THE EFFECT of DENTIN PRETREATMENT on THE MICROTENSILE BOND STRENGTH of SELF-ADHESIVE RESIN CEMENTS

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relation of pretreatment sequence diversity in NS5A region of HCV genotype 1 with immune response between pegylated-INF/ribavirin therapy outcomes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

EFFECT OF PRETREATMENT WITH VENOM OF APIS-MELLIFERA BEES ON THE YIELD OF GAMMA-RAY INDUCED CHROMOSOME-ABERRATIONS IN HUMAN BLOOD-LYMPHOCYTES

Venom of the honey bee Apis mellifera induced a protective effect against the induction of dicentric chromosomes by gamma radiation (2.0 Gy) in human peripheral blood lymphocytes which the cultures were treated with 0.00015 mul venom/1 ml medium 6 h before irradiation. In cultures to which the venom was added immediately before irradiation with 0.25, 1.0 and 2.0 Gy, no significant differences in number of dicentric chromosomes induced was observed when compared to cultures submitted to irradiation only. The venom did not induce clastogenic effects nor did it increase the frequency of sister chromatid exchanges.

Effect of chemical pretreatment on the physical properties of dehydrated grapes

The effects of chemical pretreatment and air drying temperature on drying kinetics, shrinkage, density and rehydration ratio of grapes were determined at various moisture contents. It was observed that the chemical pretreatment employed - a solution of 2% CaCO3 with 0 to 3% ethyl oleate - increased considerably the drying rate. It was established that the shrinkage increased with drying temperature between 40 to 80 degrees C and decreased with increasing concentration of ethyl oleate in the chemical pretreatment solution.

Microleakage and nanoleakage: Influence of laser in cavity preparation and dentin pretreatment

Objective: the purpose of this study was to verify if the application of the Nd:YAG laser following pretreatment of dentin with adhesive systems that were not light cured in class V cavities and were prepared with Er:YAG laser would promote better sealing of the gingival margins when compared to cavities prepared the conventional way. Background Data: Previous studies had shown that the pretreatment of dentin with laser irradiation after the application of an adhesive system is efficient in achieving higher shear bond and tensile bond strength. Materials and Methods: Er:YAG laser (Kavo-Key, Germany) with 350 mJ, 4 Hz, and 116.7 J/cm(2) was used for cavity preparation. The conventional preparation was made with diamond bur mounted in high-speed turbine. Dentin treatment was accomplished using an Nd:YAG laser (Pulse Master 1000, ADT. USA) at 60 mJ, 10 Hz, and 74.65/cm(2) following application of the adhesive system. The cavities were stored with Single Bond/Z100 and Prime & Bond NT/TPH. Eighty bovine incisors were used, and class V preparations were done at buccal and lingual surfaces divided into eight groups: (1) Er:YAG preparation + Prime & Bond NT + TPH; (2) Er:YAG preparation + Single Bond + Z100; (3) Er:YAG preparation + Single Bond + Nd:YAG + Z100; (4) Er:YAG preparation + Prime & Bond NT + Nd:YAG + TPH; (5) conventional preparation + Prime & Bond NT + TPH; (6) conventional preparation + Single Bond + Z100; (7) conventional preparation + Single Bond + Nd:YAG + Z100; (8) conventional preparation + Prime & Bond NT + Nd:YAG + TPH. All specimens were thermocycled for 300 full cycles between 5 degreesC +/- 2 degreesC and 55 degreesC +/- 2 degreesC (dwell time of 30 sec), and stored in 50% silver nitrate solution for 24 h soaked in photodeveloping solution and exposed to fluorescent light for 6 h. After this procedure, the specimens were sectioned longitudinally in 3 portions and the extension of microleakage at the gingival wall was determined following a criteria ranging from 0 to 4 using scanning electron microscopy (SEM). The medium portion sectioned of each specimen was polished and prepared for nanoleakage avaliation by SEM. Results: Kruskall-Wallis and Miller statistical tests determined that group 3 presented less microleakage and nanoleakage. Conclusion: Application of the Nd:YAG laser following pretreatment of dentin with adhesive Single Bond non-photocured Single Bond adhesive in cavities prepared with Er:YAG promote better sealing of the gingival margins.

Effects of pretreatment with rosemary (Rosmarinus officinalis L.) in the prevention of lipid oxidation in salted tilapia fillets

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Heparin, heparin plus ASA and dipyridamole, and arteriovenous fistula as adjuvant methods to prevent rethrombosis after venous thrombectomy. Experimental study in rabbits

Venous rethrombosis following thrombectomy is a common event. The aim of the present study was to verify the action of heparin, heparin plus acetyl salicylic acid (ASA) and dipyridamole, and of an arteriovenous fistula (AVF) in the prevention of this complication. Thrombosis was induced in 48 male rabbits by the injection of thrombin in a segment of the left jugular vein, in which the blood flow was arrested for 10 minutes. After 48 hours, the animals were randomly allocated into one of 4 groups of treatment: (1) control, (2) subcutaneous heparin (600 S.I. Units/kg - 8/8 hours), (3) heparin, in the same dose, plus ASA (10 mg/kg/once a day), and dipyridamole (0.5 mg/kg thrice a day), (4) an AVF was surgically constructed between the left carotid after and the left maxillar vein. After 30 minutes, thrombectomy was performed. The venous blood flow, the hematocrit, activated partial thromboplastin time and thrombin time tests were performed before, right after the thrombectomy and 48 hours after thrombectomy. Venography was performed after thrombectomy and at the end of the experiment. The animals were killed 48 hours after thrombectomy and the veins were examined macroscopically. Venous rethrombosis was significantly prevented only in the AVF group (9/12), when compared to control group (0/12), heparin group (1/12) and heparin plus antiaggregating agents group (2/12). These results validate further clinical and experimental investigations with the use of AVF to prevent rethrombosis after venous thrombectomy, when a reduction of venous flow is present.

OBTENCAO DE MESALAZINA (5-ASA) POR CARBOXILACAO DE P-AMINOFENOL

The 5-aminosalicylic acid is usually prepared: 1. by the reduction of the azodye from diazotized aniline and salicylic acid and the posterior reduction of the formed compound; 2. for carboxylation with carbon dioxide under high pressure of p-aminophenol. Both do not present high yield, but the carboxylation process of p-aminophenol can easily be used and can reduce the obtainment process of 3 steps to only 2. Another advantage of this process is the fact that the product is produced without contaminants, because only one solid reagent (p-aminophenol) and the agent of carboxylation (CO2) is used.

Retalho de rotação para defeitos da asa nasal

Surgical defects of the alar lobule can be difficult to repair with functional and aesthetically desirable results. Skin grafts are smoother and paler than the nasal skin. Flaps from the cheek and proximal nose can bridge the alar crease, resulting in obstruction. The authors describe a technique to repair nasal ala defects, with maintenance of the cosmetic unit, without airflow disturbance.

Sugarcane bagasse ozonolysis pretreatment: Effect on enzymatic digestibility and inhibitory compound formation

Sugarcane bagasse was pretreated with ozone to increase lignocellulosic material digestibility. Bagasse was ozonated in a fixed bed reactor at room temperature, and the effect of the two major parameters, ozone concentration and sample moisture, was studied. Acid insoluble and total lignin decreased whereas acid soluble lignin increased in all experiments. Pretreatment barely attacked carbohydrates, with cellulose and xylan recovery rates being >92%. Ozonolysis increased fermentable carbohydrate release considerably during enzymatic hydrolysis. Glucose and xylose yields increased from 6.64% and 2.05%, for raw bagasse, to 41.79% and 52.44% under the best experimental conditions. Only xylitol, lactic, formic and acetic acid degradation compounds were found, with neither furfural nor HMF (5-hydroxymethylfurfural) being detected. Washing detoxification provided inhibitor removal percentages above 85%, increasing glucose hydrolysis, but decreasing xylose yield by xylan solubilization. SEM analysis showed structural changes after ozonization and washing. © 2013 Elsevier Ltd.

Pretreatment of sugarcane bagasse with microwaves irradiation and its effects on the structure and on enzymatic hydrolysis

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Evaluation of a simple alkaline pretreatment for screening of sugarcane hybrids according to their in vitro digestibility

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Comparison of oxidative stress in ASA physical status I patients scheduled for minimally invasive surgery under balanced or intravenous anesthesia

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)