137 resultados para Tall towers


Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Ciências Cartográficas - FCT

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Agronomia - FCAV

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The experiment was conducted to study the relationship between the number and weight of tiller categories in Brachiaria decumbens cv. Basilisk pasture managed under continuous stocking with cattle. The pasture was managed with an average height of about 25 cm. Plants of four different heights (10, 20, 30 and 40 cm) were evaluated by means of the randomized block design with two replications. The number of vegetative tillers, both live and total, reduced linearly according to the plant height. The number of reproductive tillers increased linearly according to pasture plant height (from 8 to 84 tillers m-2 when comparing plants 10 to 40 cm high). Vegetative and reproductive tiller weight increased linearly according to pasture plant height. Vegetative tiller weight (0.316 g average) was lower than the reproductive tiller weight (0.401 g average). A linear and negative relationship was found between the number and weight of the vegetative tillers, whereas a linear and positive one was found for the reproductive tillers. There are fewer vegetative tillers, and a greater number of reproductive and dead tillers in places with tall plants. At the places with high B. decumbens plants, tillers are heavier.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Engenharia Mecânica - FEG

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The objective of this study was to evaluate the coverage of spray droplets on coffee plants as well as their deposition using a sprayer with and without adaptation of an auxiliary branch for tall plants. The experiment was conducted following a randomized block design with six treatments and four replications to evaluate the percentage of coverage for the spraying liquids in water sensitive paper fixed at four quadrants and two heights (lower and upper) of the plants, and the spray deposit with metallic marker (MnSO4) on sheets in the same positions of the water sensitive paper in two spray volumes (450 and 750 L h(-1)). The experiment was conducted in October 2011 in the town of Patroc nio-MG, and the experimental plots consisted of 30 plants of Catua IAC-99, with approximately 12 years of age and average height of 3.50 meters. The experiments were conducted following a randomized block design with six treatments and four replications to evaluate the coverage and deposition, in two spray volumes (450 and 750 L ha(-1)). Leaves were collected in four positions and also at the top four in the lower canopy. The results of the evaluations were analysed statistically by F test and for comparison of means by Tukey test at 5% probability. The auxiliary branch installed at the rear of the equipment is the most suitable when compared to use of equipment without this feature or installed in the front of the equipment. Furthermore, the application volume of 450 L ha(-1) results in coverages and deposits of spraying liquids equivalents to volume of 750 L ha(-1), considered sufficient according to the parameters evaluated.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Engenharia Mecânica - FEG