Cross-hole and seismic CPT tests in a tropical soil site

A large portion of Brazil is covered with tropical soils but literature about dynamic parameters of these soils is very limited. SCPT and cross-hole tests were carried out at an experimental research site inland in the state of São Paulo, Brazil. Shear wave velocities (VS) determined based on both tests are presented and compared. A good agreement was observed between both test results and the differences can be associated with soil variability, which was very sensitive to CPT tests. It was also observed that Go/q c ratio determined based on SCPT appears to be an interesting technique to help identify tropical soils. Copyright ASCE 2006.

The use of biodiversity as source of new chemical entities against defined molecular targets for treatment of malaria, tuberculosis, and T-cell mediated diseases: a review

The modern approach to the development of new chemical entities against complex diseases, especially the neglected endemic diseases such as tuberculosis and malaria, is based on the use of defined molecular targets. Among the advantages, this approach allows (i) the search and identification of lead compounds with defined molecular mechanisms against a defined target (e.g. enzymes from defined pathways), (ii) the analysis of a great number of compounds with a favorable cost/benefit ratio, (iii) the development even in the initial stages of compounds with selective toxicity (the fundamental principle of chemotherapy), (iv) the evaluation of plant extracts as well as of pure substances. The current use of such technology, unfortunately, is concentrated in developed countries, especially in the big pharma. This fact contributes in a significant way to hamper the development of innovative new compounds to treat neglected diseases. The large biodiversity within the territory of Brazil puts the country in a strategic position to develop the rational and sustained exploration of new metabolites of therapeutic value. The extension of the country covers a wide range of climates, soil types, and altitudes, providing a unique set of selective pressures for the adaptation of plant life in these scenarios. Chemical diversity is also driven by these forces, in an attempt to best fit the plant communities to the particular abiotic stresses, fauna, and microbes that co-exist with them. Certain areas of vegetation (Amazonian Forest, Atlantic Forest, Araucaria Forest, Cerrado-Brazilian Savanna, and Caatinga) are rich in species and types of environments to be used to search for natural compounds active against tuberculosis, malaria, and chronic-degenerative diseases. The present review describes some strategies to search for natural compounds, whose choice can be based on ethnobotanical and chemotaxonomical studies, and screen for their ability to bind to immobilized drug targets and to inhibit their activities. Molecular cloning, gene knockout, protein expression and purification, N-terminal sequencing, and mass spectrometry are the methods of choice to provide homogeneous drug targets for immobilization by optimized chemical reactions. Plant extract preparations, fractionation of promising plant extracts, propagation protocols and definition of in planta studies to maximize product yield of plant species producing active compounds have to be performed to provide a continuing supply of bioactive materials. Chemical characterization of natural compounds, determination of mode of action by kinetics and other spectroscopic methods (MS, X-ray, NMR), as well as in vitro and in vivo biological assays, chemical derivatization, and structure-activity relationships have to be carried out to provide a thorough knowledge on which to base the search for natural compounds or their derivatives with biological activity.

Differential flight muscle development in workers, queens and males of the eusocial bees, Apis mellifera and Scaptotrigona postica

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Bayesian and multivariate methods applied to favorability quantification in recôncavo Basin and Ribeira Belt, Brazil

A methodology to define favorable areas in petroleum and mineral exploration is applied, which consists in weighting the exploratory variables, in order to characterize their importance as exploration guides. The exploration data are spatially integrated in the selected area to establish the association between variables and deposits, and the relationships among distribution, topology, and indicator pattern of all variables. Two methods of statistical analysis were compared. The first one is the Weights of Evidence Modeling, a conditional probability approach (Agterberg, 1989a), and the second one is the Principal Components Analysis (Pan, 1993). In the conditional method, the favorability estimation is based on the probability of deposit and variable joint occurrence, with the weights being defined as natural logarithms of likelihood ratios. In the multivariate analysis, the cells which contain deposits are selected as control cells and the weights are determined by eigendecomposition, being represented by the coefficients of the eigenvector related to the system's largest eigenvalue. The two techniques of weighting and complementary procedures were tested on two case studies: 1. Recôncavo Basin, Northeast Brazil (for Petroleum) and 2. Itaiacoca Formation of Ribeira Belt, Southeast Brazil (for Pb-Zn Mississippi Valley Type deposits). The applied methodology proved to be easy to use and of great assistance to predict the favorability in large areas, particularly in the initial phase of exploration programs. © 1998 International Association for Mathematical Geology.

Use of myoelectric signals to command mobile entertainment robot by disabled children: Design and control architecture

Severely disabled children have little chance of environmental and social exploration and discovery. This lack of interaction and independency may lead to an idea that they are unable to do anything by themselves. In an attempt to help children in this situation, educational robotics can offer and aid, once it can provide them a certain degree of independency in the exploration of environment. The system developed in this work allows the child to transmit the commands to a robot through myoelectric and movement sensors. The sensors are placed on the child's body so they can obtain information from the body inclination and muscle contraction, thus allowing commanding, through a wireless communication, the mobile entertainment robot to carry out tasks such as play with objects and draw. In this paper, the details of the robot design and control architecture are presented and discussed. With this system, disabled children get a better cognitive development and social interaction, balancing in a certain way, the negative effects of their disabilities. © 2012 IEEE.

The seismic SPT to determine the maximum shear modulus

This paper presents the first results of a system to carry out seismic SPT, which associates the up-hole seismic technique to the currently used SPT test. This hybrid test allows determining the maximum shear modulus (G 0) together with the SPT test. G 0 is the most important dynamic soil parameter and it is calculated based on the shear wave velocity (V S) measurements. The equipment and the method of analysis will be briefly described. The V s values measured using the S-SPT in one experimental research site located inland of Sao Paulo State-Brazil are presented and compared with down-hole and Seismic CPT test data. These preliminary results indicate that the S-SPT was satisfactory and can be used for dynamic site characterization.

Estudo da porção offshore da bacia do Benin e o seu potencial no armazenamento de hidrocarbonetos, margem equatorial africana

Pós-graduação em Geologia Regional - IGCE

Modelo petrofísico 3D do Arenito Namorado no Campo de Namorado - Bacia de Campos, RJ

The Namorado Oil Field represents the beginning of the oil exploration in Brazil, in the 70s, and it is still a subject of researches because the importance of this turbidite sandstone in the brazilian oil production. The Namorado’s production level was denominated “Namorado sandstone”, it is composed by turbidite sandstone deposited during the Albian-Cenomanian. In order to define the structural geometry of the main reservoir, geological and geophysical tools like RECON and Geographix (Prizm – Seisvision) softwares were used, and its application was focused on geological facies analysis, for that propose well logs, seismic interpretation and petrophysical calculations were applied. Along this work 15 vertical wells were used and the facies reservoirs were mapped of along the oil field; it is important to mentioned that the all the facies were calibrated by the correlation rock vs log profile, and 12 reservoir-levels (NA-1, NA-2, NA-3, NA-4, NA-5, NA-6, NA-7, NA-8, NA-9, NA-10, NA-11 e NA-12) were recognized and interpreted. Stratigraphic sections (NE-SW and NW-SE) were also built based on stratigraphic well correlation of each interpreted level, and seismic interpretation (pseudo-3D seismic data) on the southeastern portion of the oil field. As results it was interpreted on two- and three-dimensional maps that the deposition reservoir’s levels are hight controlled by normal faults systems. This research also shows attribute maps interpretation and its relationship with the selection of the reservoir attribute represented on it. Finally the data integration of stratigraphic, geophysical and petrophysical calculations lets us the possibility of obtain a detail geological/petrophysical 3D model of the main reservoir levels of “Namorado sandstone” inside the oil/gás field

Caracterização da distribuição física dos dolomitos do membro Búzios no Campo de Badejo - Bacia de Campos

In the region of Badejo oil Ffeld (Campos Basin) lies an Lower Albian dolomitic layer that shows reservoir rock and seal conditions, among others and, it is occasionally karstified. This work applies geostatistical techniques of ordinary and indicatior kriging, in an attempt to determine a method that assists the analysis of different scenarios offered for petroleum drilling from a quantitative point of view this fact is justified, because there are different visions and strategies that would be adopted under different dolomite conditions (stable - low porosity and high density; reservoir - high porosity and medium density; instable - high porosity and low dentisty). The main objective is a methodological introduction that has not been tested in dolomites before aiming to characterize the distribution of the three conditions described above by ordinary and indicatior kriging, which was based on the obtained data from the dolomite layer identification through well logs interpretation and correlation, followed by seismic interpretation. In addition, it was generated structural contour maps, based on 2D and 3D seismic data interpretation, and then, seismic attributes maps were calculated, in order to transform them into pseudo-density maps, i.e., maps that correlate the density values with the attribute values. As primary results, structural contour maps and seismic attributes were obtained and ordinary and indicatior kriging maps were done, on which it is possible to interpret the distribution of the main reservoir and risk probability for drilling of exploration wells obtaining trends N35E and N10W direction for areas of stability or reservoir levels, while the central part of the map presents a higher risk for loss of drilling fluid. The cut-off values levels were based on the values of first and third quartiles of cumulative histogram (instable and stable zones, respectively), as well as the reservoir level was set as the interval...

A comunicação como barreira à inclusão de alunos com deficiência visual em aulas de óptica

O presente artigo representa uma continuidade dos resultados apresentados em Camargo e Nardi (Revista Brasileira de Ensino de Física 29, 117 (2007)). Encontra-se inserido dentro de um estudo que busca compreender as principais barreiras para a inclusão de alunos com deficiência visual no contexto do ensino de física. Focalizando aulas de óptica, analisa as dificuldades comunicacionais entre licenciandos e discentes com deficiência visual. Para tal, enfatiza as estruturas empírica e semântico-sensorial das linguagens utilizadas, indicando fatores geradores de dificuldades de acessibilidade nas informações veiculadas. Recomenda, ainda, alternativas que visam dar condições à participação efetiva do discente com deficiência visual no processo comunicativo, das quais destacam-se: a identificação da estrutura semântico-sensorial dos significados veiculados, o conhecimento da história visual do aluno, a destituição da estrutura empírica audiovisual interdependente e a exploração das potencialidades comunicacionais das linguagens constituídas de estruturas empíricas de acesso visualmente independente. Conclui afirmando que a comunicação representa a principal barreira à participação efetiva de alunos com deficiência visual em aulas de óptica e enfatiza a importância da criação de canais comunicacionais adequados como condição básica à inclusão desses alunos.

Educational robotics as a learning aid for disabled children

Severe disabled children have little chance of environmental and social exploration and discovery, and due this lack of interaction and independency, it may lead to an idea that they are unable to do anything by themselves. This idea is called learned helplessness and is very negative for the child cognitive development and social development as well. With this entire situation it is very likely that the self-steam and mood of this child. Trying to help these children on this situation, educational robotics can offer and aid, once it can give them a certain degree of independency in exploration of environment. The system developed in this work allows the child to transmit the commands to a robot. Sensors placed on the child's body can obtain information from head movement or muscle pulses to command the robot to carry the tasks. Also, this system can be used with a variety of robots, being necessary just a previous configuration. It is expected that, with the usage of this system, the disabled children have a better cognitive development and social interaction, balancing in a certain way, the negative effects of their disabilities. © 2011 IEEE.

Análise da compacidade do solo na área urbana de Bauru/ Estado de São Paulo utilizando Ensaios de Penetração Padronizado e sísmica de refração

This study was done to determine compactness of soil strata in the urban area of Bauru, central São Paulo State using standard penetration test (SPT) and seismic refraction methods. Frequency distribution within boreholes was measured every meter to a depth of 30 meters. The geometric mean of standard penetration test values was computed every meter. A biplot graph showing the relationship of SPT with depth indicates soil stratification. In addition, five sections of seismic refraction values, which also indicate the compactness of soil strata, were obtained. A comparison of the two methods shows significant correlation between the results obtained from each.

Design of a labVIEW system applied to predictive maintenance

The implementation of vibration analysis techniques based on virtual instrumentation has spread increasingly in the academic and industrial branch, since the use of any software for this type of analysis brings good results at low cost. Among the existing software for programming and creation of virtual instruments, the LabVIEW was chosen for this project. This software has good interface with the method of graphical programming. In this project, it was developed a system of rotating machine condition monitoring. This monitoring system is applied in a test stand, simulating large scale applications, such as in hydroelectric, nuclear and oil exploration companies. It was initially used a test stand, where an instrumentation for data acquisition was inserted, composed of accelerometers and inductive proximity sensors. The data collection system was structured on the basis of an NI 6008 A/D converter of National Instruments. An electronic circuit command was developed through the A/D converter for a remote firing of the test stand. The equipment monitoring is performed through the data collected from the sensors. The vibration signals collected by accelerometers are processed in the time domain and frequency. Also, proximity probes were used for the axis orbit evaluation and an inductive sensor for the rotation and trigger measurement. © (2013) Trans Tech Publications, Switzerland.

Reforma agrária e desenvolvimento sustentável: aspectos obrigacionais e instrumentos legais de proteção

Pós-graduação em Direito - FCHS

Estudo de viabilidade hidrogeológica através de métodos geofísicos no Condomínio Villa Verde, Araçariguama-SP

Pós-graduação em Geologia Regional - IGCE