Effects of the high temperature plasma immersion ion implantation (PIII) of nitrogen in AISI H13 steel

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effects of the high-temperature plasma immersion ion-implantation treatment on corrosion behavior of Ti-6Al1-4V

Nitrogen implantation into Ti alloys at higher temperatures improves their mechanical and corrosion resistance properties by forming a thicker nitride layer. In this paper, two different sets of Ti-6Al-4V samples were plasma immersion ion implantation (PIII)-treated using nitrogen plasma, varying the treatment time from 30 to 150 min (800 degrees C) and the process temperature from 400 degrees C to 800 degrees C (t = 60 min). Nanoindentation measurements of the PIII-treated samples at 800 C during 150 min showed the highest hardness value, 24 GPa, which is about four times bigger than untreated sample hardness. The N penetration at these conditions reached approximately 150 nm as analyzed by Auger spectroscopy. on the other hand, the lowest passive current density (3 x 10(-7) A. cm(-2)) was obtained for a PIII-treated sample during 30 min at higher temperature (800 degrees C). The corrosion resistance of this sample is almost the same as for the untreated specimen. Corrosion behavior evidenced that in strong oxidizing media, all PIII-treated samples are more corrosion resistant than the untreated one. PIII processing at higher temperatures promotes smoothing of the sample surface as observed by scanning electron microscopy (SEM). Grazing incidence X-ray diffraction analyses of the untreated samples identified the two typical Ti phases, Ti alpha and Ti beta. After the implantation, Ti2N and TiO2 phases were also detected.

Effects of high temperature plasma immersion ion implantation on wear resistance of Ti-Si-B sintered alloys

Although titanium and its alloys own good mechanical properties and excellent corrosion resistance, these materials present poor tribological properties for specific applications that require wear resistance. In order to produce wear-resistant surfaces, this work is aimed at achieving improvement of wear characteristics in Ti-Si-B alloys by means of high temperature nitrogen plasma immersion ion implantation (PIII). These alloys were produced by powder metallurgy using high energy ball milling and hot pressing. Scanning electron microscopy (SEM) and X-ray diffraction identified the presence of α-titanium, Ti6Si2B, Ti5Si3, TiB and Ti3Si phases. Wear tests were carried out with a ball-on-disk tribometer to evaluate the friction coefficient and wear rate in treated and untreated samples. The worn profiles were measured by visible light microscopy and examined by SEM in order to determine the wear rates and wear mechanisms. Ti-7.5Si-22.5B alloy presented the highest wear resistance amongst the untreated alloys produced in this work. High temperature PIII was effective to reduce the wear rate and friction coefficient of all the Ti-Si-B sintered alloys. © 2013 Elsevier B.V.

Incubation and rearing temperature effects on Hsp70 levels and heat stress response in broilers

Incubation temperature (IT) was changed to evaluate if 6-wk-old birds become more tolerant to heat stress. After 13 d of incubation, 470 eggs were submitted to low (36.8degreesC), normal (37.8degreesC) and high (38.8degreesC) temperatures. At day 7 post-hatching, 144 birds were allocated to three rearing temperatures (48 birds/treatment): control/thermoneutral (35-24degreesC), high (33-30degreesC) or low (27-18degreesC) according to the age of the birds. Hsp70 levels in tissues of birds (1 d and 42 d), stress response (42 d) and performance were evaluated. High IT decreased brain (P < 0.01) and liver (P < 0.01) Hsp70 levels, whereas low IT decreased brain (P < 0.01) but increased heart (P < 0.01) Hsp70 levels in 1-d-old chicks. Birds incubated at a low temperature had higher (P < 0.05) feed intake (1-42d). High rearing temperature decreased feed intake (P<0.01) and liveweight (P<0.01). Colonic temperature was lower in birds incubated at a low temperature (P < 0.05) and higher in birds reared in a high temperature (P < 0.05) before heat stress. Birds reared in low temperature had higher increase in colonic temperature after heat stress (P < 0.05). Tissue Hsp70 levels were differently affected by rearing temperature, which affected broiler performance more than IT. Lower IT seemed to increase the sensitivity of birds to heat stress at market age.

Protein levels and environmental temperature effects on carcass characteristics, performance, and nitrogen excretion of broiler chickens from 7 to 21 days of age

This trial was conducted to evaluate the utilization of low-protein diets formulated based on the ideal protein concept for broiler chickens from 7 to 21 days of age reared at different environmental temperatures. Nine hundred male Cobb-500® chickens were used. At day seven chicks were distributed according to a completely randomized design in a 3 x 3 factorial with four replications of 25 birds each. It was used three crude protein levels in the diet (21.5; 20.0 and 18.5%) and three environmental temperatures (low, thermoneutral and high). The performance, carcass characteristics (yield and chemical composition), and nitrogen ingestion and excretion were assessed. There was no significant interaction among the factors for the evaluated variables. Environmental temperatures affected differently chicken performance. High environmental temperature resulted in lower weight gain and higher wing fat percentage, whereas cold temperature resulted in higher feed conversion. on the other hand, low-protein diets decreased weight gain, breast yield, nitrogen excretion and influenced breast and wings chemical composition. Birds reared at high environmental temperature showed lower nitrogen intake and excretion. The results showed that the decrease in protein levels from 7 to 21 days of age contributed to lower nitrogen excretion in broiler chickens, but impaired performance and carcass characteristics independent of rearing temperature.

High temperature X-ray diffraction study of the U4O9 formation on UO2 sintered plates

The surface oxidation of UO2 sintered plates at 170-275 ° C was studied in situ by high temperature X-ray diffractometry. At very low oxygen concentration, UO2 is oxidized to U4O9, while at 300°C and argon-20 vol% oxygen it is oxidized up to U3O7. X-ray diffraction profiles of the UO2, U4O9 and U3O7 phases were well characterized during the transformations. The activation energy for the transformation of UO2 to U4O9, obtained from X-ray diffraction data, was found to be 117 ± 9 kJ/mol and 90 ± 14 kJ/mol for the β-(311) and α-(200) reflections, respectively. © 1991.

Heating rate and temperature effects on the BaTiO3 formation by thermal decomposition of (Ba,Ti) organic precursors during the Pechini process

Different thermal treatments for the synthesis of BaTiO3 powder obtained through the Pechini method were studied. The synthesis of BaTiO3 starts at 150 °C by the thermal dehydration of organic precursors. The usual inevitable formation of barium carbonate during the thermal decomposition of the precursor could be retarded at lower calcination temperatures and optimized heating rates. The organic precursors were treated at temperatures between 200 and 400 °C. Then, the samples were calcined at 700 and 800 °C for 4 and 2 h, respectively. The resulting ceramic powders were characterized by gravimetric and differential thermal analyses, X-ray powder diffraction and infrared spectroscopy. It was found that depending on the heating rate and final temperature of the thermal treatment, high amounts of BaCO3 and TiO2 could be present due to the high concentration of organics in the final calcination step. © 2007 Elsevier B.V. All rights reserved.

Temperature effects on baroreflex control of heart rate in the toad, Rhinella schneideri

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Substrate and Temperature Effects on the Germination of Dypsis leptocheilos (Hodel) Beentje & J. Dransf. (Arecaceae) Seeds

Dypsis leptocheilos is highly valued as an ornamental palm. Its propagation is done by seeds; however, there is little information about this process. The objective of this work was to study the substrate and temperature effects on the germination of D. leptocheilos seeds. The experiments were carried out at FCAV/UNESP, Campus of Jaboticabal, São Paulo State, Brazil. In order to study the substrate effects, four treatments were arranged (coconut fiber, sand, vermiculite and Plantmax (R)) at 30 degrees C. For the temperature effects, six treatments were performed (temperature at laboratory conditions (21.5 degrees C and 72% RU), 25 degrees C, 30 degrees C, 35 degrees C, 20-30 degrees C and 25-35 degrees C), having the coconut fiber as the substrate. The experimental design was completely randomized, with four replicates of 25 disseminules per plot (seeds with attached endocarp). Water replacement was managed to maintain 100% of the retention capacity of the substrates. The germination tests were observed every two days, and conducted over 148 days for the substrate effects, and over 152 days for the temperature effects, when no more seed germination was noted. In order to determine the germination percentage (% G) and the Germination Speed Index (GSI), the seed was considered germinated when the germinative button appeared. At the end of the experiments, leaf area (cm(2)), root and shoot length (cm), root and shoot dry mass (g) were also obtained. Statistical analysis was performed and means were compared by the Tukey test. Germination rate and speed in coconut fiber was higher at 25 and 30 degrees C. However, when other substrates were tested at 30 degrees C, the highest germination percentage was observed in vermiculite, which also sustained better results for the seed germination and for the characteristics related to shoots and roots.

Real-time multi-sensors measurement system with temperature effects compensation for impedance-based structural health monitoring

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Aspirin increases tolerance to high temperature in seeds of Raphanus sativus L. cvar Early Scarlet Globe

The incubation of seeds of Raphanus sativus L. cvar Early Scarlet Globe with 10 mu M aspirin resulted in increase in the temperature range for germination. The analysis of percentage germination and germination rates indicated the increase in the optimum temperature from 21.4 to 26 degrees C although at 32.6 degrees C 80.8% of seeds germinated with aspirin and no germination in the control. The analysis of the kinetics of seed germination indicated that aspirin treatment resulted in germination by decreasing the enthalpy of activation of the process. The aspirin treatment also resulted in the synchronization of seed germination. on the base of our results we propose aspirin application in practice to increase the tolerance to high temperature and to synchronize seed germination at least in Raphanus sativus L. cvar early scarlet globe.

Voltage-composition profile and synchrotron X-ray structural analysis of low and high temperature LixCoO2 host material

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

An application of neural network technique to correct the dome temperature effects on pyrgeometer measurements

This work describes an application of a multilayer perceptron neural network technique to correct dome emission effects on longwave atmospheric radiation measurements carried out using an Eppley Precision Infrared Radiometer (PIR) pyrgeometer. It is shown that approximately 7-month-long measurements of dome and case temperatures and meteorological variables available in regular surface stations (global solar radiation, air temperature, and air relative humidity) are enough to train the neural network algorithm and correct the observed longwave radiation for dome temperature effects in surface stations with climates similar to that of the city of São Paulo, Brazil. The network was trained using data from 15 October 2003 to 7 January 2004 and verified using data, not present during the network-training period, from 8 January to 30 April 2004. The longwave radiation values generated by the neural network technique were very similar to the values obtained by Fairall et al., assumed here as the reference approach to correct dome emission effects in PIR pyrgeometers. Compared to the empirical approach the neural network technique is less limited to sensor type and time of day (allows nighttime corrections).

ac conductivity and conduction mechanism of NaNbO3 semiconductor antiferroelectric ceramic: A relaxational approach at high temperature

The electric properties of the sodium niobate perovskite ceramic were investigated by impedance spectroscopy in the frequency range from 5 Hz to 13 MHz and from room temperature up to 1073 K, in a thermal cycle. Both capacitance and conductivity exhibit an anomaly at around 600 K as a function of the temperature and frequency. The electric conductivity as a function of angular frequency sigma(omega) follows the relation sigma(omega)=Aomega(s). The values of the exponent s lie in the range 0.15less than or equal tosless than or equal to0.44. These results were discussed considering the conduction mechanism as being a type of polaron hopping. (C) 2003 American Institute of Physics.

Conductivity mechanism analysis at high temperature in bismuth titanate: A single crystal with sillenite-type structure

Conductivity behavior of the Bi12TiO20 single crystal was investigated by the electric modulus spectroscopy, which was carried out in the frequency range from 5 Hz to 13 MHz and at temperatures higher than 400 degrees C. The resistance curve exhibits a set of properties correlated to a negative temperature coefficient thermistor. In the temperature range investigated, the characteristic parameter (,8) of the thermistor is equal to 4834 degrees C. Temperature coefficients of the resistance (a) were derived being equal to -3.02 x 10(-2) degrees C-1 at 400 degrees C and equal to -9.86 x 10(-3) degrees C-1 at 700 degrees C. The nature of the electric relaxation phenomenon and magnitude dc conductivity are approached. (c) 2005 American Institute of Physics.