159 resultados para Métodos gráficos
Resumo:
Fifteen soil samples and four extradants (DTPA, Na 2EDTA, HCl and Mehlich 1) were used to study soil extraction methods for available zinc. Each extradant was studied in three soil:solution ratios (1:2, 1:4 and 1:10) and in three extraction periods in the ratio most frequently used. The zinc extracted by DTPA, Na 2EDTA and HCl was not affected by use of soil:solution ratios 1:2 and 1:4, but the amount extracted increased with the 1:10 ratio. In this relation, the variation coefficients increased. With Mehlich, no definite tendency was observed. The increase of extraction period for DTPA extractant, in 1:2 ratio, had little effect on the amount of zinc extracted and on the precision. As to Na 2EDTA extractant in 1:10 ratio, with the increase of extraction time, both increased. As to HCl and Mehlich, both in 1:4 ratio, the increase in extraction period had no effect on the amount of zinc extracted and no definite effect on the precision. Thus, the use of 1:2 ratio for DTPA and Na 2EDTA and 1:4 ratio for acid extractants is recommended. Concerning the period of extraction, 120 min should be used with DTPA and Na 2EDTA, 15 min with HCl and 5 min with Mehlich.
Resumo:
The objective of this research was to evaluate the effectiveness of the extraction of Xanthomonas campestris pv. phaseoli from naturally infected dry bean seeds. Extraction methods tested included soaking whole seeds in sterilized saline phosphate buffer and crushing seeds after soaking in sterilized saline phosphate buffer. The bacterium was isolated on a semiselective agar medium. The seed crushing method was found to be more effective. The bacterium strains isolated were pathogenic to bean leaves, reacted with X. campestris pv. phaseoli antiserum, and had morphological and physiological/biochemical characteristics typical of the X. campestris pv. phaseoli.
Resumo:
Silages of Pennisetum purpureum Schum. cv. Guaçu prepared with 0, 8, 16 and 24% of ground ear com with husks, wheat bran and saccharin, dry weight of additive/wet weight of green chop basis. The experimental design was a randomized blocks one in split-plot; the plots were the additives and levels, and the sub-plots the sampling methods. The material was ensiled using plastic vessels in middle of which holed pvc pipes (3 inches diameter) were put. These pipes (one per vessel) had the same length as the height of the vessels, and were filled at the same time and compacted the same way as the vessels. The first method of sampling used the material ensiled inside the pvc pipe, which was lifted out from the vessel at the moment of the silo opening. The other sampling method, normaly used in digestibility trials, consisted of samples composed by daily sub-samples collected in the vessels. The pvc sampling method was more efficient because it sampled a profile of the whole silage. All of the silages showed high percentages of lactic acid and low percentages or even absence of butyric acid, though in all silages high ammoniacal-N percentages were detected.
Resumo:
BACKGROUND: Ultrasonography (US), Computed Tomography (CT), and Magnetic Resonance imaging (MR) were compared for the staging of renal tumors. The differences between these imaging techniques were also studied for their ability to detect adenopathies, vascular invasion, distant intra-abdominal metastases, and particularly adjacent organ invasion. METHODS: Thirty-one patients with solid or complex renal masses were prospectively studied using US, CT, and MR. Differences between the results obtained were studied using the COCHRAN G test and the McNEMAR test. The sensitivity and specificity of each diagnostic technique were compared against a gold standard of the surgical and histopathological findings. RESULTS: The following sensitivities were obtained: For the detection of adenopathy, US 63.6%, CT and MR 90.9%. For vascular invasion, US 42.8%, CT and MR 85.7%. For the adjacent organ invasion, US 28.5%, CT 85.7%, and MR 71.4%. Some of the criteria that suggest invasion of adjacent structures include: the envelopment of the adjacent structures by the tumor, tumor extension into the adjacent structures with an irregular appearance, and alterations in shape, size, and density of adjacent structures. Loss of fat planes between the tumor and adjacent structures is not a sign of tumor invasion. CONCLUSIONS: Significant differences were found in the detection capacity of US in relation to CT and MR, which were similar. All three techniques were highly sensitive and specific only in the detection of distant abdominal metastases. In addition to the accuracy of these diagnostic modalities for the detection and staging of tumors, invasiveness, risks and cost should be considered in relation to relative costs and benefits.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
This paper supplies a revision about the main techniques of extraction, clean-up and pre-concentration of the herbicide 2,4-dichlorophenoxyacetic acid (2,4-D) in water and soil samples, as well as chromatographic methods and immune assays for its identification and quantification.
Resumo:
Ninety eight strains of glucose-nonfermenting Gram-negative bacilli were analyzed and isolated from several clinical materials of 95 patients admitted at the Dr. Domingos Leonardo Cerávolo University Hospital and three from outpatients. All of them were assisted in the Laboratory of Clinical Analysis of Unoeste University, Presidente Prudente, SP, from the period of October of 1999 to April of 2001. In this work, the level of agreement between the semi-automated commercial system AutoScan-4 and the conventional system for the identification of those bacteria were studied comparatively. There was agreement in 81 (82.7%), showing that both methodologies are useful for identification; partial agreement in six strains (6.1%) and disagreement in 11 (11.2%). The comercial system did not identify nine (9.2%) of the strains and reported them as very rare biotypes.
Resumo:
Ammonia is the most common alkaline gas of the atmosphere, being important in the neutralization of various processes that occur in the atmosphere. Its main sources of emission are the decomposition of organic matter and dejections of animals. Ammonia is used by man in diverse activities of production, therefore it is a gas that can contaminate work environments. Measurements of ammonia concentration in some parts of the world have shown great spatial and weather variation. This large variability makes it difficult to estimate the input of reduced nitrogen to different ecosystems from measurements.
Resumo:
The objective of this work was to compare the results of measuring the specific gravity (SG) of laying hen eggs by using a weighing apparatus and the saline flotation method (SFM). Two hundred eggs from two genetic lines were distributed randomly into two groups of 50 eggs per genetic line and were submitted to two different sequences of SG measurement. Not significant differences were found between the two methods. The weighing apparatus measured the SG of the eggs accurately as the SFM.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Strongyloidiasis, a relatively common parasitism in tropical and sub-tropical areas, is the result of the infection by the smaller nematode, the Strongyloides stercoralis. Humans can be infected by this parasite, which has in its vital cycle free-life forms of male and female individuals able to live in the ground, and with another step necessary parasitism in the intestinal wall. The diagnostic of the infection is routinely done by the microscopic observation of the larva in stool samples and the high sensibility of urn method over another one allows an trustable and efficient diagnostic. The efficiency of three methods (Direct, COPROTEST and Rugai) used in the Parasitology Sector of the NAC-LACAL in Araraquara (SP) to diagnosis the strongiloidiasis were evaluated. A number of 2346 samples of stool of patients from NAC-LACAL and Nestor Goulart Reis Hospital were analyzed in the period between August and December of 2002. The Rugai Method with an positivity index of 65 % was elected as the most efficient of thee ones.
Resumo:
The aim of this study was to examine the agreement between the results of body fat (BF and BF%), fat-free mass (FFM) and FFM index (FFMI= FFM/height2) as estimated by skinfold anthropometry (ANT), bioelectrical impedance (BIA) and dual-energy X-ray absorptiometry (DXA) in two groups of men (> or = 50 y), one comprising healthy individuals (n=23) and the other, patients with chronic obstructive pulmonary disease (COPD) (n=24). Comparisons between body composition techniques were done by repeated measures ANOVA; the Bland & Altman procedure was used to analyse agreement. RESULTS AND CONCLUSIONS: 1) comparison between healthy and COPD groups showed significant differences between all studied variables; 2) in the healthy group, values for BF, BF%, FFM and FFMI were not significantly different when BIA or ANT was compared to DXA; however, in COPD, values for BF and BF% were significantly higher and for FFM and FFMI significantly lower when BIA was compared to DXA; in contrast, no differences were shown between values for these variables when ANT was compared with DXA; 3) Bland & Altman test, in both groups, showed no agreement between BIA and DXA and between ANT and DXA; it was also shown that body fat was overestimated and fat free mass underestimated by BIA in relation to DXA.
Resumo:
The (Sn,Ti)O2, system has a great interest due to its technological applications such as gas sensor and varistor. Although the thermodynamic properties and the kinetics of spinoidal decomposition in this system have been extensively studied, the general properties and applications of SnO2 - TiO2 binary compositions have been not investigated yet in depth. On the other hand, little work has been done to optimize the synthesis methods to obtain (Sn,Ti)O2 cerallmic powders, with pre - determinate physical and chemical characteristics. In this work the ceramic powders has been obtained by coprecipitation and polymeric precursor (Pechini) methods. The different physical chemistry phenomena that occurred during the synthesis were discussed. The (Sn,Ti)O2, ceramic powders were characterized with X- ray diffraction (XRD), thermal analysis (DTA/TG) and scanning electron microscopy (SEM). The knowledge about of steps and variables of synthesis process acquired with development of this work, we permited to obtain (Sn, Ti)O2, nanometers particles to low temperatures: to 450°C for coprecipitation method and to 600°C for Pechini method. The spinodal decomposition that ocurr to 900°C was discussed also.
Resumo:
A quite common problem in the recovery of degraded areas in the mineral exploration understands the compaction of the soil due to the intense traffic of machines and earth movement. The most common problem of the compaction of a degraded surface is: increase of the mechanical resistance to the penetration of the rooats, reduction of the aeration, alteration of the water flow and heat. Thus the present work had the basic objective of diagnosing the compaction of a degraded area by mining in a space way, through the mechanical resistance the way penetration to guide a future subsoiling in the place seeking recovery. Through the studies it was concluded that the kriging method in agreement with the space variation allows the division of the area studies in sub areas facilitating a future work to reduce cost and unnecessary interference to the atmosphere. The method was shown quite appropriate and it can be used in diagnosis of the compaction in a degraded area by mining, foreseeing subsoiling need.
Resumo:
Plan disease control techniques are used through the irrigation water, which reduces the labor and it improves application uniformity with smaller contact of the operator with toxic products, lower environmental impact and lower production cost. In order to control Botrytis cinerea the lisianthus culture, this work aimed to evaluate two fungicide application methods with different treatments. The fungicides were: thiophanate methyl (50 g i.a. L-1), thiophanate methyl + chlorothalonil (50 g i.a. L-1 + 35 g i.a. L-1) and iprodione (50 g i.a. L-1). Number of lesions, number of diseased floral buttons and height of the lisianthus plants were evaluated. It was possible to deduce, that in the growth stage (number of lesions in the plant) as well as in the final stage (number of floral buttons) of the lisianthus culture, the most efficient treatments were 2 (thiophanate methyl + chlorothalonil) and 3 (iprodione). Considering that treatment 2 is a mixture of two fungicides, a systemic and a contact one, independently of application methods, the mixture increased efficiency in relation to treatment 1 (thiophanate methyl). Thus, chemigation was as efficient as spreading technique.