Colorimetric determination of ammonia in air using a hanging drop

A simple and sensitive method for determining atmospheric ammonia (NH3), using a hanging drop, is described. A colorimetric sensor is composed of two optical fibers and the source of monochromatic light implemented was a red light emitting diode (LED) (635 nm). Preliminary experiments were carried out in order to optimize the geometry of the sensor. These tests showed that the best signal absorbance was obtained using a 22 muL deionized water drop for sampling the gas and as addition of 4 muL of each of the reactants to form the blue dye (indophenol). Some important analytical parameters were also studied, including sampling time and flow rate. The analytical curve was constructed with a concentration range of 3-20 ppbv of gaseous NH3 standard. The detection limit reached was of ca 0.5 ppbv. It was observed that formaldehyde and diethylamine did not interfere. However, studies showed that hydrogen sulfide caused a negative interference of 20%, when present in the atmosphere in a concentration equal to that of NE3. The method considered here was shown to be easy to apply, making it possible to make a determination every 17 min.

Determination of the force systems produced by different configurations of tear drop orthodontic loops

Objective: To determine the mechanical characteristics of teardrop loop with and without helix fabricated using different metal alloy compositions (stainless steel and beta-titanium), submitted to different intensities of bends preactivation (0° and 40°), and with different cross-sectional dimension of the wire used to build these loops (0.017 x 0.025-in and 0.019 x 0.025-in). Methods: Eighty loops used to close spaces were submitted to mechanical tests. The magnitudes of horizontal force, the moment/force ratio, and the load/deflection ratio produced by the specimens were quantified. Loops were submitted to a total activation of 5.0 mm and the values were registered for each 1.0 mm of activation. For statistic data analysis, a analysis of variance was performed and a Tukey's Multiple Comparison test was used as supplement, considering a 5% level of significance. Results: In general, teardrop loops with helix produced lower magnitudes of horizontal force and load/deflection ratio, and higher moment/force ratio than teardrop loops without helix. Among all analyzed variables, metal alloy composition presented greater influence in the horizontal force and in the load/deflection ratio. The moment/force ratio showed to be more influenced by the preactivation of loops for space closure. © 2013 Dental Press Journal of Orthodontics.

Minimizing inter-genotypic competition effects to predict genetic values and selection in forestry genetic tests

The effect of competition is an important source of variation in breeding experiments. This study aimed to compare the selection of plants of open-pollinated families of Eucalyptus with and without the use of competition covariables. Genetic values were determined for each family and tree and for the traits height, diameter at breast height and timber volume in a randomized block design, resulting in the variance components, genetic parameters, selection gains, effective size and selection coincidence, with and without the use of covariables. Intergenotypic competition is an important factor of environmental variation. The use of competition covariables generally reduces the estimates of variance components and influences genetic gains in the studied traits. Intergenotypic competition biases the selection of open-pollinated eucalypt progenies, and can result in an erroneous choice of superior genotypes; the inclusion of covariables in the model reduces this influence.

The intravenous glucose tolerance and postprandial glucose tests may present different responses in the evaluation of obese dogs

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Controle alternativo de Colletotrichum acutatum agente causal da queda prematura dos frutos cítricos

A queda prematura dos frutos cítricos (QPFC), causada por Colletotrichum acutatum, dados os grandes prejuízos que têm causado aos produtores, constitui-se numa doença de grande importância econômica. O controle da doença é feito predominantemente mediante uso de fungicidas, que eleva o custo de produção e afeta negativamente o meio ambiente. Diante disso, este trabalho teve por objetivo buscar um método alternativo de controle da QPFC, mediante o uso de agentes de biocontrole ou de biofertilizantes. Diferentes concentrações de biofertilizantes (originários de duas fontes distintas e denominados de Bio1 e Bio 2); três isolados de Bacillus subtilis (ACB-69; 72 e 77) e três isolados de Trichoderma spp. (ACB-14; 37 e 39) foram testados, isoladamente ou em combinação, sob condições de laboratório, quanto à capacidade inibitória da germinação de conídios de C. acutatum. Estudaram-se, ainda, a produção de metabólitos termoestáveis por B. subtilis e o efeito sobre a germinação do patógeno. Quinze isolados de B. subtilis foram testados quanto à capacidade de prevenir a infecção por C. acutatum em flores destacadas de lima- ácida 'Tahiti' e, no campo, foram instalados dois experimentos, visando a testar ACBs e biofertilizantes no controle da doença. Verificou-se que o isolado ACB-72 (B. subtilis) e ACB-37 (T. pseudokoningii) foram os que mais inibiram a germinação do patógeno. Quanto à produção de metabólitos termoestáveis, ACB-69 e 77 foram os mais eficientes em produzir substâncias antifúngicas, e em quantidades suficientes para inibirem a germinação do patógeno. A mistura dos quatro isolados de Bacillus (ACBs: 69; 72; 77 e AP3) foi o que apresentou maior porcentagem de inibição (73%). Os biofertilizantes (Bio1 e Bio2), em concentrações acima de 10% e, quando em associação com isolados de Trichoderma spp., promoveram maiores inibições na germinação de C. acutatum. em testes com flores destacadas, verificou-se que, onde foram aplicados os ACBs 69; 76; 74 e 77, as porcentagens de pétalas sem sintomas de infecção por C. acutatum foram de 83; 92; 92 e 97%, respectivamente. Mediante avaliações a campo, verificou-se a potencialidade de B. subtilis e de biofertilizantes em controlar a doença.

Evaluation of fungicide applications to sweet orange at different flowering stages for control of postbloom fruit drop caused by Colletotrichum acutatum

Postbloom fruit drop (PFD), caused by Colletotrichum acutatum, produces blossom blight, fruit abscission and persistent calyces. in groves of Pera-Rio and Natal sweet orange located in Santa Cruz do Rio Pardo and Rincao, São Paulo, Brazil, four experiments were carried out to evaluate the effectiveness of fungicides sprayed alone or as mixtures, at different flowering stages for the control of PFD of citrus. The number of symptomatic flowers, the percentage of fruit set (FS), and the relationship between persistent calyces and total fruit weight per plant were evaluated. The fungicides carbendazim and folpet were sprayed at 0.50 ml and 1.25 ga.i. l(-1) of water, respectively, were superior by all the criteria to the other treatments. Carbendazim and folpet fungicides performed best when they were applied at the green bud through hollow ball stages. Difenoconazole, independent of application timing, was less effective by all criteria used. Application of mancozeb at 1.60 ga.i. l(-1) at the green bud stage followed by application of mancozeb in a tank mix with carbendazim or folpet at 1.0 ml and 1.25 g a.i. l(-1), respectively, during green bud bloom and hollow ball stages were effective for disease control. Carbendazim combined with 0.25% KNO3, reduced the number of persistent calyces and increased fruit production significantly. Applications must be made between green bud and hollow ball stages for best control. Applications only at hollow ball or open flower stages did not provide effective disease control. (C)2007 Elsevier Ltd. All rights reserved.

In vitro acaricidal activity of neem (Azadirachta indica) seed extracts with known azadirachtin concentrations against Rhipicephalus microplus

The effect of four extracts from neem seeds (Azadirachta indica) containing 2000, 5000, 9000 and 10,000 ppm of azadirachtin A (AZA), quantified by high-performance liquid chromatography (HPLC) and diluted to 1.25%; 2.5%; 5.0%; 10.0% and 12.8% was verified by in vitro tests with engorged females and larvae of the cattle tick Rhipicephalus micro plus. The results from the bioassays with the engorged females showed that the main toxic effect of the extracts was reduction of the reproductive parameters, with a sharp drop in the number of eggs laid and the hatching rate, mainly when the extracts were diluted to 10.0% and 12.8%. The product effectiveness (PE) calculations for all the solutions tested showed that the AZA solution at 10,000 ppm (N10) was the most effective. However, statistical analysis of the PE data obtained for the proportional AZA concentrations in the different diluted extracts showed significance (P<0.05) of the effects included in the model (extract dilution, principle effect (classificatory) of the assay (extract) and the interaction between the two), indicating significant variations due to the dilution, the test and the interaction between the two factors in the tests with engorged females. For solutions N2, N5, and N9, it was not possible to estimate LC(90) values in the dilution range tested. The lowest LC(50) was observed for extract N5, and although extract N10 was the only extract for which the LC(90) could be estimated within the range tested, the LC(50) was higher than for N5 and N9. These results suggest that substances other than AZA present in the extracts influenced the efficacy, especially up to a certain LC range. In the tests with larvae, no mortality was observed, indicating zero effectiveness of all the extracts tested. The results of the tests with engorged females showed that the neem extracts had acaricide activity, inhibiting egg laying and the larval hatching rate. Complementary studies are necessary to develop new methods to isolate and/or identify other substances besides AZA contained in this plant, to enable using products made from it as acaricides. (C) 2011 Elsevier B.V. All rights reserved.

CHARACTERIZATION of RALSTONIA SOLANACEARUM STRAINS FROM BRAZIL USING MOLECULAR METHODS and PATHOGENICITY TESTS

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Numerical simulation of drop impact and jet buckling problems using the eXtended Pom-Pom model

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

A duplicated nitrotienyl derivative with antimycobacterial activity: synthesis, X-ray crystallography, biological and mutagenic activity tests

A duplicated nitrotienyl derivative was obtained as a by-product from the synthesis of a proposed molecular hybrid of a nitrotienyl derivative and isoniazid with an expected dual antimycobacteria mechanism. The structure was shown to be the 5,5'-dinitro-2(2,3-diaza-4-(2'-tienyl)buta-1,3-dienyl)tiophene by X-ray crystallography. The minimal inhibitory concentration (MIC) determination of this compound proved to be promising against Mycobacterium pathogenic strains such as M. avium and M. kansasei, although it had a high level of mutagenicity, as observed in mutagenic activity tests. (c) 2006 Elsevier Masson SAS. All rights reserved.

Mathematical tests about the existence and applications of PPS-wavelets in function approximation problems

Neural networks and wavelet transform have been recently seen as attractive tools for developing eficient solutions for many real world problems in function approximation. Function approximation is a very important task in environments where computation has to be based on extracting information from data samples in real world processes. So, mathematical model is a very important tool to guarantee the development of the neural network area. In this article we will introduce one series of mathematical demonstrations that guarantee the wavelets properties for the PPS functions. As application, we will show the use of PPS-wavelets in pattern recognition problems of handwritten digit through function approximation techniques.

Interpretation of Resistivity Piezocone Tests in a Contaminated Municipal Solid Waste Disposal Site

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Prediction of Soil Properties from the Concepts of Energy Transfer in Dynamic Penetration Tests

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Evaluation of geomembrane UV degradation using melt flow index and oxidative induction time tests

Many factors such as the sunlight, intensity of radiation, temperature, and moisture may influence the degradation process of geosynthetics. UV stabilizers are used especially in polyolefin geomembrane to prevent the degradation process. In these geomembranes the service lifetime is initially governed by the consumption of antioxidants. Tests like MFI and OIT are a alternative to detect the oxidative degradation in polyolefins. This article evaluates HDPE geomembrane degradation after UV exposure through the results of MFI and OIT tests. Two kinds of geomembranes were evaluated: a black and smooth (0.8, 1.0, 1.5, 2.5 mm) and a white and textured (1.0 mm). MFI test showed some levels of superficial degradation (crosslink) in HDPE geomembrane.

Pressure drop correlation for oil-refrigerant R134a mixture flashing flow in a small diameter tube

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)