Thermal degradation of a composite solid propellant examined by DSC - Kinetic study

The thermal decomposition of ammonium perchlorate (AP)/hydroxyl-terminated-polybutadiene (HTPB), the AP/HTPB solid propellant, was studied at different heating rates in dynamic nitrogen atmosphere. The exothermic reaction kinetics was studied by differential scanning calorimetry (DSC) in non-isothermal conditions. The Arrhenius Parameters were estimated according to the Ozawa method. The calculated activation energy was 134.5 W mol(-1), the pre-exponential factor, A, was 2.04.10(10) min(-1) and the reaction order for the global composite decomposition was estimated in 0.7 by the kinetic Shimadzu software based on the Ozawa method. The Kissinger method for obtaining the activation energy value was also used for comparison. These results are discussed here.

TG studies of a composite solid rocket propellant based on HTPB-binder

Thermal decomposition kinetics of solid rocket propellants based on hydroxyl-terminated polybutadiene-HTPB binder was studied by applying the Arrhenius and Flynn-Wall-Ozawa's methods. The thermal decomposition data of the propellant samples were analyzed by thermogravimetric analysis (TG/DTG) at different heating rates in the temperature range of 300-1200 K. TG curves showed that the thermal degradation occurred in three main stages regardless of the plasticizer (DOA) raw material, the partial HTPB/IPDI binder and the total ammonium perchlorate decompositions. The kinetic parameters E-a (activation energy) and A (pre-exponential factor) and the compensation parameter (S-p) were determined. The apparent activation energies obtained from different methods showed a very good agreement.

Flow-injection spectrophotometric determination of dipyrone in pharmaceutical formulations using ammonium molybdate as chromogenic reagent

A simple and rapid flow-injection spectrophotometric method is reported for the determination of dipyrone in pharmaceutical formulations. The method is based on the reaction of dipyrone with ammonium molybdate in acidic medium to produce blue molybdenum, which was detected spectrophotometrically at 620 nm. The analyte was determined in a single-line flow system. The calibration curve obtained was linear in the range of 5x10(-4) to 8x10(-3) mol L-1 for dipyrone concentration and the precision ( s r =1.7%) was satisfactory. The method proved to be selective and adequately sensitive. Application of the method to the analysis of pharmaceutical samples resulted in excellent accuracy; the percent mean recoveries were in the range 95.3%-101% and relative errors less than 5.0% for five pharmaceutical formulations were found.

Growth performance and energetic metabolism of pacu, Piaractus mesopotamicus (Holmberg, 1887), fed diets supplemented with ammonium metavanadate

Vanadium compounds mimic most of the metabolic effects of insulin, suggesting that it might be useful to improve utilization of dietary carbohydrate. This work evaluated the effect of dietary ammonium metavanadate (H(4)NO(3)V) on the growth performance and energy metabolism of pacu, an omnivorous South America characin. Two hundred and eighty-eight fish were distributed into four blocks according to the body weight (21.8 +/- 1.7, 28.5 +/- 2.0, 28.4 +/- 1.9, 35.7 +/- 1.9 g), stocked in 24 plastic tanks and fed twice daily with isonitrogenous and isoenergetic diets containing six levels of H(4)NO(3)V (0, 10, 50, 100, 300 and 1000 mg kg(-1)) for 60 days. Increasing levels of dietary ammonium metavanadate did not improve growth (P > 0.05), and the highest level of inclusion (1000 mg kg(-1)) reduced performance (P < 0.05). Blood glucose levels decreased (P < 0.05) in fish fed 300 and 1000 mg kg(-1) H(4)NO(3)V, but no differences were observed in other blood metabolites. A slight increase in muscle lipid content was observed in fish fed a diet containing 300 mg kg(-1) H(4)NO(3)V. Based on the results of this study, there is no benefit in supplementing pacu diets with metavanadate.

Ammonium and nitrate in soil and upland rice yield as affected by cover crops and their desiccation time

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influence of potassium nutrition and the nitrate ammonium ratio on the putrescine and spermidine contents in banana vitroplants

Potassium (K) is required in high doses by the banana (Musa sp.) plant and interacts with other nutrient elements in which banana tissues are maintained under in vitro condition as a consequence modifications in the plant metabolism take place mainly in nitrogen (N) compounds, such as proteins, amino acids, and secondary compounds. When K is present in concentrations lower than that required, diamines such as putrescine and poliamines are formed. This metabolic disorder can also be correlated with the presence of different inorganic N forms, such as nitrate (NO3) and ammonium (NH4), and the ratios between both ions as well. In order to follow the physiological performance of the interrelationships, K/putrescine and of the NO3/NH4 ratio in the tissue of banana vitroplantlets, shoot apex of two banana cvs. Nanica and Prata Ana were maintained in modified MS medium in the presence of six different doses of K: 5, 10, 15, 20, 25, and 30 mM. After the period of tissue proliferation the cultures were transferred to rooting media containing the same different K doses. Dry matter, K, putrescine, and spermidine contents and their accumulation were determined in the shoots and roots of the vitroplantlets and in the shoot apex of the explant donor cultivar as well as the corresponding values for the whole vitroplantlets calculated. The data were statistically analyzed. The contents and accumulations of putrescine and spermidine in banana tissues were enhanced as K concentration decreased in the medium: four times (0.19% of the dry matter) for cv. Nanica and eight times (0.25% of the dry matter) for cv. Prata Ana. This behavior was not only related to the K depletion but to the NO3/NH4 ratio as well.

Diclofenac Abatement using Modified Solar Photo-Fenton Process with Ammonium Iron(III) Citrate

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

A simple spectrophotometric method for the determination of captopril in pharmaceutical preparations using ammonium molybdate

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Electrochemical study of perchlorate reduction at tin electrodes

The electrochemical behaviour of tin in de-aerated sodium perchlorate was studied using potentiodynamic and potentiostatic techniques. Tin behaviour in sodium perchlorate has been complicated unexpectedly by the reduction of the perchlorate anion. It is shown that the reduction process takes place within a potential region comprising the negative side of the double layer region and the positive side of the hydrogen region (-0.7 less than or equal to E less than or equal to -1.3 V). The presence of oxide on the electrode surface favours the reduction reaction, which may occur in two steps: the formation of basic tin(II) chloride followed by its reduction, producing chloride.

Preparation, characterization and thermal behavior of double selenates of calcium, beryllium and ammonium.

The preparation and thermal decomposition ammonium selenate and calcium and beryllium selenates have been reported previously. However, there are not any information in the literature concerning the thermal decomposition of double selenates of calcium, of beryllium and ammonium. Thermogravimetry (TG), Differential Thermal Analysis (DTA) were used in the studies and characterisation of these compounds.

Leaching of nitrate and ammonium from cover crop straws as affected by rainfall

Nitrogen (N) mineralization dynamics in no-till systems is affected, among other factors, by N amount and quality in the mulch and by climatic conditions. Leaching of NO3-N and NH4-N from six plant species used as soil cover crops in tropical environments were evaluated when the straw was submitted to rainfall after chemical desiccation. Millet (Pennisetum glaucum), guinea sorghum (Sorghum vulgare), black oat (Avena strigosa), triticale (Triticum secale), Indian hemp (Crotalaria juncea), and brachiaria (Brachiaria decumbens) were grown in a greenhouse, in Botucatu-SP, Brazil. Forty-five days after emergence, the plants were cut at the root collar, oven-dried, and submitted to simulated rainfalls of 4.4, 8.7, 17.04, 34.9, and 69.8 mm, considering an amount of straw equivalent to 8 t ha(-1) of dry matter. The amounts of N-NO3- extracted from the straw by rainwater were very small. However, accumulated rainfall around 70 mm caused ammonium leaching ranging from 2.5 to 9.5kg ha(-1), depending on the species. Plant residues of triticale and black oat (grasses) and Indian hemp (legume) showed high N leaching intensity with the first rains after chemical desiccation. The amount of N leached from straw was highly correlated with N tissue content.

ISOLATION OF BABESIA-BIGEMINA AND BABESIA-BOVIS MEROZOITES BY AMMONIUM-CHLORIDE LYSIS OF INFECTED ERYTHROCYTES

1. We describe the isolation of viable merozoites from erythrocytes infected with Babesia bovis or Babesia bigemina organisms by ammonium chloride lysis.2. Parasite morphology was examined by both light and transmission electron microscopy. Erythrocyte-free parasites maintain their viability and infectivity, retain their antigenicity and are suitable for use in the indirect fluorescent antibody assay.

A New Sensor for Perchlorate Ion

A potentiometric sensor for perchlorate anion was developed by mixing a silica gel, chemically modified with 1,4-diazabicyclo (2.2.2)octane, with an epoxy polymer and carbon. The electode showed Nernstian response to the perchlorate ion in the concentration range of 10(-1) and 10(-4) mol L-1.

Structure of cobalt (II) perchlorate adsorbed on silica gel surface chemically modified with benzimidazole molecule

Covalently attached benzimidazole molecules on silica gel surface, ≡SiL (where L = N-propyl-benzimidazole), adsorbs Co(ClO4)2 from non-aqueous solvent by forming a surface complex according to the reaction: m ≡SiL + Co(ClO4)2 → (≡SiL)mCo(ClO4)2. The equilibrium constant and the adsorption capacity, determined by applying the Langmuir equation were b = 3.0 × 103 L mol-1 and Ns= 0.098 × 10-3 mol g-1, respectively. The metal is bonded through the nitrogen atom and the perchlorate ion is not coordinated. The ESR study indicated that the complex has essentially an octahedral geometry with tetragonal distortion, with the electrons of the four nitrogen atoms interacting with the cobalt central metal ion in the equatorial plane. Only one complex species was detected on the surface.

Evaluation of the mixtures ammonium phosphate/magnesium nitrate and palladium nitrate/magnesium nitrate as modifiers for simultaneous determination of Cd, Cr, Ni and Pb in mineral water by GFAAS

A method is described for the simultaneous determination of Cd, Cr, Ni and Pb in mineral water samples by graphite furnace atomic absorption spectrometry with a transversely heated graphite atomizer (THGA) and a longitudinal Zeeman-effect background correction system. The electrothermal behavior of analytes during pyrolysis and atomization steps was studied without modifier, in presence of 5 μg Pd and 3 μg Mg(NO3)2 and in presence of 50 μg NH4H2PO4 and 3 μg Mg(NO3)2. A volume of 20 μL of a 0.028 mol L -1 HNO3 solution containing 50 μg L-1 Ni and Pb, 10 μg L-1 Cr and 5 μg L-1 Cd was dispensed into the graphite tube at 20°C. The mixture palladium/magnesium was selected as the optimum modifier. The pyrolysis and atomization temperatures were fixed at 1000°C and 2300°C, respectively. The characteristic masses were calculated as 2.2 pg Cd, 10 pg Cr, 42 pg Ni and 66 pg Pb and the lifetime of the graphite tube was around 600 firings. Limits of detection based on integrated absorbance were 0.02 μg L-1Cd, 0.94 μg L-1 Cr, 0.45 μg L-1 Ni and 0.75 μg L-1 Pb, which exceeded the requirements of Brazilian Food Regulation that establish the maximum permissible level for Cd, Cr, Ni and Pb at 3 μg L-1, 50 μg L-1, 20 μg L-1 and 10 μg L-1, respectively. The recoveries of Cd, Cr, Ni and Pb added to mineral water samples varied within the 93-108%, 96-104%, 87-101% and 98-108% ranges, respectively. Results of analysis of standard reference materials (National Institute of Standards and Technology: 1640-Trace Elements in Natural Water; 1643d-Trace Elements in Water) were in agreement with certified values at the 95% confidence level.