Efeito do lodo de esgoto e nitrogênio na nutrição e desenvolvimento inicial da mamoneira

Aiming to evaluate the application effect of different sewage sludge ( SS) doses, with and without nitrogen addition, in the castorbean initial development, one experiment was installed in an entirely randomized experimental design, in split-plot scheme 5 X 2, constituted of five sewage sludge doses (0, 4, 8, 16 e 32 Mg ha(-1)) and nitrogen addition or not (15 kg ha(-1)), with five replications. The experimental unit was constituted of plastic bags with capacity of 3,5 dm(3) of soil. Fifty days after emergency it was evaluated height of plants, dry matter of the aerial part, nutrient content in the aerial part, soil electrical conductivity and soil chemical analysis. The SS doses promoted increase in the height of plants and dry matter of castorbean. The concentration of N, K, Mg and S and also the micronutrients Cu, Fe, Mn and Zn in the aerial part of the plants also suffered a positive effect with SS doses, the same didn't occur for the P and Ca concentrations. N addition increased the concentration of N, S, Cu and Zn in the plants. The SS did not present significant effect over pH levels, phosphorous, potassium, calcium, magnesium, organic matter and soil cation exchange capacity after the experiment conduction period.

Desenvolvimento de plantas de crisântemo cultivadas em vaso em resposta a níveis de condutividade elétrica

Na floricultura, a competição por mercados é intensa e o diferencial de produtividade consiste no manejo nutricional adequado, por promover grande impacto sobre a qualidade, a produtividade e a longevidade das inflorescências e da planta. O presente trabalho teve o objetivo de avaliar os efeitos de níveis de condutividade elétrica (CE) no desenvolvimento de plantas de crisântemo (Dendranthema grandiflora Tzvelev.) em vaso sob cultivo protegido. O experimento foi conduzido no município de Paranapanema - SP. Usou-se o delineamento experimental de blocos casualizados com quatro repetições e parcelas divididas. As parcelas foram constituídas pelas épocas de amostragem, e as subparcelas, pelos diferentes níveis de CE, determinados na solução aplicada via água de irrigação: 1,42; 1,65; 1,89; 2,13 e 2,36 dS m-1 (fase vegetativa); 1,71; 1,97; 2,28; 2,57 e 2,85 dS m-1 (fase de botão). Determinaram-se, semanalmente, a altura da planta e o diâmetro do buquê, e a cada 14 dias, a área foliar e a fitomassa seca da parte aérea da planta. O tratamento, correspondente à aplicação de solução com CE de 2,13 dS m-1 na fase vegetativa e 2,57 dS m-1 na fase de botão, proporcionou melhor aspecto visual das plantas, além de apresentar maior valor de fitomassa seca da parte aérea, maior área foliar e melhores formação e coloração.

Atributos físicos e químicos de substratos compostos por biossólidos e casca de arroz carbonizada

O objetivo deste trabalho foi estudar os atributos físicos e químicos de substratos com diferentes doses de biossólido (BIO) e de casca de arroz carbonizada (CAC), com vistas em obter um meio de crescimento adequado para o desenvolvimento de mudas. Desta forma, utilizando biossólido proveniente da SABESP, estação de Franca (SP), estabeleceu-se um ensaio com os seguintes tratamentos (proporções BIO/CAC): 100/0, 90/10, 80/20, 70/30, 60/40, 50/50, 40/60, 30/70, 20/80, 10/90 e 0/100, os quais foram comparados ao substrato comercial Multiplant®. Foram realizadas análises para determinação dos atributos físicos, como: densidade aparente do substrato, macro e microporosidade, porosidade total, capacidade máxima de retenção de água, e dos atributos químicos dos substratos, como: teores totais de macro e micronutrientes, pH, relação C/N e condutividade elétrica. Com a elevação da dose de BIO no substrato houve aumento da densidade e do percentual de microporos e, conseqüentemente, da capacidade de retenção de água. O BIO apresentou teores razoáveis de nutrientes com destaque para N e P, mas baixos teores de K. Não foram detectados teores de metais pesados superiores aos limites estabelecidos pela Legislação Brasileira no biossólido usado. Comparando-se os valores considerados adequados para o desenvolvimento de mudas encontrados na literatura com os obtidos neste trabalho, encaixaram-se na faixa adequada os substratos cujas doses de biossólido variaram de 30 a 60 %. Nenhum substrato testado, incluindo o do tratamento com substrato comercial, apresentou valores ideais em todas as propriedades estudadas.

Dispositivos flexíveis de monitoramento de pH e de deflexão mecânica à base de polianilina

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Structural and Electric-Optical Properties of Zinc Phthalocyanine Evaporated Thin Films: Temperature and Thickness Effects

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Analysis of the Al-PANI interfaces by complex impedance spectroscopy

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Effect of pH of colloidal suspension on crystallization and activation energy of deep levels in SnO2 thin films obtained via sol-gel

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Structural Characterization of Nanocrystalline Sb-Doped SnO2 Xerogels by Multiedge X-ray Absorption Spectroscopy

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Electrodeposition of copper on titanium wires: Taguchi experimental design approach

Electrodeposition of thin copper layer was carried out on titanium wires in acidic sulphate bath. The influence of titanium surface preparation, cathodic current density, copper sulphate and sulphuric acid concentrations, electrical charge density and stirring of the solution on the adhesion of the electrodeposits was studied using the Taguchi statistical method. A L(16) orthogonal array with the six factors of control at two levels each and three interactions was employed. The analysis of variance of the mean adhesion response and signal-to-noise ratio showed the great influence of cathodic current density on adhesion. on the contrary, the other factors as well as the three investigated interactions revealed low or no significant effect. From this study optimized electrolysis conditions were defined. The copper electrocoating improved the electrical conductivity of the titanium wire. This shows that copper electrocoated titanium wires could be employed for both electrical purpose and mechanical reinforcement in superconducting magnets. (C) 2008 Elsevier B.V. All rights reserved.

Photopyroelectric spectroscopy of polyaniline films

Photopyroelectric spectroscopy (PPES), in the 400 < lambda < 900 nm wavelength range, was used to study thermal properties of differently doped polyaniline (PAN) films. The photopyroelectric intensity signal V-n(lambda) and its phase F-n(lambda) were independently measured, as well as the intensity V-n(f) and the phase F-n(f) (f being the chopping frequency) for a given A of the saturation part of the PPES spectrum. Equations of both the intensity and the phase of the PPES signal, taking into account the thermal and the optical characteristics of the PAN films and the pyroelectric detector, were used to fit the experimental results. From the fittings we obtained, with great accuracy, the values of thermal conductivity k and thermal diffusivity coefficient a of PAN films of different doping degrees. It was observed that, in contrast with the strong doping-dependence of the electrical conductivity, the thermal parameters of PAN films remained practically unchanged under doping. This apparent discrepancy is explained by the granular metal model of doped PAN. (C) 2000 John Wiley & Sons, Inc.

Effect of the doping medium on blends of polyurethane and polyaniline

Flexible and free-standing films from blends of polyurethane, based on castor oil, and polyaniline were obtained with various compositions by casting. Significant increase on conductivity followed by a considerable decrease on doping time was obtained by doping the films in N,N-dimethylformamide (DMF) solution with p-toluene sulphonic acid (TSA) or HCl instead of the conventional doping in aqueous solution. This doping efficiency is proposed to be due to an improved swelling of the blend structure caused by the solvent. The electrical conductivity increases significantly upon polyaniline content increase reaching 10(-2) S/cm for a polyaniline content of about 10% (w/w).

A new route to obtain PVDF/PANI conducting blends

Electrically conductive poly(vinylidene fluoride)(PVDF) - polyaniline blends of different composition were synthesized by chemical polymerization of aniline in a mixture of PVDF and dimethylformamide (DMF) and studied by electrical conductivity measurement, UV-Vis-NIR and FTIR spectroscopy. The samples were obtained as flexible films by pressing the powder at 180 degrees C for 5 min. The electrical conductivity showed a great dependence on the syntheses parameters. The higher value of the electrical conductivity was obtained for the oxidant/aniline molar ratio equal to 1 and p-toluenesulfonic acid-TSA/aniline ratio between 3 and 6. UV-Vis-NIR and FTIR spectra of the blend are similar to the doped PANI, indicating that the PANI is responsible for the high electrical conductivity of the blend. The electrical conductivity of blend proved to be stable as a function of temperature decreasing about one order at temperature of 100 degrees C. The route used to obtain the polymer blend showed to be a suitable alternative in order to obtain PVDF/PANI-TSA blends with high electrical conductivity. (c) 2006 Elsevier Ltd. All rights reserved.

Compósitos de borracha natural com polianilina

Compósitos de borracha natural (Hevea brasiliensis)-BN/polianilina - PANI, com diferentes composições foram obtidos através da polimerização por emulsão do monômero anilina na presença da BN e do ácido dodecilbenzeno sulfônico (DBSA). Filmes finos e homogêneos foram obtidos por prensagem a quente. Os compósitos foram caracterizados por condutividade elétrica, FTIR, UV-vis-NIR, DSC e difração de raios X. Compósito com condutividade elétrica cerca de 14 ordens de grandeza maior que a BN foi obtido. Este alto valor de condutividade é atribuído à formação da PANI no estado dopado no compósito, que foi verificado através das técnicas de UV-vis-NIR e FTIR. Os resultados obtidos com a técnica de DSC e difratometria de raios X indicaram que os polímeros são imiscíveis e que a presença da borracha não altera significantemente a fase cristalina da PANI-DBSA no compósito.

Dielectric and impedance properties of Nd3/2Bi3/2Fe5O12 ceramics

The polycrystalline sample of Nd3/2Bi3/2Fe5O12 was prepared by a high- temperature solid-state reaction technique. Preliminary X-ray structural analysis exhibits the formation of a single-phase tetragonal structure at room temperature. Microstructural analysis by scanning electron microscopy shows that the sintered sample has well defined grains. These grains are distributed uniformly throughout the surface of the sample. Detailed studies of dielectric response at various frequencies and temperatures exhibit a dielectric anomaly at 400 A degrees C. The electrical properties (impedance, modulus and conductivity) of the material were studied using a complex impedance spectroscopy technique. These studies reveal a significant contribution of grain and grain boundary effects in the material. The frequency dependent plots of modulus and the impedance loss show that the conductivity relaxation is of non-Debye type. Studies of electrical conductivity with temperature demonstrate that the compound exhibits Arrhenius-type of electrical conductivity. Study of ac conductivity with frequency suggests that the material obeys Jonscher's universal power law.

Dielectric response features and oxygen migration on rare earth modified lead titanate ferroelectric ceramics

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)