16 resultados para Geotextile
em Repositório Institucional UNESP - Universidade Estadual Paulista "Julio de Mesquita Filho"
Resumo:
This paper evaluates the efficiency of geotextile filters for sludge from a compact water treatment plant (WTP). The key aspects required in the methodology of selection and designing geotextile filters for sludge from dewatering was investigated based on laboratory tests results. The analyses were supported by the measured filtrated volume of water and turbidity resulting from variable head permeability tests carried out in two geotextiles and using the conventional granular filter (sand and gravel). The results of the present study showed that more than 75% of the dewatering sludge can be filtrated with low turbidity, which permits that this water can return to the treatment plan in order to be reuse in another cycle. The reduced volume of sludge retained by the geotextile that is transferred to the drying pound increases its efficiency by reducing the drying time. The low volume of the dry waste can be removed and the geotextile can be easily cleaned or replaced when needed. These procedures significantly reduce the volume of water needed in dewatering and also avoids waste discharges in the environment.
Resumo:
This paper presents results of physical and mechanical tests in polyester (PET) and polypropilene (PP) nonwoven geotextiles that were exposed to weathering conditions (solar radiation, humidity, wind, rain) after some specific periods of exposure (1, 2, 3 and 4 months). ASTM D5970 and Brazilian standards (NBR) recommendation were followed in this research. Results show variations in tensile properties and in the mass per unit area. Variations in the deformations were more significant in the PP geotextile when compared to the PET geotextile.
Resumo:
A utilização de materiais poliméricos designados por geossintéticos tem aumentando significativamente nos últimos anos na Engenharia Civil. Para desempenhar adequadamente a função para a qual foram projetados, os geossintéticos devem ser submetidos a um rigoroso processo de controle de qualidade durante a fabricação. Discussões sobre a freqüência e os principais tipos de ensaios de laboratório utilizados nesse processo de controle para dois tipos de geossintéticos, os geotêxteis e as geomembranas, os materiais mais utilizados da famíla dos geossintéticos, são abordados no presente trabalho. As análises efetuadas com base em normas disponíveis no Brasil, nos EUA e na Europa mostram que no cenário nacional não há recomendações normativas sobre o controle de qualidade para a maioria das aplicações de geotêxteis e geomembranas, sendo o assunto pouco discutido na literatura técnica. No cenário internacional, as normas Européias se destacam como o conjunto de práticas mais completo para ensaios de controle de qualidade de fabricação, considerando os diversos tipos de aplicação dos geossintéticos na Engenharia Civil.
Resumo:
The designs of filters made by granular material or textile are mainly based on empirical or semi empirical retention criteria according to Terzaghi proposal, which compares particle diameter of the soil base with the filter porous spaces. Silveira in 1965, proposed one rational design retention criteria based on the probability of a particle from the soil base, carried by one dimensional flow, be restrained by the porous of the filter while trying to pass through its thickness. This new innovating theory, besides of being very simple, it is not frequently used for granular filters since the necessary parameters for the design has to be determine for each natural material. However, for textile this problem no longer exists because it has quality control during manufacturing and the necessary characteristics properties of the product are specify in the product catalog. This work presents one adaptation of the Silveira theory for textile filters and the step-by-step procedure for the determination of the characteristics properties of the textile products necessary for the design. This new procedure permits the determination of the confiability level of retention that one specific particle diameter form the soil base has for one specified textile. One complete example is presented to demonstrate the simplicity of the method proposed and how the textile characteristics are obtained.
Resumo:
Pós-graduação em Aquicultura - FCAV
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Pós-graduação em Aquicultura - FCAV
Resumo:
Pós-graduação em Aquicultura - FCAV
Resumo:
This study investigated the following aspects regarding a soakaway, i.e. an infiltration well: i) entrance filter device; ii) permeability of the geotextile; and iii) emptying time. The 3.6 m³ infiltration well drains a roof area of 241.8 m². The entrance device is made up of layers of sand, gravel and geotextile set on a metal structure. The concrete rings that form the lateral walls were covered with geotextile, and bricks were laid between the soil and concrete rings. The infiltration well remained in operation during the entire testing period, and specific events were simulated to measure the emptying time. Permeability and fine particle tests were carried out after eight months of operation. Samples of geotextile taken from the bottom, the walls and the entrance device presented average permeability reductions of approximately 50.7%, 7.7% and 21.2%, respectively. The sand in the entrance device retained around 34.8% of fine particles and the gravel retained 0.13% in the same period. The infiltration rate was approximately 34.7 mm/h. The R2 coefficient for measured and calculated times was 0.97.
Resumo:
This paper presents a study case in which a geosynthetic-reinforced soil (GRS) structure was used to rebuild a 12 m high slope after its failure. The failed slope is located between the parking lot of a private company and a public school. Due to surrounding structures restrictions, this project required a solution with rapidity in execution. In addition, as a requirement established by its owner, this structure should recover the original geometry of the slope. Besides the importance regarding surrounding constructions, an interesting aspect of this study case relies on the versatility of geosynthetic materials. A woven geotextile was used as reinforcement. Five other geosynthetic materials were used in this study case. Facing comprised a geocell filled with local soil cover and grass mats, resulting in a green facing. A geonet was used to hold the grass mats in place before grass roots development. Regarding the drainage system, geocomposite drains and geopipes were installed to drain subsurface water. A nonwoven geotextile was used as filter in drainage trenches, which were placed near the structure toe. Additionally to the GRS structure, the lower portion of the slope was reinforced with soil nailing technique. The face of the nailed soil portion was covered with sandbags and shotcrete. It emphasizes the flexibility of GRS structures regarding their application with other technical options in Geotechnical Engineering. The economic aspect of this study case also deserves attention. It did not require soil transportation and other design and construction steps, e.g. concrete structures design and construction.
Resumo:
Pós-graduação em Engenharia Civil e Ambiental - FEB
Resumo:
This report analyses the use of geosynthetics in railways for subgrade reinforcement and separation of the track layers. Cases of instrumented test sections were studied. These test sections were located in Australia (with geocomposite applications), Brazil (with geotextile and geodrid applications) and China (with geotextile and geodrid applications). Railway design methods using geosynthetics applications were analyzed as well. Based on a studied case for implementation of geosynthetics in a German railway, a railway track was simulated with and without the use of geosynthetics, respectively on PLAXIS v.8 and FERROVIA 3.0 softwares. The performance benefits of the geosynthetics applications in railways were, therefore, confirmed, based on the simulation results
Resumo:
Currently exists a growing concern for the preservation of the environment Around the world, the environmental awareness in Brazil has strengthened during the past two decades. This concern in Brazil arises from the creation of mechanisms of supervision and punishment on the part of the environmental agencies. In order to meet the pertinent legislation many public and private companies have performed dehydration of waste generated in the process of treatment of industrial effluents, waste water and water treatment in order to reduce transport and disposal costs. The use of geotextile tubes has proven technically and economically feasible to be applied in various situations from water treatment to mining tailings. This work presents the solution adopted for an environmental liability in water treatment plant through the use of geotextile tubes to reduce the water content of the disposal. We evaluated the size distribution curves, Atterberg limits, and chemical composition of the residue. Found high concentrations of aluminum in the waste which would characterize environmental pollution if disposed off directly in nature with no treatment
Resumo:
This work aimed to evaluate some aspects of construction and operation of full-scale best management practices and their effects on infiltration loading rate. Two systems were studied: i) filter-swale-trench (FST) and ii) infiltration well (IW). In these units, field essays and full-scale measurements were made in order to assess the soil permeability. Further, the fine particles transportation and the geotextile blanket permeability were determined before and after operation. The results pointed out that there were soil transportation to inside the FST and IW systems, despite of the installed protections, and that these material were responsible for diminishing the geotextile (reduction from 30 to 90% for FST and 40 to 70% for IW) and the full-scale infiltration loading rates (varying from 4,7 x 10-6 to 10-5 m.s-1).
Resumo:
This work presents the results of the efficiency of three protection methods of roads slopes, against the development of erosion processes.The methods anlyzed were: (1) grass planting "San Carlos" (Axonopus compressus), (2) litter, composed of remains of branches and leaves of eucalyptus E. Grandis, and (3) Compacted soil cover with a local soil with properties more resistant to erosion processes.The experiment consisted of assembly of four rectangular cells with 6 meters, three for protection systems in study and one was kept unprotected to evaluate the efficiency of the methods in study.The determination of the amount of eroded sediment was based on the sum of the solids in suspension and stored sediments in the geotextile bags.The results showed that, compared to the unprotected cell, the litter obtained a reduction of soil loss of 90%, while the grass enveloped and reduced 80% and 65% respectively.