506 resultados para Absorção de N


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Estudou-se o efeito da inoculação com fungo micorrízico arbuscular (FMA), Glomus etunicatum, Glomus clarum, ou Scutelospora heterogama, e da adição de fósforo solúvel (15, 30, 45, 60, 120 e 240 mg de P kg-1 de terra) sobre as variáveis altura, número de folhas, diâmetro do caule, massas vegetais aérea e radicular, teores de nutrientes nas folhas e colonização micorrízica no porta-enxerto limoeiro Cravo (Citrus limonia (L.) Osbeck). Os FMAs, Glomus etunicatum e Glomus clarum, e doses crescentes de fósforo exerceram efeitos significativos sobre essas variáveis. O efeito da inoculação sobre as variáveis de crescimento vegetal foi mais acentuado nos tratamentos com adição de 30 a 60 mg de P kg-1 de terra. Para o teor de P foliar, o efeito da inoculação foi mais acentuado nos tratamentos adicionados de 120 a 240 mg de P kg-1 de terra. A inoculação com estes FMAs aumentou a eficiência do limoeiro Cravo em absorver nutrientes, tanto que as variáveis estudadas em plantas inoculadas na ausência de adubação fosfática superaram às de plantas não inoculadas em substrato adicionado de 240 mg de P kg-1 de terra.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Soil that has a high degree of weathering, with more inorganic P bound to Fe and Al oxides, has less P availability to plants. Thus, the critical element of a plant refers to the level below which the growth rate and plant production decreases, demonstrating the need for supplementary fertilization. Accordingly, an experiment was conducted in a greenhouse at Embrapa Algodao with the objective of evaluating the response of castor plants to five doses of P in four types of soil with different adsorption characteristics and critical levels of foliar P. The experimental design was completely randomized in a 4 x 5 factorial design, four types of soil and 5 levels of P with four replications. For TCo, there was an increase in height growth, with dose of 229.6 mg dm(-3) responsible for maximum plant height (74.3 cm). The largest diameter stem (17.58 mm) was observed in CXve with an application of 229.6 mg dm(-3) of P; a decrease was seen when using higher doses. The increase in leaf area was smaller in RY (4724.8 cm(2)), where it was obtained with a dose of 280.2 mg dm(-3). In general, critical levels of P in the plant shoots did not vary much between the soils. The critical level of P in castor bean shoot dry mass was higher (4.61 g kg(-1)) in TCo, this result being directly related to the low clay content of the soil.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The term refrigeration solar refers to any air conditioning system that uses solar energy as a primary energy source. The use of solar radiation for cooling purposes is divided according to their technological possibilities which are distinguished from one another as the way that energy is involved in the cycle, work or heat. The first case is related to vapor compression cycles, in which the work input is provided by the photovoltaic conversion of solar energy into electrical energy. In the second case, an absorption refrigeration cycle is used and the thermal energy collected from the solar radiation is provided at the generator of this cycle.. In this work a system with an absorption cycle using the pair BrLi-water, using solar energy as input is modeled. It is considered a simple refrigeration cycle whose the equations of mass and energy conservation in each component are developed in order to obtain an algebraic equation set and a simulation routine using the EES software. Although the simulation operates under certain specified thermal load it is possible to estimate the necessary areas of heat exchangers and solar collectors

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This work presents a study of the absorption refrigeration system and the modeling and evaluation of two cycles using the binary solutions water-lithium bromide and ammonia-water for an equipment to be used in small size plants like residences. The study and evaluation aims the complete understanding of all parts of the system and the influence of each one of them as well as the spread of the knowledge to raise the use of this type of equipment in all sizes in order to decrease the energetic consumption of plants of all scales and making viable the alternative sources. The study is done in each element of the cycle separately and in some auxiliary equipments required in the operation such as the main power source, the solar collector. The software used for modeling, with emphasis on thermal part, was the EES (Engineering Equation Solver), that permitted the thermal balance calculus and acquisition of the used fluids properties. The results obtained for the equipment shows the system is more complex than the widely used in business, however, it can be viable and represents an alternative to increase the energetic efficiency

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Pós-graduação em Ciência dos Materiais - FEIS

Relevância:

20.00% 20.00%

Publicador:

Resumo:

The production systems on substrates have been employed in most commercial cultivation of flowers and ornamental plants, including gerbera. However, its introduction as potted flower is recent in Brazil and many studies, especially those related to the determination of substrates physical and chemical properties, which contribute to production quality are still needed. The present study aimed to assess the influence of substrates characteristics for nutrient absorption and production of potted gerbera. The experiment was carried out in greenhouse with the experimental design in randomized blocks, factorial arrangement 5x2 (5 substrates and 2 cultivars) and 4 replications. Treatments consisted of substrates with different physical and chemical characteristics and gerbera cultivars (Cherry and Red). Plants grown on substrate with pH above 7.0 had a reduction in iron absorption, resulting in lower intensity of green coloration in the leaves. Plants grown on substrate with pH below 5.0 showed toxic levels of manganese and lower dry mass. The characteristics of the substrate, especially the pH, influence the nutrients absorption and the production of potted gerbera, altering the final plant quality.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

A simple and fast method to determine Ca, K and Mg in a single aliquot of medicinal plants by HR-CS FAAS is proposed. The secondary lines for Ca (239.856 nm) and K (404.414 nm), and the alternate line measured at wing of the secondary line for Mg at (202.588 nm) allowed calibration within the 20 - 500 mg.L-1 Ca and K, and 1.0 - 80 mg.L-1 Mg. Twenty samples and three plant certified materials were analyzed. Results were in agreement at a 95% confidence level with reference values. Limits of detection were 2.4 mg.L-1 Ca, 1.9 mg.L-1 K and 0.3 mg.L-1 Mg. The RSD (n=12) were ≤ 5.1% and recoveries were between 83 and 108% for all analytes.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This work describes instrumental strategies for the determination of Mn in a wide range concentration by high-resolution continuum source flame atomic absorption spectrometry technique (HR-CS F AAS) by means of different atomic lines (primary at 279.482 nm, secondary at 403.075 nm and alternative at 209.250 nm). These lines provided complementary concentration intervals, and large sample dilutions became unnecessary. The proposed method was applied to tap water, metal alloy certified material and foliar fertilizer. Accuracy for secondary line were evaluated by tests of significance (t Student test) with reference materials from the Institute of Technological Research of São Paulo, and the results were in agreement at the 95% confidence level. For primary and alternative lines, recovery is were in the 84-116% range and the RSD were 6.1% for all wavelengths. Analytical curves in the 0.1 - 2.0 mg L-1 (279.482 nm), 2.0 - 25 mg L-1 (403.075 nm), 25 - 500 mg L-1 (209.250 nm) intervals were obtained with linear correlation coefficient better than 0.9991. The detection limits were 3.3x10-3 mg L-1 (279.482 nm), 7.4 x 10-3 mg L-1 (403.075 nm), 3.9 mg L- 1 (209.250 nm). The found Mn concentrations were < 3.3x10-3 mg L-1 (tap water), 1.00 ± 0.04 (% m/m) (alloy IPT 25), 7235 ± 175 mg L-1 (foliar fertilizer 1), 4990 ± 132 mg L-1 (foliar fertilizer 2). A method was developed to detect interference of Fe in the Mn primary line (279.482 nm) using the ratio of absorbances of other lines of the triplet (279.827 nm and 280,108 nm).

Relevância:

20.00% 20.00%

Publicador:

Resumo:

O Brasil ocupa uma posição de destaque como produtor e exportador de carne de frango. Um parâmetro importante na qualidade da carne de frango é a quantidade de água absorvida pela carcaça durante o processamento. No Brasil, o resfriamento das carcaças é feito por imersão em água refrigerada e, neste processo, a carcaça é reidratada, recuperando a água perdida durante o transporte e as operações iniciais. Este projeto teve como objetivo avaliar os fatores extrínsecos que podem influenciar a absorção de água pela carne de frango. Para isso, foram utilizados 144 frangos da linhagem Cobb, divididos em 24 grupos de seis aves. Aos 42 dias de idade, uma ave de cada grupo, com peso variando até 10% para mais ou para menos, em relação à média do grupo, foram abatidas em abatedouro experimental. A etapa de resfriamento foi realizada seguindo um delineamento inteiramente casualizado com arranjo fatorial 3x2, onde os fatores foram: três temperaturas na primeira seção do sistema de refrigeração (4, 10 e 16 º C) e dois graus de dureza da água (água dura e água mole), com seis tratamentos e quatro repetições. A legislação brasileira estabelece que a temperatura da água na primeira seção do resfriador não deve ser superior a 16ºC. Todas as carcaças permaneceram na primeira seção do resfriador durante 30 minutos e, em seguida, foram transferidas para outro tanque com água a 4ºC, permanecendo até atingir 7ºC. As carcaças foram pesadas antes e após o resfriamento por imersão, para avaliação da percentagem de água absorvida. A absorção de água foi influenciada pela temperatura inicial da água no pré-resfriador e pela dureza da água. Quando imersas inicialmente em água a 4ºC, as carcaças absorveram, em média, 2,70%, uma absorção significativamente menor do que a média de 3,83% observada nas carcaças que foram inicialmente imersas em água a 16ºC (p<0,05). As carcaças imersas em água a 10ºC apresentaram média de absorção de água de 3,66%, não diferindo das médias observadas nos outros tratamentos (p>0,05). Em água dura, a média de absorção de água foi de 2,46% e, em água mole, de 4,33% (p<0,05). Em todos os tratamentos, a absorção de água não excedeu o limite estabelecido pela legislação brasileira, que é de, no máximo, 8%. Esta informação é importante para controlar a absorção de água pelas carcaças em processamento de carne de frango, impedindo que os consumidores sejam prejudicados.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Pós-graduação em Agronomia (Irrigação e Drenagem) - FCA

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)