Energy efficiency for standard penetration tests

The need for standardization of the measured blow count number N-spt into a normalized reference energy value is now fully recognized. The present paper extends the existing theoretical approach using the wave propagation theory as framework and introduces an analysis for large displacements enabling the influence of rod length in the measured N-spt values to be quantified. The study is based on both calibration chamber and field tests. Energy measurements are monitored in two different positions: below the anvil and above the sampler. Both experimental and numerical results demonstrate that whereas the energy delivered into the rod stem is expressed as a ratio of the theoretical free-fall energy of the hammer, the effective sampler energy is a function of the hammer height of fall, sampler permanent penetration, and weight of both hammer and rods. Influence of rod length is twofold and produces opposite effects: wave energy losses increase with increasing rod length and in a long rod composition the gain in potential energy from rod weight is significant and may partially compensate measured energy losses. Based on this revised approach, an analytical solution is proposed to calculate the energy delivered to the sampler and efficiency coefficients are suggested to account for energy losses during the energy transference process.

Transport properties of the transverse charge-density-wave system Fe3O2BO3

We study the transport properties of the charge-density-wave system Fe3O2BO3. ac conductivity measurements for different frequencies are presented for temperatures above and below the structural transition. dc conductivity, as a function of temperature and pressure, yields the variation of the transition temperature with external pressure. Below this transition the conductivity is thermally activated in a wide range of temperature and the gap obtained is strongly pressure dependent. The ac conductivity at sufficiently low temperatures below the transition is ascribed to the excitation of local defects associated with domain walls and which are characteristic of the one-dimensional nature of the Fe3O2BO3 system.

Assessment of brachial plexus blockade in chickens by an axillary approach

Objective To assess the brachial plexus block in chickens by an axillary approach and using a peripheral nerve stimulator.Study design Prospective, randomized, double-blinded study.Animals Six, 84-week old, female chickens.Methods Midazolam (1 mg kg(-1)) and butorphanol (1 mg kg(-1)) were administered into the pectoralis muscle. Fifteen minutes later, the birds were positioned in lateral recumbency and following palpation of the anatomic landmarks, a catheter was inserted using an axillary approach to the brachial plexus. Lidocaine or bupivacaine (1 mL kg(-1)) was injected after plexus localization by the nerve stimulator. Sensory function was tested before and after blockade (carpus, radius/ulna, humerus and pectoralis muscle) in the blocked and unblocked wings. The latency to onset of motor and sensory block and the duration of sensory block were recorded. A Friedman nonparametric one-way repeated-measures ANOVA was used to compare scores from baseline values over time and to compare the differences between wings at each time point.Results A total of 18 blocks were performed with a success rate of 66.6% (12/18). The latency for motor block was 2.8 +/- 1.1 and 3.2 +/- 0.4 minutes for lidocaine and bupivacaine, respectively. The latencies for and durations of the sensory block were 6.0 +/- 2.5 and 64.0 +/- 18.0 and 7.8 +/- 5.8 and 91.6 +/- 61.7 minutes for lidocaine and bupivacaine, respectively. There was no statistical difference between these times for lidocaine or bupivacaine. Sensory function was not abolished in nonblocked wings.Conclusions and clinical relevance The brachial plexus block was an easy technique to perform but had a high failure rate. It might be useful for providing anesthesia or postoperative analgesia of the wing in chickens and exotic avian species that have similar wing anatomy.

Optimization of Radial Basis Function neural network employed for prediction of surface roughness in hard turning process using Taguchi's orthogonal arrays

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

The Poisson-exponential distribution: a Bayesian approach

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Perturbations to Saturn's F-ring strands at their closest approach to Prometheus

The strange morphology of the F ring of Saturn is thought to be caused by the perturbing effects of two close satellites, Prometheus and Pandora. The F ring and the satellites also experience periodic close encounters as a result of differential precession arising from Saturn's oblateness. Using the orbits of the F-ring strands derived by Murray et al. (1997, Icarus 129, 304-316) the behaviour of the ring particles at their closest approach to Prometheus is analysed using numerical simulations. The results show that a gap and a wave are formed in the ring at each encounter with the satellite. However, the gap is expected to have a short lifetime due to keplerian shear. © 2000 Elsevier Science Ltd. All rights reserved.

Pion structure function within the instanton model

The leading-twist valence-quark distribution function in the pion is obtained at a low normalization scale of an order of the inverse average size of an instanton pc. The momentum dependent quark mass and the quark-pion vertex are constructed in the framework of the instanton liquid model, using a gauge invariant approach. The parameters of instanton vacuum, the effective instanton radius and quark mass, are related to the vacuum expectation values of the lowest dimension quark-gluon operators and to the pion low energy observables. An analytic expression for the quark distribution function in the pion for a general vertex function is derived. The results are QCD evolved to higher momentum-transfer values, and reasonable agreement with phenomenological analyses of the data on parton distributions for the pion is found. ©2000 The American Physical Society.

The two-impurity Anderson model: An effective medium approach

The two-impurity Anderson model is solved within a effective medium approach. All impurity parameters are modelled via Slater atomic orbitals. Impurity spectral densities and spin correlation functions are readily computed. Results are presented for the zero temperature, half-filled case. © 2002 Elsevier Science B.V. All rights reserved.

Soliton propagation in a medium with Kerr nonlinearity and resonant impurities: A variational approach

The soliton propagation in a medium with Kerr nonlinearity and resonant impurities was studied by a variational approach. The existence of a solitary wave was shown within the framework of a combined nonintegrable system composed of one nonlinear Schrödinger and a pair of Bloch equations. The analytical solution which was obtained, was tested through numerical simulations confirming its solitary wave nature.

Thermogravimetric studies of the decomposition kinetics of four different Hevea rubber clones using Ozawa's approach

Thermal degradation of natural rubber extracted from four different rubber clones of the Hevea brasiliensis species was investigated by thermogravimetry using Ozawa's approach to assess the kinetic parameters of the decomposition process. The results are discussed in terms of the order of reaction, kinetic parameters such as activation energy as a function of conversion degree, and thermal stability for each of the clones.

Dynamic programming approach for road centerline extraction from digital images

This paper presents a dynamic programming approach for semi-automated road extraction from medium-and high-resolution images. This method is a modified version of a pre-existing dynamic programming method for road extraction from low-resolution images. The basic assumption of this pre-existing method is that roads manifest as lines in low-resolution images (pixel footprint> 2 m) and as such can be modeled and extracted as linear features. On the other hand, roads manifest as ribbon features in medium- and high-resolution images (pixel footprint ≤ 2 m) and, as a result, the focus of road extraction becomes the road centerlines. The original method can not accurately extract road centerlines from medium- and high- resolution images. In view of this, we propose a modification of the merit function of the original approach, which is carried out by a constraint function embedding road edge properties. Experimental results demonstrated the modified algorithm's potential in extracting road centerlines from medium- and high-resolution images.

Stability analysis of power system including facts (TCSC) effects by direct method approach

The problem of power system stability including the effects of a flexible alternating current transmission system (FACTS) is approached. First, the controlled series compensation is considered in the machine against infinite bar system and its effects are taken into account by means of construction of a Lyapunov function (LF). This simple system is helpful in order to understand the form the device affects dynamic and transient performance of the power system. After, the multimachine case is considered and it is shown that the single-machine results apply to multimachine systems. An energy-form Lyapunov function is derived for the power system including the FACTS device and it is used to analyse damping and synchronizing effects due to the FACTS device in single-machine as well as in multimachine power systems. © 2005 Elsevier Ltd. All rights reserved.

A neural approach to evaluate the effect of lightning in power transformers

This paper proposes the application of computational intelligence techniques to assist complex problems concerning lightning in transformers. In order to estimate the currents related to lightning in a transformer, a neural tool is presented. ATP has generated the training vectors. The input variables used in Artificial Neural Networks (ANN) were the wave front time, the wave tail time, the voltage variation rate and the output variable is the maximum current in the secondary of the transformer. These parameters can define the behavior and severity of lightning. Based on these concepts and from the results obtained, it can be verified that the overvoltages at the secondary of transformer are also affected by the discharge waveform in a similar way to the primary side. By using the tool developed, the high voltage process in the distribution transformers can be mapped and estimated with more precision aiding the transformer project process, minimizing empirics and evaluation errors, and contributing to minimize the failure rate of transformers. © 2009 The Berkeley Electronic Press. All rights reserved.

On the kaon' s̄ structure function from the strangeness asymmetry in the nucleon

We propose a phenomenological approach based in the meson cloud model to obtain the strange quark structure function inside a kaon, considering the strange quark asymmetry inside the nucleon. © 2009 American Institute of Physics.

Modeling approach based on experimental results for prediction of measurement errors in energy meters

This paper presents a general modeling approach to investigate and to predict measurement errors in active energy meters both induction and electronic types. The measurement error modeling is based on Generalized Additive Model (GAM), Ridge Regression method and experimental results of meter provided by a measurement system. The measurement system provides a database of 26 pairs of test waveforms captured in a real electrical distribution system, with different load characteristics (industrial, commercial, agricultural, and residential), covering different harmonic distortions, and balanced and unbalanced voltage conditions. In order to illustrate the proposed approach, the measurement error models are discussed and several results, which are derived from experimental tests, are presented in the form of three-dimensional graphs, and generalized as error equations. © 2009 IEEE.