Fishery of the Uçá Crab Ucides Cordatus (Linnaeus, 1763) in a Mangrove Area in Cananéia, State of São Paulo, Brazil: Fishery Performance, Exploitation Patterns and Factors Affecting the Catches

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Early selection in open-pollinated Eucalyptus families based on competition covariates

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Desempenho de bovinos de corte em pastos de Brachiaria brizantha cv. Xaraés manejados em diferentes alturas de pastejo

The production of grazing cattle has been very interesting, due to the low cost to produce fodder, compared to other sources of forage used to feed these animals, but the adequate management pasture has high influence on the success and profitability of cattle production systems. Thus, the objective of this study was to determine the optimum grazing height of Brachiaria brizantha cv. Xaraes, which provides the highest individual weight gain and gain per area. The stocking rate was continuous, with variable stocking rate. The experimental period was from January to December 2010. Three Nellore males were used in each experimental plot, and, when needed, additional animals were used for adjusting the desired heights. Monthly sampling was obtained to estimate forage mass (kg.ha(-1) of DM) and the structural characteristics of the pastures, such as, leaf: stem ratio. The animals were weighed at the beginning of the experiment and every 28 days, after 12 hours of fasting, to measure the average daily gain (ADG) After weighings were performed adjustments stocking rate to desired heights. Throughout the experimental period the animals received mineral supplementation. The desired sward heights were 15, 30, 45 and 60 cm, with three replicates each. The experimental design was completely randomized with four treatments and three replications. To body weight gain (BWG) and average daily gain (ADG), each animal was considered an experimental unit. To gain per area and stocking rate, the paddock was considered the experimental unit. The leaf: stem ratio showed a linear increasing behavior in the spring and summer seasons. The smaller grazing heights provided higher gain per unit area (812.15 kg ha(-1)), while the highest grazing heights promoted high individual weight gain (0.790 kg.dia(-1)). The results suggest that Xaraes grass pastures should be grazed between 30 and 45 cm to allow reasonable performances by area and individual performances.

Caracterização hidráulica do aspersor Super 10 e sua influência na energia cinética e erosividade

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Sistemas de cultivo em área de reforma de cana-de-açúcar e a sucessão de culturas na composição da comunidade infestante

Pós-graduação em Agronomia (Produção Vegetal) - FCAV

Validação das unidades arbitrárias de teor de clorofilas obtido em folhas intactas de seringueira

The determination of foliar chlorophyll content is a characteristic that interests ecophysiologists and rural producers. With consideration for practical uses as well as scientific publications, our present work aims to establish equations, for rubber tree leaves, that can convert arbitrary units of expressing chlorophyll content to the international system. Chlorophyll a (Chla), chlorophyll b (Chlb), and total chlorophyll (Chltot) were obtained from intact leaves using a portable chlorophyll detecting instrument. Leaves from different positions on the plant, at various stages of maturity, and representing a large spectrum of pigment concentrations, were collected and analyzed in the field using the Clorofil OG Falkner ® instrument, through four evaluations in forty-five medium leaflets. At the laboratory, leaflets underwent a process of pigment extraction. They were incubated in a water-bath with dimethylsulfoxide (DMSO), dosed in molecular absorption spectrophotometer, and converted into pigment content per unit of fresh weight using conventional equations. The data were evaluated according to the Pearson correlation coefficient and tested with different regression models. For all variables, the linear fit is the most adequate, with correlation coefficients (r) 0.74 for Chlb and 0.88 for Chla and Chltott.

Validação das unidades arbitrárias do teor de clorofilas obtido em folhas intactas de seringueira

The determination of foliar chlorophyll content is a characteristic that interests ecophysiologists and rural producers. With consideration for practical uses as well as scientific publications, our present work aims to establish equations, for rubber tree leaves, that can convert arbitrary units of expressing chlorophyll content to the international system. Chlorophyll a (Chla), chlorophyll b (Chlb), and total chlorophyll (Chltot) were obtained from intact leaves using a portable chlorophyll detecting instrument. Leaves from different positions on the plant, at various stages of maturity, and representing a large spectrum of pigment concentrations, were collected and analyzed in the field using the Clorofil OG Falkner ® instrument, through four evaluations in forty-five medium leaflets. At the laboratory, leaflets underwent a process of pigment extraction. They were incubated in a water-bath with dimethylsulfoxide (DMSO), dosed in molecular absorption spectrophotometer, and converted into pigment content per unit of fresh weight using conventional equations. The data were evaluated according to the Pearson correlation coefficient and tested with different regression models. For all variables, the linear fit is the most adequate, with correlation coefficients (r) 0.74 for Chlb and 0.88 for Chla and Chltott .

Farelo de abacaxi como fonte de fibra na alimentação de leitões desmamados

Pós-graduação em Ciência e Tecnologia Animal - FEIS

On the standardization of the fishing effort

In this note we demonstrate that the use of an index to standardize the fishing effort using the cpue of a standard vessel or gear is mistaken, once the cpues- catch per unit of total effort after standardization is similar to cpues - catch per unit of effort of the standard vesel or gear arbitrarily chosen.

A comparison of mucosal surface area and villous histology in small intestines of the brazilian free-tailed bat (Tadarida brasiliensis) and the mouse (Mus musculus)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Response of laying hens to methionine plus cystine intake by dilution technique

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Temperature-dependent fecundity and life table of the fennel aphid hyadaphis foeniculi (passerini) (hemiptera: aphididae)

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Biomass burning fuel consumption rates: a field measurement database

Landscape fires show large variability in the amount of biomass or fuel consumed per unit area burned. Fuel consumption (FC) depends on the biomass available to burn and the fraction of the biomass that is actually combusted, and can be combined with estimates of area burned to assess emissions. While burned area can be detected from space and estimates are becoming more reliable due to improved algorithms and sensors, FC is usually modeled or taken selectively from the literature. We compiled the peerreviewed literature on FC for various biomes and fuel categories to understand FC and its variability better, and to provide a database that can be used to constrain biogeochemical models with fire modules. We compiled in total 77 studies covering 11 biomes including savanna (15 studies, average FC of 4.6 t DM (dry matter) ha 1 with a standard deviation of 2.2), tropical forest (n = 19, FC = 126 +/- 77), temperate forest (n = 12, FC = 58 +/- 72), boreal forest (n = 16, FC = 35 +/- 24), pasture (n = 4, FC = 28 +/- 9.3), shifting cultivation (n = 2, FC = 23, with a range of 4.0-43), crop residue (n = 4, FC = 6.5 +/- 9.0), chaparral (n = 3, FC = 27 +/- 19), tropical peatland (n = 4, FC = 314 +/- 196), boreal peatland (n = 2, FC = 42 [42-43]), and tundra (n = 1, FC = 40). Within biomes the regional variability in the number of measurements was sometimes large, with e. g. only three measurement locations in boreal Russia and 35 sites in North America. Substantial regional differences in FC were found within the defined biomes: for example, FC of temperate pine forests in the USA was 37% lower than Australian forests dominated by eucalypt trees. Besides showing the differences between biomes, FC estimates were also grouped into different fuel classes. Our results highlight the large variability in FC, not only between biomes but also within biomes and fuel classes. This implies that substantial uncertainties are associated with using biome-averaged values to represent FC for whole biomes. Comparing the compiled FC values with co-located Global Fire Emissions Database version 3 (GFED3) FC indicates that modeling studies that aim to represent variability in FC also within biomes, still require improvements as they have difficulty in representing the dynamics governing FC.

Photoelectrocatalytic/photoelectro-Fenton coupling system using a nanostructured photoanode for the oxidation of a textile dye: kinetics study and oxidation pathway

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Análise estrutural de aerogéis via espalhamento de luz a baixo ângulo

The sol-gel process is a method for obtaining vitreous or vitro-ceramic materials which, are prepared a sol and by drying the liquid phase. This technique has been used extensively for the preparation of glassy gels, films, fibers and particles from the hydrolysis and polycondensation reactions of metal alkoxides. The usual methods for drying are: evaporation drying (xerogels), freeze drying (criogéis) and via supercritical CO2 extraction (aerogels). In the present work, we studied the preparation of silica gels by the sol-gel process from the hydrolysis of alkoxides tetraethylorthosilicate (TEOS) and 3-glycidoxypropyltrimethoxysilane (GPTS). The hydrolysis was promoted from GPTS and TEOS in proportion (4: 1) under acidic conditions. The hydrolysis reaction was promoted inside a Becker at room temperature. After hydrolyses the prepared sol had pH 2, and kept under mechanical agitation for a period of 1 hour. In order to accelerate the polycondensation reaction, the pH was corrected to a value near 5 by slowly adding NH4OH. Then the sols were leaked in sealed polycarbonate containers and maintained for 20 days at 40°C for gelation. Silica aerogels were prepared via supercritical CO2 extraction of the wet gel at temperature and pressure higher than 31°C and 74 atm, in an autoclave specially developed for the process. The structural characteristics were studied in the dry gel (aerogel). Aerogels were then characterized by nitrogen adsorption and small angle light scattering. The nitrogen adsorption data were analyzed for the determination of the BET specific surface (SBET), the total pore volume Vp, the pore mean size (lP=4Vp/SBET), the particle mean size (lS) and the pore size distribution (PSD). And the data from small angle light scattering were analyzed to determine the correlation function (γ'), the area per unit volume (S/V), average pore size (l ) and the average particle size...