Assessing the surface roughness of a posterior resin composite: effect of surface sealing

This study assessed the in vitro influence of surface sealing on the surface roughness of a posterior resin composite before and after tooth-brushing. Thirty. specimens (13 nun diameter x 1 mm high) were fabricated from Filtek-P60 resin composite and randomly assigned to three groups (n=10): a non-sealed control and two groups sealed with one of the tested materials-a surface-penetrating sealant (Protect-it!-PI) and a one bottle adhesive system (Single Bond-SB). The samples were subjected to a surface roughness reading to determine the initial roughness, then submitted to simulated toothbrushing with 35,600 cycles for 100 minutes. Specimens were then cleaned and a post-abrasion surface roughness reading accomplished. Means (pm), recorded before (B) and after (A) toothbrushing, and standard deviations were: Control-(B): 0.032 (+/-0.005), (A): 0.054 (+/-0.005); PI-(B): 0.034 (+/-0.005), (A): 0.060 (+/-0.034); SB (B): 0.031 (+/-0.004), (A): 0.047 (+/-0.007). Data were tabulated and submitted to two-way ANOVA. No statistically significant difference was observed when the control and experimental groups were compared. However, a significant difference (p<0.05) was found between the measurements performed before and after toothbrushing. Based on these results, it may be concluded that using either a surface penetrating sealant or a one bottle adhesive system did not provide the optimization of superficial integrity. The use of a dentifrice and toothbrush resulted in significant alterations to the surface smoothness of the resin composite.

Effect of light curing sources on microhardness of different composite resins

This study evaluated the influence of light-curing units (LCUs) on Knoop microhardness (KHN) of different composite resins formulations. Four LCUs, one Quartz-Tungsten-Halogen (QTH) for 20 s, one Argon-Ion-Laser (AL) for 10 s, one Plasma-Arc-Curing (PAC) for 9 s, and one Light-Emitting-Diode (LED) for 20 s, and three composite resins, nanofill and easy cure (Filtek (TM) Supreme), microhybrid and medium cure (Herculite XRV), and microfill and difficult cure (Heliomolar) were used. Discs (4 x 2 mm(2)) of each composite resin were divided in 12 Groups and KHN was measured at the top (T) and bottom (B) surfaces. Data were analyzed using two-way ANOVA and Tukey's test (p < 0.05). Top presented significantly higher KHN than bottom surface for all composite resins and LCUs tested. Statistical significant differences were observed among the LCUs. At the bottom surface QTH and LED presented higher KHN than PAC and LA. However, at the top surface PAC and LA presented similar results than QTH for nanofill and microhybrid composite resins. Different LCUs play an important effect on Knoop microhardness and the composite resin formulations were significant factor on the photosensitivity.

Bond strength of different endodontic sealers to dentin: push-out test

Objective: The aim of this in vitro study was to evaluate the bond strength of different root canal sealers to dentin. Material and Methods: Forty extracted single-rooted human teeth were examined and the coronal and middle thirds of the canals were prepared with a 1.50 mm post drill (FibreKor Post System, Pentron). The teeth were allocated in two experimental groups, irrigated with 2.5% NaOCl+17% EDTA or saline solution (control group) and instrumented using Race rotary files (FKG) to a size #40 at the working length. Then, the groups were divided into four subgroups and filled with Epiphany sealer (Group 1), EndoREZ (Group 2), AH26 (Group 3) and Grossman's Sealer (Group 4). After 2 weeks of storage in 100% humidity at 37 degrees C, all teeth were sectioned transversally into 2-mm-thick discs. Push-out tests were performed at a cross-head speed of 1 mm/min using a universal testing machine. The maximum load at failure was recorded and expressed in MPa. Results: Means (+/- SD) in root canals irrigated with 2.5% NaOCl and 17% EDTA were: G1 (21.6 +/- 6.0), G2 (15.2 +/- 3.7), G3 (14.6 +/- 4.5) and G4 (11.7 +/- 4.1). Two-way ANOVA and Tukey's test showed the highest bond strength for the Epiphany's group (p < 0.01) when compared to the other tested sealers. Saline solution decreased the values of bond-strength (p < 0.05) for all sealers. Conclusion: Epiphany sealer presented higher bond strength values to dentin in both irrigating protocols, and the use of 2.5% NaOCl and 17% EDTA increased the bond strength values for all sealers.

Do extrafloral nectaries present a defensive role against herbivores in two species of the family Bignoniaceae in a Neotropical savannas?

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Application of C-banding in two Arachis wild species, Arachis pintoi Krapov. and W.C. Gregory and A-villosulicarpa Hoehne to mitotic chromosome analyses

Two wild diploid (2n = 20 chromosomes) and self-pollinating Arachis species, Arachis Pintoi Krapov and W.C.Gregory and A. villosulicarpa Hoehne were submmited to C-band technique to karyotype analyses. Root tips were employed in the analyses. Morphometric data chose that chromosome lengths varied from 3.12 in A. villosulicarpa to 1.45 in A. Pintoi. Karyotype formula obtained was 10sm to A. Pintoi and 9sm + 1m to A. villosulicarpa. There was a predominance of pericentromeric C-band in all mitotic metaphasic chromosomes in both species. Besides C-band values, both species still did not differ in respect to chromosome absolute and relative lengths, centromeric index, symmetry index and total karyotype haploid length. C-band and morphometric data did not show strong or significant differences which could separate these two species of peanut which belong to evolutive different sections.

NORs inheritance analysis in crossings including individuals from two stocks of rainbow trout (Oncorhynchus mykiss)

Silver nitrate staining of rainbow trouts (Oncorhynchus mykiss) chromosomes, for the identification of the nucleolar organizing regions (NORs), revealed that in individuals from Nucleo Experimental de Salmonicultura de Campos do Jordao (Brazil) NORs were located in the long arms of a submetacentric pair while in specimens from Mount Shasta (USA) NORs were located in the short arms of a submetacentric pair. Cytogenetic analysis of the offspring, obtained through artificial crosses including individuals from both stocks, allowed the identification of NORs in two submetacentric chromosomes, one in the short arms and the other in the long arms, confirming the effectiveness of the hybridization process. Complementary results obtained using the FISH technique with 18S and 5S rDNA probes showed that NOR-bearing chromosomes exhibited a cluster of 5S genes located in tandem with the 18S gene cluster in both stocks. The results allow us to suggest that the difference in NOR-bearing chromosomes found between the two stocks is likely to be due to a pericentric inversion involving the chromosome segment where 18S and 5S rDNA genes are located. The presence of ribosomal genes in the long arms of a submetacentric chromosome is apparently a particular characteristic of the rainbow trout stock of Campos do Jordao and might be used as a chromosome marker in studies of controlled crosses in this species.

Detection of hybrids and genetic introgression in wild stocks of two catfish species (Siluriformes: Pimelodidae): The impact of hatcheries in Brazil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Comparison of cheliped weight and growth in two species of crabs of the genus Callinectes (Brachyura, Portunidae)

A comparison of the cheliped's weight in two species of the genus Callinectes was accomplished. The species C. danae e C. ornatus were collected by two otter trawl in Ubatuba bay (23 degrees 26' S and 45 degrees 02' W). The allometric constants obtained from the regression adjusted to a power function (Y = aX(b)) were analyzed. These species presented different allometry degrees for each sex considered. The relation Pe x PC presented positive allometry for sex of both species, but male presented higher positive allometry than female. C. danae presented higher positive allometry for chelipeds than C. ornatus. We suggest here that C. danae could be indicated to be submitted to grow out in ponds since it reaches higher size and bigger chelipeds.

Allochthonous matter input in two different stretches of a headstream (Itatinga, São Paulo, Brazil)

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Bathymetric distribution of the shrimp Rimapenaeus constrictus (Stimpson, 1874) (Decapoda, Penaeidae) in two locations off the southeastern Brazilian coast

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Seed dispersal and spatial distribution of Attalea geraensis (Arecaceae) in two remnants of Cerrado in Southeastern Brazil

The seed dispersal system of Attalea geraensis (Arecaceae), an acaulescent palm, was investigated during one year in two Cerrado fragments in the state of São Paulo, southeastern Brazil. A. geraensis had inflorescences and infrutescences throughout the year. Two scatter-hoarding rodents (the spiny rat, Clyomys bishopi and agoutis, Dasyptocta azarae) were identified as seed predators/dispersers, able to move seeds up to 30 in from the palms, although most of the fruits (57.5%) were dispersed less than 2 in. The removal rates were high and after 20 days, 97.2% of the fruits were removed. Fruit fate was not related to fruit mass, length and diameter. The application of Morisita's index showed a more clumped distribution of adults in the smaller fragment, probably because of the absence of agoutis. Higher seed removal by rodents in the large Cerrado remnant may decrease seed predation by beetles. (C) 2007 Elsevier Masson SAS. All rights reserved.

Temporal variation in the abundance of two species of thrushes in relation to fruiting phenology in the Atlantic rainforest

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Stress biomarkers in rats submitted to swimming and treadmill running exercises

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

CONDITION of Hoplias aff. malabaricus (BLOCH, 1794) IN TWO COASTAL STREAMS of ITANHAEM RIVER BASIN, BRAZIL

The main purpose of this research was to measure the condition of the fish species Hoplias aff. malabaricus collected in Aguapeu River (black waters) and Branco River (white waters), which belong to Itanhaem River basin, a coastal watershed in São Paulo state, Brazil. Individuals of Hoplias aff. malabaricus were sampled by using gill nets, monthly from March 2001 to February 2002. The Condition Factor was obtained through the length-weight relationship, assuming that the higher the mass for a given length, the better the condition of the fish. The Condition Factor was compared among fishes from both rivers, resulting that Branco River individuals have significantly lower condition. Limnological aspects were studied from May 2001 to November 2002 and some show significant differences between Aguapeu River and Branco River. These were salinity, do and total organic N, which the higher values being observed in Branco River propably due to estuarine waters influence. However, the lower condition of the Branco River fishes should also be an effect of a disturbance due to the sand mining in this river, since this activity cause important alterations to the environment, affecting the whole biota, included aquatic macrophytes, invertebrates and fishes.

Visual communication stimulates reproduction in Nile tilapia, Oreochromis niloticus (L.)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)