Injúrias causadas por mosca-das-frutas sul-americana em cultivares de videira

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Os acidentes humanos e suas implicações fonoaudiológicas: opiniões de docentes e discentes sobre a formação superior

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effects of powder preparation and sintering procedure on microstructure and dielectric properties of PLZT ceramics

PLZT ceramics belong to one of the very important groups of functional materials that make a basis for the production of a large range of electronic devices. The microstructure and properties of ceramics depend on the powder preparation and thermal processing conditions. Various techniques have been used to obtain chemically homogeneous and fine starting powders. PLZT powders have been prepared by two different production routes: by a modified Pechini method, using a polymeric precursor method (PMM) and by a partial oxalate method. A two-step sintering process, including a hot pressing, was carried out at 1100 and 1200degreesC Distinct phases obtained during the sintering process have been investigated by SEM and EDS techniques and dielectric properties such as permittivity and dielectric loss were measured in a frequency range from 1 to 20 kHz.. A significant difference in microstructure and dielectric properties, depending on powder origin and sintering procedure, has been noticed.

Characterization of bismuth titanate ceramics derived by mechanochemical synthesis

Bismuth titanate, Bi(4)Ti(3)O(12) (BIT) nanosized powders have been successfully synthesized via high energy mechanochemical activation. The phase formation of BIT, crystal structure, microstructure, crystallite size and specific surface area were followed by XRD, scanning electron microscopy (SEM) and the BET specific surface area measurements. The BIT milled 2 h shows the orthorhombic crystalline structure with small amount of amorphous phase. The microstructure of Bi(4)Ti(3)O(12) ceramics sintered at 1000 degrees C for 12h exhibit plate-like grain structure.

Some comments on the F ring-Prometheus-Pandora environment

The system formed by the F ring and two close satellites, Prometheus and Pandora, has been analysed since the time that Voyager visited the planet Saturn. During the ring plane crossing in 1995 the satellites were found in different positions as predicted by the Voyager data. Besides the mutual effects of Prometheus and Pandora, they are also disturbed by a massive F ring. Showalter et al. [Icarus 100 (1992) 394] proposed that, the core of the ring has a mass which corresponds to a moonlet varying in size from 15 to 70 kin in radius which can prevent the ring from spreading due to dissipative forces, such as Poynting-Robertson drag and collisions. We have divided this work into two parts. Firstly we analysed the secular interactions between Prometheus-Pandora and a massive F ring using the secular theory. Our results show the variation in eccentricity and inclination of the satellites and the F ring taking into account a massive ring corresponding to a moonlet of different sizes. There is also a population of dust particles in the ring in the company of moonlets at different sizes [Icarus 109 (1997) 304]. We also analysed the behaviour of these particles under the effects of the Poynting-Robertson drag and radiation pressure. Our results show that the time scale proposed for a dust particle to leave the ring is much shorter than predicted before even in the presence of a coorbital moonlet. This result does not agree with the confinement model proposed by Dermott et al. [Nature 284 (1980) 309]. In 2004, Cassini mission will perform repeated observations of the whole system, including observations of the satellites and the F ring environment. These data will help us to better understand this system. (C) 2003 COSPAR. Published by Elsevier Ltd. All rights reserved.

An approach to analyzing synthesis, structure and properties of bismuth titanate ceramics

The family of bismuth titanate, Bi(4)Ti(3)O(12) (BIT) layered-structured ferroelectrics materials is attractive from the viewpoint of such as their application as electronic materials dielectrics, piezoelectrics and pyroelectrics, because they are characterized by good stability of piezoelectric properties, a high Curie temperature and a good resistance vs temperature. Bismuth titanate (Bi(4)Ti(3)O(12)) powders can be prepared using different methods, depending if the creation will be film coating or ceramics. The structure and properties of bismuth titanate materials show a significance dependence on the applied synthesis method. In this review paper, we made an attempt to give an approach to analyszing the structure, synthesis methods and properties of bismuth titanate ferroelectrics materials.

Application of Polysaccharide Hydrogels in Adsorption and Controlled-Extended Release of Fertilizers Processes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Níveis de proteína digestível e energia digestível em dietas para tilápias-do-nilo formuladas com base no conceito de proteína ideal

This study was carried out to determine the best digestible energy and digestible protein ratio in feeds for Nile tilapia (Oreochromis niloticus) juveniles 30.0 +/- 4.21 g) based on digestible amino acids and the ideal protein concept). Twelve rations were formulated with protein levels 22.0; 26.0; 30.0 and 34.0% of digestible protein and levels 3,000, 3,300 and 3,600 kcal/kg digestible energy. The digestible energy/digestible protein ratio was between 8.94 and 15.19 kcal/g. Three hundred and twenty four tilapias were randomly distributed in thirty six 250 L circular tanks at a density of 9 fish/tank, a total of 12 treatments with three replications. After 60 days, there was no significant difference in weight gain, daily weight gain and feed conversion ratio among the studied treatments. A linear increase was observed in fillet yield with increasing digestible protein. With respect to feed cost/kg weight gain, the treatment with 30.0% DP and 3,000 kcal/kg DE presented low cost and better cost effectiveness index. Therefore, it was concluded that digestible energy did not influence the productive performance parameters and that effective feeds can be formulated with DP levels lower than 34% when feeding juvenile tilapias. The ration should be formulated based on the concept of ideal protein.

Aerosol Deposition of Ba0.8Sr0.2TiO3 Thin Films

In this work we optimized conditions for aerosol deposition of homogeneous, nano-grained, smooth Ba0.8Sr0.2TiO3 thin films. Investigation involved optimization of deposition parameters, namely deposition time and temperature for different substrates. Solutions were prepared from titanium isopropoxide, strontium acetate and barium acetate. Films were deposited on Si (1 0 0) or Si covered by platinum (Pt (1 1 1) /Ti/SiO2/Si). Investigation showed that the best films were obtained at substrate temperature of 85 degrees C. After deposition films were slowly heated up to 650 degrees C, annealed for 30 min, and slowly cooled. Grain size of BST films deposited on Si substrate were in the range 40-70 nm, depending on deposition conditions, while the same films deposited on Pt substrates showed mean grain size in the range 35-50 nm. Films deposited under optimal conditions were very homogeneous, crack-free, and smooth with rms roughness lower than 4 nm for both substrates.

Effect of atmosphere and dopants on sintering of SnO2

Tin oxide is an n type semiconductor material with a high covalent behavior. Mass transport in this oxide depends on the surface state promoted by atmosphere or by the solid solution of aliovalent oxide doping. The sintering and grain growth of this type of oxide powder is then controlled by atmosphere and by extrinsic oxygen vacancy formation. For pure SnO2 powder the surface state depends only on the interaction of atmosphere molecules with the SnO2 surface. Inert atmosphere like argon or helium promotes oxygen vacancy formation at the surface due to reduction of SnO2 to SnO at the surface and liberation of oxygen molecules forming oxygen vacancies. As a consequence surface diffusion is enhanced leading to grain coarsening but no densification. Oxygen atmosphere inhibits SnO2 reduction by decreasing the surface oxygen vacancy concentration. Addition of dopants with lower valence at the sintering temperature creates extrinsic charged oxygen vacancies that promote mass transport at the grain boundary leading to densification and grain growth of this polycrystalline oxide.

Effect of Nb on barium titanate prepared from citrate solutions

The influence of the addition of dopants on the microstructure development and electrical properties of BaTiO3 doped with 0.2, 0.4, 0.6, 0.8 mol% of Nb and 0.01 mol% of Mn based compounds was studied. Doped barium titanate was prepared using the polymeric precursor method from citrate solutions. The powders calcined at 700°C for 4 hours were analysed by infrared (IR) spectroscopy to verify the presence of carbonates, and by X-ray diffraction (XRD) for phase formation. The phase composition, microstructure and dielectric properties show a strong dependence on the amount of added niobium.

Structure study of donor doped barium titanate prepared from citrate solutions

Barium titanates doped with Nb5+, and Y3+, were prepared. The starting powders were synthesized from citrate solutions by the Pechini process and partial Pechini process in two steps. Sintering was performed in the range from 1310° up to 1380°C for 2 hours in air atmosphere. The structural study concerning the incorporation of Nb and Y ions in the barium titanate crystal lattice was performed by XRD, XANES and EXAFS techniques. The dielectric properties were analyzed and the relationship between properties and structure of doped barium titanate was established.

Absence of mutagenicity of plants used to treat gastrointestinal disorders

The Brazilian Savanna (locally called Cerrado) is an important biome presenting several plants that are used in popular medicine. However, the risks associated with the consumption of derivatives from these plants are generally unknown. Studies with compounds obtained from different species have shown the risks of DNA damage. The present work assessed the in vivo mutagenicity of three plant species used in popular medicine to treat human gastrointestinal disorders (Mouriri pusa, Qualea grandiflora and Qualea multiflora). The micronucleus assay was performed in peripheral blood of mice submitted to acute treatments. Results showed that no assessed extracts were mutagenic in vivo. In fact, the absence of mutagenicity in the present study indicates that the extracts do not contain compounds capable of inducing DNA breaks or chromosomal loss. However, further analysis should be performed in others systems to guarantee their safety, mainly to human chronic use.

Thickness-dependent piezoelectric behaviour and dielectric properties of lanthanum modified BiFeO3 thin films

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Piezoresponse force microscopy behaviour of Bi4Ti3O12 ceramics with various excess bismuth

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)