highest temperature and the fifth at the lowest temperature) were kept among the reactors for each temperature range. The entire system was fed through the first reactor. The lowest values of biomass and viability were obtained for reactor R-3 located in the middle of the system. The highest yield of biomass was obtained in the effluent when the system was operated at 35-43degreesC. This nonconventional system was set up to simulate the local fluctuations in temperature and nutrient concentrations that occur in different regions of the medium in an industrial bioreactor for fuel ethanol production mainly in tropical climates. Minimized cell death and continuous sugar utilization were observed at temperatures normally considered too high for Saccharomyces cerevisiae fermentations.

SECAGEM DE SEMENTES DE SOJA em SILO COM DISTRIBUIÇÃO RADIAL do FLUXO DE AR: II. EFEITOS SOBRE A QUALIDADE DAS SEMENTES

O trabalho avaliou, em sementes de soja, as conseqüências qualitativas provenientes da secagem estacionária com distribuição radial de ar, variando o fluxo (26,9, 28,4 e 33,2 m³/minuto/t) e a temperatura do ar insuflado (42, 46 e 50ºC), considerando a posição das sementes na massa (17, 34 e 51 cm em relação ao cilindro de insuflação) e o tempo de secagem (0 a 12 horas, com intervalos de quatro horas). Para tanto, além das determinações das temperaturas e dos teores de água da massa, foi avaliado o desempenho fisiológico das sementes no início e ao final de seis meses de armazenamento. Apesar das vantagens físicas operacionais resultantes da combinação entre o fluxo e a temperatura intermediários (28,4 m³/minuto/t e 46ºC), a qualidade fisiológica foi menos prejudicada nas combinações dos menores fluxos (26,9 e 28,4 m³/minuto/t) com a maior temperatura (50ºC) e do maior fluxo (33,2 m³/minuto/t) com as menores temperaturas (42 e 46ºC); entre estas, levando em conta os aspectos físico-operacionais, a associação de 28,4 m³/minuto/t com 50ºC foi a mais eficiente na retirada de água das sementes. Assim, admitindo os intervalos de fluxo (26,9 a 33,2 m³/minuto/t) e de temperatura (42 a 50ºC) estudados, conclui-se que a elevação na temperatura demanda redução no fluxo e, inversamente, o aumento no fluxo demanda redução na temperatura.

Produção de snacks extrusados à base de polvilho doce e fibra de laranja

Este trabalho teve por objetivo avaliar o efeito da umidade, temperatura de extrusão e rotação da rosca na produção de produtos extrusados expandidos com a utilização do polvilho doce e da polpa de laranja desidratada como matéria-prima. O processo seguiu delineamento central composto rotacional com três fatores, totalizando 15 tratamentos (oito pontos fatoriais, seis pontos axiais e um ponto central com seis repetições). Os produtos obtidos foram caracterizados quanto ao índice de expansão (IE), ao volume específico (VE), ao índice de solubilidade em água (ISA) e à cor (L*, a* e b*). Os resultados mostraram efeito das condições operacionais do processo sobre as características físicas dos produtos, e produtos claros com maior expansão e menor solubilidade em água foram obtidos nas condições mais elevadas de temperatura (80-90°C), condições intermediárias de umidade (16%) e rotação da rosca (218rpm).

Potential use of the veris apparent EC sensor to predict soil texture under the semi-arid conditions of central Arizona

The operational details of the apparent electrical conductivity (ECa) sensor manufactured by Veris Technologies have been extensively documented in literature reports, but the geographical distribution of these research studies indicate a strong regional concentration in the US Mid-west and Southern states. The agricultural lands of these states diverge significantly to the soil conditions and water regime of irrigated land in the US South-western states such as Arizona where there is no previous research reports of the use of this particular sensor. The objectives of the present study were to analyze the performance of this sensor under the conditions of typical soils in irrigated farms of Central Arizona. We tested under static conditions the performance of the sensor on three soils of contrasting texture. Observations were collected as time series data as soil moisture changed from saturation to permanent wilting point. Observations were repeated at the hours of lowest and highest temperatures. In addition, this study included soil penetration resistance and salinity determinations. Preliminary results indicate that soil temperature of the upper layer caused the most dynamic change in the sensor output. The ECa curves of the three soil textures tested had well defined distinctive characteristics. Final multivariate analysis is pending.

Fluoride concentration in public water supply: 72 months of analysis

Known as one of the ten most important advances on Public Health in the 20th century, fluoridation of public water supply is a measure of wide population coverage, which is effective on caries control. The city of Araçatuba, in the Northwest region of the São Paulo state, Brazil, started public water supply fluoridation in 1972 and, based on the average annual highest temperature, has kept the fluoride concentration between 0.6 to 0.8 mgF/L. The purpose of this study was to analyze monthly the fluoride concentration in public water supply in the city of Araçatuba during 72 months. Water samples were collected monthly on weekdays, directly from the water distribution network, on pre-established locations and analyzed in duplicate between November 2004 and October 2010 at the Research Laboratory of the Nucleus for Public Health (NEPESCO) of the Public Health Graduate Program from Araçatuba Dental School/UNESP, Brazil, using an fluoride-specific electrode connected to an ion analyzer. From the total of samples (n=591), 67.2% (n=397) presented fluoride concentration between 0.6 and 0.8 mgF/L; 20.6% (n=122) below 0.6 mgF/L; 11.5% (n=68) between 0.8 and 1.2 mgF/L and 0.7% (n=4) above 1.2 mgF/L. Most samples showed fluoride levels within the recommended parameters. Minimal variation was observed among the analyzed collection locations, showing that the city has been able to control the fluoride levels in the public water supply and reinforcing the importance of surveillance and constant monitoring to assure the quality of the water delivered to the population.

Efeito de métodos de preservação dos grãos úmidos de milho e de sorgo sobre a estrutura do endosperma, dos grânulos de amido e desempenho de leitões

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Reação exotérmica e expansões de presa e térmica de revestimentos frente às técnicas de fundição convencional e rápida

Pós-graduação em Odontologia - FOA

Análise isotópica (delta 15N), produtividade e composição química do capim-marandu adubado com uréia e cama de frango

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação do comportamento da temperatura na massa deresíduos com diferentes tempos de disposição no aterro sanitário de Rio Claro - SP

The present work investigates solid waste temperature behavior in different depths in two cells in the Rio Claro-SP city’s sanitary landfill. One of the cells is in operation with waste disposal beginning about one year ago. The other one is located in an closed area and contain waste disposed from five to seven years before. Measures were also made in an area that have no disposed waste in order to collect reference values. The data were obtained every fifteen days. The temperature results shows higher values in the operating cell, with maximum 38,1 °C in a depth of 4,0 m. In the closed cell the highest values were 36,3 °C in a depth of 8,5 m. The highest temperature values were obtained in the operating cell due to wider substract availability that indicates a more intense biological degradation activity. With three meters depth, the temperature results were 36,6 °C in the operating cell, 33,8 °C in the closed cell and 24,5 °C in the reference area. Therefore the temperature can be used as a biological activity indicator in sanitary landfills, supporting biogas studies

Comportamento da temperatura da massa de resíduos aterrados em um aterro sanitário

In this paper we investigate the temperature variation of the mass of waste along the depth in a household waste landfill of Rio Claro - SP, São Paulo, having a climate characterized as Tropical Altitude. In this research, there were two holes in two distinct points of the landfill, with different depths and characteristics in order to fix several thermal sensors - RTDs - to record the temperature at predetermined depths. Overall, the results show the influence of temperature at depths of up to 3.0 meters (from the surface) and that it varies in a manner to stabilize at depths above 5.0 meters. The highest temperature obtained was approximately 37.5 ° C for a time of waste disposal of 7 to 10 years. The results showed the presence of organic matter (substrate) which resulted in elevated temperature resulting from biological activity

Fluoretação das águas de abastecimento público no município de Araçatuba/SP

Fundação de Amparo a Pesquisa do Estado de São Paulo (FAPESP)

Effects of the spermatozoa: oocyte ratio, water volume and water temperature on artificial fertilization and sperm activation of cascudo-preto

The objective of this study was to evaluate the effects of water volume and water temperature on the sperm motility duration and the number of spermatozoa, and the water volume on the fertilization rates of oocytes of Rhinelepis aspera. Experiments were carried out to evaluate the effect of semen dilutions (1.74×10-5, 1.74×10-4, 1.74×10-3, 1.74×10-2, 1.74×10-1 and 1.00 mL of sperm.mL-1 of water) and water temperature (5, 10, 15, 20, 25, 30, 35, 40, 45, and 50 ºC) on spermatozoa motility duration. In addition, the effects of insemination dose (7×10³, 7×10(4), 7×10(5), 7×10(6) and 7×10(7) spermatozoa.oocyte-1) and water volume (1.0, 30.0, 60.0, 90.0 and 120.0 mL water.2.0 mL-1 oocytes) on the artificial fertilization rates of oocytes were evaluated. The longest sperm motility duration were observed for the semen dilution of 1.74×10-5 mL semen.mL-1 water and in water at 5 ºC. The highest fertilization rates were obtained for insemination doses between 7.00×10³ and 1.23×10(7) spermatozoa. oocyte-1 and water volume of 28.11 mL water.2.0 mL-1 oocytes.

Effect of temperature on incubation period, embryonic mortality, hatch rate, egg water loss and partridge chick weight (Rhynchotus rufescens)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)