Automatic Classification of Three-Phase Flow Patterns of Heavy Oil in a Horizontal Pipe Using Support Vector Machines

The pipe flow of a viscous-oil-gas-water mixture such as that involved in heavy oil production is a rather complex thereto-fluid dynamical problem. Considering the complexity of three-phase flow, it is of fundamental importance the introduction of a flow pattern classification tool to obtain useful information about the flow structure. Flow patterns are important because they indicate the degree of mixing during flow and the spatial distribution of phases. In particular, the pressure drop and temperature evolution along the pipe is highly dependent on the spatial configuration of the phases. In this work we investigate the three-phase water-assisted flow patterns, i.e. those configurations where water is injected in order to reduce friction caused by the viscous oil. Phase flow rates and pressure drop data from previous laboratory experiments in a horizontal pipe are used for flow pattern identification by means of the 'support vector machine' technique (SVM).

Pressure drop correlation for oil-refrigerant R134a mixture flashing flow in a small diameter tube

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Gene flow networks among American Aedes aegypti populations

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Flow evolution of a metallic slurry during thixoextrusion of an automotive valve

The aim of this work is to characterize a metallic slurry (Al-4.5%Cu) flow during thixoforming of an automotive valve. The necessary globular structure was obtained by first inoculating the alloy with TIBAL (5%Ti, 1%B, Al - rest) at 750.0°C, and then reheating to a state between liquidus and solidus prior to thixoforming. Two metallic slurries, with a solid phase of approximately 86.1 and 78.2 percent, were used to generate different experimental flow patterns during the thixoforming process. The flow of the material into the die was observed for total, and partial displacement (2.7, 5.4, 7.5mm) of the punch. The first displacement shows formation of the valve rod. The patterns at each step of displacement of the punch were preserved by quenching in water, thus revealing the profile of the die fill and microstructural evolution. Degeneration of the globular phase was observed along the piece thixoextruded. Thixoextrusion forces versus time curves were generated for partial and full displacement of the punch. Porosity was visible along the billet prior to thixoforming. However, some areas show that the porosity gradually decreased to zero as the thixoextrusion pressure increased. Turbulent, transient and laminar flow are analyzed in this work.

CH and C2 radicals characterization in natural gas turbulent diffusion flames

This paper reports the construction of an axisymmetric nonpremixed piloted jet burner, with well-defined initial and boundary conditions, known as the Delft burner, to assess turbulence-chemistry interaction in non-premixed turbulent flames. Detailed experimental information is described, involving hot-wire anemometry, thin-wire thermocouples and chemiluminescence visualization measurements. Radial profile of the axial mean velocity indicates excellent agreement between flow patterns developed within Delft installation and the one described herein. Chemiluminescence emissions from CH and C2 free-radicals were acquired with a CCD camera. Tomography reconstruction analysis was utilised to compare radical emissions and temperature spatial distributions. There was a strong dependence between temperature and CH/C 2 emissions. This is an indication that these radicals can be used in flame front studies.

Carbon dioxide evaporation in a single microchannel

Despite its importance for designing evaporators and condensers, a review of the literature shows that heat transfer data during phase change of carbon dioxide is very limited, mainly for microchannel flows. In order to give a contribution on this subject, an experimental study of CO 2 evaporation inside a 0.8 mm-hydraulic diameter microchannel was performed in this work. The average heat transfer coefficient along the microchannel was measured and visualization of the flow patterns was conducted. A total of 67 tests were performed at saturation temperature of 23.3°C for a heat flux of 1800 W/(m2°C). Vapor qualities ranged from 0.005 to 0.88 and mass flux ranged from 58 to 235 kg/(m2s). An average heat transfer coefficient of 9700 W/(m2°C) with a standard deviation of 35% was obtained. Nucleate boiling was found to characterize the flow regime for the test conditions. The dryout of the flow, characterized by the sudden reduction in the heat transfer coefficient, was identified at vapor qualities around 0.85. Flow visualization results showed three flow patterns. For low vapor qualities (up to about 0.25), plug flow was predominant, while slug flow occurred at moderated vapor qualities (from about 0.25 to 0.50). Annular flow was the flow pattern for higher vapor qualities. Copyright © 2006 by ABCM.

Estudo experimental do escoamento sobre placas planas munidas de protuberâncias quadradas e onduladas

Pós-graduação em Engenharia Mecânica - FEIS

Estudo experimental do escoamento em cavidades retangulares: padrões de escoamento e instabilidades hidrodinâmicas na camada cisalhante

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo experimental do escoamento em torno de cilindros circulares em movimento de rotação

Pós-graduação em Engenharia Mecânica - FEIS

Recanalization after acute deep vein thrombosis

O processo de recanalização das veias dos membros inferiores, após um episódio de trombose venosa profunda aguda em pacientes anticoagulados com heparina e inibidores da vitamina K, faz parte da evolução natural da remodelagem do trombo venoso. Esse complexo processo de remodelagem envolve a adesão do trombo à parede da veia, à resposta inflamatória da parede do vaso, levando à organização e subsequente contração do trombo, à neovascularização e à lise espontânea de áreas no interior do trombo. A presença de fluxo arterial espontâneo em veias com trombose recanalizada tem sido descrita como secundária à neovascularização e se caracteriza pelo desenvolvimento de fluxo com padrão de fístulas arteriovenosas, identificadas por meio de mapeamento dúplex colorido. Nesta revisão, são discutidos alguns aspectos controversos da história natural da trombose venosa profunda, para uma melhor compreensão da sua evolução e do seu impacto sobre a doença venosa.

Numerical solution of the FENE-CR model in complex flows

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Variabilidade genética e estruturação populacional do Bicudinho-do-brejo-paulista, Formicivora paludicola (aves: Thamnophilidae): uma espécie criticamente ameaçada do estado de São Paulo

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Caracterização de sedimentos do testemunho NAP61-1 da plataforma continental da bacia de Santos por meio de susceptibilidade magnética

A parameter commonly used in investigations of environmental magnetism is the magnetic susceptibility (MS), which is the quantitative measure of the ability of magnetization of a specific material in the presence of an induced magnetic field. The present study aimed to determine the magnetic susceptibility of sediments collected on the continental shelf near the Santos Basin, southeast of the São Sebastião island (25°57.97’S 45°07.81'W), seeking to identify the possible source area of terrigenous sediments and the flow patterns of siliciclastic sediment yield in the area. It was used particle size analysis and contents of organic matter and calcium carbonate to characterize the sediments, besides paleomagnetism parameters. The analyzed material - core NAP61-1 - was collected using the piston corer sampler in 60 meters water depth, recovering 3.98 meters of sediment core. As from experiments, cyclicity was observed in relative abundance between sand and silt, most likely due to rapid and cyclical variations in the depositional environment. In general, the MS values are low, and show that the sand supply (terrigenous material) has a certain consistency, probably having the same origin. More absolute age is still necessary to establish clearly the events marked here

Visualização experimental de escoamentos no interior de canais munidos de protuberâncias parietais

Pós-graduação em Engenharia Mecânica - FEIS

Estudo hierárquico do sistema de reprodução entre e dentro de frutos, fluxo de pólen e estrutura genética espacial em um fragmento e em árvores isoladas na pastagem de hymenaea stigonocarpa mart. ex hayne na região de cerrado

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)