Aplicação do Índice Relaçáo Declividade-Extensão - RDE Na Bacia do Rio do Peixe (SP) para Detecção de Deformações Neotectô nicas

This paper presents the identification of tectonic deformation through the application of the stream-gradient index (slope x length) method in the Rio do Peixe hydrographic basin, located in western State of Sã o Paulo. The main principle used is that river valleys are the best tools for this type of analysis because of their fast adjustment to even the most gentle crustal deformations. This type of analysis for structural studies is extremely useful in the western region of the State of São Paulo, where deep chemical weathering results in a thick regolith and scarce outcrops. The stream length index is the ratio of the altimetric amplitude of each drainage and the natural logarithm of its length. The value obtained is plotted on maps at the median point of each drainage, allowing the drawings of lines with the same values (isodefs). Three anomalies (A, B and C) were identified along the Rio do Peixe valley representing uplift sectors indicated by the formation and distribution of Upper Quaternary deposits in terraces and modern fluvial plains and alluvial fans. In correlation with known tectonic data for this region it is possible to attribute the A and B anomalies to the Ribeirão Preto and Presidente Prudente crustal sutures, respectively. The smaller C anomaly needs further field investigation, but it could be associated with the Três Lagoas crustal suture. It must be emphasised that these sutures are inherited from the Precambrian Basement which had a strong influence on the Phanerozoic evolution in the whole sedimentary and volcanic stratigraphic pile of the Paraná Basin and on the dominant structural lineaments directions developed therein .The A, Band C anomalies are suggestive of renewed uplift as a result of neotectonic action in modern times.

Detecção de prováveis deformações neotectônicas no Vale do Rio do Peixe, Região Ocidental Paulista, mediante aplicaçao de Índices RDE (Relac̈ão Declividade-Extensão) em segmentos de drenagem

Running water is one of the most important of all the physical processes which fashion the landscape, allowing gravity to operate along the valley floors. Besides this, the streams show a fast adjustment to the crustal deformations, even to the most gentle ones. This geologic behavior turns them a potential tool for neotectonic studies, specially the analysis of morphotnetric parameters associated with hydraulic gradient and discharge, this second factor being directly proportional to the extension of the streams. Both elements, gradient and stream length, can be combined in the SL index. The purpose of this paper is to show the RDE index application in the neotectonics analysis of the Rio do Peixe hydrographic basin and to compare the obtained values with the geologic basement incised by the streams. This basement encompasses Cretaceous sedimentary rocks of post-Serra Oeral Formation magmatism (Caiuá and Bauru groups) and Quaternary deposits that include chiefly recent alluvial plains and some Pleistocene terrace deposits. In the final part of this paper, an attempt is made in order to correlate the RDE results and the neotectonic framework admitted to this portion of the São Paulo State territory, as well as with field geologic, seismologic and paleoseismologic known elements. The results indicate the presence of two groups of anomalies: The first set corresponds to the Marília-Exaporã Plateau border, and the second one, located in the central portion of the hydrographic basin, is correlated to the Presidente Prudente seimogenic zone.

Avaliação das metodologias de derterminação das áreas de contato e deformações elásticas de pneus agrícolas em função das pressões de inflação e cargas radiais

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Análise computadorizada das cargas e deformações na utilização do fixador externo linear monoplanar nas fraturas instáveis da tíbia similar a tíbia humana

Pós-graduação em Engenharia Mecânica - FEG

Extensometria: estudo das deformações ao redor de três implantes cone morse, com posicionamento linear, sob carga axial

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Estudo in vitro das micro deformações ao redor de implantes suportes de próteses parciais fixas submetidos à cargas axiais e não axiais

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Simulação numérica através do método dos elementos finitos e comparação experimental para obtenção de tensões e deformações específicas em fêmur com prótese total de quadril

Pós-graduação em Engenharia Mecânica - FEG

Análise dos efeitos das deformações estruturais sobre a transferência transversal de carga em um veículo do tipo fórmula SAE submetido a uma aceleração lateral constante

This paper studies the frame deformations on a formula SAE vehicle in steady-state cornering and its influence on the lateral load transfers and, consequently, on the tires normal loads due to the applied lateral load. For a vehicle with a perfect rigid frame, the vehicle mass, the position of the center of gravity and the suspensions are the only factors responsible for the load distribution between the tires. When the frame deformations are no longer negligible, the frame deformations affect the loaddistribution between the tires. The frame flexibility turns it able to behave as an additional set of springs to the suspension system, thus changing the behavior of the set. This paper describes howit happens and suggests ways to minimize this phenomenon

Análise morfotectônica do Planalto Ocidental Paulista, ao sul do Rio Tietê: indicadores de deformações neotectônicas na fisiografia da paisagem

Pós-graduação em Geologia Regional - IGCE

Análise comparativa de tensões e deformações específicas em uma estrutura treliçada, utilizando abordagem experimental e pelo método de elementos finitos

The process of knowledge construction is associated with physical or mechanical view of the phenomenon. In mechanical engineering courses should supplement their courses with physical or virtual learning devices to aid visualization of these phenomena. For the purpose of improving the mechanical engineering department laboratory practice was developed, through a project, a didactic device a trellis. The purpose of this work is the detailed study by comparing the theoretical results with the experimental results collected through the specific strains collected in the Catman. The study was iniatially done with nodes made of aluminum, giving results with high errors not allowing a good conclusion of results. For best results were achieved an improvement of the structure with strict we support the lattice and, thus, further study and greater quality of lattice structure

Deformações elásticas e áreas de contato de pneus agrícolas e florestais utilizando prensa hidráulica em superfície rígida

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Anomalias e números fermiônicos induzidos em grafeno com deformações

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influência da lubrirrefrigeração na qualidade superficial de metais retificados

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)