Espectro de gotas gerado por diferentes adjuvantes e pontas de pulverização

The application technology shows many parameters related to the quality of the application, one is the droplet spectrum, which is influenced by the spray nozzles and the adjuvant used. Therefore, the objective of this work was estimate the behavior of the droplet spectrum generated with different nozzles and different adjuvants. The experiment was installed containing four solutions from different type adjuvant dilution, as vegetal oil, mineral oil, surfactant and drift reduction, which were applied with two nozzle, one pre-orifice flat fan (DG 8003 VS) and other of air induction flat fan (AI 8003 VS), totaling 8 treatments with 3 repetitions. The experiment was realized in ideal weather conditions for spraying. The treatments averages were compared using Confidence Interval at 95% probability and the correlations between variables were analyzed using Pearson at 5% of probability. The analysis of droplet spectrum showed different behavior for each adjuvant and nozzle. The surfactant treatment showed VMD superior for all treatments when sprayed with AI nozzles. For the %vol.<100 µm the lowest value found was for the AI nozzle in combination with the surfactant. The significant correlations found for the nozzles AI and DG were negative between VMD and %vol.<100 µm. It can be concluded that the values of DMV and %vol.<100 µm showed that the nozzle with pre-orifice have droplet spectrum more prone to drift. The surfactant showed to be the best drift reduction technique when combined with the AI nozzle.

Influência de adjuvantes no espectro de gotas de ponta com indução de ar

This study aimed to verify the influence of adjuvants on the droplet spectrum of an air induction nozzle. The experiment used nine spray solutions, one including only water and eight containing adjuvants: Nimbus® (mineral oil), Óleo vegetal Nortox (vegetal oil), Li-700® (a mixture of lecithin and propionic acid), Agral® (nonyl phenoxy poly ethanol), In-Tec® (nonyl phenol ethoxylate), Antideriva (nonyl phenol ethoxylate), Silwet® L-77 Ag (copolymer polyester and silicon) and TA 35 (sodium lauryl ether sulfate). A flat fan air induction nozzle Hypro® Guardian Air 110 03 was used for the droplet spectrum evaluation. The study was conducted at the Laboratory for Particle Size Analysis (Lapar), at FCAV/UNESP, Jaboticabal/SP - Brazil. The determination of the droplet spectrum characteristics (Volume Median Diameter/VMD, percentage of droplets smaller than 100 micrometers and span) was carried out by a particle size analyzer by laser diffraction Mastersizer S (Malvern Instruments). For statistical analysis the mean values were compared using Confidence Interval at 95% (CI 95%). The results showed that for the Hypro® GA air induction nozzle the oil based adjuvants (Óleo Vegetal Nortox e Nimbus®) increased the VMD. The percentage of droplets smaller than 100 micrometers was lower for the Agral®, Antideriva, In-Tec® e TA 35, in comparison with the Óleo Vegetal Nortox and Li-700®. The span was higher for the oil based adjuvants (Óleo Vegetal Nortox e Nimbus®) and lower for the TA 35 (sodium lauryl ether sulfate), showing that the TA 35 adjuvant has a potential to improve the quality of the droplet spectrum of the Hypro® GA 11003 nozzle.

Caracterização física e química e potencial de deriva de caldas contendo surfatantes em pulverizações agrícolas

The aim of this work was to evaluate the effect of the addition of different surfactants in physical and chemical properties of spray solutions, droplets spectra and drift potential on agricultural spraying. The surfactants and concentrations (v v-1) were: Haiten (0.1%), Antideriva and Intec (0.05% and 0.1%). The following characteristics were analyzed: surface tension, viscosity, density and electric conductivity. The droplet size spectrum was determined by a laser particle analyzer (Mastersizer S®, version 2.15) including measurements of volume medium diameter (VMD), the percent of droplets below 50 and 100 μm (V50 e V100) and index span. In order to estimate the drift potential, a series of wind tunnel tests were performed with a Teejet XR 8003 flat fan nozzle at 200 kPa (medium droplets) used to apply the spray solutions containing water, the adjuvants and a food color dye (Brilliant blue FD & C no 1) at 0,6% m v-1. The drift was collected on nylon strips transversally fixed along the tunnel at different distances from the nozzle and different high from the bottom part of the tunnel. Drift deposits were evaluated by spectrophotometry. The results showed that the addition of adjuvants changed physical and chemical properties of spray solutions in different magnitudes according to the surfactant. Surfactants changed the droplet spectrum and drift potential, indicating that higher VMD and smaller V100 induced higher percentage of drift.

Eficácia do flutriafol e do flutriafol + tiofanato metílico aplicados com gotas finas ou médias no controle da ferrugem asiática da soja

The aim of this study was to evaluate the influence of fine and medium droplets in the performance of flutriafol and thiophanate methyl + flutriafol for the control of Asian Soybean Rust (Phakopsora pachyrhizi Sydow & Sydow). The experiment was a 2 x 2 factorial design (2 droplet sizes x 2 fungicides) resulting in four treatments with six replications. The experimental area was set up with 24 plots (50 x 21 m). In each plot there was a central assessment area with 10 x 20 m. To the each plot there was a non-treated area placed in opposed direction to the wind. The evaluations of rust control were made by of the calculation of incidence (percentage of plants with rust), severity (level of infection), defoliations and soybean yield. The results were analyzed by the calculation of the confidence interval at 90%. The study was set up in curative control conditions with average infestation of 68.6%, average severity in the lower part of the canopy was of 35.9% and on the upper parte it was 4.57%. The results of severity, defoliation and productivity did not show statistical difference among the treatments. However, it was observed that in general there was tendency of better results with the application of flutriafol alone comparing with thiophanate methyl + flutriafol, since there was a small difference between two commercial products in the flutriafol active ingredient content (62.5 g ha-1 to the flutriafol alone and 60 g ha-1 to the thiophanate methyl + flutriafol). There was no statistical difference between fine and medium droplets. This fact can be explained by the characteristics of systemic action of the flutriafol and by the type of control made (curative). The flutriafol, being a systemic fungicide is less sensitive to the better coverage provided by the smaller droplets and, on the curative control, the amount of product deposited can became more import than coverage, mainly on the superior part of the leaves. These leaves are healthier than the inferior leaves that in general are the first to become completely compromised by the rust, losing importance to the plant. By this reason, medium droplets appear to have offered similar performance even not offering advantages in the leaf coverage. This fact may become important because in the practical side of the use of medium droplets, since this may increase the amount of time to spray, mainly because the fine and very fine droplets have more limitations related to drift and evaporation.

Remoção pela chuva de diferentes formulações de flutriafol aplicada em soja, com e sem a adição de óleo mineral na calda

The present study had as objectives to verify the effect of rainfastness of different flutriafol formulations, in laboratory conditions, applied on soybean plants with and without the oil adjuvant in the spray solution, as well as to verify the influence of the oil on the droplet spectrum. The experiment considered ten spray solutions related to five treatments containing flutriafol (four formulations of flutriafol and a flutriafol mixture with tebuconazole), all applied with and without mineral oil. Particles size analysis were based on the determination of the droplet spectrum, medium volumetric diameter and the amount of droplets below 100 μm. All the solutions were sprayed with Teejet XR 11001 (fine droplets). Droplet spectrum was determined in a direct way by diffraction of laser (Malvern Mastersizer S®, version 2.15). Confidence interval at 90% degree was used to compare the mean data. The results showed that the addition of mineral oil in the solutions provided tendencies of larger medium volumetric diameter, smaller amount of droplets below than 100 µm and better uniformity of the droplet spectrum. All of the solutions with the addition of mineral oil presented larger adhesion and/or absorption of the fungicide on the plants in comparison with the solutions without oil. The increase of the time between the application and the rain, caused reduction of the fungicide removal, independently of the rain intensity. The increase of the amount of rain didn't change the relative behavior among the solutions; however, this larger amount of rain caused larger fungicide removal along the time. It was observed significant removal of flutriafol by the rain up to 48 hours after the spray application.

Equipamentos de pulverização associados a volumes de calda e avaliados por alvos artificiais em cafeeiro

The aim of this study was to evaluate the quality of spray droplet spectrum on coffee tree, by using different equipments and syrup volumes. The experiment was set up in a coffee farm, Acaiá variety, Campos Gerais city, MG, Brazil. The treatments were three syrup volumes (150, 300 and 600 L/ha). The lower volume was sprayed with the pneumatic sprayer Martignani, Whirlwind B612 Autonom-Trac mode, and the other volume rates using the conventional hydraulic sprayer to coffee tree. It was possible concludes that the spray volume can be reduced in applications on coffee tree using the pneumatic sprayer.

Desenvolvimento de uma câmara para combustão de combustíveis líquidos, operando sob regime de combustão sem chama visível

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)