Effect of density on population development in the Amazon River prawn Macrobrachium amazonicum

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Survival of Ucides cordatus (Decapoda: Ocypodidae) megalopae during transport under different conditions of density and duration

Target areas for Ucides cordatus (Linnaeus, 1763) restocking programs are often located far from the laboratory where larval rearing is developed. During translocation, the larvae are submitted to highly stressful conditions due to handling, packing, and transport activities. The aim of the present study was to assess the mortality rates of U. cordatus megalopae caused by different transportation procedures. Megalopae at loading densities of 50, 150, and 300 ind.L-1 were packed in double polyethylene 12 x 25 cm plastic bags with 200 ml of marine water at salinity 30. The bags were filled with oxygen at a proportion of 1:2 parts of water and sealed tightly. The trepidations during transport were simulated by the use of a shaker device (800 vibrations/minute) over periods of three and six hours inside a dark container. The survivorship rates of larvae after simulation were compared to those obtained in control groups, which consisted of plastic vials with megalopae at a loading density of 50 ind.L-1 maintained at rest. Immediately after the two transport simulations, there was no significant difference in survivorship between the treatments and the control. However, 24 hours after simulation some of the tested densities resulted in significantly lower survivorships. The results demonstrated that U. cordatus megalopae can tolerate six hours of shaking during transportation, at high densities with minimal mortality.

Changes of density, thermal conductivity, thermal diffusivity, and specific heat of plums during drying

The thermal properties of plums (Prunus domestica) and prunes were investigated in the moisture content of 14.2-80.4% (wet basis) near room temperature (approximately 28 degrees C). The apparent density of the fruits increased from 1042.9 to 1460.0 kg/m(3), and the bulk density increased from 706.6 to 897.5 kg/m(3) as the plums were dried, following classical empirical models as a function of moisture content. It was found that specific heat, effective thermal diffusivity, and effective thermal conductivity of the prunes increased with the moisture content of the samples, which can be represented by using different empirical models.

Temperature and concentration dependence of density of model liquid foods

Density of binary solutions and combinations of sucrose, glucose, fructose, citric acid, malic acid, pectin, and inorganic salts were measured with an oscillating tube density meter in the temperature range from 10degrees to 60degreesC, at varying concentrations. Density can be predicted with accuracy better than 5 x 10(-5) g cm(-3) using predictive equations obtained by fitting the experimental data. Available literature values agreed well with experimental data. Relations for the excess molar volume of these solutions were derived in terms of mole fraction and temperature. A thermodynamic model for the volumetric analysis of multicomponent aqueous solutions containing electrolyte and non-electrolyte compounds was also proposed. These models can be used for prediction of density of liquid food systems, specially fruit juices and beverages, based on composition and temperature, with high accuracy and without elaborate experimental work.

Optimization of the Transesterification Reaction in Biodiesel Production and Determination of Density and Viscosity of Biodiesel/Diesel Blends at Several Temperatures

Waste frying oil has been used to optimize the production of biodiesel. Biodiesel was prepared through sodium ethoxide catalyzed methanolysis from the transesterification of recycled waste frying oil. Optimization of the transesterification reaction for biodiesel production was carried out by means of statistical analyses using ANOVA. The optimum conditions for reaction were the following: a oil methanol mole ratio of 1:9, temperature of 50 degrees C, catalyst mass fraction of 0.9 %, and reaction time of 40 min, which enabled a yield of 98.7 % determined by gas chromatography/mass spectrometry (GC/MS) analysis. The density and viscosity of biodiesel/diesel blends have been determined as a function of composition at several temperatures.

Determination of density of states in PPS from space-charge-limited current measurements

Space-charge-limited currents measurements have been carried out on undoped amorphous poly p-phenylene sulfide. The scaling law is checked for different samples with varying thickness, and J-V data analyzed. The position of the quasi-Fermi level and the density of states was obtained.

GREEN MACHINING ORIENTED TO DIMINISH DENSITY GRADIENT FOR MINIMIZATION of DISTORTION IN ADVANCED CERAMICS

After sintering advanced ceramics, there are invariably distortions, caused in large part by the heterogeneous distribution of density gradients along the compacted piece. To correct distortions, machining is generally used to manufacture pieces within dimensional and geometric tolerances. Hence, narrow material removal limit conditions are applied, which minimize the generation of damage. Another alternative is machining the compacted piece before sintering, called the green ceramic stage, which allows machining without damage to mechanical strength. Since the greatest concentration of density gradients is located in the outer-most layers of the compacted piece, this study investigated the removal of different allowance values by means of green machining. The output variables are distortion after sintering, tool wear, cutting force, and the surface roughness of the green ceramics and the sintered ones. The following results have been noted: less distortion is verified in the sintered piece after 1mm allowance removal; and the higher the tool wear the worse the surface roughness of both green and sintered pieces.

Larval density, temperature and biological aspects of Chrysomya megacephala (Diptera: Calliphoridae)

Analisou-se o efeito de duas densidades larvais e duas temperaturas sobre a sobrevivência, fecundidade e tamanho corpóreo de C. megacephala em condições experimentais. Nenhum efeito simultâneo da densidade e temperatura foi encontrado sobre as variáveis investigadas em C. megacephala. Entretanto, foram observados efeitos isolados significativos da densidade e da temperatura sobre a fecundidade e tamanho corpóreo. A importância desses resultados para a dinâmica populacional de C. megacephala foi discutida.

Density and Spatial Distribution of Buffy-tufted-ear Marmosets (Callithrix aurita) in a Continuous Atlantic Forest

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effects of the density, aviary type, breed, and age on the behaviors of laying hens kept in cages

An experiment was carried out in order to investigate the behaviors of laying hens due to the environmental factors of: density inside of the cage, aviary type, breed, and age. The experiment was configured as a factorial 4x2x2x2 study, with treatments being four different ages, two different breeds, two different cage densities, and two different aviaries. The birds' behaviors were recorded using video cameras installed in the cages, using samples of 15 minutes recorded from 12 PM to 4 PM. The observed behaviors, frequency and duration of behaviors (measured in seconds) were identified and noted related to each bird. The study was initiated in March 2007, during four non-consecutive weeks. The observed behaviors were: opening wings, stretching, threatening, ruffling feathers, drinking water, aggressive pecking, eating, running, lying down, stretching head out of the cage, preening, mounting, prostrating, and doing nothing (inactivity). Due to the non-normality of the data recorded, the Kruskal-Wallis statistical test of the MINITAB Statistical Software® was used to compare the medians of the variables. For breed factor, only the durations of the eating presented significant differences (p-value< 0.05). For cage density, there was a significant median difference (p-value< 0.05) for almost all behaviors observed. The average length of time of behaviors was higher for the lowest cage density. However, the frequency of behaviors was lmerfor the lowest cage density. The frequency of the behaviors to preen feathers, to lie down, to drink water and to stretch the head were higher in the aviary, where the groups of birds were smaller. The observed behaviors were particularly affected by experimental factors cage density, and aviary type, which directly affects the available space for each bird.

Evaluation of solid residues removed from a mangrove swamp in the Sao Vicente Estuary, SP, Brazil

Mangrove swamps are found in estuaries along the coastal plains of tropical regions and have be subjected to heavy occupation and use pressure due to their privileged locations and abundance of biological resources. The present work evaluated the ecological characteristics and solid wastes accumulated in eight areas along the Santos - Sao Vicente Estuary Complex. The superficially deposited residues at each sampling site were collected and subsequently washed, drained, counted, weighed and separated into classes according to their composition and predominant use. The predominant litter type in terms of density was plastic (62.81%) and, by weight, wood (55.53%). The greatest deposition of residues was associated with areas that were less inclined and that had low plant density levels, indicating that the presence of obstacles was not critical for retaining floating residues in mangrove areas. The presence of the most frequently encountered types of solid waste residues could be explained by local activities. (C) 2010 Elsevier Ltd. All rights reserved.

Infestation rates of the pedunculated barnacle Octolasmis lowei (Cirripedia: Poecilasmatidae) on the spider crab Libinia spinosa (Decapoda: Majoidea)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Characterization of a plankton community in a fish farm

Aim: The objective of this study was to analyze the composition of phytoplankton and zooplankton communities related to the dynamics of a fish farm; Methods: Samples were collected every other day, within a period of twenty consecutive days, during the dry and rainy seasons. Two samples were collected upstream from the fish pond (reservoir); the other four samples were collected in the fish farm area; Results: Rotifera and Chlorophyceae species were found in high densities at almost all sampling sites during both seasons under analysis. The higher phytoplankton species richness from site P3 to P6 was influenced by the management employed within the fish farm. The zooplankton community showed low values of density, species richness and equitability during the dry season; Conclusions: The continuous water flow and the addition of fertilizers (organic and inorganic) in the fish ponds had an influence on the plankton community, leading to a reduction in water quality and Cyanobacteria dominance.