Photoelastic comparison of single tooth implant-abutment-bone of platform switching vs conventional implant designs

Objectives: The maintenance and stability of peri-implantar soft tissue seem to be related to the crestal bone around the implant platform and different implant designs connections might affect this phenomenon. The aim of this study was to evaluate by photoelastic analysis the stress distribution in the cervical and apical site of implant-abutment interface of conventional implant joints (external hex, internal hex and cone morse) and compare to the novel platform switching design. Materials and methods: It was fabricated photoelastic models using five different implant-abutment connection, one set of external hex (Alvim Ti, Neodent, Curitiba, Brazil), one set of internal hex (Full Osseotite, Biomet 3i, Florida, USA), one cone morse set (Alvim CM, Neodent, Curitiba, Brazil), and two sets of internal hex plus platform switching concept (Alvim II Plus, Neodent, Curitiba, Brazil) (Certain Prevail, Biomet 3i, Florida, USA). These models were submitted to two compressive loads, axial from 20 kgf (load I) and another (load II), inclined 45° from 10 kgf. During the qualitative analysis, digital pictures were taken from a polariscope, for each load situation. For the quantitative analyses in both situations of load, the medium, minimum and maximum in MPa values of shear strain were determined in the cervical and apical site. The Kruskal-Wallis test was used to compare the results between the different systems and between cervical and apical site were compared using Mann-Whitney U test. Results: The results from qualitative analysis showed less concentration of strain in the cervical area to the internal hex plus platform switching (Certain Prevail), in both situation of load. The same results were get in the quantitative analysis, showing less stress concentrations around the implant Certain Prevail with internal hex plus the novel design (17.9 MPa to load I and 29.5 MPa to load II), however, without statistical significant difference between the systems. Conclusion: The minor stress concentration strongly suggest the use of platform switching design as a manner to prevent bone loss around the implant-abutment platform. Clinical Significance: From the result of this study its possible to make clinical decision for implant system which provides implant components with platform switching characteristics.

The challenges of treating a fused tooth

This paper describes and discusses the multidisciplinary treatment involving a permanent maxillary lateral incisor fused to a supernumerary tooth, both presenting pulp necrosis and periapical lesion. A 15-year-old male patient sought treatment complaining of pain, swelling and mobility on the maxillary right lateral incisor. After clinical and radiographic examination, root canal preparation was performed according to the crown-down technique and a calcium hydroxide dressing was placed for 15 days. The patient returned and the definitive endodontic filling was done with thermomechanical compaction of gutta-percha and sealer. After 18 months, clinical and radiographic examinations were carried out and no pain or swelling was reported. Two years after endodontic treatment, the patient returned for periodontal and cosmetic treatments. Nine months later, a cone-beam computed tomography (CBCT) revealed that the previously detected periodontal defect and periapical lesion were persistent. Apical endodontic surgery was indicated. The supernumerary tooth was removed, the communicating distal surface was filled and the surgical site received bioactive glass and demineralized bovine organic bone. The pathological tissue was submitted to histopathological examination and the diagnosis was periapical cyst. One year after the apical endodontic surgery, CBCT showed bone formation at maxillary lateral incisor apical area. Two years after the surgery, the restoration was replaced due to aesthetic reasons and periapical radiograph showed success after 5 years of treatment. A correct diagnosis and establishment of an adequate treatment plan resulted in a successful management of the case.

Evaluation of effect of cyclosporine A on the bone tissue with induced periodontal disease to ligature in rats

The administration of cyclosporine A (CsA) has been associated with significant bone loss and increased bone remodeling. The present investigation was designed to evaluate the effects of CsA on alveolar bone of rats subjected to experimental periodontitis, using histomorphometric and histological analysis. Twenty-four rats were divided into groups with 6 animals each: 1, control; 2, rats with ligature around the lower first molars; 3, rats with ligature around the lower first molars and that were treated with 10 mg CsA/kg of body weight/d; and 4, rats treated with 10 mg CsA/kg of body weight/d. At the end of 30 days, rats were humanely killed and subjected to a histological processing, with analysis of the distance cemento-enamel junction and alveolar bone crest, bone area, eroded bone area, and cemento surface. All of them were assessed at the mesial region of the alveolar bone. The CsA therapy combined with ligature placement decreased bone area and increased the eroded bone area around the tooth surface. The results at the histological analysis showed the same combination and changes. Therefore, in spite of the lack of a direct effect on the alveolar bone height, the CsA therapy intensified the imbalance of the alveolar bone homeostasia in a rat model of experimental periodontitis. © 2013 Elsevier Inc.

Adjunctive antimicrobial photodynamic treatment of experimentally induced periodontitis in rats with ovariectomy

Background: The aim of this study is to compare antimicrobial photodynamic therapy (aPDT) as an adjunctive therapy to scaling and root planing (SRP) for the treatment of experimentally induced periodontitis in rats with ovariectomy (OVX) that are or are not treated with estrogen replacement. Methods: A total of 270 female rats were divided into three groups: 1) normal rats; 2) rats with OVX; and 3) rats with OVX with estrogen replacement. Periodontal disease was induced through the introduction of a cotton thread around the mandibular left first molar. After 7 days, the ligature was removed, and the rats were randomly divided into the following treatment groups: 1) SRP plus saline solution; 2) SRP plus low-level laser therapy (LLLT); and 3) SRP plus toluidine blue O irrigation followed by LLLT. Ten rats from each group were euthanized at days 7, 15, and 30 after dental treatment. Bone loss (BL) in the furcation region was evaluated using histometric and immunohistochemical analyses. Results: aPDT treatment resulted in reduced BL compared with SRP treatment at all time points. Additionally, rats treated with aPDT exhibited reduced numbers of tartrate-resistant acid-phosphatase-positive cells and more proliferating cell nuclear antigen-positive cells in all treatment groups regardless of estrogen status. Whereas rats treated with aPDT showed weak immunoreactivity to the receptor activator of nuclear factor-k B ligand at day 7 post-treatment, strong osteoprotegerin immunoreactivity was observed at day 15 post-treatment. Conclusion: aPDT is an effective adjunctive therapy for the treatment of periodontitis in rats with OVX that are or are not given estrogen replacement therapy.

Stress analysis in bone tissue around single implants with different diameters and veneering materials: A 3-D finite element study

The aimof this study was to evaluate the stress distribution on bone tissue with a single prosthesis supported by implants of large and conventional diameter and presenting different veneering materials using the 3-D finite elementmethod. Sixteenmodels were fabricated to reproduce a bone block with implants, using two diameters (3.75 × 10 mmand 5.00 × 10 mm), four different veneering materials (composite resin, acrylic resin, porcelain, and NiCr crown), and two loads (axial (200 N) and oblique (100 N)). For data analysis, the maximum principal stress and vonMises criterion were used. For the axial load, the cortical bone in allmodels did not exhibit significant differences, and the trabecular bone presented higher tensile stresswith reduced implant diameter. For the oblique load, the cortical bone presented a significant increase in tensile stress on the same side as the loading for smaller implant diameters. The trabecular bone showed a similar but more discreet trend. There was no difference in bone tissue with different veneering materials. The veneering material did not influence the stress distribution in the supporting tissues of single implant-supported prostheses. The large-diameter implants improved the transference of occlusal loads to bone tissue and decreased stress mainly under oblique loads.Oblique loading was more detrimental to distribution stresses than axial loading. © 2013 Elsevier B.V. All rights reserved.

Estudo dos efeitos do risedronato e da calcarea phosphorica 6CH na reparação óssea em ratos machos castrados

Pós-graduação em Biopatologia Bucal - ICT

Padrão alimentar de mulheres obesas que subnotificam ou não a ingestão energética

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Análise microbiológica da peri-implantite induzida por ligadura em diferentes superfícies de implantes osseointegrados: estudo em cães

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Repercussões minerais ósseas no alcoolismo crônico associado à deficiência hormonal em ratos

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Influência do consumo crônico de etanol 20% na doença periodontal induzida em ratas com deficiência estrogênica

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito de diferentes tempos de deficiência estrogênica na perda óssea resultante da periodontite experimental em ratas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação clínica e radiográfica de implantes osseointegráveis instalados na mandíbula posterior e submetidos a um protocolo de função oclusal precoce

Pós-graduação em Odontologia - FOA

Avaliação da influência da velocidade de perfuração na reabsorção óssea ao redor de implantes osseointegrados instalados por meio de cirurgia guiada sem retalho: estudo clínico, radiográfico e histológico

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Influência da Calcarea phosphorica e do alendronato sódico na remodelação óssea de ratas ovariectomizadas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Osteogênese in vitro em amostras de titânio com diferente porosidades

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)