Mechanical behavior of dental implants in different positions in the rehabilitation of the anterior maxilla

Statement of problem. In dental rehabilitations that involve implants, the number of implants is sometimes smaller than the number of lost teeth. This fact can affect the biomechanical behavior and success of the implants.Purpose. The purpose of this study was to investigate the mechanical behavior of different implant positions in the rehabilitation of the anterior maxilla.Material and methods. Three-dimensional models of the maxilla were created based on computed tomography images for 3 different anterior prosthetic rehabilitations. In group IL, the implants were placed in the lateral incisor positions with pontics in the central incisor positions; in group IC, the implants were in the central incisor positions with cantilevers in the lateral incisor positions; and, in group ILIC, one implant was in a lateral incisor position and one was in a central incisor position, with a pontic and a cantilever in the remaining positions. A 150 N load was distributed and applied at the center of the palatal surface of each tooth at a 45-degree angle to the long axis of the tooth. The resulting stress-strain distribution was analyzed for each group.Results. The lowest displacement of the prosthetic structure was observed in group IC, although the same group exhibited the largest displacement of the bone tissue. In the bone tissue, the von Mises stress was mainly observed in the cortical bone in all groups. The maximum value of the von Mises stress shown in the cortical tissue was 35 MPa in the implant that neighbors the cantilever in group ILIC. The maximum von Mises stress in the trabecular bone was 3.5 MPa.Conclusion. The prosthetic configuration of group IC limited the displacement of the prosthetic structure but led to greater displacement of the bone structure. The use of a cantilever increased the stress concentration in the implant and in the bone structure adjacent to the cantilever under the conditions studied here.

Photoelastic Analysis of Stress Distribution in Oral Rehabilitation

The purpose of this study was to present a literature review about photoelasticity, a laboratory method for evaluation of implants prosthesis behavior. Fixed or removable prostheses function as levers on supporting teeth, allowing forces to cause tooth movement if not carefully planned. Hence, during treatment planning, the dentist must be aware of the biomechanics involved and prevent movement of supporting teeth, decreasing lever-type forces generated by these prosthesis. Photoelastic analysis has great applicability in restorative dentistry as it allows prediction and minimization of biomechanical critical points through modifications in treatment planning.

Craniofacial Implants Success in Facial Rehabilitation

The use of craniofacial implants is an effective treatment for patients with deformities, burns, and cancer sequelae. The sites with the most successful implants are the auricular, nasal, and orbital regions. Furthermore, other factors can affect the implant longevity such as irradiated area, surgical technique, bone quality and quantity, macrostructure and microstructure of the implant, maintenance, and systemic factors.

Use of a Tooth-Implant Supported Bone Distractor in Oral Rehabilitation: Description of a Personalized Technique

Osteodistraction is a clinical reality available for the resolution of bone deficiencies before dental implant placement or in cases where the existing implants are at the wrong position. The objective of this study is to suggest a new possibility for bone distraction, based on tooth-implant bone distractors, in areas were there is the need for extensive alveolar bone recovery, with installed dental implants. This technique presented good results associated with its simplicity and low cost, making it a viable clinical solution for bone tissue augmentation. Although its use is recent, the suggested technique shows the potential to become used widely in attempts to achieve bone-height augmentation, primarily when dental implants are installed and osteointegrated already. (C) 2008 American Association of Oral and Maxillofacial Surgeons

The flower workshop in psychosocial rehabilitation: A pilot study

We report a pilot study with the Flower Workshop, a new modality of psychosocial rehabilitation group activity. Cognitive performance in schizophrenia and other mental conditions can be impaired depending on the tasks to be executed and their respective social context. The vulnerability of these individuals can be reduced by means of cognitive and socio-affective facilitation. We conducted a pilot study to introduce the Flower Workshop in a public Mental Health Service in the city of Ribeirao Preto (Sao Paulo-Brasil) with 12 participants during 18 months (2002-2003). With cognitive and socio-affective facilitation, participants were able to construct vases and make flower arrangements successfully.

Professional Master's degree in Nursing: knowledge production and challenges

OBJETIVO:analisar a produção do conhecimento gerada pelos programas de mestrado profissional em enfermagem e refletir sobre suas perspectivas para a área.MÉTODO:estudo descritivo e analítico. Foram incluídos dados das dissertações de três instituições de ensino que titularam alunos em programas de mestrado profissional em enfermagem entre 2006 e 2012.RESULTADOS:a maioria dos 127 trabalhos de conclusão analisados se desenvolveu no contexto hospitalar; houve tendência de concentração nas áreas organizacional e assistencial, nas linhas de pesquisa processo de cuidar e gerenciamento e predomínio de estudos qualitativos. Há diversidade de produtos resultantes dos trabalhos de conclusão: avaliação de serviços/programas de saúde e geração de processos, protocolos assistenciais ou de ensino.CONCLUSÃO:os programas de mestrado profissional em enfermagem, em fase de consolidação, têm produção recente, em desenvolvimento, havendo lacuna na geração de tecnologias duras e inovação. São fundamentais para o desenvolvimento das práticas profissionais inovadoras que articulem o setor saúde e a educação.

Failures in the rehabilitation treatment with removable partial dentures

Background. Despite being functional and having aesthetic benefits, the acceptance of patients regarding the use of removable partial dentures (RPDs) has been low. In part, this is due to the deleterious effects that causes discomfort to the patient. Success depends not only on the care expended by the patient, including daily care and oral hygiene, but also on common goals set by their professional and clinical staff, aiming beyond aesthetics, to incorporate issues of functionality and the well-being of patients. Methods and results. For rehabilitation treatment with RPDs to reach the desired level of success without damaging the support structure, all the steps (diagnose, cavity preparation, adaptation of the metal structures, functional of distal extension and posterior follow-up) in the rehabilitative treatment should be carefully developed. A literature review was carried out, searching through MEDLINE (PubMed) articles published between 1965 and December 2012 including clinical trials and reviews about the use of RPDs. Conclusions. This study describes factors that lead to failures and complications in oral rehabilitation through the use of RPDs and suggests possible solutions.

Cardiac risk stratification in cardiac rehabilitation programs: a review of protocols

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Infrared spectroscopy: a tool for determination of the degree of conversion in dental composites

Infrared spectroscopy is one of the most widely used techniques for measurement of conversion degree in dental composites. However, to obtain good quality spectra and quantitative analysis from spectral data, appropriate expertise and knowledge of the technique are mandatory. This paper presents important details to use infrared spectroscopy for determination of the conversion degree.

Study of the timber constructive systems that are more commercialized in Brazil

The Brazilian houses in wood are executed with several techniques and species, in function of the areas they are located, therefore, it is treated of regional traditional houses, built practically without modem technological resources. These houses are the ones of the tropical areas, where there is abundance of this material, or the ones of the south region, prevailing the European immigrant's constructive techniques. Nowadays, in the urbanized centers of the country it is observed that this type of house can be found sheltering the most lacking populations, in the slums; or in highly sophisticated residential units which are conceived and executed by specialist professionals for a social class of high purchasing power; or still, those that are marketed by companies of small load, that offer standardized residences, usually acquired by the middle class as second residence, in the field or in the coast. The work has for objective to study the houses of these companies that are consolidated at the market, identifying the constructive system, the product; as well as, its production process, trying to verify which technologies are incorporated to these processes. The analysis that was made allows a larger understanding of the product, wood house, that exists in the market and identification of the technological degree in the productive process of those constructive systems.

International Recommendations for Training Future Toxicologic Pathologists Participating in Regulatory-Type, Nonclinical Toxicity Studies

The International Federation of Societies of Toxicologic Pathologists (IFSTP) proposes a common global framework for training future toxicologic pathologists who will support regulatory-type nonclinical toxicology studies. Trainees optimally should undertake a scientific curriculum of at least 5 years at an accredited institution leading to a clinical degree (veterinary medicine or medicine). Trainees should then obtain 4 or more years of intensive pathology practice during a residency and/or on-the-job "apprenticeship," at least 2 years of which must be focused on regulatory-type toxicologic pathology topics. Possession of a recognized pathology qualification (i.e., certification) is highly recommended. A non-clinical pathway (e.g., a graduate degree in medical biology or pathology) may be possible if medically trained pathologists are scarce, but this option is not optimal. Regular, lifelong continuing education (peer review of nonclinical studies, professional meetings, reading, short courses) will be necessary to maintain and enhance one's understanding of current toxicologic pathology knowledge, skills, and tools. This framework should provide a rigorous yet flexible way to reliably train future toxicologic pathologists to generate, interpret, integrate, and communicate data in regulatory-type, nonclinical toxicology studies. (J Toxicol Pathol 2010; 23: 171-181)

Foreign Body in Preauricular Region

Foreign bodies, although they are often found throughout the body, to a lesser degree in the face, still constitute a diagnostic challenge for the trauma surgeon. Its removal means danger of damaging important facial anatomic structures, even if its exact position from the image data was known. So, the objective is to describe a clinical report of a patient (42 years of age, male sex) who experienced falling to the ground, attended by the Department of Surgery and Traumatology Bucco-Maxillo-Facial Surgery, Faculty of Dentistry of Aracatuba, São Paulo State University, and 2 days after the trauma, he reported difficulty in mouth opening and pain. After clinical evaluation, we observed the presence of injury in the left preauricular region already in the process of healing. During the intraoral physical examination, a limitation of the mouth opening was noted. Radiographic posteroanterior and profile of the face showed 2 radiopaque foreign bodies in the left side, lying apparently at the region of the mandibular condylar process. Under local anesthesia, foreign body removal was carried from there with access to it through the preexisting facial injury. Further clinical examinations showed an improvement in mouth opening, absence of pain complaints, and/or functional complaints.

Analysis of mechanical behavior of implant-supported prostheses in the anterior maxilla: analysis by speckle pattern interferometry

The use of implants to rehabilitation of total edentulous, partial edentulous or single tooth is increasing, it is due to the high rate of success that this type of treatment present. The objective of this study was to analyze the mechanical behavior of different positions of two dental implants in a rehabilitation of 4 teeth in the region of maxilla anterior. The groups studied were divided according the positioning of the implants. The Group 1: Internal Hexagonal implant in position of lateral incisors and pontic in region of central incisors; Group 2: Internal Hexagonal implant in position of central incisors and cantilever of the lateral incisors and Group3 - : Internal Hexagonal implants alternate with suspended elements. The Electronic Speckle Pattern Interferometry (ESPI) technique was selected for the mechanical evaluation of the 3 groups performance. The results are shown in interferometric phase maps representing the displacement field of the prosthetic structure.